Lexus RX 2010-15 :: How To Change Light Bulb On License Plate
How to change the license plate light bulb for lexus rx 350 2010.
View 4 RepliesLexus GX 2004-09 :: Cannot Find Fuse For License Plate Lights
I try to install LEDS on it and I guess I accidently blew the fuse and when I try to search for it, I can't locate it.
View 3 RepliesLexus GX 2004-09 :: Front License Plate Mounting Holes?
I need to mount a plate on front bumper and there are dimples for 2 holes. Do I just use self tapping screws here as I've read you don't need a mounting frame?
View 3 RepliesPrius (2004-09) :: License Plate Light Comes On When Any Door Opens Post Led Install
License plate light comes on when any door opens? it fades out a little after it's shut. stays on for a minute or so. (like interior lights would if i had the door dome switch on).
Any way to turn this license plate light off for this function? stays on if the hatch is open, or any door. I car camp a lot and crack the hatch for air. license plate light stays on.
Also the lower door lights, when they are individually open. I'd like them to not come on. Yes I could just remove those bulbs.
I had installed led lights on the whole car/ every bulb inside and out. even fog lights. i didn't replace the hid headlights, though I'd like to.
Ford F-150 (2004-2008) :: Tail / Turn / Backup / Flasher / License Plate Light Won't Working?
No tail, turn, backup, flasher, license plate - NOTHING. i checked fuses - cleaned both connectors under the truck by drivers door, cleaned connectors by the spare tire (2) one large one and one small round, the cleaned ground lug on top of spare tire bracket, all bulbs are new. cleaned with LPS contact cleaner, they were new and shiny and reinstalled. NOW - turn is very weak and when i push on brake they go off and the front blinkers blink twice as fast? I a aircraft technician and know my way with an ohm meter but totally stumped.
View 8 RepliesLexus RX 2010-15 :: 350 Front License Plate Holder?
After going through the car wash several times now in my 2010 RX 350, my front license plate has been bent in all different directions. Car wash guys say it's due to not having a full plate holder, where as 4 screws secure the plate vs. only the top 2 as we have. Any plate holder from another vehicle that I might adapt to overcome this?
View 14 RepliesLexus ES 2007-12 :: How To Change License Plate Bulbs
How do I change my license plate bulbs in a 2010 ES350? I bought some 194 JDM Astar LEDs. I took off liner and changed backup bulbs but can't figure out how to change license plate bulbs.
View 4 RepliesLexus ES 2007-12 :: How To Replace License Plate Bulbs
I'm trying to change my license plate bulbs to LED but cant figure out how get to the bulb. I've already removed the carpeted cover but cant seem to figure out how to get the bulb out..... 2007 ES350....
View 3 RepliesLexus RX 2010-15 :: How To Change License Plate Bulbs To LEDs
I wanted to change my license plate bulbs to LED's. Can't figure out how to get to them. The book says have the dealer replace these bulbs if burnt out. I Always like to try to do things myself.
View 7 RepliesLexus SC430 :: 2002 - From Where License Plate Lights Get Power
Where the license plate lights get thir power from? I have a 2002 SC430 and the plug is just dangling. It goes behind the plate and then if I look under the car, it is just there by the bumper and I cannot find a connector that it can reach.
View 3 RepliesLexus IS 2014+ :: License Plate Rattle On Closing Trunk
Notice a rattle when they close their trunk?
My top screws are plenty tight, but the bottom portion seems to not be secure enough since they do not have screws.
Lexus IS 2014+ :: Trunk License Plate LED Bulbs Replacement
I tried doing a search on how to replace the License plate LED bulbs...
Looking for pictures or instructions on how to replace them...
Lexus RX 2010-15 :: 450h / Front License Plate Frame?
I have a 2010 RX450h and live in Minnesota where it is hard to hand wash my car. The darn car washes tend to catch the front of my license plate frame and bend it and the license. I have tried several different plate frames and none worked. Minnesota plates are now the thin, non-stamped plates so they are very flimsy.
I even tried putting a plastic plate behind the license to make it more rigid but that failed too.
Lexus ES 2013+ :: Front License Plate Relocation On 2016 350?
yesterday I got the idea to move the plate bracket on the front all the way down so it gives it a much cleaner look and doesn't obstruct the grille. To do so test mount the bracket on the lowest position, then have someone hold it. Then you take a 1/8 drill bit and make the two new wholes then put everything back together.
View 8 RepliesLexus IS 2014+ :: Rear License Plate Mount Rusting Already?
My Ultra white IS350 is 15 months old, and when I took out the screws to my license plate today, I noticed a little bit of rust on the mounts (where the screws would go into).
I believe this is a pretty common issue for all cars - essentially, the mount was sprayed with body paint, but the paint would be stripped when you put a screw in. It's just a matter of time before that happens.
I am just concerned it would rust through my trunk if I continue to leave it.
FYI: I already use stainless steel screws
Golf V R32 :: License Plate LEDs Went Haywire - Dim Light
I ordered an LED interior package from Deautokey and they also came with license plate LEDs. The interior looks great, the license plates looked great except for one thing, the right side was slightly yellower than the left. So I contacted Deautokey and they sent me two new ones:
These are identical to the original LEDs except in the old ones the squares are arranged in a diamond pattern but I don't think that matters.
Tonight, I was replacing the right side LED hoping that replacing one is all I had to do to match colors but in order to see better I kept the plate lights on. Well when I went to pull out the housing I forgot that they were still on and pulled it out anyways, there may have been a noise when that happened but I forgot.
I put the new one in, turned the plate lights back on and found that it was dim, I rotated it and same look. I tried the second replacement, equally dim, so I thought "okay, I'll just give up and put the old ones in." Did that and they are now these ones became dim!
What happened!? Did pulling it out while it was still on (only did it that first time BTW) mess something up? Did the new ones being in there mess something up? There is no warning light or message in my instrument cluster.
Golf IV / Jetta IV :: 1 License Plate Light Not Working?
So I noticed a few days ago just one of my license plate bulbs blew, so I tried throwing another in and it won't light up. If I check for 12v at the housing and I have 12 where do I go from there? 2005 golf 2.slow
View 1 RepliesLexus RX 2010-15 :: Replacing Bulb On License Plate Of 2014 RX350?
Replacing license plate bulb on a 3rd gen rx? I tried taking off the interior lining on the rear hatch but no luck. There's access covers for taillight & reverse, but none for license plate light. I also tried "popping" out the plate light cover right above the license plate... don't think they are designed to be popped out.
View 3 RepliesLexus GS 2013+ :: Changing License Plate Bulbs - How To Get Plastic Covers To Pop Off
How do I change my license plate bulbs? I can't seem to get the plastic covers to pop off without worrying about breaking something. Even reading about people saying the puddle lights were hard to change, i did mines in 10 minutes in the dark with a small flashlight lol.
This was a lot easier old my old g37/350z ....