Prius (Gen 2) :: 2006 - Passenger Rear Brake Light Won't Lit Up
I was told the Led went out and I would have to buy a complete assembly Part 8155147100. Is this correct? Is there anyway to just replace the led?
I looked at after mark replacements, but after reading some of the reviews, I think I should buy a genuine Toyota replacement.
Ford F-150 (2004-2008) :: 2006 - In Rear No Brake Lights And Turn Signals?
I have a 2006 F150 xlt 5.4 3v. I've owned it since Oct. 15'. In approximately Nov. I lost the rear right brake and blinker light, and then around Christmas I lost the rear left brake and blinker. I also have no rear hazards, but the inst cluster flashes at a normal rate when the flashers are engaged. All running lights work, and 3rd brake light works. Front blinkers work and all other electrical works. Have checked all fuses and bulbs with no solution.
View 6 RepliesPrius (2004-09) :: One Rear Brake Caliper Not Braking Properly
I have a 2007 Prius gen II with 50,000 miles on it. I took it for MOT ministry of transport annual test and it failed on rear brakes. The near side puled 82kg the off side puled 242kg I puled the pads and copper slipped the pads and sliders the piston pushed bake with ease reassembled them and re tested them witch increased the near side by 5kg. How did you rectify it.
View 2 RepliesPrius (2004-09) :: 2008 - Rear Drum Brake Shoe Thickness?
Getting ready to perform the clean and adjust rear brakes maintenance. I took a digital caliper and measured my rear drum brake thickness. The thinnest measurement I got was 3.19 mm.
I looked up the specifications and rear shoes brand-new are 4 mm. Minimum thickness allowed is 1mm.
I have 95K on my 2008. Since my brake shoes are showing close to brand-new measurements does this mean my rear drums are out of adjustment or is this normal?
XT1080 ?
Prius (2004-09) :: Rear Wheels Stuck When Released Parking Brake?
My brother-in-law has an '04 with ~160K miles that we're potentially interested in picking up from him. It's been sitting for awhile with the parking brake on. When going to try it out today I released the parking brake (it seemed to release okay) but both rear wheels were stuck. I drove it a few feet and the left rear freed up but the right rear would not budge (multiple attempts.) It was dragging on their driveway and I could barely get the car back out of the way.
Looking for (videos, manual, etc.) how the parking brake works? Is there an external adjustment I can reach or some place to try to release the cable? We had an '06 that our daughter now drives but I've never had any issues with rear brakes in 200+K miles on that car.
Golf IV / Jetta IV :: Removing The Headlight Adjusters?
I have the lights all taken apart but I can't really see how they would come out.. Are they pressed in? Screwed in?
View 4 RepliesPrius (2004-09) :: 2006 - Rear AC Won't Shut Off?
i have a 2006 prius with 110k on it and a few days ago all the warning lights started coming on (check engine, vsc, red triangle, (!) ) this morning the car was completely dead so i replaced the 12v battery and it startedup fine and the lights all went away. i drove a few miles to work and the lights came back on and the rear ac will not shut off. it just keeps blowing full blast and the engine will not cut out at idle like it normally does. im assuming this is because it is trying to power that rear ac.
View 19 RepliesPrius (2004-09) :: 2006 - Removing Brake Actuator Resistor?
The brake actuator on our 2006 Prius (95K miles) was activating (pump turned on) every 20 seconds or so. I used AutoEnginuity (AE) software to monitor the pressure of PACC (accumulator pressure sensor) and the pressure dropped rapidly once the sensor voltage got up to around 3.1 volts; therefore, the pump would activate again and this cycle would keep repeating as long as the Prius was turned on. Therefore I decided to replace the brake accumulator and its associated resistor. I purchased a new brake actuator and its associated resistor from Toyota. The brake accumulator replacement went well but when I tried to locate the resistor to replace it, I was dismayed to see that the old resistor is very hard to access (even though I took most of the dash apart to find it).
In my 2006 Prius, the resistor is on the driver's side near the body and high up under the dash. I think I understand the reason for matching the resistor value with the resistance of the pump windings but I am going to use the old resistor and see how noisy the pump is. BTW I referenced Toyota website (TIS) for how to do the replacement procedure and now I am going to see how good AE software (latest version) is at bleeding the various components. This is FYI when replacing the brake actuator and wanting to know where this resistor is located and how difficult it is to access.
Prius (2004-09) :: 2006 - ABS / VSC / Parking Brake Light Stay On?
Today I took my 2006 Toyota Prius with 167,000 miles out to drive my dog to the vet. I turned the car on and deactivated the parking break and noticed the light stayed on, then I noticed the VSC and ABS lights stayed on as well.
My car was parked backwards on a driveway incline for about 14 hours. My 12v battery is old, not sure what shape it is in. The hybrid battery was replaced 2 years ago. I have been reading up and i guess it could be a sensor, skid sensor, 12v battery, or some sort of pump. Also, my parking break has felt a little weak as of late.
The car still drives, not sure if it drives funny or psychologically I think it does.
Prius (2004-09) :: Rear Axle Cracks / Rust At Corner / Bushing Arm - Squeaking Brake Pedal
Just hit 225k with my 2004 Prius about a week ago. I passed inspection without replacing the (slightly) cracked rubber bushings for now, but what worries me is the cracks and a slight hole (it has not rusted completely through). Pictures attached. Should I do anything about this, and if so what?
Also, I've noticed that when I let go of the brake pedal, especially after a medium to the hard stop, I hear a squeaking... what's the cause for that? I know the front rotors have a bit of rust on the edges, but not sure if that's the cause... it seems to come from the back.
Other than that, the only other noise I've noticed is a slight clacking/tapping when the A/C is on, usually in hotter weather. The only thing I needed to pass inspection was to replace the muffler after a year and 1/2 ago, the last non-OEM part they put in at another shop was junk and rusted through pretty badly leaving a hole that was leaking. Ended up getting it replaced at the dealer with the OEM part this time...
Prius (2004-09) :: 2006 - Wobbly Rear Spoiler
I just got a 2006 prius with a wobbly rear spoiler. I pulled it off and took some pictures....It seems like there might be something missing, or is it just that the plastic round things are chipped and thus, the spoiler recesses are not grabbing on? It looks like the round plastic things are riveted in, which I assume will make it difficult to replace.....
View 3 RepliesPrius (2004-09) :: 2006 - Rear Washer Won't Spray?
I have a 2006 Prius and the rear hatch washer fluid sprayer does not spray (wipers work fine). The front window fluid sprayer works fine and I'm told that they work off of the same motor/fuse and reservoir.
View 4 RepliesPrius (2004-09) :: 2006 - VSC / Brake / Master Warning And Hybrid Light On
I just purchased this vehicle from a private owner, and the first day everything seemed fine. After a few days I get all these warning lights - Master Warning (Red Triangle !), VSC, and the Brake Light, plus the NAV screen shows the red car with ! in it. The car seems to run just fine though. I don't notice any performance issues. One thing I did notice when I purchased the vehicle, the previous owner had a batter charger in the trunk before he took it out.
Now I've check the batter using the LAN Monitor and it shows like 12.1 volts when I turned the car on (not started). I decided to give the batter a deep charge overnight (2 amp charge) after disconnecting NEG terminal from car. It cleared the codes for a little while, but then they came back. My ODB II tester shows no codes, only codes I found on the LAN Monitor was for NAVI - 01-e3 sub 00-5. Do I need to replace the 12v Battery?
Prius (2004-09) :: 2006 - Rear Window Washer / No Fluid?
The outlet holes do not appear to be blocked and I cannot hear a pump motor running when trying to clean the rear window. Is there a separate pump to supply fluid to the rear window?
View 3 RepliesPrius (2004-09) :: 2006 - Rear Tail Light Cracked?
I have a hairline crack (with some starring) on my left rear tail light of my 2006 Prius touring. Any good glue or compound to patch it up and prevent water/moisture/dirt from getting in there and still stay clear for light to shine through?
View 2 RepliesPrius (2004-09) :: 2006 - Rear Door Is Not Opening From The Inside
I have Toyota Prius 2006. Last night suddenly the rear right door didn't open from inside and it still doesn't want to open from inside. It opens from outside OK but is not opening from inside regardless what we are trying to do. It only one door misbehaves, the right rear door. How to fix this problem and why it happened?
View 9 RepliesPrius (2004-09) :: 2006 - Rear Driver Side Drum Not Engaging
2006 prius 130k ...
I replaced the rear drum brakes, wheel cylinders, and bled the brakes. I discovered on drivers side, that no matter how much bleeding, the brake does not engage on the rear drivers side. While bleeding, I discovered very little pressure. The brake light, VSC, ABS, and ! lights remain lit while the cars on. Does this sound like a master cylinder or ABS failure? Can the autoenginuity scan this issue?
Prius (2004-09) :: 2006 - Rear Door Stuck In Double Locked Mode
I have a UK right-hand drive Prius gen 2 2006 T4 model.
My rear door on the driver's side won't unlock. it appears to be stuck in double locked mode. It cant be unlocked manually from inside the car and the lock button just springs back to lock position (as you'd expect it to do when in double lock mode).
I can lock/unlock the car other 3 doors using the fob, I can lock/unlock the cars other 3 doors using the internal button on the driver's door.
I suspect there must be a failure of the lock motor or solenoid inside the door but I cant figure out how to get the door unlocked just so i can get the trim off and check. What the cause or remedy could be?
Elantra XD (2001-06) :: 2004 - Rear Brake Sticks / Parking Brake Is Broken
I have a 2004 Elantra GLS. My left rear brake was hanging (wheel was very hot to the touch after driving, while other wheels were not), so I had a friend check the brake pads. We decided to replace the pads and rotors. While doing so, the parking brake seemed stuck in the on position, so I opted to have him disconnect it completely until I could afford to replace it. I had used it for the first time about 2 weeks before I noticed the hot brake problem, so we figured that must have been why the brake was hanging.
My friend replaced the rotors and pads, put some penetrant/lubricant on the piston of the caliper and reassembled the brakes. He did use the special tool to spin the caliper in when putting the pads on, however he didn't know that was necessary and tried to force them in with a C-clamp first.
Now, I seem to have two problems:
1. The left rear brake still hangs sometimes. I will drive the car and when I park it I can feel the heat coming off of the left rear wheel. It is extremely hot, so I know the brake is hanging (even with the parking brake disconnected). What is the problem here? Is the caliper bad? Would replacing the caliper solve the problem? Does the parking brake have to be connected to stop the caliper from hanging up?
2. My second problem is the pulsating of the brakes. I am afraid the rotor is warped because of the heat, or maybe he didn't clean everything well enough before he put the new rotor on. How can I figure out what the problem is? Is there a way to check a rotor to see if it is warped? Could there be another reason I feel the pulsating brakes? By the way, the brake fluid is full.
If the caliper needs to be replaced and I can leave the parking brake disconnected, are there any special instructions my friend should know about before working on this? He does work on a lot of cars and rebuilds cars to sell, so he is pretty knowledgeable. I think the only thing he didn't know about was rotating the piston. I would like to provide him with detailed instructions if necessary.