Ram / SRT10 :: 1994 Dodge Gets No Oil Pressure And No Oil To Top End
I've got a1994 dodge ram 1500 with a 318 cam bearings are good new oil pump new oil pump drive pin getting oil to the filter and that's as far as it gets no oil pressure and no oil to the top end? Me and a couple engine builders are stumped!
View 1 RepliesRam / SRT10 :: 1998 Dodge AC Blowing Hot
I have a 1998 dodge ram 1500 5.9 the ac blows hot I've replaced the ac compressor the evaporator and the accumulator I even did a ac vacuum on the lines their are no leaks.
View 13 RepliesRam / SRT10 :: 99 Dodge Stalled While Driving And Won't Turn Over
I have a 99 dodge ram i was driving it home the other night and it stalled out on me and will not turn over. When i try to start it it just clicks once and that's it. I just replaced the fuel pump and have already checked the starter, alternator, and battery and have still found nothing.
View 1 RepliesRam / SRT10 :: 1999 Dodge Will Not Idle Until Engine Is Fully Warmed Up
I have a 1999 Dodge Ram 1500, 5.9L. My problem is it will not idle until the engine is fully warmed up. When I first start it, I need to keep my foot on the gas, if I let it go it dies.
View 1 RepliesRam / SRT10 :: 1999 Dodge Battery Dying Constantly - All The Gauges On Dash Go To 0
So, about 6 months ago, I bought a 1999 Dodge Ram just to keep around the house to do odd and ends jobs. Not a daily driver. I might have a need for it every few months. Well, a few months ago, I went to start it and the battery was dead. I have a battery charger that tests the battery. It said the battery was bad. So, I bought a new battery. A few days ago, I went to start it... again with the new battery, it was dead.
Put the charger on it and it said again that there was a shorted cell in it. So, I returned that one under warranty. Now went to start it, dead again (a week later.) So, I guess it's obvious it's not a bad battery (or at least the bad batteries are a cause of something else wrong.) I'm guessing there's a slow drain somewhere in the truck. How to find it?
I don't know if this has anything to do with it... Ever since I've owned it, every once in a while when driving the truck, all the gauges on the dash go to 0. Then it will just randomly start working again. Don't know if that has anything to do with the battery dying problem.
Ram / SRT10 :: Lamp Out Warning With Turn Signal On 2002 Dodge Pick Up
2002 Dodge pick up constantly gives me this warning when the park lights are on and then use a turn signal. All lamps do work and the front control module has been changed.
View 4 RepliesRam / SRT10 :: 2001- Engine Won't Turn Over
Turn the key, engine won't turn over, straight hook up starter with battery cables, starter spins engine won't turn, all lights come on on instrument panel, checked all fuses, relay, etc..solenoid won't kick gear into flywheel.
View 3 RepliesRam / SRT10 :: Sometimes When Start 2001 - It Begins To Run Rough Like It Is Off Timing
I have a 2001 ram 1500 sometimes when I go to start it, it begins to run rough like it is off timing and then it dies, do a restart and it runs ok, it has done this a few times when I come to a traffic signal. it just starts running rough and the stalls.
View 5 RepliesRam / SRT10 :: 2000 / 1500 - Air Bag Light Came On
I was driving my truck and then started binging and I looked at dash and the air bag light lit up, what does this mean what would be wrong?
View 6 RepliesRam / SRT10 :: 1994 - Code 35 On Check Engine Light
Just got a 35 on my check engine light. From the list of codes this has to do with a radiator fan control, but the fan is not electric. It's a 1994 Ram with 5.2L 318 engine. I'm confused, what does this mean?
View 7 RepliesRam / SRT10 :: 2001 Starts Fine Then Dies At Idle And Runs Rough On Gear Till 1000 Rpm
Starts fine. Runs fine till warmed up. Then dies at idle and runs rough on gear till 1000 rpm. Has only coded iac when unplugged. But would idle with it unplugged. I replaced it. Also got crank can code once while checking it ...
2001 dodge ram 1500 318 engine ....
Ram / SRT10 :: Heater Quit Blowing Hot Air
I have an 03 Ram 1500 that quit blowing hot air. I have heard of doors not opening to divert the air to the heater core. Heater hoses are both hot, so I'm pretty sure the water is going where it's supposed to, just not the air.
View 3 RepliesRam / SRT10 :: 2003 - Shaking In Front End While Going From 45 To 50 MPH
While going from 45 to 50 MPH, there is a shaking in the front end. Also, above 60 MPH the shaking starts again, but it's more of a rougher vibration. Both u-joints were replaced less than 2 months ago as well as both hub bearings. Tires are rough with only the front left one having decent tread, and I do not remember the last time the tires were balanced. Could this be it? I'm about to put 35 inch toyo mt's and 20x10 fuel maverick rims on it, could new tires fix this problem? Or maybe it could be tire pressure or camber?
View 2 RepliesRam / SRT10 :: 03 Hemi - Clicking / Grinding Noise In 4WD
I recently bought an 03 Hemi Ram 4x4 and it has a nasty clicking/grinding type noise in 4wd when turning the steering wheel. If going straight it's fine. The driver side cv joint was bad, so I replaced both sides thinking this would stop the noise, but it didn't. Not sure if this is related, but when driving down the road in 2wd, it sounds like I'm dragging a chain underneath the truck. It's not real loud, but I can here it.
View 1 RepliesRam / SRT10 :: 98 1500 4x4 Quad Won't Start Just Clicks Once
98 1500 4x4 quad, 5.2.. Did run fine. Go out to start wont start just clicks once. Replaced starter and the battery. Still only clicks once. checked voltage across terminals to the grounds. swapped relays around still one click. Going to check in the morning make sure it didn't seize.
View 4 RepliesRam / SRT10 :: Oil Pressure Jumps From 40 To 0 For No Apparent Reason
I Have A 2001 Ram 1500 With The 318 5.2 Engine , Oil Pressure Jumps From 40 To 0 For No Apparent Reason, And Then Lifters Began To Tick. Turn Off Truck And Recrank Oil Pressure Returns To 40 Lbs, Rev Up Engine To 2000 Rpm Or Better And Pressure Goes To 0 Instantly. I Have Replaced Sending Unit, Replaced Oil Pump And Pickup, Changed Oil And Filter Using Dodge Filter, Removed Valve Covers And Intake Cleaned Out All Sludge, Tried 3 Different weights Of Oil, Cleaned Oil Passages, Inspected Oil pump Drive Shaft, Pulled Rear Main Cap And Inspected Bearing , Looked Good, Changed Oil And Filter 3 Times , Engine Is Very Clean. Engine Never Has Low Oil Pressure Either 0 Or 40 Lbs Never 10 Or 20. I Have Heard Others Describe This But Never Heard The Answer . Truck Has 70,000 Miles ,runs And Sounds Perfect When Oil Pressure Is At40. It Can Idle At 40 Lbs Hot, Which Leads Me To Believe Bearing Clearances Are Fine.
View 14 RepliesRam / SRT10 :: 1996 / V10 - Truck Has A Tick / Knock But Can't Seem To Locate?
I have a 1996 Ram with the V10 that only has 10,000 miles since it was replaced by Dodge. 7 years has passed since that shortblock warranty job. It now has a tick/knock that I cant seem to locate? I changed the lifters and one push rod since is was a little bent and put it all back together. Still getting the same thing - nothing has changed ...
View 13 RepliesRam / SRT10 :: 1988 318 / 5.2 Runs Rough And Stalls When Hot (after Around 20 Miles)
Truck in question has 175k, is the TBI version (fuel injected carburetor design), has had the plugs cap and rotor replaced fairly recently.
When cold, it starts and runs normally. As it warms (after around 20 miles) it starts running rough, then after getting warmer/full operating temp, it will stall at stop signs and runs very rich - so rich you can smell the unburned fuel. At this point it is also difficult to start and requires adding some gas pedal.
I am thinking a vacuum issue, or something that is not allowing it to transition from the warm up cycle to normal cycle.
Ram / SRT10 :: 2003 - Clunking In Front End As Something Dropping Down Onto Another Component
Today, I installed a 2.5 inch leveling kit on the truck. Now when I go over a bump, I hear a "clunk" as if something is dropping down onto another component in the front end. Sway bar links are good. Springs and strut assembly are tightened down well. Could it just be the spring on the new shocks and spacers, or do I need to check other components?
View 4 Replies