Santa Fe (CM - 2007-12) :: Check Engine Light Not Working On Dashboard
I recently bought a Santa fe 2007 Limited 3.3L, it has 101500 miles. The issue is that when i run the scan it has 3 minor sensors that needs to be replaced but my biggest concern is that the check engine light does not come on in the dashboard even when i turn the ignition to on.
I need to know if there is a fuse that can cause this or a bulb in the dashboard that i can replaced for myself or if it is something else.
Passat (B5) :: EPC And Check Engine Light Stay On After Letting The Key Out Of Start Position
My wife drives a 2004 passat 4 motion 1.8 T that for a couple of days has been acting up. By acting up I mean it will turn over but won't start. When this happens and after letting the key out of the start position, the epc and cel light will stay on. After letting it sit for a while it will start.
View 2 RepliesFord - Explorer :: 1997 - Stay Idle Kick Into Gear And Jump Start - O/D Light Flashing?
I have a 97 Ford Explorer. I bought it in 07 and it was nice until like 2 years ago when it started to give me doubts. It never died on me,yet, but everyday when I first start it for the day, if I put it in gear right away, it will stay idle for a while and then kick into gear and just jump. I would drive but it keeps kicking off and on until it is warmed up, I guess because it goes away. Also the OD light would come on also.
View 2 RepliesSanta FE SM (2001-06) :: Jerking / Stalling - Need To Jump Start
Bought a 2006 2.4L Sante Fe a few months ago. Had a couple incidents of it jerking after descending the same hill in our neighbourhood. Have a 6 month warranty so brought it to mechanic. All their "scans" were showing everything working so they guessed at replacing the fuel pump and filter. A week later did the same thing but this time it stalled out and I had to jump start to get it back to garage. My wife scanned the internet and noticed other similar complaints. The crankshaft position sensor seemed to come up as being replaced in these incidences, and apparently the "scan" will not show it as failed if it is still somewhat operable. Based on that, we told the garage to replace it as they literally could not figure out what was wrong with the car, having driven it over several days for it to repeat the jerking and stalling we had experienced. It has only been a few days so here's hoping that was the answer.......
View 1 RepliesSanta FE SM (2001-06) :: 2005 V6 Transmission Jump Hard And Bucked On Cold Start
I own 2005 Santa Fe. Vehicle is a 3.5l V6. 90,000 miles. Transmission flushed few months ago. Few weeks ago I notice that transmission jump hard and bucked on cold start then smooth out once the engine warm up. Is it normal? if not what could be a problem.
View 3 RepliesSanta FE SM (2001-06) :: Codes For Check Engine Light
My '04 santa fe 3.5 v6 gls/lx, 79k miles, gas, auto, check light has just come on while I was driving a less than 10 mile journey. How can I check what is wrong. Do I need some sort of diagnostic code checker. Do any national outlets check it for free (Pep Boys or Auto Zone, etc).
Just 5 days ago (about 50 miles only) I had timing belt, water pump, plugs and leads replaced, brakes checked and lubes flushed; BUT not at above dealers. I would rather know what the code is saying before I go back to the shop who carried out the work.
Santa FE SM (2001-06) :: How To Turn Off Check Engine Light
How can i turn off check engine light (hyundai santa fe 2003 3.5) by fuse ? I do not have any code scanner.
View 10 RepliesSanta FE SM (2001-06) :: 3.5 V6 - Check Engine Light Keeps Going On And Off - O2 Sensor?
I recently purchased a 3.5 V6 Santa fe. The Check engine light keeps going on. I took it to a few shops and I am getting the same code. It is the O2 sensor in bank one. (I think the the code was po170.) The light keeps going on and off. All I can find are the same problems with different Santa Fe engines (2.7, etc. )... My SUV has 100,050 miles on it.
View 1 RepliesPrius (2010-12) :: Check Hybrid System Light Came On After Jump Start
Check hybrid system light came on and the whole dash lit up like a christmas tree. After i jumpstarted the 12v battery when it died. It was driving fine for about half an hour and all of a sudden the lights came on during acceleration from a stop light.
View 7 RepliesSanta FE SM (2001-06) :: Check Engine Light Go On And Off With P0700 And P0741 Codes
I have had a check engine light go on and off with P0700 and P0741 but since the flush day 3 it hasnt come back on and it was chucking with rpm doing small jumps... but now it does it in the mornings after sitting all night after a few chucks its fine for the rest of the day til the next day no check engine light so far, but transmission flush has worked a lot not as bad as before the flush.. So what else could be causing it? Its a 2006 hyundai santa fe with 274,000 kms.
View 24 RepliesSanta FE SM (2001-06) :: Check Engine Light On - Muffled Backfire Noise
I have A 2001 Santa Fe. The check engine light came on about 3 weeks ago and the car was still running fine up until the last few days it felt a little sluggish. Today I got a little muffled backfire noise. It was like a putting noise if I pushed on the gas to hard to speed up. The car has 95,000 miles on it.The car starts up with no problems and doesn't stall. Its A 6 cylinder All wheel drive vehicle.
View 10 RepliesSanta FE SM (2001-06) :: Check Engine Light On And Car Stalled Once - Code P0320
Check engine light on, car stalled once. Pulling code p0320 "Engine Speed Input Circuit Malfunction." Tachometer works intermittently. Where do I start?
View 2 RepliesSanta FE SM (2001-06) :: Check Engine Light Fault Code P0320
Recently got check engine light fault code p0320
2005 3.5 with 172k miles
Santa FE SM (2001-06) :: Check Engine Light Has Come On - Codes P0501 And P1529
I have a 2002 SF GLS/LX (?) with 2.7 L V6 2WD (60,000 miles) and it started to apply the ABS brakes in a random manner. Found out it was caused by a broken front wheel tone ring. So, I pulled the ABS fuse under the dash and it stopped the brake problem. Drove it today to pick up some wood and now the check engine light has come on.
My neighbor has an OBD scanner and he plugged it in and said I have a P0501 code and a P1529 code, but he didn't know what they meant. What they mean and are they related to me pulling the fuse under the dash? Did I pull the wrong fuse? Is there another fuse somewhere that I should have pulled?
Santa FE SM (2001-06) :: 2002 V6 AWD Check Engine Light Stays On After Replacing ECM
My 2002 Hyundai Santa Fe 2.7L V6 AWD failed to start a week ago. After towing to my neighborhood repair shop, it was diagnosed as a faulty ECM based on code P560 (System Voltage Problem). They replaced the ECM (along with relay) with a used one with the exact same part#. After that, the car was started and run OK but Check Engine Light stays on all the time. The codes displayed are:
P1529 TCU MIL Request Signal
P0501 VSS Range Performance
I was told that this is caused by the fact that each ECM is VIN/PIN locked. The replacing ECM was used in another car before and was locked with a different VIN thus cannot communicate with some components of the current car.
My questions are:
Can this used ECM be unlocked and relocked with a new VIN/PIN? If so, does it require the previous VIN/PIN to unlock? Most likely the previous VIN/PIN is no longer available.
Does this service require the presence of the car or can it be done with the ECM alone? Do keys need to be re-registered? The car starts fine currently.
Santa FE SM (2001-06) :: 2005 2.7L - Check Engine Light Comes On After 5 To10 Minutes Of Driving
My wife's car is throwing at p0306 code. I have changed the park plugs and the check engine lights comes on after 5-10 minute of driving and gives the same code. Can I move the spark plug wire to another ignition coil bank to test the coil? The picture shows the current plug locations on the ignition pack. Is there any certain order they need to be in or can I just swap 6 and 5 since they are the closest together?
View 6 RepliesSanta FE SM (2001-06) :: 2004 - Check Engine Light Is On / EVAP Canister Solenoid
I have a 2004 Santa Fe 2.4L the check engine light is on and says about the evap canister solenoid. I am trying to located it but I can't find it. So, where would it be located at so I can take it apart and where is the Canister located as well...
View 1 RepliesSanta FE SM (2001-06) :: Check Engine Light Came On - Code For Throttle Position Open
My check engine light came on the other day and the code stated the the "throttle position is open" so after researching and everyone telling me that i need to change the sensor. I did everything after was fine running better but today only after 3 days replacing it i get the same problems. car has no get up and go hardly can push to 20 mph and when in idle i press the break it starts to bog down and almost want to shut off! and can be really loud...
Santa fe 05' 3.5L ....
Santa FE SM (2001-06) :: 2004 - Power Loss With A Check Engine Light On / Intermittent Misfire
I have a 2004 santa fe with a 2.7 v6. I have had a little misfire issue lately. I had a major power loss with a check engine light on it lasted for just a minute before it settled itself out. Had the code pulled at a local parts store. P0301 so I checked the plugs and they looked worn out. I pulled the upper intake and replaced the plugs and wires plus the upper intake gasket. I cleared the code and that seemed to correct the problem. Two days later, same thing happened. The engine seems to be running fine now. I wiggled the wiring harness to the injector and to the coil, no change in the way it runs. I was thinking it could be an injector or a coil pack.
View 6 Replies