Santa FE SM (2001-06) :: 2004 Won't Crank For 10 Minutes Or So When Stopped The Car
This had occurred twice thus far in the past 6 months.
2004 Santa Fe 3.8L Automatic:
I had stopped the car at a store several months back, got back in the car after about an hour and I go to turn the key and the motor will not crank at all. Battery was fine, lights all worked, etc. After about ten minutes of fiddling with the shift it finally cranked and started without issue. Tonight I had stopped, topped off the tank (mistake I am sure) and tried to leave the gas station, again, no crank (and I forgot my cell phone at home!).
After about 15 minutes of fiddling with the shifter thinking a lock switch issue it again finally cranked over and started right up! Sounds like a couple of isolated incidents, however what may be the causes?
The first time I don't recall if I had gotten fuel or not. I did travel a ways afterward if I indeed had. This time I could not get it to crank right at the pumps.
Could this indeed be the purge valve issue I have heard about on these causing it not to even crank?
Santa FE SM (2001-06) :: Temp Control Unit Clicks Rapidly With A/C Indicator Lights Turning On And Off
2003 Santa Fe 2.7L
When I turn off the A/C my Temperature Control unit clicks rapidly with the A/C indicator lights turning on and off. It's almost like something was turning it rapidly between on and off. Maybe a short in the controls somewhere. I may try and take it apart and see if I can find an intermittent connection in the switch or a short or loose connection or bad wiring somewhere in the unit.
The other option is just to replace the whole A/C Heater Temp Ctrl. unit.
Chevrolet - Colorado :: Starter Clicks But Won't Crank
Starter clicks wont crank...
View 2 RepliesSanta FE SM (2001-06) :: No Crank After Battery Replacement
I remove the battery of my Santa Fe 2005, cleaned cable, added grease, placed a brand new battery, reconnected the cables. But, when I tried to start nothing happens. The Radio, lamps, etc.. are working, so the car is powered, but no cranking, nothing.... I tried to reset ECU by disconnecting the battery cables for a while to empty the condensator. But it does not work. I also tried to connect the batteries NEG and POS poles together to reset the ECU but no success... I need my car to work....
View 3 RepliesSanta FE SM (2001-06) :: Crank No Start And Code P0340
2002 Santa Fe 2.4L Automatic. Driving on the freeway when it lost power. Couldn't go over 65 even with the accelerator all the way down, even slower on uphill climbs. The engine wouldn't rev higher than around 3000rpms.
I figured it sounded like a loss of power due to weak fuel pump. I replaced it as well as the fuel filter, and verified it was pumping. Put the car together, and still the same loss of power. Drove home and parked it, but next morning it won't run at all. It cranks all day long but doesn't fire.
So far, I have made the following repairs and checks:
-Verified catalytic converter was clear and not plugged
-Verified fuel pressure
-Checked spark plugs - all are good and gaped properly
-Replaced crank position sensor (With the code, I thought this would solve it)
-Verified timing belt and cam belt in time - both have also been changed recently
-Checked all relays and fuses
-Battery and alternator are good - both are new
I still have a crank no start issue, and I'm going crazy taking things apart and putting them back together only to have this car not fire.
Santa FE SM (2001-06) :: Crank With No Start In Cold Temps
I am having a crank and no start issue for a while now In Cold Temps -20 Celsius Or Colder... dealership checked fuses and relays they came back fine. there was an active CEL code for Low System Voltage would that have something to do with my problem here, and what else could be the problem? this has happened in the past after short 2 min drive and go in the store and come back out from being in the store for a few mins, eventually it does turn over but not without alot of cranking and curse words, until now I just found out after a longer 20 min trip it did it again, telling me its getting worse. 2006 Hyundai Santa Fe / 205,000 kms....
View 11 RepliesSanta FE SM (2001-06) :: Starter Doesn't Crank At All - How Immobilizer Works
I have 2005 Santa fe. I replaced the battery about 1000 km (about 600 miles) ago. Interior lights are bright. Now the car won't start, starter doesn't crank at all. At first I thought that it's an immobilizer problem, but not so sure now.
Could you tell me how Hyundai's immobilizer works. Some other cars starts but then turns off if immobilizer is on. Is it the same thing with Santa Fe?
I read from the manual that immobilizer-light should blink if immobilizer is on. I have not watched the dashboard lights so accurately before this. When I turn key to position "on", the immobilizer-light turns on (it doesn't blink). Is it supposed to do so and turn off when the car is running? Or is that a sign that immobilizer is on?
Santa FE SM (2001-06) :: 3.5L 4WD Not Starting / Replaced Crank Position Sensor
We bought a 2006 Hyundai Sante Fe with the 3.5L and 4 wheel drive about two months ago, it has 94,000 miles on it. It was purchased from a dealership, and they had to work on it for a month before we took it from them because of some lights that were on, resulting in some sensors being replaced. We had it about a month when we took it to the grocery store, when we came back out I started it and it made a terrible noise, but was running, I immediately turned it off. Upon further inspection, the main serpentine belt had snapped, causing some damage to the secondary belt. We towed it home and I began to fix the belts.
When I pulled off the passenger side wheel and access cover, I noticed the remains of the belt were stuck behind the harmonic balancer, I tugged on it with about 5 pounds of force, and the entire pulley fell off of the harmonic balancer. I'm not sure if the belt stacked up behind and pushed it off, or if it just went bad, but the rubber between the portion that connects to the crank and the pulley was ripped, and missing in some spots. I replaced the harmonic balancer, and both belts, good to go, everything is running fine.
About a week later, the TCS etc. lights came on, but no check engine. I researched it a bit and came up with three possibilities:
1. Fuse
2. Tone wheel cracked/broken
3. Crankshaft position sensor
I checked the fuses and nothing was burnt, I never lifted the truck up to check the tone wheels.
Santa FE SM (2001-06) :: 2003 - Crank Position Sensor Blown
I've a 2.0L Santa Fe CRDI 4WD, 2003. My Crank position sensor has blown. My question is, does the timing belt have to be replaced with the sensor, or can the sensor be replaced alone? I know the belt must be replaced with petrol models but I've been told it may not be necessary with diesels.
View 1 RepliesSanta FE SM (2001-06) :: Jiggle The Shifter To Get Engine To Crank - Neutral Safety Switch?
I have a '05 santa fe, auto, 2.7L, 4WD...sometimes I have to jiggle the shifter to get the engine to crank...would this be the neutral safety switch? or is there something in the shifter housing that could be causing this?
Maybe a minor adjustment... Just a slight movement of the shifter and it fires right up... If it is the neutral safety switch..where is it located? on the trans?
Santa FE SM (2001-06) :: Engine Making Loud Ticking Noise - Crank Pulley Gone
Oh where do I start. 2003 Santa Fe, V6 Auto, FWD.
The engine has been making a loud ticking noise lately, starting right after an oil change it seemed. It actually sounded a lot like a stuck lifter, so I had an engine flush done, but this did not remedy the problem. Popping the hood one day it was particularly noisy, I noticed that it sounded like it was coming from the serpentine belt tensioner (or there abouts).
Anyway, tonight, *something* finally gave. All of a sudden I heard a squealing noise, then smelled burning rubber, and my battery light came on, and I lost my power steering. I figured that the tensioner finally gave out.
I turned off the vehicle to see what I could see. A bit of melted S-belt was it. I restarted it, and the belt was turning fine again, but while it was idling, I noticed that the crank pulley was shifting in and out now and then. When it moved inward, the S-belt shifted in as well, and started to rub on the timing cover, wearing a hole right through it! Have a look at the attached photo, showing the grove worn right through.
So I'm assuming that my tensioner was fine, and it was my crank pulley all a long. I'm figuring that 3 thing will need replacing:
1. Crank Pulley (the source of the problem)
2. Serpentine Belt (since it's probably half melted)
3. Timing Cover (can't see that water getting in there would be good)
Does this sound accurate?
Ford Super Duty (1999-2016) :: 2003 F350 Won't Start / When Turn The Key It Just Clicks And Doesn't Crank
So I 2003 6.0 F350 that is a Dually. Been sitting in my yard for about two years now. I turn the key it just clicks and it doesn't crank. The starter solenoid is not on the firewall so I use the trick with the battery connected positive straight to the starter with the whit The starter solenoid is not on the firewall so I use the trick with the battery connected positive straight to the starter with the wire on the engine bay. It cranked for a while and that started ran rough. Then it just died. I did not start again. I did this during winter so the engine have time to cool off it was about below freezing. Done this multiple times and drove up and down in my backyard but not on the road. What could be wrong with it. Either way I put in diesel 911 and more fuel but and I change the filters with Motorcraft OEM filters. Sure that the caps were right.
View 14 RepliesSanta Fe (CM - 2007-12) :: 2010 - Random Clicks Before Engine Would Start Normally
2010 Santa Fe V6...about a week ago the starter started acting up. When you try to start the car, you would hear 3 clicks before the engine would start normally. The clicking is random and does not happen every time. The dealer could not find anything wrong other than the battery was reading 440CCA vs the 600CCA it was rated. Starter clicked first thing today on the way to local mechanic to get brakes replaced. They tested battery and it tested good. What could be the problem?
View 4 RepliesElantra XD (2001-06) :: 2004 Just Shutting Off While Driving - Crank Sensor?
I'm having a problem with the car just shutting off while I'm driving. The computer says its the crank sensor. I replaced it and it got worse would not start. Put old one back same results. Put new one in and it starts and runs but still stalls while I'm driving. Computer now says crank sensor circuit. Not sure if it is another bad sensor or short somewhere.
View 1 RepliesGolf IV / Jetta IV :: 2001 TDI Clicks Or Grinds With No Start
2001 Jetta 1.9 TDI that won't start! For the past few months, starting the car has been hit or miss. I started by changing the battery, later the starter, then later the glow plugs. Each item seemed to get it start. When I say "hit", the car started fine as long as it was plugged in when cold. And "miss", the car clicks or grinds with no start.
After I changed the glow plugs it didn't miss at all for a couple weeks (the outside weather has been getting warmer too). Then it started missing on and off, and now wont start at all.
Here is a video - the sound it makes during the second attempt (clicks then winds) has been common since not long after changing the starter. [URL] ..... The car is being boosted during the video.
Some extra information: about a month ago I notice the coolant was a little low (added less than a cup of G12), a few years back the car, had some half diesel and half gas ran through it. The car has 350,000 kms..
Passat (B5) :: 2001 - Transmission Jerks / Clicks Whenever It Is Downshifted Into 2nd Gear
So my trans clicks and jerks every time it downshifts into 2nd but that is the only time it does it. When i down shift using the tip shift it doesn't do anything and it all feels normal. What it could be being that it is just when it downshifts into second.
My car is a 2001 v6 4motion.
Elantra XD (2001-06) :: Front CV Joint Axle Clicks When Going Around Corners
I just bought a 2003 Hyundai Elantra GLS, yesterday. 167k. Some faded paint on top areas, dead battery & in need of driver's front CV joint axle i believe, clicks when going around corners. Starts without hesitation, no smoke, no ticking, very clean and has only had 1 owner.
View 10 RepliesSanta FE SM (2001-06) :: 2004 3.5 Engine Will Die Randomly
Engine will die randomly. After sitting for half hour it will restart. It has been to the dealer, it sets no codes but when it dies all lights on dash come on just like when you first start car. It has 75k on it timing belt replaced new plugs and wires. Dealer kept it 2 days and could not replicate the problem.
View 2 RepliesSanta FE SM (2001-06) :: 2004 - Low Beams Don't Work
My low beams won't work. High beams and fog lights work just fine. We just replaced both bulbs a few months ago so the chances are pretty slim that it's a blown bulb.
I've checked the fuses and relays. I switched the low beam and high beam relays with no luck. Still no low beams.