Prius (2010-12) :: Can Scangauge See Inverter Temperature?
I just received the Scangauge II and wonder if it can display the inverter temperature?
View 13 RepliesPrius (2010-12) :: Mounted Scangauge On Dashboard Starting To Fall
My Scangauge is mounted on the dash just above the steering wheel. My last car, a Subaru Impreza had lots of room on the steering column. On the 2010 Prius it's very difficult to see when mounted there.
Cold weather is setting in and the glue on the velcro is starting to give out and the Gauge will soon fall. Where are you mounting them? How are you getting them to stick?
Prius (Gen 3) :: Location To Plug In Scangauge II
Where do you plug Scangauge II inside the Prius?
How do you mount it? On the window or on the dash, and can you buy the mount or does it come with one?
Prius (Gen 2) :: Scangauge - DTC Code And / Or Freeze Frame Data
When I use the "scan" feature of my Scangauge II, sometimes the DTC code and/or freeze frame data will change on me. That is, I check it and it says "1 stored code" (without clearing it), then go back to "Gauge" and then check the scanning function again, sometimes the code has changed to something else! With the freeze frame data, sometimes it will even change as I'm scrolling through the different data fields. Very disconcerting....
View 3 RepliesPrius (Gen 2) :: CEL On - ScanGauge Reports Diagnostic Code P0505
I made three ten mile trips this evening. On the first trip the "engine" light came on. This is the first time I have seen this light (2004 @ 134,000 miles). ScanGauge reports diagnostic code P0505. The "engine" light remained on through all three trips. Also, I was not able to get the ICE to shut down and run only on battery at all, even though the battery was on the upper level of charge and the engine was warm. There were long stretches where I normally run on battery at around 35 mph. I'm supposing there is a connection.
View 19 RepliesPrius C :: Won't Shift Out Of Park - Getting Code U0293 On Scangauge
I was successfully able to install my Prius backup camera, but a few hours later I found that I could not shift out park. I was getting code U0293 on my scangauge. I can push the override button next to the shifter to shift out of park, but I can't figure out whats going on.
View 6 RepliesFord 6.0L Power Stroke Diesel :: 2006 - Measuring ECT On Scangauge II
I have a 2006 6.0 and just recently purchased a Scangauge II. when i got it i programmed all of the X gauges i wanted except i couldnt find the code for ECT. is it possible to measure ECT with this Scanguage? and where can i find the code for it? I am just curious because my EOT is running 204 degrees after it is warmed up. i see most people say theirs never gets over 195 or so.
I also heard there should be a certain degree difference between your EOT and your ECT? i just recently had a new injector put in, and fixed an EGR problem i was having. I don't seem to be having any problems and the truck is running way better than before. everything is stock by the way and not running any tunes.
Prius (2004-09) :: Scangauge To Throw Lots Of Pending Codes
I occasionally drill-down to check on pending codes, and my 2007 Prius likes to generate a LOT of them. Maybe pending codes don't count unless they escalate to an active code that triggers the check engine light.
View 3 RepliesPrius (2001-03) :: Alarm Triangle Came On - Scangauge Shows No Codes Found
I use a scangauge to monitor the traction battery in my 2001 prius. Today when I started the car to come home, the alarm triangle came on, but the scangauge shows no codes found. The car ran fine and got me home, but what the alarm is about.
View 11 RepliesPrius (2004-09) :: 2005 - Two Lights On Dashboard / No Code Found When Run Scangauge
I have a 2005 prius and I got a scanguage to read the codes. I have two lights on my dash. One is the check engine and the other is the (O) light. I think this is something to do with the regen braking. Anyways when I run the scanguage it says no codes found. What type of scanner would be able to pull up all prius codes?
View 6 RepliesFord 6.0L Power Stroke Diesel :: Scangauge Volt Reading Fluctuate Between 12.5 - 13.5 While Driving
I've had a scangauge on my truck for years and today while on vacation I noticed the voltage was fluctuating between 12.5-13.5 while driving. It has always ran at 13.5-13.7 .... I checked it with a fluke and it is a solid and steady 13.8v at idle. Why would that gauge be fluctuating like that? Truck seems to be running fine.
View 6 RepliesPrius (Gen 3) :: 2010 - Air Vents Stuck In One Position
I have a strange problem with the air circulation in my 2010 prius. The vents are stuck in one position. When I try to go to different mode (windshield, floor, etc) it doesn't do anything.
This happened when I was alternating between windshield and other modes to get small parts of glass from the vents (car had a windshield damage due to a "meeting" with a deer). Anyway, I don't know what could be wrong.
Is there a motor that overheated (due to constant switching of modes)? Is there a piece of glass blocking the system from switching?
Prius (2010-12) :: Weird Sound After Sitting In The Car In Off Position
Like the title says, weird sound after sitting in the car in off position around 15 min. or so. The first time this happen I jump out to see if a bird landed on the roof of the car, but no bird. Anyways, It has done this every time I sit in my vehicle with it off.
View 8 RepliesPrius (2010-12) :: Horn Only Works After Rotating It But Not In Straight Position
We also noticed when depressing the horn to actuate it in the straight position, there is hardly any movement. When in a rotated position, there is a definite actuating movement or depression of the horn. There something happening when it's a straight position, the horn is being prevented from making contact so the horn will work.
View 5 RepliesPrius (2010-12) :: Blinking R In Reverse Position - Warning Symbols On Dash?
I had the dealer disable the beep in the "R" reverse position soon after I got my Prius. This worked great. After about a week, however, I now notice that the "R" symbol blinks whenever I am in the "R" position.
Also, when pushing the start button, the dash only showed the warning symbol and TRAC symbol for a couple of seconds and then went out. Recently, however, 8-10 warning symbols come on in the right part of the screen and then go out. Why this suddenly comes on?
Gen 3 Prius (Audio/Electronics) :: 2010 - Navigation Display Stuck In Open Position
I started my Prius and the Navigation Display open on it's own without me touching any buttons as though it wanted me to load a CD. Now it is stuck in the open position and the CD player is making noises like a CD is stuck but do not have a CD in the player.
I have hit every button to try to get it to close, no luck. It is stuck on the FM station I was listening to and will change stations or to AM, CD, SAT. I turned the car on and off several times just stuck open.
Prius (2010-12) :: Yellow Triangle With Message - Low Traction Battery Shift Into P Position
Today after running several errands, I stopped by the local CarWash to rinse the car. Same as always, parking brake off, shift into neutral and away we go. Half way threw she starts beeping, I see the yellow triangle and to the right a boxed message "LOW TRACTION BATTERY SHIFT INTO P POSITION". There was a sudden rush of anxiety because I could not shift while being conveyor-ed threw the wash. As soon as I was pushed out and the light turned green, I shifted into drive to exit. The warning and box cleared instantly.
I pulled into parking, shifted into P, and noticed the battery indicator had only 1 bar. Did a quick walk around of the car and got back on the road thinking, head directly the Dealership. Before I got to the freeway I was back up 4 bars and climbing. Continued on the freeway and within 2 exits all looked normal. As it is Saturday and the Dealership was 1 hour from closing, I proceeded home. Later we went to dinner and an event, then came home. All is still normal. Owners Manual only states to follow the command on page 515.
I know this is a long story and was intentional to starve off multiple questions. The only thing I can think is that the air conditioner, radio and headlights were on prior to, while waiting my turn for wash (park-roll-park-roll...) and up to the point of the warning (tuned off all at that point) while in the tunnel. However this is normal for me. Will monitor the battery indicator more closely for a while. I'm sure this event latched in a computer somewhere, so will run by the Dealer if anything else acts up again. A/C and radio and lights are turned off now while in "neutral", for whatever reason. The car is a 2010 II and only 27600 miles. Was not a pleasant feeling.
Ford Super Duty (1999-2016) :: Linking Trans Temp To Scangauge 2
I put in the X codes and it doesn't show. The icon is on the screen but no reading for temp shows up. The truck is a 2008 with the 3V V10. Maybe verify the codes for me?
View 6 RepliesElantra MD (2010-15) :: Can't See Speedometer From Driving Position
Am I the only one that has a hard time seeing the speedometer when driving? I have always driven leaning slightly to the right with the steering wheel down and my arm rested on the armrest and using my left hand to steer. This is the first car that have driven where its hard to see your speed when the steering wheel is lowered down. I am thinking about getting some sort of OBD display such as the super gauge.
View 28 Replies