Golf IV / Jetta IV :: Side Markers Does Not Turn On

I tried putting the bulbs from the side repeaters located on the fender to the sidemarker on the bumper and the bumper sidemarker still does not turn on. I am also getting no voltage readings. Is there a specific fuse I might need to replace?

View 4 Replies

Golf V R32 :: Front Side Markers Suppose To Light Up?

Just got my R32, used. I noticed that the previous owner had replaced the front side markers with clear ones. I checked that there are no bulbs inside, and they don't light up. Are they suppose to light up?

View 13 Replies

Golf V R32 :: Wiring For Side Markers And Outside Temperature Sensor

I just got a R32, but its missing the wiring for the side markers as well as the outside temperature sensor. My assumption is that both are in the same wiring harness and that harness starts at the corner of the radiator on the drivers side of the car.

View 24 Replies

Passat (B5) :: Driver Side Lights Partially Out - Both Side Markers / Rear And Front Bulbs

1 week ago I changed low beam bulbs(one was out).

1 week ago $2 tire pressure gauge fell through the slots on the left side of the trunk inside, I have tried to reach it, but to no avail(touched wires, which goes to the rear/stops driver's side several times).

Today I noticed one of my side markers was not working, I turned on lights, tried to change bulb in it and as of now neither marker nor left front light(that small upper bulb in bigger bulb slot) nor rear lights work.

Low and high beam are ok on both sides.

View 1 Replies

Golf/GTI VI :: Clear Or Smoked Side Marker

I have a 2013 UGM GTI. The amber side markers are really starting to bother me. I've looked at ECS Tunings side markers (clear and smoked) but they show them on a white car. Which would look better on a medium gray car like mine?

View 17 Replies

Lexus SC430 :: 2004 - No Fog Lights Or Front Side Markers

Just bought a 2004 SC to go with our '07. Noticed the fog lights and front side markers are not working. Checked the fuse and it is ok.

View 9 Replies

Ford Super Duty (1999-2016) :: Headlamp Side Markers Not Working

I recently installed LEDs on my 2011 Super Duty and also had the dealership turn off the build out indicator. Now I have noticed that the Headlamp Side markers are not working.

View 6 Replies

Golf/GTI VI :: How To Remove Rear Bumper Markers

The red ones that are in the rear bumper, Do I have to take off the whole bumper?

View 22 Replies

Golf/GTI VII :: Squeaking Noise From Driver Side When Go Over Bumps After VWR Spring Install

Instead a set of VWR springs yesterday on my GTI. Initially driving it, everything seemed fine. After about 20 miles and taking an off ramp aggressively, I noticed a squeaking noise from my drivers side when I go over bumps. I cannot pin point what may be causing it.

View 11 Replies

Golf/GTI VI :: 2010 - Unable To Remove Rear Side Headrest In Order To Install Child Seat

I have a 2010 4 door GTI. I'd like to install my daughter's front facing Britax child seat either in the rear right or rear central position. However, in either case, I'm finding that most of the rear weight ends up on the headrest and I would like to simply remove the headrest from that seating position.

I read in the user manual that to remove the headrest,I pull it to it's highest position and then push the button on the right side of the plastic entrance of the head rest into the seat, and 'simply' pull the headrest vertical out of the seat.

This is similar to how this was done in other cars I've owned. However it is not working for me with the GTI. Once I pull the headrest to the highest possible position I can get to, I press the button but the headrest simply refuses to come out. I've tried this on the other rear seat and same problem. With the middle rear seat I can't seem to pull the headrest out beyond its lowest position.

View 4 Replies

Ford - Explorer :: 2002 - Windshield And Side Windows Taking Forever To Clear Up When Foggy

I got an 02 explorer xlt with the manual heater control and I've noticed now that it's getting colder it seems like my windshield and side windows are taking forever to clear up when they are foggy. When I put my hand up by the window or the vents for the driver/passenger side windows there's barely any air movement, and that is even when the blower is on the maximum level.

Another thing I've noticed is if I set it to floor only, it blows out the defrost. Same for the defrost only, I can feel some air blowing onto my feet. So what to look for when I pull this into a garage and start to looking around. I also changed the coolant and put in a new thermostat about a month ago, if that's of any importance.

View 5 Replies

Golf IV R32 :: Some Clear Liquid Is Leaking

Just noticed this the past couple of days. Something is leaking. Its a clear liquid and has a slight oily texture.

View 10 Replies

Golf IV / Jetta IV :: 2005 - ABS Light Is On - Can't Clear The Code

I have an 05 GLI with many mods, far from stock. In the past i have tried to recode the ABS module with my vag com to ABS only because the traction control does not work when you make 300whp and im sick of pushing the button every time i get in the car. The module will not take the recode so i gave up. Then about a week ago the ABS light came on for no reason and i can not turn off the traction control with the esp button so i checked the code.

It said something about a system test (ill have to check it tomorrow to find out what the code was) i tried to clear it and it would come right back with no other codes. Then i took the car out and beat on it and the traction control still works (or trys to) and i hammered on the brakes and the ABS still works and the fluid is still full. Then i came to red light and i after i stopped i pushed the brake petal hard and the traction control light started flashing (im still stopped and not moving at all) It just kept flashing for over a minute even after i started driving. Then the tc light stayed on and the ABS light went off. As soon as i turned the car off and back on it was ABS light on and tc light off. Still only the same code stored. I tried recoding it to a car with ABS, ESP, and HD suspension and it took that coding. But still had the same code so i recoded it back to my oem one.

View 24 Replies

Golf/GTI VI :: How To Clear Service Required Indicator On Startup

Any way to clear the "service required" indicator that pops up when you first start the car?

View 2 Replies

Golf V R32 :: Should Have Spacer To Clear Brakes And Prevent Rubbing?

Just picked up some VMR V701 18X8.5 with a 45 Offset in Gunmetal. Do I need Spacers to clear the brakes and prevent rubbing for the front and/or rear? If so, how many mm?

View 4 Replies

Golf/GTI VII :: How To Install VER Spring

I'm having trouble getting the strut back through the steering knuckle. I used the 1/4 ratchet to spread it and get the strut out but I can't get the strut to go back after installing the VWR spring. I've tried speaking with many tools now and it's just so damn stuck. I hope I haven't damaged anything by hammering a wedge into the point where the ratchet is supposed to spread it. After a couple of tries the ratchet doesn't seem to spread it at all.

View 2 Replies

Golf/GTI VI :: Misfire On Cylinder 4 After APR Install

I had my car tuned over the weekend with apr stage 1. As soon as I went to start the car to leave I started getting a misfire on cylinder 4. We have tried swapping coils around and re-flashing the ecu with no luck.

Details on the car : 2010 GTI 6spd 21,000 miles

View 24 Replies

Golf V R32 :: How To Get Rid Of Bulb Out Warning After LED Install

I recently installed the LED euro tail lights with out swapping pins, or any ghetto harnesses. i simply installed my tail lights with the oem harness. Anyways, after i installed the lights, the bulb out warning came on, i got rid of it, but when i press the brakes it triggers the warning light to appear after i vagcomed it to go away. so what is the coding to get rid of it?

View 2 Replies

Golf V R32 :: Alignment After Spring Install Necessary?

Is an alignment after a spring install necessary?

Getting my H&R springs installed tomorrow and was curious

[URL]

View 4 Replies