Lexus GS 2006-11 :: 2008 - Leaking Grease From The Boot?
I bought my 2008 GS 350 in March of this year, got it checked by Lexus of Edison at 70,606 miles (I purchased it at 69,850 miles) and everything was fine. So I went in for my 75,000 mile service and now they're saying that my LF axle is leaking grease from the boot and to replace it with a brand new axle it will cost $1773. Here's a picture from directly underneath the drivers side
View 14 RepliesLexus GX 2004-09 :: Grease Splatter On The Frame / CV Boot Clamp Leaking
I noticed a little bit of grease splatter on the frame last night when I was changing the running board lights. The grease was coming out from the clamp, no ripped or torn boot.
Maybe one day I'll buy the special clamp and crimping tool but for now I used some silicone tape. It seals to itself and it doesn't leave a sticky residue if removed. If you use this tape make sure you stretch it and pull it really tight as you're wrapping it so it can seal to itself. I used some zip ties just in case.
Passat (B5) :: CV Boot Split Open With Grease / Oil Everywhere
While changing over to snow tires yesterday, I noticed the driver's side CV boot was split open with grease/oil everywhere.
Questions:
How urgent is this repair? Is the car drivable for a short while until I can get it fixed?
How much might I expect a CV boot replacement to cost?
Santa Fe (CM - 2007-12) :: Grease Coming From Inner CV Axle Boot On Passenger Side
So the other day I was changing the oil on the SF, and I noticed a glob of grease (fist sized) on the passenger side of the frame. After cleaning up the mess it appeared that the grease was coming from the inner CV boot on the passenger side. From my position under the SF I could not see any obvious crack in the boot, and I also squeezed the boot and ran my finger around it in each of the bellows. I still didn't find any rupture. I then began to wonder if the boot had slipped off of the base of the axle. I pushed and pulled on the boot and could not really budge it.
In full disclosure I did change the front struts 2 weeks prior. My only thought is maybe I pulled the boot off somehow during that job. If that was the case though wouldn't I be able to move/dislodge the boot now?
FWIW there is no noise coming from the passenger side that would indicate the CV joint is bad or on its way out.
Golf/GTI VII :: CV Boot Spitting Grease - Won't Turn Left - Broken Control Arm?
Had a "Friend" who multiple friends suggested could install my VWR springs put my springs on. Long story short, the installation was a nightmare. And I should have just been patient and taken it to the local tuner.
My problems now are: Guy snapped an inner axle bolt off. CV boot is spitting grease everywhere. Car does NOT want to turn left. It will turn a little then it just wants to go straight. Am I guessing the last issue may be a broken control arm? What do you think? I'm calling the local tuner tomorrow and getting my car in this week to be repaired.
Prius (2010-12) :: Boot That Is Attached With Brake Pedal Is Leaking Sticky Stuff
I have the regular Prius 2012, The brake pedal is attached to a rod that goes into a flex boot and then into the ABS module in the Engine compartment. The Boot is leaking sticky greasy/oily fluid. It not a constant leak. Its like it leaked on a Hot day and then stopped leaking.
Its not the one from my car, but its what I'm calling the ABS Mod Is this not just the lubricant for the Pedal or is this real brake fluid from the ABS module leaking into the Car? took it to Toyota and they said they had never seen this before and they are recommending to replace the entire ABS Module and Brake Fluid at a cost of $3346 + Tax. (roughly $2700 in parts)
GMC - Sierra :: 2006 - Front End Vibration / Grease Leaking Out Of Rear Seal Of Hub
I have a 2006 gmc sierra, 4x4, 1/2 ton, has 155,000 miles on it. I recently changed both front hubs on my truck. They didn't have any play in them just noise. I had one new front hub that was leaking grease out of the rear seal. I took that one back off and got a new one. Must have had a bad rear seal. Now I'm getting a front end vibration at highway speeds. Between 70-75mph. It gets worse when turning left when highway turns. It goes completely away when turning right at highway speeds. It doesn't shake in the steering wheel. Feels like its coming from the left front area or left front tire. More in the floor boards. So i rotated my tires, and its not as bad but still is there in the same spot. I've checked everything.
Cv axles have no tears in the boots and aren't spinning out any grease. I turn the steering back and fourth while the truck was on the ground and I didn't notice any play in any of the front end components. The only thing I did notice was the passenger side inner tie rod boot had a bunch of grease built up on it. But the boot was actually full. Could one of the bad wheel bearings caused something else to go bad? Warped rotor? Truck doesn't shake or vibrate when braking either.
Honda :: Creaking Noise From Under The Truck / Right-front Inside CV Joint Leaking Grease
So... someone smashed in the right front of my Honda Ridgeline about a year ago. Lot's of body work and parts of the steering infrastructure replaced. In for service and they say that the right-front inside CV joint leaking grease. Insurance, no problem we'll replace the axle. Had it done at the dealer, about 2 weeks ago. Since the, I have noticed a "creaking" noise from under the truck. Sounds like a metal on metal joint that should be lubricated but isn't. Only noticeable at very low speeds, stopping or accelerating. Maybe there other times, but hard to tell. Sometimes almost seems like a "clunk". FYI, I don't think this is it, but they also did a front brake job at the same time. 75,000 miles.
View 6 RepliesGolf/GTI VII :: Water Leaking In Trunk / Boot
I just went to grab some things out of the trunk of my MK7 GTI when I put my hand down I felt moisture so I picked up the mat and I saw about 3 inches of water surrounding my spare donut.
View 2 RepliesFord 6.0L Power Stroke Diesel :: Slight Exhaust Smell In The Cab - Bellow Joints Leaking?
I have been smelling a slight exhaust smell in the cab of the EX. I slide under the truck and looked at the up pipes and bellows. I saw a slight amount of soot on the outside of both bellows. So does that mean I have a leak? What is the most economical fix? Does the turbo need to be removed?
View 4 RepliesPhaeton :: Leaking Steering Rack - Oil Pouring Out Of The Boot
I'd noticed an oil leak drivers side and upon investigation it appears the rack has developed a leak. I lifted the car on the vehicle lift and when I did noticed oil pouring out of the boot surrounding the steering linkage coming from the steering rack. With the tires dropped the full amount this created a tilt of said boot allowing the oil that had filled the boot to drain out. My conclusion is the rack has developed a leak with the boot being full of oil.
I did a "steering rack" search but nothing of value appeared.
Lexus ES 2007-12 :: Passenger Inside CV Boot Leaking
2007 Es350 with 60k. Boot is not cracked or split and does not have any holes. It appears to be leaking where the big band is next to the tx.
View 3 RepliesLexus RX 2004-09 :: Power Steering Rack Seems To Be Leaking Through Rubber Boot
I was replacing the oil in the transfer case and came across this under the passenger side. Power steering rack seems to be leaking through the rubber boot, but I have not noticed anything on the garage floor in recent months...
Can the boot itself be replaced? I hate to think the whole system needs to be replaced.
Subaru - Outback :: 2006 Occasionally Smell Something Burning - CV Joint Boot Leaking?
I believe that I have a leaking CV joint boot in my 2006 Outback. Occasionally smell something burning. Lifted hood and had some smoke. Saw leak and a friend stuck a finger into a hole in the boot.
View 9 RepliesGolf/GTI VII :: Inboard Front Light Seems Nonfunctional
Seems that on my GTI S w/lighting the inner headlamps are completely nonfunctional. Just a tiny marker light in the center with headlamps turned on. Even the inner 'hockey stick' LED tube is dark. My MK5 R32 also had non-working inner lights, but I stumbled upon a post that allowed the inner halogens to turn on with my high beams. I don't remember what I did, but it didn't require VAGCOM or hardware changes.
View 3 RepliesGolf IV / Jetta IV :: Slave Cylinder Green Rubber Boot Filled With Brake Fluid And Began Leaking A Little
Was bleeding my brakes and clutch. Using a power bleeder and it seems as though I put a little too much pressure into the system. The Slave cylinder's green rubber boot filled with brake fluid and began leaking a little. Did I blow a seal? Is this normal with pressure like that? I feel like pushing the clutch in would give more pressure than my little hand pump gives...
View 2 RepliesPassat (B5) :: 2001 V6 - Right Ball Joints Replacement
We have a 2001 passat wagon, V6 and we are told we need to replace right ball joints ...
View 5 RepliesGolf V R32 :: Separate Boot From Knob To Install New Boot?
I'm repainting my peeling shifter trim plate and replacing the shift boot with a new one. Lots of support available on removing the shifter and disassembling the trim plate, but no clear instructions on how to remove the boot from the knob. It looks like this inside:
How do I separate the boot from the knob to install a new boot? The only instructions I found showed a metal collar which is not the case in our cars.
Ford Ranger / B-Series :: 2001 - ABS Light Is On / Front End Joints Replacement
I have a 2001 ranger 3.0 auto 2wd and the abs light is on. this is what i have done so far. I had to replace all the front end joints so i took the front sensors and ohmed them and got continuity and voltage when i ran a metal past them and the same for the rear on the diff. so i figure they are fine. the wires to the frame look ok and i the truck has no damage so i figure the wires are fine.
I checked to see if the fuses are installed after I got the fuse layout and all the fuses are there and good. So I took it to advance auto and it came back with everything bad sensors motor controller and if anything else could be bad with the abs it said it was. I told them it is impossible for all of it to be bad. so it must be the controller. No I'm thinking the controller it the box attached to the abs pump and lines at the power distribution box under the hood.
Can I just remove that box and replace it with little difficulty or will i have parts fly out all over the place if i remove that box from the pump? All the pictures i see the the abs controller don't look the same as the one i have on my abs pump.