Touareg :: Disabled DRLs Now Some Instrument Lights Are Out?
My buddy Mark and I followed the directions to VAG my moms DRL's so they dont come on anymore, but now the lights illuminating her garage door opener and the lights around her shifter do not light up, did we do something wrong or forget something?
View 2 RepliesSonata I45 (LF 2015+) :: HIDs Flickering For About 5 To 15 Seconds Then Stop
Both of my bulbs flicker, intermittently. They will flicker, most times not at the same time as one another, for about 5 to 15 seconds then stop. I have not yet been able to detect a pattern. The battery is fully powered and the resistors are not throwing a code so I assume they are working (I installed them to eliminate an error code and stabilize the voltage). The capacitors (or "error eliminators") I have installed do not seem to do anything.
This problem just started recently too, they never used to flicker at all. The only problem I had is I used to get a bulb out warning but like I said I got rid of that by adding resistors. The bulbs are only 5 months old.
Elantra MD (2010-15) :: HIDs Flickering Every Time On Hitting A Bump
I got my 6k HIDS installed yesterday but for some reason they start flickering every time I hit a bump but they stop flickering once the car is stable or just idling on a light. I think the lights flicker because the ballasts are screwed to one of the existing screws on the car and they kind of dangle and nothing else makes it stable which makes my lights flicker. Question is, where did everyone install their ballast or the best place to put them so they wont vibrate?
View 7 RepliesLexus GS 2006-11 :: Disabled Seat Buzzer But It Came Back On
I have been able to disable the seat belt buzzer in both my 2007 and 2011 GS 350. But unfortunately, it doesn't 'stay'. Next time I start the car the buzzer is back. I used to have a 2009 RX 350 as well as a 2009 ES 350 and I had no problem whatsoever permanently disabling the seat belt buzzer in those two cars.
View 5 RepliesPassat (B6) :: Can The Wheel Air Pressure Sensors Alert Be Disabled?
Purchasing snow tires with OEM rims and trying not to have to purchase a new set of wheel pressure sensors - hence my question: Can the wheel air pressure sensor alert be disabled to do away with that nagging info?
View 1 RepliesPassat (B6) :: HIDs Go Out When Using High Beam
I installed an aftermarket HID's on my 06 B6 2.0T, used VAG-COM to disabled DRL's. They work great no issue, expect when I use my high beam.....both HID's go out and I get warning light/message on the dash. I can get them to come back on by turning the lights off and back on.
View 7 RepliesPassat (B5) :: Dull Headlights - HIDs Are Out?
My sister said her headlights were dull. So when she came over it looks like both HID's are out?
Since I have only owned pre Mk5 cars I know NOTHING about HID's. So why would they BOTH go out?
Lexus GS 2006-11 :: Can TPMS Check System Light Be Disabled
How to Fool Your Tire Pressure Sensors
Step by step instructions for do-it-yourself repairs
Browse all: Tires and Wheels Guide....
Passat (B5) :: Fog Lights As DRLs?
I was on youtube and saw a video, of a guy running fog lights as DRL's and only the fog lights, how to do this, or how to on the foglights independently?
View 2 RepliesSonata NF (2006-10) :: 2007 - HIDs Causes Car To Stall Out
So I have had HID's on my car since the purchase back in 2007. Until recently, approx 2 months ago, if I turned on my fog lights, my car would stall out. Then about a month ago, my only of my headlights started blinking and it went out. So I decided to replace all the lights with new kits.
So I just purchased 5000K 35w headlight and 25w(only ones they sell) fog lights for my car from HIDExtra. First sets were Xentec.
1. Headlights are H7 slim ballast
2. Fog lights are 881 regular ballast but still slimmer then the original big boys
**No relays**
So the car ran fine with them for about 2 days but if I turn them on while driving the car will stall out. I didn't have this problem before so I am trying to see has something worn out or what?? I didn't have relays before.
So what I went ahead and did was order relays for the fogs and headlights in hoping it would fix the issue. I am waiting for them to come in on Wednesday. Should this fix my issue? I never had them before(maybe I should have had them).
Its like the RPM's drop then engine skips then stalls. Car goes into limp mode and CEL stays on. Turn the car off and back on and limp mode goes away but CEL stays on until I let the car stay off for a while.
Brand new battery from Advance Auto. I thought that was the original problem before getting the lights so battery cannot be the issue. Could it be alternator?? Car runs fine as long as I turn the lights on first then start it up but if I have to turn them on while in motion...stall out.
Passat (B5) :: 2001 - DRLs Not Working
Purchased used: 2001 Passat 1.8T w/ Manual The DRLs are not working. The low beams work fine and my understanding is that the DRLs are reduced wattage low beams. I have checked with the vehicle running , handbrake off, and in gear.
View 2 RepliesSonata NF (2006-10) :: HIDs Cause Check Engine Light
I recently installed HID lights in both the low beam and fog/driving lights on my 2008 Sonata Limited. I used relay wiring kits so the HID's pull power straight from the battery. When I turn on the HID's after starting the car, the engine stalls and throws a check engine light with codes P0698 & P2110. Took the car to the dealer and all they really did was verify the codes and clear them claiming it was fixed...NOT!!
If I restart the engine 2-3 times with the HID's off, the check engine light clears itself and if I rev the engine RPM's while turning on the HID's then it's no problem. The HID's otherwise work great..and again the only power they pull from the car's electrical wiring is the signal from the headlight switch wiring that trips the relay to turn the HID's on!! The HID relay wiring kits have inline 20amp fuses between the battery and relays and they are fine, so the HID's can't be pulling that much current.
Sonata NF (2006-10) :: HIDs Installation - Keep Blowing Fuse
I tried installing my new DDMTuning 35W 6000K HID headlights with relay harness. No issues until I went to turn the car on and actually power them up. Neither side would work. I checked my power connection, ground, in-line fuse, swapped out the relay, tried without the harness, and nothing worked. I tried putting the stock bulbs back in and I found out they wouldn't turn on either.
I found the issue to be a blown 20 amp fuse in slot 23 (see pic). I replaced it and tried to turn the car on with the HIDs and it blew again. I hooked the stock lights back up and they seem to work fine now with another new fuse. The fuse description says H/LP LO and HID LO LH. Why this fuse is blowing. I am wondering if I just need a higher amperage fuse because of the HID power (in line for harness is 30 amp) or if something else is the culprit. I'm stumped.
Passat (B6) :: 2012 - Installing HIDs - Removing Headlights?
My DDM HIDs came in the mail today and fellow vortexer D.Passat00 was kind enough to meet up with me and do the needed vag-com adjustments. So firstly a shout out to him, he's a solid dude and really nice
Now: Is there a DIY for headlight removal? I can't seem to find one, and without removing the headlights I'm afraid there just isn't enough room to install the new HID bulbs without dinging/touching them.
I have a 2010 2.0t Passat and I got the 35w 6000k DDM HID kit
Passat (B5) :: 2002 1.8t Sedan - HIDs Blowing Low Beam Fuses
Car is a 2002 b5.5 1.8t sedan.
Bought the DDM Tuning HIDs, 3500k 35w for the fogs, installed with no problems. Also ordered the 5000k 35w for the low beams. Installed them, they flickered on for a second, then nothing. Let the ballasts charge for a while but still nothing. Called DDM, they said my car needs a error code eliminator kit thing later they were at my doorstep. Plugged one side in, flicked on then nothing. Thought both sides might need the code eliminators plugged in...wrong. both flickered on, and then nothing. Tried again, no flicker, both low beam fuses burned. Plugged the regular bulbs in, changed the fuses, lights working again.
I don't know much about electrical, but DDM said i def don't need a relay kit. Do I need a relay kit? Or would putting higher amperage fuses in the place of the original ones work? if so what amperage?
Passat (B6) :: 2008 - After Installation Of HIDs All Warnings And Bulb Out Lights Went Off
I installed some aftermarket HID lights in my 08 passat. I took it to a local shop to have the drls turned off and the bi xenon turned on. All the warnings and bulb out lights went off, the lights fire up perfect. but for some reason now the lights (all of them, rear, dash, parking all come on with the ignition whether or not the lights are switched on or off.
I am sure a code got changed that causes that, but which code would activate all lights all the time? It's not DRls it all lights are on just like you turned the lights on manually.
Passat (B6) :: High Beams At Lower Percentage For DRLs?
Can I change the coding to run the High Beams at a lower percentage for DRLs? Is this possible? I have a feeling its not but just wanted to ask around.
View 7 RepliesPassat (B6) :: Turning Off DRLs By Pulling Out Switch On Dash?
I'd like to turn off my drl's.....getting new front bulbs and going to install some led's to use as drl's. Up to now, I've only read about using VAG-COM to turn off. I just came across a YouTube demo about turning off drl's by pulling out switch on dash, disconnecting switch from connector and bending down a prong inside the connector. Sounds and looks simple. I haven't seen this method written up on Vortex before....
View 3 RepliesMonte Carlo :: 2006 3.5 Liter - Engine Power Is Reduced / Starting Disabled Service Throttle
A month or so ago my engine light came on with the message "engine power is reduced". well i had it checked out, the code from the engine light suggested a bad throttle body. I then replaced the throttle body myself. (unplugged the throttle body sensor, unscrewed the four bolt holding it on, replaced with new throttle body, and reattached cord to new sensor that was attached to the new throttle body) i then re-learned the idle speed through chevys process on their website. The engine light disappeared and everything was a okay for about a week and a half. then it started doing the same thing again. (engine light came on message appeared, obvious reduction in power from the throttle) It is continuing to get worse and sometimes it will shut off my engine display the message "starting disabled service throttle".
I have been shutting the car off ( if it wasn't already off) and wiggling the wires leading to the sensor attached to the throttle body. i'd then close the hood and start the car and it would act normal (engine light still on) with no reduction in power until the next time (which was usually about 30 driving min later give or take) recently a new symptom popped up when i am going uphill or giving it the beans it'll display the usual engine pwer reduced message and sometimes shut off the car. not only that but if it gives me the message and shuts off if i dont wiggle the wires or something of that nature when i start it the whole car shutters while the rpms go up and down. so did i just get bad luck and buy a faulty throttle body ( i bought i t brand new from o'riellys or however you spell that) .