Passat (B5) :: Clutch Chatter / Odd Grinding Noise When Turning Under Acceleration
My car is making an odd grinding noise when im turning under acceleration. I can only hear it at low speeds but it may be doing it at higher speeds and i just cant hear it.
The noise happens when I am turning both left and right and only when accelerating and seems to dissipate as I pick up speed or change from turning to going straight.
Car has 100k miles on it and don't think the clutch has been replaced.
Car is an all stock b5.5 wagon v6 30v 5 speed.
Golf IV R32 :: Grinding Noise Under Acceleration
"Workshop?" Will there by cuties there? Will I have to participate in small group discussions? What exactly happens at these workshops?
I've had this happen to me at least twice now since I've had the starter replaced @ Stohlman VW in N.VA. I've had some good experience with them thus far considering I've drop quite a bit of money into their service: complete hvac rebuild, starter, replaced a couple of pistons, etc...
Before I dive head first into replacing the alternator, is there a slight chance that the 2 are related? I figure I could try & fix it myself b/4 my car turns into a money pit.
There's no real rhyme or reason when the warning light comes on, I do notice that I hear some sort of grinding noise under acceleration. If I'm in neutral & coast, the warning light cuts off. It's not throwing any codes that I know of. I've got around 77K on the car now.
Other things I've read I could do too. Check:
1) battery terminals
2) slip clutch pulley
3) belt & tensioner
Camry :: 2003 SE - Strange Grinding Noise During Acceleration
Experiencing a strange grinding noise, around the front right tire area, during acceleration?
View 1 RepliesElantra XD (2001-06) :: Grinding Sound On Initial Acceleration From Park / Scrapping Noise During Braking
2001 Hyundai Elantra, with an automatic transmission.
1. I am experiencing a "grinding" sound upon my initial acceleration from park? This only occurs when the car has been sitting for a decent amount of time and the engine is relatively cold. To give you more detail: I start the car, throw it in gear and begin to accelerate. The grinding sounds is almost instant and sounds horrible. It is fairly consistent how long it lasts and generally once the car shifts to 2nd or 3rd it goes away. I do not hear it again until I park, leave the car for a while, then start it up and begin driving again.
2. I am hearing a "tension" like noise, also a little like scraping, when I brake at slow speeds coming from my driver side front wheel. I recently had my brakes replaced so I know its probably not the pads and at the time the rotors looked fine too. It is not a constant noise during the breaking either meaning, I apply the breaks, i hear it for a second, then it goes again, then it comes back, then goes away. Again it sounds like a mix between scrapping metal and tension.
What it could be, what I could look at on my own or how to get it resolved?
Ford Super Duty (1999-2016) :: 2006 F350 - Serious Grinding Noise During Acceleration
My 2006 F350 is giving me grey hairs. I'm trying to figure out what's going on with it. I have been getting an occasional (more often than not) grinding noise from what seems to be the front of my truck. It will do it from a stop, under light, moderate, or heavy acceleration. Doesn't matter. If I let off the throttle momentarily it will stop until it shifts and will grind again through all shift points it seems.
Logic says it's got to be the wheel bearings or locking hubs. I recently did both on both sides to no relief. Because this is an 06 it had a different hub set up then the previous years which I've read a lot of info about (needle bearings). It doesn't make a lick of difference if hubs are locked or on auto. If in 4x4 (ESOF) or 2wd.
As mentioned I replaced both wheel bearings with FORD parts and both locking hubs From FORD as well. (Small fortune). Axle u joints seemed tight. Greased me up but no play.
Santa Fe (DM - 2013+) :: Grinding Noise Coming From Rear Of Vehicle On Sharp Turns Under Moderate Acceleration
I own a Canadian 2013 Santa Fe sport AWD 2.0l turbo. Back in June/ July 2015 I noticed a poping / grinding noise coming from the rear of the vehicle when ever I made sharp turns under moderate acceleration. I brought my car into the dealer as it was still under warranty. They diagnosed the problem to be my viscous coupler apparently it was defective.
The part was ordered and replaced about 3 weeks later. After the warranty work was completed in still noticed a noise coming from the back end. I took my car back to the dealer. They found that the rear tires were "cupped" they recommended to get a 4 wheel alignment to solve the cupping issue.
In my past experiences tire cupping is usually caused by a worn out suspension component such as bad shocks. So to avoid conflict of interest I took my car to Canadian Tire to get the alignment checked and adjusted.
Sure enough the front wheels only were slightly out of alignment and a minor adjustment was made. No adjustments made to the rear. The technician advised me that due to the minor adjustment, the alignment would not cause my rear wheels to cup. The complete suspension was checked and no problems were found.
So...would a bad viscous coupler cause wheel cupping???
My Santa Fe had 48000kms at the time of the original noise was detected.
I do not tow a trailer or haul overloaded loads.
The majority of kilometres made Is done on highway.
The rear tires have now been rotated to the front.
Passat (B6) :: New Grinding Noise From Brakes?
Just bought some new tires (Michelin Pilot Exalta A/S) and we've been getting a lot of rain/snow in Chicago and I'm just thinking its the brakes getting wet and kind of rusting. I drive local and less than 1 mile every other day. When I brake it sounds like the brakes are grinding. Almost like the sound your brakes make after a heavy rain fall and when your car sits for the day. It grinds a bit.
That's what my guess is. The tires are new and have a little noise when slowing down and turning slow. Basically I know I don't need new brakes. Just checked them about a month ago.
Passat (B6) :: Metal Grinding Noise At Low Speeds?
Ok so 11 days into ownership and only slightly over 800 miles the car started to act funny. First the common DVD nav issue (no disk in drive message).
Second issue is a strange metal on metal rubbing noise when turning at low speeds (i.e. in parking lots). When I make a big turn (either direction) it sounds like either the brake calipers aren't releasing fully and is causing the pad and disk to rub, or something else is rubbing.
This actually happened once yesterday on the highway as well. going 75mph, a very loud metal on metal rubbing noise.
Seems to only happen when temps outside are below 40. It warmed up yesterday afternoon and the noise went away, but after it got cold again last night, the noise came back.
Passat (B7) :: Grinding Noise When Turning Right At Low Speeds
I have a 2013 Passat TDi SE with about 64000 miles on it and 20 rims. I noticed a grinding noise when turning right at low speeds. It was a very slight noise at first, but has gotten louder over the past 1-2 months. The grinding noise sounds like it's coming from the back of the car and only at fairly tight turning radii, with speeds 10 - 20 mph (think going up the levels of a parking garage). What could this be????
Other things to note:
No other noises, vibrations accompany the sound.
I do get the steering rack creek when turning lock-to-lock, but this sound is definitely not that sound.
I mentioned I have 20 wheels thinking that might have something to do with it. They don't rub at all going in a straight line, however.
Sound is only present when turning right.
Passat (B5) :: Grinding Noise In Tiptronic When About To Hit 3000 RPMs
I have a 01 b5.5 Passat. When I'm in tiptronic and I'm about to hit 3000 rpms, a really off noise goes off and it's like a grinding sound.... Like when your car doesn't want to go to the next gear!
View 1 RepliesPassat - Volkswagen :: Grinding Noise In Reverse - Tranny Bad?
My 1.8 Turbo runs great, but when I am backing uphill (standard 5 speed trans), it makes a grinding noise. Is my tranny bad?! Or what is this? Never have a problem with any of the other gears...
View 5 RepliesPassat (B5) :: Tranny Makes Occasional Grinding Noise When Cold
01 Passat v6 150K tiptronic. When cold, the tranny makes an occasional grinding noise however when at operating temp it runs fine with no slippage. Changed the fluid/filter and added lucas treatment. It worked a little but my mech said to warm up the car before driving. Might be the torque converter?
View 3 RepliesPassat (B6) :: Oil Pressure Light And Eventual Grinding Noise From Under The Hood
Took trip these past few weeks and on the way home today I got the oil pressure light and eventual "grinding" noise from under the hood. I was at about 75mph on the interstate. So now I am stranded 800 miles from home. VW is towing the car tomorrow morning. Car has 24k.
View 24 RepliesPassat (B6) :: 2002 - Idles Roughly - Makes Grinding Noise When Backing
I have had this problem since day one. The idle seems to be very rough once you give it some gas and drive the car it runs smooth as silk. The dealer told me that is the wayit should be due to the narrow V6 with one head cylinder. I have had an 02 Passat V6 and I dont remember it having a rough idle.
My other issue is again since day one when I am moving very slow like when I am backing out of my drive way there is what I would describe as a grinding sound. It does it all the time forwards and back, all day not just the first thing in the morning. Again the dealer says it is normal.
I just had my first oil change about 2 weeks ago and was hoping these were just thing that would be addressed then but they dont seem to be better or worse always the same.
Passat (B5) :: Howling Noise Under Light Acceleration
Lately I've been experiencing a howling noise upwards of 2000 rpm when accelerating under a certain throttle position... Basically makes a WOO type of sound coming from the drivers side of the car.. very noticeable and annoying. When I step on the gas harder it goes away, and if i just rev the car in neutral (no load) the noise will not happen! This makes it impossible to figure out where it's coming from with the hood open. Checked the IC hoses, air box and a bunch of vacuum lines and no luck...
View 4 RepliesPassat (B5) :: 2000 GLX V6 - Clunk Noise Just Upon Acceleration
I have a 2000 Passat GLX 2.8 V6 w/ trip that makes a "clunk" noise just upon acceleration. I did a search for this and it seems like this has been asked before about the 4 motion cars but never on a non 4 motion car. It only happens when I hit the gas...
View 5 RepliesPassat (B5) :: Loud Air Flow Noise During Acceleration
Hearing loud blowing air noise coming from under dashboard/pedal area during acceleration...also turbo power loss...no codes and brakes work fine...
View 10 RepliesPassat (B7) :: Engine Knocking Noise Under Acceleration?
I've noticed distinct engine knocking noise under acceleration/load especially at lower RPMs on a '14 TSI. I'm at 20k miles and wondering if cheap gas from ARCO is the culprit.
View 3 RepliesPassat (B6) :: Reverse Jumping Out Of Gear / Loud Grinding Noise And Pops Back In
I have a problem with my reverse in a 5 speed 105 hp Tdi. It jumps out of place when i try to move the car, makes a loud grinding noise and pops back in, I'm guessing the selectors are worn or maybe the teeth are too. My question is, how hard is it to replace the selectors (if it is the selectors that are worn of course), what is the cost of getting it done in the shop and most important does this sign mean I will have the same problems with the rest of the gear in nearby future?
View 2 Replies