IS F (2008-2014) :: Getting Information About PPE Header And Dual Mode Exhaust?
Been researching exhausts a bit and getting information about the full PPE header and PPE Dual mode exhaust to review?
View 10 RepliesLexus IS 2014+ :: Can't Find Digital Tachometer To Customize
I have a 2014 Lexus IS 350 .
I was wondering where the digital tachometer is, could I customize it to just stay in one spot and to stop going back everyone I turn the car off? I would like for it to stay on source with the artist and song information. Is it possible to do this or am I just stuck?
Camry :: 2004 - Dash Stopped Displaying Information - Fuel Gauge / Speed
Last week, our 2004 Camry's dash stopped displaying information - fuel gauge / speed / etc. two nights ago, I reseated a number of fuses, and it worked for a while, but stopped working again yesterday. All the fuses looked intact, even though some of the contacts were a little gunky. I cleaned them off, but it continues not to work.
Additionally, after reseating a number of fuses, I get 5 quick beeps when turning off the car, which may be coming from our aftermarket radio.
I read on another site last night to disconnect the battery, and that may reset the computer, and relight the dash. I did that, it didn't fix the problem, and afterwards when I started the car the idle was so slow the car wouldn't even stay running. After about 20 minutes, the idle was still very low, but the car would run. When I checked it this morning, it was idling fine, but the dash still wasn't lighting up.
The seatbelt lights and gear light up ok, but nothing else on the dash works. Battery, alternator, dash? What does this sound like?
Lexus IS 2014+ :: How To Turn Off Freeway Exit Information On Nav
Is it possible to turn off the freeway exit info on the nav? This is the info that shows up when you are in a long stretch and it shows POIs in between your current location and the exit that you will take. I do not like that it takes up half of the screen to display info I do not need.
View 9 RepliesCamry 2012+ :: 2014 - Radio Is Not Displaying Information
I have 2014 0.5 Camry with Entune Premium Audio with Nav & App Suite. The radio will not display any info from the station I'm listening to, other than the station number. I know that not all stations provide that info in their streams, but I've never found one that will show the song name, artist, etc., although the music sounds fine. Is there a fix for this?
View 5 RepliesLexus IS 2014+ :: Displaying Song Information On Home Screen
I have my home screen set to show audio on the left side, weather upper right and climate lower right. Even though the audio section is the whole left side of the screen, it does not display the artist or song information for radio stations. If I click on audio, though, then in the full audio screen (with presets, etc.), it does show the artist and song information. How to get the info to display on the home screen?
View 9 RepliesLexus IS 2014+ :: 15 IS350 F- Sport Don't Have Elapsed Time In Multi Information Display
I noticed just recently my 15 IS350 F- Sport doesn't have elapsed time in the multi information display. Instead it has 2 different average fuel economy spots under Driver info 1.
I remember seeing it on a 14 IS base, is this something different 15 or F-sport? Is there a setting to get it back?
IS F (2008-2014) :: Car Will Not Rev About 1500 Rpms And Check VSC Blinking On Dash
I have a 2008 is-f. My car will not rev about 1500 rpms and the hazard exclamation mark symbol is blinking on my dash saying check vsc! I had a bad battery and thought with the little research I have done that might be the problem but I put a new one in and the problem is still there. i own a scan tool so I scanned the cel and came up with code p2118 , it has to be something with the throttle sensor or something. I've tried pulling fuses and resetting the ecm but still no luck. I reset the cel with my little tool but it comes right back on as soon as its started.
View 14 RepliesPrius V :: How To Customize Splash Screen
Ok, I just figured out how to customize the Startup Image..the instructions are on page 48 of Nav System Owner's Manual. I have the Advanced Tech Package.
The Image has to be a JPG or JPEG image up to 10MB. On your home PC, you create TWO files on a USB thumb drive, one called "StartupImage" and "DisplayOffImage" (Both Case sensitive). You put the files (images) that you want, inside the "StartupImage" folder. You then go to your Prius and plug into the USB port. You then go into Setup -> General -> Customize Startup Image. Then just follow the onscreen instructions and your done!
Prius (Gen 3) :: Customize Steering Wheel Controls?
Trying setting up new controls in the steering wheel of a Prius? I have the "four" package so there's a blank spot on the right side where the radar cruise and lane assist controls would be, and I would kill to have the three driving mode buttons right there for easy switching while driving around town. Is that sort of thing even technically possible?
View 7 RepliesLexus GS 2013+ :: Driver Memory Seat - Customize Settings In Nav Area
I can set my seat to recognize what key is unlocking the door to set the drivers seat to registered position (1, 2 or 3). Now when I customize settings in the Nav area so that the driver's seat slides back partially or fully when shutting down car, it no longer recognizes the keys. When I cancel the slide back option in the Nav, it quickly recognizes the keys again. I like both options and do wish that there is a way to remedy this. Is this normal?
View 14 RepliesCamry 2012+ :: 2014 / 2014.5 Reset TPMS Light On Dash
I can't find the button to reset the TPMS light on my dash. It's not even in the glove compartment.
View 7 RepliesLexus ES 2013+ :: Traffic Information Map Is Blank
Every time I go to the traffic information map it's a blank yellow screen, my weather map works just fine.
View 3 RepliesPrius (Gen 3) :: Multi Information Display Blank / Not Working
My wife on her way home from work called me to say that the MID screen was blank - not working. I asked if she could drive the car, she could, but the energy monitor screen that she has on usually was not coming on. Her concern while driving was that she could not tell how fast she was going.
Fortunately, just a week ago I had installed Scangauge II in her car and had her convert one of existing gauge to MPH. This is a new 2012 Prius IV that is about 2 months old. I'm pretty sure that MID can't be turned off.
Phaeton :: When Fuel Trip Data Information Resets To Zero?
When I fuel my car the the trip data information resets to zero, keeping track of when I last fueled my car, as it should. The problem is that if often resets back to zero even though I have not fueled my car.
View 8 RepliesPrius (2004-09) :: 2005 - Information Screen Isn't Working
The info screen on my 2005 Prius shows up black. When I push one of the buttons, it gradually goes to its normal brightness, stays that way for about 10 seconds, then goes black again. The buttons all work while its lighted.
View 3 RepliesPrius (2010-12) :: 2011 - Hybrid Information Screen Went Out
We bought our 2011 2 weeks ago today and the hybrid information screen went out. Is this happening alot and are those it is happening to experiencing any other problems? Taking it to the dealers tomorrow.
View 13 RepliesGolf IV R32 :: UM Tune - Failed To Get Control Unit Information From ECU
I am trying to run the UM tune on my ecu, getting an error "Failed to get control unit information from the ecu"
I do not have vag-com unfortunately but I don't believe it's currently flashed. If it's already flashed, I can still just over-write the current tune because it's just software from my understanding.
I have no blown fuses, I have already checked them all!
Prius Plug-in 2012-15 :: Multi-information Display Changes On Its Own?
Every day I stop at my mailbox to get the mail. I get out of the car with the FOB in my pocket and leave the car running. When I close the door the car beeps three times to let me know it's still on. This is exactly how my 2010 Prius operated. However, when I get back in the car the multi-information display always changes from the hybrid system indicator screen to the energy monitor screen. I always have the HSI on as default. This isn't a huge deal but it's kind of annoying. Is there a setting somewhere that I can change that I've missed?
View 6 Replies