Camry :: 2007 SE - Knocking Sound After Changing Front Brake Pads
Scion TC for Camry SE 2007.
I changed the front brake pads and resurfaced the rotors. After putting everything back together, I took the car to test drive it. The stopping power is fine and there is no squeaking or robbing sounds. However, when I apply the brakes at lower speeds moving forward there is knocking sounds the comes with the tire rotations. What is the reason for this sound?
This is my second time changing the pads and rotors, with the first with no issues. I put grease between the shams and the pads, and I sprayed the rotors with brake cleaner before the installation.
Prius (2001-03) :: Changing Brake Pads - Should Change Fluid As Well?
I am going to have to change my brake pads (I am probably going to do the rear shoes as well). I was wondering if I should get my Toyota dealer to change the fluid as well. I have 116,000 miles on her. Lots of highway driving, and this is only the first replacement set, these pads last forever. The fluid has never been changed before.
View 6 RepliesPrius (Gen 3) :: 2010 - VSC / TRAC Warning Comes On After Changing Front Brake Pads
I changed the front brake pads, took all the precautions during the change, did not disconnect the 12 v battery, pumped the brake pedal 12 times, started the car and no warnings. Now the brake pedal is a little spongy, if I press the pedal to the floor the VSC/TRAC light comes on, to reset it I have to press on the pedal again and the brakes do work.
View 11 RepliesPrius (2004-09) :: Brake System Failure After Changing Front Pads
2004 prius. I change the brakes on various cars all the time, and never had this problem. After I changed both sides, I started the car, and saw 4 lights:
- Red brake light
- The yellow exclamation light
- ABS light
- VSC light
The car now stops funny, and reading the service manual, it says that if there's a failure detected, that it will revert back to very basic braking (no abs, only fronts, etc..)... As I was exiting off the fwy, I realized this when one of my front wheels locked up, even and I was not stopping very well. Scared the crap out of me.
In any case, I can't see what I may have done which would cause a failure. The only thing I could think of is to bleed the brakes again, but I did this and think it's ok. Is there anything else I can check or is this something I have to get serviced? I saw another thread where they suspected the actuator, but it is somewhat a coincidence that it would go bad after I replace the pads? I'm not sure how the regenerative brakes works on a prius, and whether there's anything I could visually inspect to see if I bumped something???
Acura - Integra :: 1987 - Brake Light Continue To Stay On For About 10 Minutes After Parking
1987 Acura Integra 165k... After parking the car, and turning off the engine, and locked the car, the brake light continue to stay on for about 10mins - then goes off on its on.What seems to be the problem - easy to fix?
View 6 RepliesPrius (2004-09) :: 3 Brake Dash Warning Lights Came On After Got New Brake Pads / Rotors
i have the brake (!) the ABS and the VSC lit up after i got new bearings and new brake pads and rotors, the car was also stalling before the mechanic removed these bearing "dust cover" circles that must have been causing speed sensor interfernce bc the spedometer was stuck on 0....so the car seems to be done stalling after those were removed and all the big lights went off then i hit the brakes a few miles later and those three lights came on...
View 2 RepliesFord Escape / Hybrid :: 2007 - Brake Lights Stay On?
we have a 07 Escape that the brake lights stay on even with the ignition key off. I changed the brake switch twice. Thinking maybe the first may be faulty from the factory. I'm stuck on what the problem could be
View 8 RepliesLexus IS 2014+ :: Changing Brake Pads Without Unbolting The Caliper?
What is the proper procedure in changing the brake pads without unbolting the caliper?
View 7 RepliesGolf VI R :: Changing Front Brake Replace Rotor And Pads?
Just got out of the dealer they said they recommend front brake change. They quoted me for ~730 just for Rotors/Pads/labor on the front (I am going to shop around).
I tried search Golf R Brakes info prior to posting but alot of the searches are for people buying Golf R brakes for Gti's.
1) Do I need to Replace Both Rotors and Pad at the Same time?
2) Currently Car is still stock and see's no tracks, the most car would see in the next 2 yrs would probably be stg 2+ if that. Would OEM Rotors + OEM pads be sufficient? or should i upgrade pads? Below is listing i found with some different pads options.
[URL]
3) Car is currently a 47.5k miles with oem brakes, should i just replace rears as well? even though dealer did not recommend?
4) SS Brake Lines, should i get them?
Lexus LS 2007+ :: Brakes Shudder After Changing Pads And Machining Rotors
2008 LS600hl with 31K miles, been having low speed brakes shudder for quite sometime even after changing pads and machining rotors. This weekend thought about putting grease on the pins holding the pads, this did the trick, shudder is gone!
View 9 RepliesLexus LS 2007+ :: Which Ceramic Brake Pads Best For 460
getting Ceramic brake pads for lexus ls460.
what is the best brand and from which vender can i get it from.
Passat (B5) :: Brake Lights Stay On When Lights Turned On
The brake lights stay on when I turn the lights on. If the light switch is off they work fine. Is this a brake switch? Or something else.....
View 3 RepliesLexus LS 2007+ :: Reset Brake Light After Pads Replacement
I just changed brake pads front and rear. My light was on indicating need for such. After changing i figured light would reset and turn off. Not the case. How do i reset the light? Was there something i needed to do to sensor when pads changed?
View 5 RepliesSanta Fe (CM - 2007-12) :: Squeaking On Passenger Side - Brake Pads?
My son was hearing a bit of a squeaking on the passenger side. So I decided after some time to pull the front wheel. (most important brake). Well the pad wasn't moving on the outer guides (serviced it as required and lubed to get it moving). But the lower guide pin wouldn't move in/out. Needed to drift it out and it was very well rusted end to end. I put new pads on early as year I am sure and all was fine. I cleaned the pin on my wire wheel grinder. That lower pin had a collar near then end. Turns out its rubber, I thought it was a metal spring collar. Oh well the wire wheel did a number on it. I don't know the significant of that piece nor whether the pin is in the right place since the top one is different. I do these one at a time so its almost impossible I swapped them in the number of times they've been out.
I never seen so much tightening on any vehicle of pads and pins rusting in as on this vehicle. One has to wonder why. My vehicle also seems to have or what sound like a gear slap upon engaging in reverse or forward from front and back which is most notable after sitting and first engaged. Not every time but this is built in 2007 and there is a TSB for some washers. Hyundai Canada does NOT use the same TSB number they have their own. I talked to a dealer about it but he never indicated it would be the cause only its a different number. I am not impressed in this AWD drive power train. It needs a lot of TLC and the slap I hear is typically due to power train engagement play/slack being excessive most likely due to wear somewhere.. Even my rear sound off not a howl but noisy running which doesn't change with road surfaces so its not the tires. Maybe the AWD bearing or unit going. No of this should even remotely close to needed anything for at least another 100-150k at least.
Lexus SC430 :: 2007 - How To Change Rear Brake Pads
I am wanting to change my rear brake pads and . Looking for step by step instructions or photos.
View 1 RepliesLexus LS 2007+ :: Fog Lights To Stay On With Parking Lights?
LS460 L ... Re-wiring fog lights to come on with only parking lights? How did you do it. Do fog lights also stay on now with brights?
View 4 RepliesFord 6.0L Power Stroke Diesel :: 2007 F250 - Rear Brake Pads Don't Fit
I bought new pads for my truck and the fronts went on with no problem at all, but when I got to the rear the tabs/ears on the pads are about 1/8 inch wider than the notch they are supposed to fit in. I bought part number BR-1067, which is supposed to fit but obviously doesn't. What part number should I have bought? My truck is a 2007 F250 Super Crew Lariat FX4.
View 9 RepliesPrius (Gen 3) :: Brake And Traction Control Lights Went Off While Driving
2010 Prius 98,000 miles - No Accidents
I was driving on the freeway cruising about 65-70mph.. Not using the brake at all. All the sudden the car starts beeping loudly with the Brake light going off, traction control light going off, and the ((!)) light as well. So I wanted to pull over to the side and realized my brakes were not working . It was the same as if you're trying to brake the car when the car is turned off. I slowly pulled off the freeway. Tried to reset the ECU, battery, everything, thinking at the traction control is just going crazy.
Sonata NF (2006-10) :: ABS / ESC Off And Brake Lights Stay On
Received a battery jump in the dark from a friend who mistakenly had crossed the polarity. It blew the 150amp alternator fuse which is now replaced. Now, the ABS, ESC Off and brake lights stay on after starting. I have checked all fuses and the main relay, both under the hood and in side of dash, and cannot figure out what is causing this. The auto shift lever is locked out and I don't want to override it not knowing if it will cause any damage. Also, what protocol OBD system would this auto fall under?
View 9 Replies