Chevrolet - Blazer :: Barely Move Forward And Will Not Move In Reverse

My trailblazer will not move in reverse , and will barely move forward, i checked transmission fluid hot and it's not even on the dipstick but when it was cold. it was?? Do I add more or what?..

View 9 Replies

Ford F-150 (2004-2008) :: Truck Doesn't Really Want To Move Forward When Let Go Off Of The Brake

What should the idle be at for a 2004 f150 fx4. When I first start the stuck it jumps to about 1200 or so and then after a few seconds settles at about 500 and stays there at all stops. It seems to be smooth but when I let go of the brake, the truck doesn't really want to move forward. It is a crew cab so I know there is some weight there. If anything is wrong, what are some possible fixes.

View 3 Replies

Lexus RX 2010-15 :: Power Seat Continues To Move All The Way Forward After Car Starts Up

My 2010 Rx has just recently been doing funny things, and when I mention it to non lexus owners i get the stink eye, as in you're really complaining about that?

So I turn to you, I think you all are familiar with when you press on the break and hit the start button the power seat rolls you into memory 1 (I am the sole driver) well i have noticed that when I do this, my seat moves up about an inch and then pauses while the car literally starts up it then continues to move the chair all the way forward.

Also when i go to lock my car from my keys the chirping confirmation isn't as loud as it once was. its raspy somehow? I was sure if these two things have any correlation but I noticed these two issues together.

View 4 Replies

Ford F-150 - 1997-2003 :: 2000 - Truck Will Barely Move / Running Full Rich

I have a 2000 F150 4WD 5.4 running Extremely rich to bank one. The O2 sensors for bank 1 are reading lean(0-50 mV) Bank two is completely unaffected. New plugs in Bank one, 3 new coils in bank one, all pvc lines checked with good vacuum. Previous codes : P0171, P0301-3. The Truck will barely move. Would a small leak up stream of the O2 sensors cause this?

View 10 Replies

Lexus LS 2007+ :: No Power - Car Will Barely Move

I just purchase 09 LS460 41k miles AWD. I was returning from a nice highway ride had driven about an hour doing an average around 80 getting 23.3MPH. As I was arriving home I stop at the store when i was leaving the store I turned right in front of traffic hit the accelerator and the car would barely move I released hit the gas again gunned it no power and the car gradually got up to speed 35MPH, So i went down the street a little came to a stop made a hard right and gunned it and my moped would get up to speed faster than the car would.

View 14 Replies

Ford Ranger / B-Series :: Throttle Stuck Open Causing Truck To Move Forward When In 1st Gear

Have a 99 Ranger XLT, 4 cyl, manual transmission with 191K miles. Was running good as ever last night but went to start it this morning and throttle's stuck open, causing truck to move forward when in 1st gear. Even with clutch in, near impossible to get vehicle in or out of gear. Managed to get it into reverse, but truck was having none of it. What is the cause or causes of my trouble? Or how much the repairs might cost? I'm on the road so no chance of doing this myself.

View 2 Replies

Ford 6.0L Power Stroke Diesel :: 2006 F250 - Lack Of Power / Truck Will Barely Move And Takes Long Time To Accelerate Under A Load

I have a 2006 F250 6.0 Amarillo Edition. 133,000 When I bought the truck it was a theft recovery vehicle where the turbo, injectors, FICM and wiring harness were stolen. The company I bought it from replaced the injectors, wiring harness-new, and a used FICM, and turbo. Also has EGR delete and SCT tuner with basic tunes. I believe the SCT was put on to mask another problem. No dealer would spend that kind of money to sell a truck unless something was wrong. The truck would accelerate some with the tuner but shift the tires so hard it would bark them. I removed the tuner and went back to stock program.

The truck will barely move and takes a long time to accelerate under a load. In park and neutral it is fine. A friend has a ford diagnostic program on his computer and says the readings were all good except EBP was a little high. Removed exhaust and air intake to verify no restrictions. Turbo sounded like the vanes might be sticking so I replaced the turbo and VGT solenoid. Now truck feels like its trying to make more boost but not transferring power to the engine. Have blown the silicone hose off twice now during testing. Checked the EBP sensor and tube and only thing I see is a little carbon buildup inside the sensor. What else to check. I'm new when it comes to diesels.

View 6 Replies

Ford Excursion :: 2000 - Won't Move Forward - On Acceleration Jerks - Brake Pads / Hoses?

I have an issue with something when I stop. When I apply the brakes and come to a complete stop, right when the forward motion is completely stopped the ex kind of rocks back on the shocks. When that happens the ex jerks just a little. Kind of like if the brakes were sticking to the rotor, or the shocks are sticking. Then when I start to accelerate it jerks again. How can I tell if the brake hoses are bad, calipers are bad, or if it's the caliper slide pins, or if the shocks are bad?

View 11 Replies

Ford - Explorer :: 2010 Won't Move When Cold / Lunge Forward

I bought my wife a 2010 Explorer a couple years ago, nice car but when it gets to 0 or -0 it wont move. After idling for an hour and some persuasion with the throttle it will lunge forward and then there is no issue until it is shut off and cooled down again. I'm wondering if there could be water in the tranny and its freezing but there is no way to check it.

View 4 Replies

Lexus ES 2013+ :: Can Head Rests Move Forward / Backward?

Can the head rests in a 2013 ES be moved forward or back, not just up or down? I thought I read somewhere they could, but for the life of me I can only get mine to go up and down ....

View 6 Replies

Subaru - Legacy :: 2010 - Passenger Seat Ceased To Move Forward And Backward

Just a few days back, the front passenger seat of my 2010 Legacy ceased to move forward and backward. So no one can feasibly sit in the front when I'm driving unless under 5' tall. The lumbar and seat back motors seem to be working just fine, so just the back and forward function/motor is dead. I initially thought something was stuck in the tracks that hold the seat in, but checked all of that out and nada. The motor makes no sound or vibration. I'm also surprised the seat mechanism seems to be broken in a 4-yr-old car with low mileage.

View 4 Replies

Lexus GX 2004-09 :: Brakes Lock Up After Washing - Car Will Not Move In Reverse Or Forward

After washing my 08 GX and putting in the garage to wax dry I have found that the next time I get in it to drive-often a day or so later,the car will not move in reverse ( or forward) without me revving it up quite high to overcome the locked up pads on the rotors. Sometimes its even screeches the tires to get in unlocked. I just washed it and letting it sit outside for a bit to see if the sun will dry out the rotors/pads and that would work.

View 10 Replies

Lumina :: 1993 - While Turning Makes Grinding Clattering Noise - Won't Move Forward But Will Move In Reverse

I'm new here and I am having issues with my Lumina. It is a 93 Chevy Lumina Euro 3.1L 6 cylinder and has 192K miles on it. It has had one owner for the past ten years that I know for a fact.

Here's what happened. I was coming back home (2hr trip) The brakes had started making that roaring sound on the way down and had gotten worse when I got ready to make the trip home. Okay so I know the brake pads needed to be changed. No big deal. Well going down the road at 65mph I round a curve and my car starts making this REALLY LOUD grinding clattering noise. It took me forever to get it stopped. I will still in the road and I needed to get it out bc it was right around a curve. So I put it in drive and it wont move. So I put it in reverse and it moves just fine with no problems and no noises made. After backing it out of the road I tried to put it in drive. It moved forward a few inches and stopped like something was binding it up.

So here's the problem.. it will move in reverse with no problems at all and only creeps a couple of inches forward then stops. The harder you press on the gas the more it tries to lurch forward but will not move.. like it's caught on something.

We changed the rear brakes on it. Discovered that the driver side rear rotor and caliper were broke beyond repair so we replaced those too. Still the same.. moves forward a lil bit and stops but will go in reverse just fine. We don't seem to think its the tranny bc it pulls hard and seems to not have any problems pulling.. but its like something is bound up somewhere. That is the best way I know how to explain this situation.

View 8 Replies

Ford - Ranger :: 1993 - Emergency Brake Only Stops Truck From Rolling Forward

My emergency brake works fine when I am parked nose down; it prevents my truck from rolling forward. When I'm parked nose up, the e brake doesn't stop the truck from rolling backwards. 2.3L 1993 ford ranger manual trans.

View 3 Replies

Ford Transmission :: 2005 Expedition - No Forward / Engine Revs And Barely Pulls In Drive

Reverse works great....engine revs and barely pulls in drive. Not sure yet if it actually changes gears. I am planning on replacing tranny. I have a few questions :

1: Could it be something more simple like a selonoid or ???

2: What all trannys will fit? this is the 2wd 5.4 liter xlt ...

View 9 Replies

GTI 337/20th Anniversary :: Barely Able To Move The Shifter / Clutch Pedal Fell To Floor

The transmission is a Six-speed MQ350 transmission in an MKIV 337 GTI.

I was driving last week and ran over a large snow chunk, heard it hit the underside of my car. A mile down the road my foot is resting on the clutch pedal at a stop light, and the clutch slowly went to the floor. It was still drivable, barely. The clutch came about an inch off the floorboard, but still caught. So i pull into the parking lot ahead of me, and was barely able to move the shifter left to right nor would the shifter go into gear. There were no fluids coming from under the car, nor could i see anything that looked wrong. I turned off, back on again. nothing. I then pulled the clutch pedal up from the floor and it went back to normal. Everything seems normal now, but the shifter seemed a little sticky yesterday from left to right.

View 6 Replies

Passat (B6) :: 2010 Tranny - Car Will Lurch Forward When Take Foot Off The Brake

I have a brand new 2010 Passat. I am unable to achieve a smooth start from stops and the car will lurch forward when I take my foot off the brake. Any small input from the gas pedal produces a jumpy start to the acceleration process. I have about 300 miles on the car. I bought this for my wife and she is very uneasy about driving it.

View 18 Replies

Ford 6.0L Power Stroke Diesel :: Stuttering On Acceleration / Fuel PSI At Idle Barely Move

I fear my truck may be stuttering on acceleration.

I hooked up a fuel pressure gauge tonight and the fuel PSI at idle and under acceleration... barely moved. Stayed between 60-62PSI.

I'm thinking this isn't normal... shouldn't the PSI be reduced especially when I accelerate hard ?

I'm thinking the "delivery" fuel line... perhaps there is a bottle neck somewhere which is causing constant PSI at the fuel housing ?

View 3 Replies

Ford 7.3L Power Stroke (1999-2003) :: Right Front Window Would Barely Move When Opening It

My right front window would barely move when I was opening it. Binding real bad on the way down. So I pulled the door panel, ( a two minute affair ) lubed all the tracks with silicone grease. Now the window goes down very easily.

I had all four doors done in an hour. To remove the door panels, remove the red reflector from the door, remove the screw underneath of it. Gently pry up on the window switch bezel at the front for the front door, and the side for the rear doors if so equipped. There will be another screw underneath. Unplug the switch, remove the screw. Remove the trip piece from above the hinge area. Push up on the panel and it comes off.

I used that real thick silicone grease that you can get a plumbers supply for lubing faucet o-rings. It looks like double thick vaseline. Windows work like a dream now.

View 14 Replies