Lexus IS 2014+ :: Check BSM System Message On The Dash
My 3is blind spot monitor and cross traffic alert doesn't seem to work anymore. I've tried playing around with the BSM button under the steering wheel.... i get nothing except a message on the dash saying "check BSM system" . Whats going on and how to fix it?
View 5 RepliesLexus GS 2013+ :: Check Park Sonar System Error Message
So with all of the snow we've been having in the north east this is usually an error message I get almost every week. Normally this is due to the front sonar sensors being covered in ice or snow and will go away once it melts when I'm parked in the garage or is washed off.
However the past few days, I've had the car washed a few times to make sure the salt is off of the sonar on the front bumper but I'm still getting the error message stating to check the front sonar. If I leave the park assist on it works for the sides but not the front and the error message still stays on the screen. I've hand-washed the sonar sensors several times and 'massaged' them in place to maybe break up some ice behind the bumper or get the sensor to work but I've gotten nothing. Upon further inspection, one of the sensors has a deep scratch in it to where you can see past the paint of the car slightly.
I'm really not looking forward to taking the car to the dealer to have them look at the sensor because they will most likely charge me a ton. I saw a few other posts on the forums about the LS400 from '99-'00 having a similar issue and it cost them $550 to get it fixed. Obviously it's not the same car but I'm expecting a similar quote. I'm assuming the paint scratch is what is causing the issue as another post for the LS mentioned the same thing and said they had to scratch all the paint off of the sensor to make it work again.
Lexus LS 2007+ :: 2008 LS460L Periodically Displaying VSC System Error Message In Dash
My 2008 LS460L has been periodically displaying the following message in the dash display: "VSC System Error" ...
This message displays on and off about every other day. Yesterday, I hooked an OBD2 scanner up and discovered the following error code history:
P0171 : System Too Lean Bank 1
P0174 : System Too Lean Bank 2
P0022 : "A" Camshaft Position - Timing Over-Retarded Bank 2
P0335 : Crankshaft Position Sensor "A" Circuit
P2195 : 02 Sensor Biased/Stuck Lean Bank 1 Sensor 1
Every now and then the engine will run a little rough, but usually at low RPM, and (again) not very often. The car has 166,000 miles of mostly highway driving.
Lexus LS 2007+ :: Brake System Is Malfunctioning And Check ABS System Message
I have Lexus 460 LS L 2007. Few months back changed the battery and every thing was ok. 2 months after I had problem in the sound system ( radio and dvd ) which was on and off. One month back suddenly I had all the warning lights in the dashboard on with massage saying that that the brake system is malfunctioning and check the ABS system.
I took the car to LEXUS dealer and they reprogrammed the computer abd then every thing went back to normal and the problem fixed. Two days after I had these warning lights again with the same massege. I do not know what to do ??
Taurus :: Check Brake System Message - Dimming Dash Lights
I have a 2007 Taurus and for some odd reason I get a message saying to check the brake system. Its accompanied by dimming dash lights and symptoms of a bad alternator. I'm suspecting the battery (its from 2009). Sometimes the issue goes away and when I drive and get the car above 1300 rpm it will go away until the next stop light/sign.
View 11 RepliesPrius (2010-12) :: All Dash Warning Lights Came On / Check Hybrid System Message
My Prius yesterday while driving slowly (under 10 mph) all the dash warning lights came on(triangle, cel, trac control, brake). the gas engine started and the message came on that says: "check hybrid system". Today when I went out to check there only two warning lights on (triangle and cel) with the same message displayed. My question is can the vehicle operate without damaging anything if I drive it as is? I have read on several threads that the engine will not start if the hybrid motor(s) are not working. Since my engine starts and runs I have to believe the motor(s) are working.
View 19 RepliesSanta Fe (DM - 2013+) :: Check Steering Wheel Locking System Message
2013 Santa Fe 2.2 Turbo Diesel. I left the smart key in its pocket. The battery went flat. Re-charged the battery. Vehicle won't start. Dash does not light up. Warning message displayed is:- Check Steering Wheel locking System. The steering wheel is not locked.
View 1 RepliesLexus GX 2004-09 :: Disk Check Message On DVD System
I have a 2003 GX with DVD & NAV. The DVD gives me a message on the rear screen that says "Disk Check" and then never plays the disk. I tried multiple disks and am pretty sure the DVD unit is toast. Looking forward to replace the DVD unit in the center console?
View 2 RepliesLexus IS 2014+ :: Check AWD System Warning Message
Today I received a “CHECK AWD SYSTEM” warning message. Car seems to be driving okay.
View 7 RepliesLexus LS 2007+ :: Check Brake System Error Message
1. I think my battery is getting weak.... when i cranked it, it didnt sound strong and the original battery eye says to add distilled water. I am thinking about getting a replacement battery at Costco.
2. so right after it started, the message of "Check Brake System" shows up. Tried to restart but no go. Drove about 15 miles and all seems fine but message is still there.
* is it OK to replace with a Costco brand battery (they have a great returns policy) and is there anything i need to do before or after replacement?
* could the Check Brake System be due to the weak battery? How can I reset it?
* Anything else that can cause this error message?
Lexus GX 2004-09 :: How To Disable Navigation System Caution Message
My wife drives a 05 GX470. Is there a way to disable the caution message (i.e. Caution: Drive safely and obey traffic rules...) that appears on the navigation screen every time you start the suv?
View 5 RepliesLexus GS 2013+ :: 1st Gear Not Available Message Every Time Tried To Downshift
Happened today during the snow storm. I never drive in auto when it's snowing. I usually use the first 3 gears to get around, this allows me to engine brake, which reduces the slipping and sliding greatly.
Anyways, today my car ( after 3 winters and many snow events ) decided to disable the 1st gear ??? I have tried turning the snow mode on / off as well as the VSC , but the car would not give me the 1st gear back
Eventually it released it and I was a happy camper again. Below is the message I was getting every time I tried to down shift.
Lexus LS 2007+ :: Check Parking Brake System Message On Start Up
Started the car this morning- and got a message. "Check parking brake system" .
The Auto button for the parking brake seems to flicker, and the park light on the dash blinks. Car make ding sound while driving.
2008 LS460
Lexus RX 2010-15 :: Check AWD System Message / Hard Jerky Downshifting
So I just purchased my new-to-me, CPO 2010 RX 350 two weeks ago. It had 81,750 miles when I purchased it, and it now has about 83,000 miles. I just came back from a weekend vacation, having driving about 500 miles total. This morning when I turned on the car, I noticed a message saying "Check AWD System," the check engine light was on, the general warning light was on, and the traction control light was on. As I was driving, I realized that the car wasn't downshifting properly. I didn't drive faster than 40 mph on my morning commute. When the car did downshift, it was a hard, jerky shift.
I did some reading on the forum, and many people suggested all the warning lights could be fixed by taking off and retightening the gas cap (due to the vehicle not reading the emissions properly or something?). I also read that topping off and overfilling the gas tank can be cause for the warning lights to go on. I did fill up once on my way home from my vacation, and haven't filled up since.
Anyways, I just now tried to adjust the gas cap and then restart the car, but the warning lights are still on. What I should do or if I should drive it a bit to let the emissions build up again? My problem is is that I live about 6 hours from a Lexus dealership, so I'm trying to figure out if I can resolve this on my own or what I should tell a mechanic specifically if I need to take it in.
Lexus RX 2004-09 :: Error Message Shift To P When Starting With Check VSC System Warning
I have a 2006 RX400h. On 3 occasions I've been stranded. The car won't start and I get an error/message Shift to P when Starting. However I am in Park. It's coupled with a Check VSC System warning. Service department says I have just drained the accessory battery, however nothing is being used other than standard equip such as lights, dash etc. I've had all batteries changed in the car over the 4 years I've owned it. Is this usual?
View 14 RepliesLexus RX 2004-09 :: Navigation System Giving Message - Insert Correct Disk
I was playing around with the navigation system of my 06 RX400H because I read about the motion override online; however I was being stupid and chose the wrong option under the "load" menu, so the navigation system kept telling me "insert correct disk. ". Hoping that I could find a simple "reset" option there, I was playing with the diagnostic mode quite a bit. One setting allow you to select the navigation unit start up logo between Toyota, Lexus, and None. There is another interesting option called "car setting" don't know what it does.
Seemed like it let you toggle between a numerous of settings, I remember one being 9001X4WD or something. I didn't know what the setting does and accidentally changed the vehicle setting for my navigation unit. After confirming the edit, I realized that the mapping for all the buttons on my panel completed changed! First of all the map button (which wasn't working at the time because I had the wrong load option) became the "Audio" button that is similar to the audio button on my other car, 06 IS350, it showed me all my audio presets and I could choose using the touch the screen (normally this feature is disabled for RX400H).
I realized I might have screwed up the setting and wanted to change back to the original vehicle setting. I couldn't find much information online, so I figure I probably hit that set button by mistake 2 or 3 times, so I reverted the car code back to what it was 3 selections ago, and bam! My panel buttons are messed up even further! Now I don't even have access to the "info" button any more! I can still get access to the first level diagnostic mode using the "display setting" (display key is mapped to the info button now) then left upper corner + left lower corner method, however I can't change the vehicle code in this mode.
I took the car to a local dealer, and the service tech was like "what the heck did you do" and he said he don't know how to fix this except to replace the whole navigation ECU which would cost thousands of bucks. I asked him it would be as simple as getting access to the onboard ECU memory and rewrite it and he said the data format is Toyota proprietary and the dealer doesn't know how to fix it.
Of course I wasn't satisfied with the answer I got, I took the car home. Following some good information on forums and navigation ECU replace instructions on AllData, I was able to remove the navigation ECU from the car, then took it apart, disconnected the power daughter board, pushed the black reset button(?), and then put everything back together. I have seem people saying this method working and not working, but for me it did work. When I restarted the vehicle, the "loading data do not turn off" screen came on, and after the system booted, GPS navigation is working as usual now. On e interesting observation, before the GPS unit has established a connection with the satellites (took about 2-3 minutes to do so), the default location for the vehicle in the system is somewhere in Washington D.C.
Now I have undone my "load version" mistake. However, without the "info" button being mapped to the dashboard, I don't even have access to the menu where you can change the "car code", so even if I know the correct code now, I wouldn't be able to enter it. also it seems that I was able to reset the ECU when I took it apart, I am suspecting that the setting for "car code" isn't store in the ECU but it is stored somewhere instead.
Lexus RX 2010-15 :: 2013 RX350 - How To Eliminate Maintenance Required Message
I am out of town and did the 15K maintenance. Garage tech did not eliminate this message. I do not have my manual here. 2013 RX350 ... steps to eliminate this message...
View 2 RepliesLexus LS 2007+ :: Passenger Side Daytime Running Light Is Out - No System Warning Message?
Just noticed that the passenger side daytime running light is out. There is no warning message shown on the dash? Is this normal?
View 2 RepliesLexus ES 2007-12 :: 2008 ES350 Navigation System Outage / Program Cannot Be Read Message
We bought our ES350 used a number of years ago. When we changed the battery, the Nav system no longer worked and a " A program cannot be read. Please consult to a dealer." message appeared. Am I wrong to assume that the loss of power from the battery swap caused the software to dump from the system and there was no disc installed to "reboot" the system? All I need is a disc and the system will restore? If so will an "update" disc work or do I need an original "program" disc?
View 1 Replies