Ford A/C :: Can't Unscrew Engine Block Drain Plug Using 14 Mm Allen Hex Bit?
Ford Escape 6 cylinder - 100,00 miles. want to flush and change the coolant. Cannot unscrew the engine block drain plug using a 14 mm allen hex bit. Afraid of damaging the block, maybe cracking it. I tried turning the plug with my 1/2" torque wrench up to 130 ft. lbs. torque and it would not budge. Am afraid to use more or to put a cheater on the torque wrench. If something goes wrong the engine becomes scrap. What's the solution?
View 1 RepliesPrius (2004-09) :: CEL Code P0300 After Replacing The Air Filter
My CEL has come on about four times in the last month shortly after replacing the air filter with a pepboys Purolator air filter. I have cleaned the MAF sensor each time using MAF cleaner and the issue along with the CEL go away then come back in about a week.
I don't know if the MAF sensor is bad because each time i clean it, the issue stops. also, upon first glance at the Purolator filter, i thought it looked a little thicker than the stock one but I didn't think twice about it.
Prius (Gen 3) :: Oil Filter Tool Getting Stuck To Oil Filter Cap
Did my own 30k oil filter change today after taking it to the dealership for 10k and 20k. What do you know, they over torqued the crap out of the filter that I had to use my 1/2" breaker bar and all my strength to remove it. After all of that somehow the oil filter tool (the typical one) ended up getting stuck to the oil filter cap. It was at a slight angle so it must have shifted as I was trying to loosen it with the breaker bar.
Well, spent the next hour trying to separate them with no luck. Didn't want to damage the filter housing, and since the tool was stuck on there good just decided to put it back on with the tool attached. Any concerns about leaving it on, other than it randomly falling off one day?
Hopefully I'll still find the tool attached next time I change my oil, maybe pick up an extra oil filter cap and tool just in case. Btw I changed it myself at 5k before doing the free changes at dealership. Another reason I won't let them touch my car again...
Prius (2004-09) :: Thin Coat Of Oil At Bottom Of Filter / No Leak Found
Maybe I am running out of my beginner's luck. Recently when I did the second oil change at 10K miles, I placed the drain pan without taking into account the fact that the oil drains partially sideways. The oil stream ended up splashing off the edge of the drain pan and made a mess. Then I did not withdraw my hand fast enough when unscrewing the oil filter and allowed a stream of oil running down my arm and staining my new shirt. The I filled the new oil filter too full and had one more spill when installing it.
About two weeks later I found there was a very thin coat of oil at the bottom of the oil filter but no drips either on the filter or on the ground. I checked the oil level and it was the same as before. I checked the filter tightness with a torque wrench and it was also as tight as before. I wiped the bottom of the filter clean with paper towel. Now about another two weeks passed and a corner of the bottom of the filter is coated with oil again.
I am thinking maybe it was just the spilled oil gradually making its way from the (outside) top of the filter to the bottom? If there is a leak then I should get at least some drips, not just a thin film every two weeks, right? I also thought about untightening the filter and then tighten it again but I was afraid of large amount of oil coming out, would it? Also I had carefully checked the o-ring and wiped the flange clean before installing the filter and there are so many threads to screw the filter on - it is hard to imaging the filter would not seat correctly.
Ford 6.0L Power Stroke Diesel :: 2004 E350 - Bypass Coolant Filter Or IPR Full Flow Coolant Filter
I am going to install a coolant filter on my 2004 6.0 E350 van. I have read threads about bypass filters and full flow filters and I started asking myself "Why use a bypass when I can filter all of the coolant?"
Is there any reason why someone should use a bypass filter? I bought the van used knowing I would eventually have to do most if not all of the 6.0 repairs. IPR sells a complete coolant filter.
I talked with the people at FICM repair and they suggested I do my research but leaned towards the IPR cooler. Ed spent a good 30 minutes on the phone answering all my questions and never asked if I wanted to buy anything. If anything, he was trying to stop me from throwing money at the van until I isolated what needs to be repaired.
I already bought the Sinister Kit and requested a return.
Ford Super Duty (1999-2016) :: Spring On Top Of Oil Filter - Replace Whole Filter Assembly?
So there I was doing a simple oil change and when I took the filter out I noticed the little spring on top, in the center of the big spring (oil filter adapter) cocked to the side with the little plastic piece broken.
does anybody know if I can replace just the oil filter adapter (spring thingy that goes in the middle of the filter when installed) or do I have to replace the whole filter bowl assembly? And if so where would be a good place to get this part?
Ford Super Duty (1999-2016) :: Tranny Filter Change - Stuck Filter ORing
Changing tranny fluid/filter today, all has been going great until I went to take the filter o-ring out that didn't come with the filter. It will not come out! made a hook tool out of an old tooth brush like someone on here did, o-ring wont budge. Tried a hook pick, it wont dudge (actually bent the tip on the pick and started to tear the o-ring). Everything is ready to go back together and get filled, but this stupid o-ring will not come out!
View 3 RepliesFord Super Duty (1999-2016) :: Trans Filter 4R100 - Safety Clip Used To Hold Filter Up?
On my previous 1992 F-350, when I serviced the E40D 2WD trans I replaced the filter during a trans service. I read about some filters falling down inside pan causing shifting issues. There is an aftermarket clip sold that holds the filter in the up position and prevents it from falling into pan.
Is the clip also used on the 2WD 4R100? is it the same issue of potentially falling down in pan as was the case with the E40D? Preparing to service my 2003 F-350 2WD 4R100 and install a new filter and want to be sure I have all parts/supplies ready to go.
Ford Super Duty (1999-2016) :: 2002 - Gas Engine Won't Start After Replacing Fuel Filter / Pump Relay / Air Filter?
After replacing fuel filter, pump relay, and air filter for good measure my 2002 f250 v10 gas engine still wont start. What to do?
View 13 RepliesPrius (Gen 2) :: Air Filter Light On Message
I have a 2008 model and when I started it yesterday I had a message in the computer about the air filter and I think the air filter light was on. I first thought, maybe the computer wasn't reset, when I had it serviced. I checked it and it seemed clean (I could see sunlight through it.) I had it serviced about 2 months ago and have noticed my gas mileage dipping.
View 2 RepliesPrius (2010-12) :: When Should The Air Filter For ICE Be Changed
When to change the air filter for ICE? 10,000 mile? Does the Gen III need to change the transaxle fluid? if so, what is the service interval? I am putting a lot of miles on my new Prius. Really want it to serve a long time.
View 16 RepliesPrius (2010-12) :: 2013 - Where Is The Oil Filter
We are taking her in for 5000 mile check tomorrow and wondering where the heck the oil filter is...
View 5 RepliesLexus RX 2004-09 :: Foam In Cabin Air Filter
Why is there foam in my wife's in-cabin air filter?
View 3 RepliesLexus GX 2004-09 :: How To Replace Engine Filter
I found the filter at O'Reilly's but looking for step-by-step instructions.
View 1 RepliesPrius (Gen 3) :: Oil Leak On Backside Of Engine Right Above Filter
I was changing the ATF fluid for the first time and noticed a film of oil on the backside of the engine right above the oil filter. It appears to be from a sensor, but, not sure what it is.
View 19 RepliesPrius V :: 2012 - Car Cabin Air Filter Preinstalled?
Just purchased a 2012 Prius a few weeks ago. if cabin air filter preinstalled in the new cars?
View 19 RepliesPrius (Gen 2) :: 2007 - Changing PCV Valve And / Or Gas Filter
I am about to change the spark plugs on my 2007 Prius with around 120,000 miles on it. While I am doing that I wanted to possibly change the PCV Vavle. Where is it located? Also does my Prius have a fuel filter? I would change it also if it does.
View 2 RepliesPrius (Gen 4) :: Pleats On Cabin Air Filter Run In A Different Direction
I had a surprise this morning when I attempted to put in a new Cabin Air Filter. These filters look square at first glance, but are actually rectangular -- about 7-3/4" x 8-3/8" or so.
The issue is that the pleats on the one that came with the car run in a different direction than the one I purchased from my local Toyota dealer.
While the obvious enough solution would be to simply rotate the new filter 90* before putting it into the plastic carrier, this is impossible since the plastic carrier has a divider that runs parallel to the pleats.
Prius (2010-12) :: Oil Filter Wrench - Will This Model Fit
Will the assenmacher toy 640 fit my 2013 Prius two?
View 1 Replies