Golf VI R :: 2012 - Clutch Slipping In 5th Gear?
I have a 2012 Golf R 6 Speed manual, Just noticed that my clutch was Slipping in fifth gear when I give it gas. What clutch kit is recommended. It is the first time I have a VW and dont really know what will work better on it. Mods are Full catless downpipe and exhaust, Injen air intake and Revo stage 2 tune, ST Coilovers and NICHE Bronze wheels. Podi boost gauge and AEM wideband. I put down 285hp and 310TQ at Dyno jet 2 weeks ago I was kind of suprise expected a bit more but maybe the clutch was going bad already.
View 1 RepliesGolf/GTI VI :: 2012 - Shifter Squeaking When Changing Gear?
It happens when there's side to side movement or any gear change. I've tried spray/grease nothing seems to be working. I've read on other forums people replace everything under the boot only to have it return in a few months. I would really like to have this this squeaking gone. Cars a 2012 GTI
View 13 RepliesGolf/GTI VI :: 2012 Manual - Fluttering Vibration Noise In 5th Or 6th Gear On The Highway
New to the board- sold my b6 passat for '12 GTI manual.
Its been a few years since i've owned a stick so I'm not sure if this noise is normal or just because the car as 100 miles on it OR just because I'm a freak when it comes to hearing every little noise.
But when i'm say in 5th or 6th gear on the highway and give it some gas I hears some noise like a fluttering vibration noise for a second or two and then it goes away? It sounds like its coming from right underneath me. Its not a huge deal but on my first brand new car, I'd rather just have someone tell me its normal or if it needs to be fixed or a bolt tightened or something.
Prius (Gen 1) :: 2001 - Car Stalls When Put It In Gear
I have a Prius 1st gen and I just started having this problem yesterday. I started the car and the warning lights came on but the engine started. Then I put it into gear and the car stalled, engine shut down completely. Then I put it back into park and the engine started up again. So I put it into drive again and the engine shut down again, put it back into park and the engine started up. So I turned off the car and waited several minutes, started the car and put it into drive gear and was able to drive it to a mechanic. He said they couldn't get a code reading on it.
View 6 RepliesChevrolet :: 1956 - Stalls When Put In Gear - Repair?
I have a 1956 Chevy Bel-Air that has been in my family since purchased new. It stalls when I put it in gear (reverse, to be precise). Any thoughts as to why? And, what can I do to repair it?
View 13 RepliesSuburban :: Engine Stutters And Sometime Stalls Only In 3rd And 4th Gear
I have a problem I have been struggling with for the last year.... Here are the main symptoms:
- Engine stutters and sometime stalls ONLY in 3rd and 4th gear
- 1st and 2nd gear has NEVER given us a problem
- The outside temperature has to be above 75 degrees. The truck ran great all winter, but last week with the first warm day, acted up again
- There has to be a sizable load (6 adults, full tank of gas)
- gets much worse going up hills (again load)
Not sure if it is related but one time in the winter, the truck stopped blowing heat. If I turned off the fan, the system would "build up" heat but then as soon as I turned it back on, the heat would stay for maybe 30 seconds and then fizzle out back to cold air. This happened only on the coldest day of the year. The heat has been decent the rest of the time.
Last year they replaced the crankshaft position sensor like 4 times, then claimed it was the ECM, replaced that and it still acted up. Then they finally said it was some corrosion in the wiring harness. However by the time they got through with it, it got cold enough outside where it didn't act up any more.
Ford Aerostar :: 1991 - Stalls When Put In Gear
My engine stalls when cold or warm, when put in gear or idling in gear at a stop. If I left foot break and give a little gas I can usually keep it going. I ran 2 bottles of fuel injector cleaner through, but no dice. Could the fuel filter need to be replaced? If so, where is it located? 1991 Aerostar 3.0 Auto RWD
View 14 RepliesCamry 2012+ :: SE L4 Stalls After Disconnecting Battery?
I just bought a '12 Camry SE I4 about 6 months ago. It stalls at first startup after disconnecting and reconnecting the battery. After the first start and stall it will start normally. A pending code will come up P1604 'Startability Malfunction.' The code doesn't have a real definition other than the engine failed to start. It has a new AGM battery, serpentine belt, and the alternator passed a bench test. Had this problem with the 2.5L I4 or the 3.5L V6? Is this normal?
View 8 RepliesElantra XD (2001-06) :: Each Gear Catches On Something And Stalls After MTX Replaced
I replaced the MTX transmission, and while cleaning off the rotors of oil, I let the one side spin while in first gear. I put the wheels back on and started to back out of the driveway. It seemed as if I was rolling into something as it wanted to stop moving backwards. I then put the front of the car back on jackstands and tried to move through the gears. While in 1st or reverse, the car begins to engage and then acts as if it is grabbing gears and will stall. The car does not want to move. I then went outside with the car off and tried to spin the wheels in neutral. One wheel spins one way, the other spins another. I tried to put the car in reverse and it starts to move the tires, then catches on something and stalls. Then, the shifter is stuck in reverse and I have to work to get it out.
View 4 RepliesFord - Mountaineer :: 1999 4.0 5r55e Stalls When Put In Gear
I'm having a hell of a time with my mountaineer. Reverse went out so I put a tranny in it. It was junk. Got another and it worked fine. Drove it to get gas then home. Woke up this morning to go to work and it stalls out when put in reverse or drive. I broke the o2 sensor when putting the tranny in so bought a new one hoping it would solve the problem and no luck.
View 11 RepliesFord F-150 (2004-2008) :: Low Idle When Put In Gear And Sometimes Stalls
I changed the plugs on my 2004 F-150 FX4 with 165,000 miles. Immediately afterwards I experienced a low idle problem. After engine warms up, idle is at about 400 rpm in nuetral or park. When I put in gear it drops to 200 rpm and sometimes stalls. Ford analyzer says misfire #8 cylinder. I swapped coils with #7 and reset fault. #8 cylinder misfire came back. So next I put new plug in #8 thinking the plug was bad. Still have low idle problem. What I should try next?
View 3 RepliesFord Ranger / B-Series :: 2003 XLT Stalls When Put It Into Gear
2003. Ranger xlt with the 4.0.... So I just bought this truck and was informed that the vacuum might not be functioning correctly. And here's the symptoms. It idles a little rough, nothing major. When I put the truck into gear either drive or reverse, it stalls out almost every time unless I give it some gas and hold the brake. But after that I could drive it all day with out a problem, as long as I don't put it into park. And last it starts a little hard. But the damn thing runs great while driving it. It's still very snappy even having high miles.
View 4 RepliesTiguan :: 2012 2.0 TDi Misfire And Sputters Then Stalls On Startup
I have recently purchased a 2012 facelift Tiguan diesel and it has a running fault. When starting the engine, 50% of the time it starts fine, 50% of the time it starts with a "misfire" and sputters for a short while (5-6 seconds) then stalls. If you Rev it a bit while it is sputtering then it clears the sputter and doesn't stall. It doesn't matter if it's hot or cold. Once it's running fine then the misfire never returns until you shut off the engine and then try to restart. The start stop also fails to cut in and I'm wondering if this could be linked. It had a new battery and alternator fitted a few months ago but a non start stop battery was fitted. This has now been changed for the correct battery but both problems still persist.
View 2 RepliesLumina :: 1994 Chevy 3.1 Stalls When Put In Gear While Engine Warm
A week ago, driving home, the tech started to drop quickly to zero then recover, like the ignition was turned off and then back on. I was able to make it home. The car was due a tune up. I replaced the crank position sensor (OEM), replaced sparkplugs (Autolite Iridium), air filter, fuel filter, no luck. I ohmed the coil packs, secondary resistance showed good, replaced the ignition control module (aftermarket). After this, engine would stall after it was at temp, could restart, once put in gear it would stall, but I could go in reverse and drive home backwards.
Reinstalled original OEM ignition control module. Towed to GM Dealership, mechanic said fuel pump was bad, ignition wires needed replaced, one injector ohmed bad. I took car home, replaced fuel pump (OEM), ignition wires (OEM), no luck. Removed plenum, found pcv valve clogged, and hose kinked, replaced both, ohmed all 6 injectors, 5 injectors read 12.3 ohms, 1 injector was 11.6. Replaced all 6 injectors, (Napa), plenum gasket, still same problem.
GM dealership said computer said no data, they though perhaps ignition control module was bad, but I don't think so. I hooked up my Actron shorting plug, reads code 12 which means no faults, no other codes. I noticed EGR valve has a lot of carbon in the hole, thought about changing it, but I'm really not sure where to go now. The car is a 1994 Chevy Lumina with 230,000 miles, spent about $500 the last week doing brakes, and trying to fix this engine. Where to go from here.
Honda - Cr-v :: 2000 Stalls When Engine Is Cold And Shift Into Gear
My 2000 Honda CRV starts when cold, however I must continue to give it gas and it will die when I shift into Reverse or Drive. If I rev the engine, I can keep it running and it will run OK once warmed up. When I get it going, the engine will stall if I attempt to let it idle. All problems resolve themselves once the engine is warm. Several mechanics have seen the problem, but cannot determine a solution other than to let the engine warm up. I live in Boston and the combination of having to work my way out of a parking space and the enginge continously stalling when I shift into R or D is making life difficult?
View 5 RepliesHonda - Cr-v :: 2001 Stalls Almost When In Gear Or Even When RPMs Fall To Idle
Have a 2001 CRV that is running really bad. It almost stalls when I put it in gear or even when the RPM's fall to idle. It is now throwing a p0172 code. I have a simple scan tool and verified the MAP reading and primary O2 voltages as suggested by the manual, both appeared to be normal. It seems all the symptoms point to valve clearance, however the valve were adjusted not 2000 miles ago by the dealer during the 150K service, and this issue has existed before and after that adjustment. I also cleaned the IAC screen with no changes.
View 5 RepliesFord F-150 - 1997-2003 :: Truck Stalls Out In Gear But Not In Park
I had what I was told was the breather (on the drivers side valve cover) snap off. I was able to place a piece of tubing In it and reconnect it. I had to change the #7 cylinder spark plug wire. Got a misfire code and found the wire was loose and corroded. Replaced wire and PVC valve.
My problem is, it seems not to be idling as fast as it was before this happened. The truck stalls out now in gear but not in park. 1997 F150 4.6 ....
Accent RB (2012+) :: 2013 GLS Manual Stalls In Cold Weather
She's got a 2013 RB GLS.
In very cold weather, we're talking around -15c (5f) or colder the car has serious trouble going into first gear or any gear.
The car starts fine, we even have let it warm up so the engine temp is fully warmed up.
As soon as we put the car into first and release the clutch, the car immediately stalls. It's also difficult to get into first gear, as it's locked out and takes repeated attempts to get into first, just to have it stall when the clutch is released.
Civic - Honda :: 2012 - Stalls / Hesitation When Slowing And Turning
I have a 2012 Honda Civic, with only 4500 miles on it. When slowing and turning i have a hesitation. It does this about 6 out of 10 times. When pulling into traffic, this can be scary. I have asked the dealer about said problem, but told it's just because its new and will get better when i get some miles on it. No way do i believe that. Not sure where to turn. I might add this is an automatic transmission.
View 7 Replies