Lexus GX 2010+ :: Car Keeps Deleting Homelink Programming

I was able to program my GX into the garage opener but it deletes my Camry. As soon as I program the Camry it deletes the GX. Strange. I was able to have both cars when I had the ML320.

View 5 Replies

Lexus ES 2007-12 :: 2009 ES350 - Homelink Button Gets Stuck And Opens Garage Door On Its Own

2009 ES350. Yesterday, I came back from work to see that our garage door was left open all day then in the middle of the night, I saw that it was opened again. Luckily, nothing was taken from our garage. When I checked the homelink button, it was jammed in (stuck) which most likely is causing this. When I tested the button, it keeps getting stuck.

View 5 Replies

Lexus LS 2007+ :: 2008 460L - Bluetooth Pairing And Phonebook Sync

Just picked up an 08 460L with navigation and was looking to sync my Motorola Droid X. I have successfully paired the phone for voice communications using the instructions in the manual but when I go to transfer my phone book the car just says transferring. I left this for about 10 minutes and no numbers moved. The phone says Paired for audio is this would be my guess as to why this isnt working. Any tips to get my numbers imported?

View 14 Replies

Ford 6.0L Power Stroke Diesel :: 2007 - Cranks But No Start - FICM / Cam / Crank Sensor No Sync

2007 6.0l cranks but no start. Read all the forums and I think I performed all the checks. Getting a ficm/ cam sensor/crank sensor no sync. I'm also getting 84.70% at the ipr while cranking. Do I have multiple problems? Watched videos on either the ficm or ipr percentage but not one that had both problems. Getting injector clatter and fuel pump runs. Didn't see anything obvious with the harness.

View 14 Replies

Prius (2010-12) :: 2015 - Homelink Mirror With Compass

I would like to install a Homelink mirror with compass on my wife's 2015 3, but a search on here is not coming up with much info on this install on the newer vehicles. It does seem like I found a post where the mirror that was purchased would not work for some reason. I did one on our 2011 (purchased new in 2011) when we bought it and I was able to find enough info to feel comfortable buying a mirror on E-bay and being sure it would work. Anyway, I guess I would like to know if the mount on the windshield is still the standard wedge mount and if there is anything else I need to know/watch for.

View 1 Replies

Prius (2010-12) :: Auto Dim And Homelink Mirror Installation?

I am trying to install an auto dim mirror. The listing said it was OEM from a 2010 -2012 Prius.

View 9 Replies

Lexus GX 2004-09 :: Sunroof Homelink No Longer Works

I pulled it out last week to fix my aftermarket reverse monitor, so when i pulled the console i tested the light make sure i didn't screwed up anything. Then it was turned on for 2 seconds and slowly died. Since then, none of the button work !!! no sunroof, no homelink, nothing.

I've checked fuse already, 27, 35, 36 I believe. i replaced them all, still not working.

View 6 Replies

Lexus ES 2007-12 :: 2010 ES350 Check Completed Error Upon Every Subsequent Start-up

Question about my mom's 2010 ES350.

This morning, it wouldn't start. She tried it a second time, and it started. But...

Upon every subsequent start-up, the LCD in the gauges displays "CHECK COMPLETED".

Car runs and drives fine, otherwise. The security light does go off like it should.

View 3 Replies

Lexus ES 2007-12 :: 2010 ES350 Won't Start - Brake Pedal Couldn't Be Pressed Down

My wife called and said her ES350 couldn't start. I told her to wait 5 minutes and tried again. It still wouldn't start.

So I went there and tried to start the car. My first try did not work either. I noticed that the brake pedal couldn't be pressed down. It was quite stiff. So I pressed hard on the brake pedal and tried again. This time it started. It has been working fine since then.

View 13 Replies

Santa Fe (CM - 2007-12) :: Ticking Noise In Sync With RPMs?

I pulled out into traffic and let the RPM's get up there (6500 rpm's) and now I've seemed to have developed a weird ticking sound that is in sync with my rpm's. What could I have popped/broken? Rocker arm? I have the SUV sitting in the driveway and it makes the ticking sound whose interval increases as the rpm's increase...?

View 20 Replies

Lexus IS 2014+ :: Locks Are Out Of Sync

Why this is happening...... I lock my doors and the gas door pops open. It's like the locks are out of sync.

View 5 Replies

Corolla / Matrix 2009-13 :: Unable To Sync New Key To 2010?

I have bought a new key for my 2010 Corolla. But i can't seem to find a reliable source that has the process in order to sync my new key to my car. Does what the process is to sync my new key?

View 1 Replies

Ford - Focus :: 2010 SE Loses Sync Intermittently

I have a '10 Focus SE I got used about three months ago. I updated the Sync software to the then-current version. I connect my iPhone for both phone and music via Bluetooth.

Every now and then, with no pattern I can determine, when I get into the car and turn it on, the music system immediately plays the FM radio instead of connecting to my phone and playing the music where it left off when I last got out of the car.

I am turning Bluetooth on on the iPhone before I get in the car, and I'm turning it off after I turn off the car and exit it, so it's not a matter of BT from the phone not being available.

View 2 Replies

Lexus GX 2004-09 :: AC Was Out Of Sync With Temp Reading On Dashboard

Just replaced both inside and outside temperature sensors because my AC was out of sync with what the temp was reading on the dash AC....seem to work for me...I'm also including some picks on locations...about a 30min job.

View 4 Replies

Ford 6.0L Power Stroke Diesel :: Crank But No Start / Fluctuating RPM / No Sync

Truck Details:
2004 6.0 F250 extended cab.
Mileage: 1,162,000 Kilometres (the dash stopped at 999,999)
Egr is deleted.
Motor has approximately 120,000 miles on it.

The previous owner delivered campers with it. He said that almost everything in had been replaced except the transmission.

I've had an intermittent crank, no start since I've owned the truck. (2.5 years) It's only happened maybe 5 times and the second attempt was always successful....until yesterday morning.

It threw a few codes but none I believe related to the no-start. One code for a transfer case issue, one for a turbo under-boost, one for the ac clutch not communicating, one for the exhaust pressure sensor not communicating. I would list the actual code #'s but after the first scan I reset them due to my ignorance.

While cranking I get the following numbers:

FICM LPWR- 11 to 12.5 volts
FICM MPWR- 47.5 to 48.5 volts
ICP v- up to 1.8 volts
ICP pressure- up to 1493 psi
IPR %- 15 to 55%
No FICM sync
No ckp/cmp sync
RPM- 0 to 60 and fluctuating
FUELPW- 0.00 ms

I've checked hertz across the red and orange wire at the centre plug of the pcm while cranking and i believe it tested good at 1.4 hertz. The batteries are both getting old and I plan on replacing them but the voltage seems adequate.

The following Forscan tests all checked out good.

PCM KOEO
PCM KOEO injector electrical
TCM KOEO

There were a few others but I think they're irrelevant and they checked out good anyway. I've visually inspected for chaffing but I need to look harder still. There were definitely no codes regarding the cpm, ckp or ficm. Based on what I've read, the fluctuating rpm reading should point to something I'm not aware of.

View 14 Replies

Ford 6.0L Power Stroke Diesel :: 2004 - Crank But Would Not Start - No FICM Sync

2004 6.0 Truck has been slow to start and sometimes took a few tries to get it to fire up. On monday the Truck would not start. The FICM was not getting sync. I figured it could be a bad connection to the FICM. I pulled the FICM, cleaned the contacts and reconnected it. The truck fired up. It ran all day Tuesday without incident but wednesday morning it would again not start. Again what was missing was FICM sync. This time disconnecting and plugging back in the FICM did not fix the problem. I have spent the last two days troubleshooting and am out of things to try.

The problem as it stands right now

The truck will crank but not start. Scanner says it has oil pressure, a steady 48v (FICM has new power supply). The IPR sits around 50% when cranking at 1200psi. However, the FICM will not get sync. I have worked my way down and tested both the Cam and Crank sensors from the PCM. The Crank sensor has a resistance of 360 ohms and produces a AC voltage of 500mV when cranking. The camshaft sensor produces 100mV AC when cranking (camshaft sensor was replaced as the original produced AC voltage seemed low 20mV, new sensor produces 100mV). I have tested the camshaft sensor at the sensor and at the PCM connector. This has lead me to believe both the cam and crank sensors are ok and their signals are being probably transmitted to the PCM.

I have tried to check the inputs to the FICM to confirm the signals are getting there. I was unable to find a good pin out diagram for the 2004 FICM but what I found told me the crankshaft was pin 5 and the camshaft was pin 10. When cranking, pin 5 (crankshaft) did not produce a signal and pin 10 (camshaft) had a 200mV DC signal. Despite searching I have been unable to find what the input signals to the FICM should be.

Right now I suspect bad wiring between the PCM and the FICM, or a bad PCM. This is based on having good signals to the PCM, but (what I think may be) a lack of crankshaft pos. sensor signal to the FICM. I am specifically looking for what the crank/camshaft pos. sensor signal at the FICM should be, as well as confirmation/disconfirmation on the diagnosis of bad PCM or PCM-to-FICM wiring

Truck Details
Ford F350 King Ranch 2004 6.0
Truck build date 11/18/2003
350,000 km
Studded
New FICM power supply
Stock truck; don't run any tunes

View 14 Replies

Lexus LS 2007+ :: 2009 LS460 Engine Would Not Start When Pushing Start Button

Car battery was dead, got a new battery from Walmart and replaced.

After that, from time to time, the engine would not start when pushing the start button, sometimes it takes 2 or 3 tries to get the engine to start. This has never happened before.

What is the reason for it, could it be that the walmart battery is not as powerful as the previous LEXUS battery? or something else?

By the way the car is due for an engine oil change with the warning light on. I use Mobile 1 fully synthetic 0w20 and the light went on every 5000 miles.

View 4 Replies

Lexus ES 2007-12 :: Remote Start ES350 - Lights Flash But Car Won't Start

When lock button on the remote is pressed twice and held for 3rd time , lights flash but car won't start. I just put fresh battery in remote Haven't used remote start since last winter..

View 1 Replies

Lexus LS 2007+ :: 2008 LS460 Won't Start When Press Brake And Start Engine Button

2008 ls 460 won't start when I press brake and start engine button. Car battery is strong. Tried two different keys. Start engine button has green light and when push all dash lights come but engine does nothing. Tried holding Lexus emblem on key next to button and pressing unlock button on key several times. Nothing?

View 4 Replies