Nissan - Frontier :: 2005 Reeks When Driving At 55 Mph For About 20 Minutes
My 2005 Nissan frontier reeks badly.
Has new air filters and new cabin filters. Only seems to smell when driving at 55mph for about 20 minutes, the funk comes from the vents and in all heat/AC and fan modes seems to be less stinky in the winter.
Nothing is dead in the heater box because it does not stink in when driving around town and I have poured gallons of Lysol down the air intake during recic, open vent, etc, Smells like a mix of eggs, oil, and funk.
Dealership says it is not the catalytic converters as they "check out fine" Nissan dealership says it's bad gas, which is unlikely as when I drive away from home and I use other gas, it still smells.so what is it? What is it?
Nissan - Frontier :: AC Compressor Clutch Noisy When 3 Discs Stop Spinning While Driving
'99 Frontier (3.3L), 140k miles. Just had fan clutch, radiator and belts replaced. Now noticing that the a/c compressor clutch (pictured below) is noisy when the 3 discs stop spinning while I'm driving...it's a noticeable "clack" sound that I can hear with the windows UP.... is this normal? Is there any cure, like lubrication it needs? I pushed on the belts a bit, they don't seem too tight....
View 2 RepliesNissan - Frontier :: 1999 - Air Conditioner Kept Going Off
I have a '99 Nissan Frontier 4cyl. p'up and the air conditioner kept going off. The truck has three drivebelts, all inline. The first is Crankshaft to the Power steering pump , the second goes from Crankshaft to the water-pump & the alternator and the third one goes to the air-conditioning compressor; the one that keeps coming off my truck & shutting down the A.C. I replaced it three times and the last time it went off within a couple of miles. I know the crankshaft and the A.C. compressor pulley's are out of line and believe that's my problem. A mechanic friend of mine looked at it and said he thought it was something called a belt-leveler that keeps all the belts from slipping off.
View 2 RepliesNissan - Frontier :: 2000 V6 Just Randomly Die Going Down The Road
It's a 2000 Frontier V6 4x4 CC with 104k miles. It just randomly dies going down the road. Sometimes it restarts. Sometimes it doesn't. Sometimes I just get a small blip (loss of spark or fuel - unsure which) when going down the road then it's fine again. It seems seems like a loose connection somewhere to me but I have checked and repaired everything I can find.
A little history of problems...
Fall 2014 - Fuel Sending Unit; I had similar problems a little over a year ago and I replaced this at ~90k miles. The stock one was corroded and the fuel pump wasn't getting power. Got the part from Nissan directly. Truck ran great for a year then started having same issues in fall of 2015. I am thinking this couldn't have gone bad again in only a year, but who knows? No engine codes at the time.
December 2015 - Distributor #1; I replaced it with one from Auto Zone. Had the same problems that day. Returned that and replaced with one from Napa Distributor #2 (New - house brand - supposedly made by Altrom - which is supposedly comparable to OEM) This seemed to fix it for a little while. At the same time I did the timing belt, spark plugs, wires, valve cover gaskets, a bunch of suspension work, etc. so I had the harness off. Did I knock something loose? I feel like I have checked it up and down.... doesn't seem that way.
January 2016 Bad Wire?; Same issues. Wiggling the harness into the distributor seemed to have an effect on restarting so I pulled the harness apart from the dist to the main and found a small cut on the casing of one of the ground wires. The wire was not damaged, just casing. Fixed that with a double layer of shrink tube and it ran fine again for a couple weeks. In this same period my catalytic converters also went bad. My exhaust manifolds cracked, next thing I knew I had catalytic converter codes on both sides of the engine. Ran it like this for a few months.
April 2016 Distrbutor #3 Same problem. Randomly dies. Gets progressively worse over a couple day period. I gave up and took it to a shop (Downing St. Garage in Denver, CO) They diagnosed it as a bad distributor so I had it replaced AGAIN (they were nice enough to use the Napa part I bought and get a free warranty part)
June 2016 Distributor #4 Same problem again. Still have not replaced cats - did not want to spend the money when the ignition problem seems un-related. Replaced distributor with another warranty part from NAPA. This time the one that I took off made a crunching sound when you turned it by hand.
August 2016 Finally replaced cats. CEL codes were gone for an afternoon then the truck started sputtering down the road again... CEL P1320 and CEL P0325 BACK AGAIN!
I am at a loss on what to do. I have read that the MAF sensor can get dirty... but this doesn't seem to explain the P1320. Anyway, I ordered some cleaner, a new knock sensor and another distributor (this time Nissan brand but re-manufactured... they no longer sell new ones.)
Nissan - Frontier :: 2003 - Runs Hot When Idling
Our mechanic is stumped. The Frontier runs hot when idling. The clutch fan and thermostat have been replaced. The radiator has been flushed. When you are driving or you turn off the A/C, the temp goes down. The next suggestion is to replace the radiator, but I'm already hundreds into this so I hate to do anything else unless I'm pretty sure it is going to fix it.
We do know that the catalytic converter needs replacing. Could this have anything to do with it?
Nissan - Frontier :: Engine Shuts Down Will Restart Only After A While
When I cut off the engine by mistake (shift slip ie ) the restart comes around but only after about 5 to 15 minutes . The last time this happened the car was at an intersection and this situation is getting dangeous.Why is the restart taking so long ?
View 2 RepliesNissan - Frontier :: 1999 - Overheating Over 45mph
I have read two other threads that indicate a leaky head gasket for Nissan Frontiers overheating...but I'd like an opinion on my problem: I have a 1999, v6 3.3L, 4x4, manual Frontier that I have owned since 2001, always well-maintained, timing belt, water pump and thermostat already replaced a couple of years ago; currently has 129k mi. I rarely drive it (about once or twice a month).
Last time I drove it (I'm in AZ and heat was over 100 degrees) it started right up and was fine until I'd gone about 3 miles on the freeway doing about 65mph. Started to climb in temperature, but not into the red zone. I drove with it hovering just above the midway point (midway meaning perfectly normal temperature on my gauge) for a couple of more miles, when it started to climb just a bit more, I got off the freeway and dropped under 45 mph, the temperature went down to normal. I drove about 40mph back home and haven't driven it since.
I checked my coolant, which was extremely clean and not low, and was not boiling when I checked it soon after the temp went up on the freeway. What is the most likely cause?On a side note, since I do not drive it that often, what is recommended as to the gas that has been sitting in my tank since? How long does the gas stay good for? Further wondering how often it is recommended I drive it, for how long and at what sustained speed to keep my truck up and running?
Nissan - Frontier :: 2000 - A/C Malfunction - Not Cooling In Hot?
I have a 2000 Nissan Frontier that is a 4X4 and has the V6 engine. Mileage is 172,000+. For a few years, I have had problems with the AC no longer cooling after I drive 20 or so miles and stop the truck, go in a store and start back up only to find that the AC will not cool after the stop. This seems to happen more when the weather is hot. Only once has it gone out without stopping the car and it was on I40 driving trough Oklahoma in 100+ degree weather. Once it quits cooling, after driving 20 to 30 minutes, it usually starts to cool again. It sometimes speeds up the process if I roll the windows down.Coolant levels are fine.
So...is there a faulty sensor somewhere? What could it be that is the problem?
Nissan - Frontier :: AC Compressor Clicking / No Cooling
We have a 2003 Nissan frontier pickup (automatic).The AC recently stopped cooling, but the fan works. It was cooling perfectly great when all of a sudden, it stopped. If we turn the AC on, the compressor (I'm guessing) starts to click and continues to click until turned off. (started to grind under hood). It's not a rattle, definitely a click as if it wants to turn on but can't make the electrical connection. It kind of sounds like when a starter has gone bad and it clicks. Except, it does it repetitively until turned off. This doesn't happen if we turn on the fan but leave the AC off. Does it sound like the compressor went out? How can we troubleshoot it?
View 19 RepliesNissan - Frontier :: 2003 - Vibration At About 40 To 50 MPH Only When Accelerator Depressed
I have some serious vibration at about 40 to 50 MPH only when the accelerator is depressed. As soon as I let off the gas it stops. I have had the tires rotated and balanced and the U joints checked. My Mechanic says he can't figure it out and to drive it until it breaks.
View 3 RepliesOil - Nissan - Frontier :: Oil Pressure Gauge Showing High
After having my oil changed at a local place, the oil pressure gauge showed "high." hoping it would go away, i drove for a week. it didn't... took it back to the shop and they said it was a little full which would cause it to show high pressure. That was earlier today. The gauge however has not changed. Still shows high oil pressure. I need to drive 400 miles tomorrow and am not sure if it is safe? Perhaps just a bad sensor??? I need to know if i can hit the road or not.
View 5 RepliesNissan - Frontier :: 2004 - Brake Shudder Or Vibration
I have a 2004 Nissan Frontier with V6 non-supercharged engine, 4x4, with manual transmission, 150k miles. For approximately the last 30k miles, I have had a persistent shuddering in the cab when I apply the brakes slowing from about 15 to 0 MPH. It is accompanied by a low humming noise that decreases in pitch as the truck slows down. It only happens when the brakes are warm; about 70+ degrees outside or after I've been slowing down a lot. It does not seem to correspond to engine temperature, only my perceived temperature of the brakes. There is no pedal feedback, and it does not shudder when I stop using only the parking brake. It does not seem to affect stopping distance.
I first tried to fix it by doing a very thorough front/rear brake job - new pads/shoes, new rotors/drums, and repacked front wheel bearings. That had no effect on the problem. I tried rotating the tires and that had no effect. I then did a complete front end job and replaced all the bushings and balljoints via brand new pre-assembled control arm assemblies. I also replaced the tie rod assemblies, sway bar bushings/end links, and had an alignment done. That had no effect.
Based on the repairs I've done, I would assume that it is having to do with the front brakes, but is not warped rotors or anything in the front suspension.
Nissan - Frontier :: 2001 - Catalytic Converters Rusting
I have some rust building on the heat shield of my cats on my 2001 Nissan Frontier.. I had a weld done to keep it from rattling after replacing the OEM muffler. It there anything I can put on it to retard the rusting process on the shield and will that affect my emissions?
View 4 RepliesNissan - Frontier :: Vibrates Going Uphill / Code P0400
2003 Nissan Frontier with a 4cyl engine, just over 300k.
It vibrates and starts chugging anytime it's under a small load, like going up a hill. Cruises nice and smooth on level ground or going downhill. Feels like a misfire, but idles perfectly and had new plugs/wires installed a few month ago with no problems.
So there's no service engine light, and no codes set, but when I plug my scanner into it the code P0400 appears and disappears randomly on the screen but never sets itself in the computer.
My question is, where is a good starting point? Any components known to go bad in the EGR system? And would a bad/stuck EGR valve cause these symptoms?
There is also a code set for the catalytic converter, it was catalyst efficiency below threshold but I don't remember the exact code. Any way this could be part of the problem, or related in any way?
Nissan - Frontier :: 2004 - Pulls Badly To Left
I have a 2004 Nissan Frontier pickup that pulls to the left. I've had the alignment done - no change. I had the tires moved from the left to the right side - still no change. Firestone is recommending I all the front ball joins at a cost of $1200. Is that really the problem?
View 6 RepliesNissan - Frontier :: Signs Of Bad Intake Manifold Gasket?
On a 1997 Nissan pickup 241,000 mile 2.4 liter. What are the signs of a bad manifold gasket. How can i test it.
View 6 RepliesNissan - Frontier :: 2013 - Acceleration Won't Respond When Gas Applied?
My dad purchased a new 2013 Nissan Frontier 4wd in June 2013. On occasion he has issues with acceleration in that he steps on the gas to go (from a full stop), or steps on the gas to speed up (and pass) and the accelerator does not respond. After anywhere from 3-10 seconds it will lurch forward and go. This is an inconsistent/random occurrence. He has taken it to 2 dealerships and they can't seem to find anything wrong.
View 2 RepliesNissan - Frontier :: 2006 - Ticking Noise When Cold?
I've heard about stuck valves or lifters causing the ticking noise, I try to drive slow until it warms up, but what would a better treatment for this issue?
Also, the anti freeze got contaminated with the transmission fluid. Now there are days when it doesn't shift into reverse (hesitates). The dealer doesn't fix “intermittent”, but the transmission and radiator were replaced
Nissan - Frontier :: 2006 - Extra Cranking Required To Get The Car To Start
I have a 2006 Nissan Frontier v6 4L 4x4 The truck ran great with no problems other then the fuel sending unit was bad so my gas guage was always wrong. I purchased a replacement sending unit and dropped the tank, removed the fuel pump, and finally replaced the bad fuel sending unit. My gas guage works now, but I noticed it took a few extra seconds to start...it cranked and cranked...then finally started. This is not how is was before. I thought maybe it was due to fuel needing to run through the lines. I thought nothing of it and drove off.
Everywhere I parked...I always returned to extra cranking to get the car to start. A day later I decided to look for kinks in the lines. I thought I found one, so after dropping the tank, making sure everything was secure and routing the lines...i bolted it all back together...But now it won't even start. The truck cranks and cranks, but there is no start. I was thinking of dropping the tank half way to make sure the electrical connector was on....