Metro :: AC / Heater Blower Switch Lever Slides Smoothly Without Stopping At Desired Speed
My switch is bad. I took it out and looked at it and cleaned it up and put it back in. The lever slides smoothly without stopping at the desired speed. Contact is made but the switch likes to pop up out of the assembly. I could use zip ties to keep it in, but like I said, it doesn't work properly anyway. I have looked everywhere in the searches and used parts links on the Geo Forum but can't find one.
Any blower switch that I can put in my Geo Metro '97, 1.0L, 3 cyl., base model with std. trans.? I need the switch/cover that is at the top of the picture, It pops in above the lever and by the 4 little clip rectangular holes coming up from the assembly.
Inside the switch there is a small spring and ball bearing about the size of a bb that causes the switch to "click". Spring and ball disappeared long ago. -- From a different thread. Does the spring and ball bearing come with the switch or is that a separate item?
Passat (B6) :: Slow Wipers At Highest Setting?
So compared to my old Jetta, these wipers are "fairly" slow at the highest seeting, and in a down poor at 70 mph they do not clear the windshield fast enough.
View 5 RepliesChevrolet - Tahoe :: 2003 - HVAC Blower Switch Only Works When Put It On Highest Setting
My HVAC blower switch only works when I put it on 5 (the highest setting). What needs to be replaced (besides the whole truck)?
View 4 RepliesFord F-150 - 1997-2003 :: 1999 - Code P0500 - Speed Sensor Has Been Broken Off
So I'm getting code p0500 the question I have is will the speed sensor on the tail on my transmission cause this code on my 99 f150 4x4 . the reason I ask is because this sensor has been broken off . I'm hopeful it only control's my speedometer and is not related to the code . I've tried to remove what is left however in fear if I get it loose it may fall into the transmission. I will be replacing the speed sensor on the pumpkin this weekend . but the transmission it's the upper one is broke off below the surface of the transmission this is a manual transmission....
View 2 RepliesPassat (B6) :: Climatic Fan Runs Only At Highest Speed
Today for the first time, my fan won't run on anything but "4". Car only has 2K miles, and of course I'll take it to the dealer unless it's something I can fix with VAG-COM.
View 2 RepliesDodge - Ram :: Blower Operate Only At Highest Speed Setting - Resistor Failed
2002 Dodge Ram 3500 van (engine unknown, but I think it doesn't matter). Blower operate only at highest speed setting. OK, that's the classic symptom of a failed resistor. Replacements are readily available at chain parts stores.
Where is the resistor located? This video shows me for a 2002 Ram 1500 van. Will it be the same on the 3500?
I've learned here that sometimes resistor failure results from bearings going bad in the blower, causing excessive current draw. Is there a way to test that other than with an ammeter? What's the correct current?
2a. If the blower motor is going bad, is that something we'll be able to replace ourselves? (Yes, I should tell them to get a Haynes or Chilton.) I don't like the idea of taking off dashboard panels.
2b. Is there any other "prime cause" I should look for if the blower motor seems OK?
Are there any other parts (other than the switch) whose failure would also give that symptom?
Ford A/C :: 2010 Expedition - Blower Motor Not Turning Off / Stuck In Highest Fan Speed Setting
My 2010 Expedition Limited AC seems to be stuck in the highest fan speed setting. Changing the setting on the panel control do nothing to change the speed. But you can adjust the temp and it will respond. It is a dual control unit. When I try to turn the system to off completely it will go to what I believe is the vents and stay on full blast. If I turn the truck off and on again the whole system remains off until I turn it on again. The only way to turn it completely off is to turn it to off mode and turn the truck off.
View 1 RepliesMetro :: 1993 - Creaking And Popping When Go Over Wavy Roads Or Take Sharp Curves At Speed
My '93 Metro 3 cyl (The Phoenix) is becoming a bit 'Long in the Tooth'...
Now, this summer, it has started creaking and popping when I go over wavy roads or take sharp curves at speed.
If I accelerate/decelerate the frame pops over on the passenger side and I hear pops in the trunk area.
I wonder how much longer it will be safe to drive.
Geo - Metro :: 1997 - Won't Start Once It Warms Up
First time user here, have done several repairs to my vehicles, but I'm still a greenhorn when it comes to general car operation knowledge.
My 1997 Geo Metro with a 1.3 Liter will start when the engine is cold but once it warms up it refuses to start. I've replaced fuel filter and fuel pressure regulator, and checked to make sure the fuel pump is working and it is. I think I've narrowed it down to the fact that the fuel injector is not pulsing. It will fire when I prime it, but dies immediately.
Metro :: 95 Geo Metro Stopped Running
I bought a 95 geo metro it ran for a few days then stop running. i have replaced about everything, new plugs, spark plug wires, sensors carborator etc. it seems like maybe it could be the timing but timing seems on. it wont turn over.
View 2 RepliesRodeo :: Wipers Just Stop When Switch To Intermittent Control
2000 Rodeo, wipers work when on, no intermittent control. They just stop where ever they are if you swtich to intermittent control. I've heard this is a module above the glove box that costs about $200. Is it parts on the board in the module that fail so the module has to be replaced, or can I open the module, resolder grounds etc and restore operation? If not, anywhere less expensive than the dealer to get a replacement module?
View 14 RepliesGolf IV / Jetta IV :: Turn Euro Switch Wipers Come On?
Having a few electrical issues lately, that are really starting to irritate me. This is pretty random. OCCASIONALLY, not all the time. When I turn my euro switch all the way to the right, my windshield wipers will go across the windshield twice. Obviously the wipers aren't on. And I don't accidentally hit the stalk. This just random and annoying when it smears stuff across the windshield. I don't even know where to start.
View 2 RepliesBuick - Lesabre :: Windshield Wipers Turn On When Switch Is Off
My Buick LeSabre, 2000 model, has had the wiper motor replaced 3 times in an attempt to solve this problem. The multi-switch has also been replaced. The rain sensor on the windshield was disconnected after the 3 motors were put in just to eliminate a potential cause. It is plugged back in now.The problem is intermittent as well. When you are driving, the wipers engage and nothing will stop them.The car has a little less than 80,000 miles on it.
View 2 RepliesStarting - Gasoline - Geo - Pump - Metro :: 1997 - Stalled Driving Up A Hill / Won't Restart
I have a 97 Geo Metro two door that just stalled on me one day driving up a hill. It was low on fuel and so I thought it might have just ran out of fuel. I put more fuel in it but it would not start. I had it towed back home and disconnected the hose out of the fuel pump to see if any fuel would spray out. It did not. This lead me to conclude the fuel pump is bad. I replaced the fuel pump but this still did not fix the problem. I had an electrical guy looking at it run a bypass wire to the fuel pump and it still did not work. His conclusion was that the ECM is bad. Does this sound like a logical conclusion?
View 3 RepliesTiguan :: Front Wipers Not Responding To Switch Inputs Or Delayed Turning On
There is a new issue with our 2012 Tiguan S 4Motion. On several occasions the wipers did not turn on when the stalk switch was moved through its positions. Right now, the switch and wipers are working but we don't know for how long.
One interesting fact is that when the switch is left in the on position, the wipers eventually start working. This delay can be as long as 5 minutes.
I scanned with VCDS and found no faults. I monitored the switch position with no issues in any of the 4 positions. Forcing the output causes the wiper motor to work as well. Since the wipers will not operate with the hood open I also checked the status of the hood switch. That too had no errors and responded correctly, disabling the wipers when the hood was unlatched/opened.
Having issues with your wipers not responding to the switch inputs? I will continue to monitor it and will scan with VCDS if I can catch it in the act.
Camry :: 2009 - Cruise Control Switch Broken?
My wife has a 2009 Camry LE, 4cyl with approximately 63,000 miles on it. Yesterday when driving it, I went to turn the cruise control off and my finger slipped, causing the button to pop out. Both of us have tried to fix it and I know I tried at least three or four different ways to reinstall the little three prong copper piece and no luck. The cruise control still refuses to work.
Having problem with the button popping out and been able to fix it? If so, how did you fix it? I hope it's something simple, such as re-installing the copper piece a certain way.
Ford Super Duty (1999-2016) :: 2008 F250 - Wipers Came On With Switch In Off Position And Won't Stop
I have a 2008 f250 with 6.4. Was sitting my truck with key on and motor off listening to radio on lunch and my wipers came on by themselves. Switch was in off position and we're in slow speed. If I turn switch they wouldn't change speed til high position. Turned key off and back on and they came on still. Pulled 30 amp fuse in battery junction box to shut them off.
View 3 RepliesCamry 2012+ :: 2015 - Front Dome Light Switch Broken
My 2015 camry front dome light switch is broken. This is the push type light. I am not sure how but today i was trying to turn the light on and noticed it wasn't turning on. When i opened the lens cover to switch the bulb i noticed the button was missing and the other side has a button. I don't understand why the light will not turn on when i open the door either. I tried sticking some thing small in to the broken part where the button used to be and it turns on if i do that, but i would have to hold it in place which is pretty inconvenient. What can i do to fix this? it seems like i have to replace the whole overhead assembly. Is there a cheap fix? i would be happy if the light comes on when i at least open the door.
View 9 RepliesGTI 337/20th Anniversary :: Faulty Reverse Lights - Switch / Sensor Broken
(6 speed)... I have faulty reverse lights, my speed sensor is working so I am sure it isn't the fuse, I am guessing this means the switch/sensor is broken. Where it is located, and what the correct part number is?
View 3 Replies