Grand Prix :: 2002 How To Test The New Harness
I have an 2002 GT with a 3.8 in it. Two wires broke on my harness that plugs into the shift solenoid so it will not shift out of park.
I got a new harness and wired it how it was wired before but it is not working when I plug it back in. Is there a way to test the new harness to make sure it works?
Grand Prix :: 2001 SE 3.1 - Brake Pedal Goes To Floor / Fluid Low
I have a 2001 Grand Prix SE 3.1 that the brake pedal goes to the floor. I did notice the fluid was low , filled it up. I do not think it sucked air, although I can not be sure of that. As you can imagine, it is a beater so don't want to stick a ton of money in it. I had someone look at it that said he thought it was a "sensor" that would cost over 500 bucks. I don't know of any brake sensors at all. If there is, do they cost that much? If not would this be a master cylinder.
View 5 RepliesGrand Prix :: 2000 - Soft Brake Pedal Goes To An Inch Off The Floor
I have a 2000 Grand Prix 3.8 with 65,000 miles. Bought the car new for the wife to drive. The front brake lines rusted out. My wife has a friend who is a backyard mechanic. She had him replace the front brake lines, from the abs block to each front wheel. Well she finally told me that the brake pedal is not right. I went out and sure enough with pressure on the pedal it goes to an inch off the floor. I bled all for lines at each caliper, no change in pedal. I bled almost a full bottle of fluid. You can pump the pedal for 10 minutes and no change in the pedal. I don't think it is air in the line. I changed the pads and rotors on all four corners last fall. The brake pedal was normal then.
View 5 RepliesGrand Prix :: Theft Deterrent Service Light Keeps On
My 2004 grand prix gt2 theft deterrent service light is on. So far I have no problems with the car starting or runiing at this point.
View 1 RepliesGrand Prix :: SES Light Comes On Intermittently - Evap System?
Just found out I have a problem with my evap system (97 Grand Prix GTP). My SES light comes on intermittently. Not sure what the number of the code is, but my mechanic said it was because the vacuum was too strong (not a leak). He said could be from a kink or clogged hose. What this could be? Are the hoses and canister easily accessible for me to check?
View 10 RepliesFord Excursion :: 2002 7.3L - Wiring Harness For Brake Controller
I am going to be pulling a trailer next week. I bought a raybestos voyager XP controller. I expected it to be plug and play but what I got was four wires. I have heard that there is a plug ready under the dash to plug a controller into directly. I found a gray pigtail with male ends. Is this it? Should I take controller back and get one with the correct plug or is there a harness one can buy or is a stop to my local ford dealer in the future.
View 5 RepliesGrand Prix :: SES Light On / Small Emissions Leak - Code P0442
About a month ago I had my SES light go on and I took it to the auto parts store and they said it was a small emissions leak. I am not sure of the code though. I took my car to the shop and they said that a sensor that had something to do with the exhaust was bad or unplugged.
My SES light came back on about about a week ago and I had it tested and it said the same thing. "Small emissions leak" This time I got the code and its P0442. The shop is closed today and tomarrow so what and where the sensor is located? Or if its the same thing?
Grand Prix :: 2002 GT Started Then Died - Security Light Flashing
Having an issue with my 2002 GP GT. I started it, but then it died after a couple of seconds while the "Security" light was flashing.
I actually had both original keys with and tried each to no avail (same thing: starts, but engine kills after a few seconds). I checked the PassKey III fuse and even replaced it - still no luck.
Called two different dealer service departments and they suggested turning the key to the "ON" position and leaving it for 15 minutes. I tried this 3 times and still the same issue.
I understand this can be a VERY expensive repair as I've read it requires replacing the ignition module and perhaps the Theft Deterrent Module. How to at least temporarily by-pass or reset the system so I don't have to get it towed (of course it's no where near my place).
Grand Prix :: 2002 Pontiac - Gauges Flipping / Air Bag Light Flashing Now It Won't Start
2002 Grand Prix, 3.8L na motor, 187K miles. It was running perfectly until 4 days ago. initially, odd gauge stuff and flashing air bag light, then very, very slight engine skip with the tach gauge flipping around. 2 days ago, harder than usual starts ( a couple of seconds cranking instead of instant starts ), 1 day go, longer cranking in the morning, worse stuttering at highway speed. Afternoon, very hard start, stuttering right away, and then it would hardly start and quit after seconds. Gauges flipping and relays buzzing under the dash.
I had it towed home. Moving the key to run I didn't hear the fuel pump running. Checked the pressure at the rail, zero pressure. I removed the relay and jumped it to run the pump at high pressure. Fuel pump ran, pressure was 50-60lbs. Reinserted the relay, tried to start it and no change. I couldn't hear the pump running. Removed the relay and jumped the pump again, left it running and tried starting the car. Also no start.
I'm thinking it may have something to do with the ignition switch, PK3 system, BCM or PCM although I'm not sure which way to go with testing. I'm going to re-check the fuel pump and then start taking ignition switch out.
Ford 6.7L Power Stroke Diesel :: Cab Light Wiring Harness PN?
Need to know the Ford part number for cab light wiring harness? I am wanting to install some LED cab lights but I do not currently have any so I will need the wiring harness.
View 3 RepliesFord Super Duty (1999-2016) :: ABS Light On - Wiring Harness Damaged
I have been tracking down my ABS light and found that the left front wheel speed sensor has had the wiring harness ripped off from behind the front wheel. I have about 2ft of the harness coming off of the actual sensor.
Question is, since I cannot locate any wires that this seems to be able to be connected to, can I simply cut and splice these wires directly into the Tan/Black + Tan/Lt Green wires going straight to my ABS controller?
Ford Wiring/Electrical :: Moving Engine And Ignition System - Wiring Harness For Further Use?
I plan on moving the engine/drivetrain from my 1986 F350 460 to my 1996 F250. I also want to move over the 1986's ignition system with a Duraspark 2 setup.
Although I could just cut in the easiest places to remove the wiring for later reuse I am looking for where to make the cuts, what to take and what to scrap. Alternatively I am also asking if there are aftermarket or OEM replacement sets out there are aren't a ton of money. The current harness in the 1986 has been sprayed with engine oil and cooked for 27 years so I am looking at alternative options if there are any.
Ford 7.3L Power Stroke (1999-2003) :: 2001 F350 - Fog Light Wiring Harness
Where I can get the head light to fog light wiring harness..it is almost as hard as finding the holly grail..... 2001 f350 7.3 .......
View 9 RepliesGrand Prix :: Battery Won't Charge
I just bought a new 2001 Grand Prix. I am not completely car savvy, but I know a few things for a lady.
The battery won't hold a charge.
and the computer diagnostic tester thing says the Headlamp Relay is malfunctioning.
Ford Wiring/Electrical :: Different Color Wires In Cab - Brake Light Not Working - Wiring Diagram?
Need a wire diagram. I have a connector in the cab that has red,blue,lt green,white wires. It's causing my brake lights not to work. I need a wire diagram that shows were they go. I can't find these wires in my Haynes manual.
View 3 Replies95 Grand Prix Ignition Cylinder - Cannot Turn Key
I have a 95 Grand Prix 3.1L and I can't turn my key. You can put it in and take it out, but it won't turn whatsoever. It's stuck in my driveway and I've tried just about everything to get it to turn.
View 1 RepliesGrand Prix :: 99 GTP - How To Lift / Hoist Engine Out
I'm pulling the engine to overhaul. I've borrowed a hoist and think I'm ready to lift the engine out, but I don't know how to strap the engine to the hoist. I first thought of using the brackets with the eyelets bolted to each head and bought chain and hooks. But I had to remove the rear bracket so I could remove the rear exhaust manifold so I could remove that darn rear engine-transaxle bolt. (That really bites because I want to have the exhaust manifolds on when dropping it back in.)
Are those brackets intended for lifting the engine? If so, I could reinstall the back bracket and give it a go.
Searched the internet for info but didn't find much. Did find a 3800 being lifted with two straps completely under the engine.
Also, the engine-transaxle joint hasn't cracked open yet. I'm guessing it's because they're stuck after 198k miles and will eventually separate. But I did not find one of the engine-transaxle bolts mentioned in the 98 FSM: front lower (#1). I don't see how I could have missed it ; maybe the 99 doesn't have it?
Grand Prix :: 2005 GT Transmission Was Slipping
Thought my transmission was slipping. So I changed the tanny. been driving it for a few days and now it doing the same thing. Is it possible that it a different problem with the same symptoms?
View 4 RepliesGrand Prix :: 2002 Pontiac - When Turn Off The Car Key Only Goes To Acc
When I turn the car off the key only goes to acc. If I wait a few minutes I can hear a clicking sound coming from the steering column I think. Then I can turn it off all the way.Whats causing this? and how do i fix it. My car is a pontiac Grand Prix 2002.
View 2 Replies