Accent RB (2012+) :: No Drill Front Bumper Mount
I just did a front bumper repair and now I need something to mount my plate because because in Ontario we need a plate in the front and the back. I current have it zip tied to the lower grill. Any good option for a mount that doesn't involve drilling?
View 12 RepliesFord Super Duty (1999-2016) :: Install And Mount A Light Bar Without Drilling Into The Front Bumper Or Grill?
Any good way to install and mount a light bar without drilling into the front bumper or grill? I have a 32" LED bar I want to mount between the top of the bumper and bottom of the grill, but the mounts aren't ideal for where I want to put the light.
View 9 RepliesPrius (2004-09) :: Front Bumper / Left Front Fender And Driver Door Replacement
Looking for info on these replacements and is there any manuals out there to assist with the process?
View 1 RepliesPrius (Gen 3) :: Front Bumper Removal?
How to remove front bumper?
View 1 RepliesPrius (Gen 2) :: Matrix Front Bumper Cover?
Have an '04 Prius and banged up the front bumper cover. Wanted to know if a Toyota Matrix front bumper cover from the same year would fit on it (without extensive mods, I know anything could fit, but would it bolt right up?).
View 4 RepliesPrius (Gen 3) :: Indents On Front Bumper - No Holes
I need to put a front license plate on my Prius. I notice there are a couple little indents on my front bumper but no holes . Do I need to drill holes or something else here to mount a plate ?
View 13 RepliesPrius (Gen 2) :: Front Bumper Damaged After Collision
So I have a 2009 metallic Prius and I just recently got into an accident. I ran over a fire hydrant. My front bumper went through a front collision. The left part of my front bumper is pretty much destroyed.
View 10 RepliesPrius (Gen 2) :: 2008 Air Dam Under Painted Front Bumper Damaged
I have a 2008 Touring Package 6 which has served me perfectly for the last 55,000 miles. Today while driving a paving stone fell off the landscaping truck in front of me and (luckily) only came in contact with the black plastic air dam under the painted front bumper. The corner of the air dam is damaged and it looks like a 1 piece unit to replace. What is the part number of this piece?
View 3 RepliesPrius (Gen 3) :: Prevent Under Carriage / Front Bumper From Scraping?
Entrance way to my office parking garage is VERY steep. Aside from careful entry/exit is there a protective shield/device that I can apply to prevent paint damage to under carriage of front bumper?
View 7 RepliesPrius (Gen 2) :: Liner Don't Stay Behind Lip Of Front Bumper During Freeway Driving
I recently replaced the front wheel well liner on the passenger side. The old one was shredded and I figured it had come loose. I put a new one in and made sure all fasteners are used (bought new fasteners). Still during some freeway driving the liner did not stay behind the lip of the front bumper and rubbed a small hole in it from the tire. Any way to prevent it?
View 17 RepliesPrius V :: 2016 - Front Bumper LED Accent Lights Stay On With Low Beams
How to modify this light so that it can stay on with the low beams? This light only works in "auto" mode.
View 1 RepliesPrius Plug-in 2012-15 :: Front Spoiler / Bumper Height From Pavement
Was talking to a cab company running over a hundred Prius, they like the gas mileage.
Biggest problem running a hundred plus Prius in LA is the skirt front bumper is so low to the ground (for better aerodynamics) ... less than 5 inches ground clearance when loaded ... it hits the ground and bows the side moldings of the bumper.
Prius (2004-09) :: Large Puddle Of Water Under Car - Dripping From PS Front Bumper Area
I have a 2005 Prius. I came home the other day and parked the car in the garage. I came back out the next morning to find a large puddle of water in the garage and the car still dripping. The drip is from the PS front bumper area just ahead of the front PS wheel. This is not the typical AC water puddle; we have two Prius so I am familiar with that one. I searched here and found a few threads on water pump issue but the description did not quite match what I have going on.
View 7 RepliesFord 6.0L Power Stroke Diesel :: 2004 - Loud Screening Sound - Starter Replacement?
after a loud screeching sound that sounded like a spun shaft rubbing on metal iwent under and found the starter wabbling around. Its going to be a first for me. Anything out of the ordinary i should know before moving on with the replacement..
04 f250 diesel 6.0
Golf IV / Jetta IV :: Front Strut Mount All Sorts Of Crooked?
Was tinkering on my car this morning, and at first noticed one side had a bigger gap than the other. Ok, I really need to change strut mount bushings, no big deal. Then I actually looked closer, and they both have some lean to them, but the drivers side is much more than the other one. Is this normal? I've never noticed any play in control arm bushings or anything. So what could be causing this? I would assume they are meant to sit flat but maybe not?
View 8 RepliesPassat (B7) :: Squeaking / Groaning Sound From Front Strut Mount Area
I had my ST coilovers installed a while back. I love the ride, but a really annoying squeaking/groaning sound developed several weeks ago from the front strut mount area. The noise is heard at low speeds as I roll down the road (most likely high speeds, too) and sounds like its coming from both sides of the upper strut mount area. If you lift up/push down on the car, you can also hear the sound.
I purchased a set of 034 Density upper strut mounts from AMI Motorsports in hopes of eliminating the sound, but the sound got worse!! I still do not have a resolution. At this point, I'm thinking about putting the stock strut mounts back in, as the sound wasn't near as bad with the OE mounts in place.
I've lubricated the sway bar bushings and installed shorter end links (thinking the sound may be sway bar related), but the noise is still there. I even disconnected the end links all together - sound is still there. Could this be faulty coilovers? I tried to file a warranty claim through ST - they don't think their strut is faulty, and even if they did, I'm having a hard time with warranty coverage (long story). If it's the struts, then why did the sound get worse when the new 034 Density upper strut mounts were installed? Could it be faulty mounts?
At this point, I think it's either the mount or the strut, as I did not experience any issues prior to the coilovers.
Yaris/Scion & Vitz :: Can't Get Front Passenger Side Motor Mount Out
I can't get my front (passenger side) motor mount out because it's under the refrigerant line. How would I do that? There is a black, coiled "jacket" that goes around the line right before it enters the back of the radiator, can I detach it there? The line snakes all over the engine compartment and appears to be bolted onto the radiator on one end and the other end goes through a clamp and into the dash area. [URL]....................
View 5 RepliesBuick Regal :: 1994 - Lack Of Acceleration - Front Motor Mount?
The front motor mounts are bad. This has been confirmed. When I am cruising at a constant 45 or 55 mph and choose to accelerate because traffic is clearing, etc. the car will thump a bit and only slowly creep faster. It feels as if there is very little response other than the mild thumping. Getting to 65 mph takes time. The car has 70k miles and performs almost flawlessly at slower speeds. Is the thumping/lack of acceleration a symptom of the bad front motor mounts?
View 12 RepliesPassat (B5) :: 1999 - Front Motor Mount Missing - Crank But Won't Turn Over?
My 99 Passat 1.8t broke down on me last night... my front motor mount is missing and my motor snaps back from time to time but last night i think it went back all more than normal and as soon as it snapped back the motor cut off and won't turn over... it will crank and crank but not turn over. i looked for any loose wires or anything possible that could be out of place and couldn't really see anything out of the ordinary... There are 3 sensors right next to the power steering reservoir that aren't connected but don't look like they were connected, need to identify those sensors.
View 2 Replies