Golf V R32 :: P000A Powertrain Code - Intake (A) Cam Position Sensor Slow Response

I've tried to do my due diligence searching on this (I've seen many posts but most have other codes).. I have the P000A code, reads as follows-- Intake (A) Cam Position Sensor Slow Response (powertrain).

I have no misfires, hesitation rough idle, nothing. I have 94k miles and I always done my oil changes @ 5k intervals and I have not had any prior engine maintenance done to the car....

I took my R32 to the local VW dealer today and they are saying they believe it might be the time chain tensioners. I am wonder if this could be a simple sensor issue since the car runs perfectly fine, I just get the engine light coming back on after 1 to 2 weeks of clearing the code. I have had this issue since January and I thought it might be the cold weather here in WI.

View 2 Replies

Golf VI R :: Got Code P000A - Hole In CAI

I opened my hood 6 days ago to look at a possible cel issue throwing code P000A, ever thing was fine. Today I opened my hood for another reason and found my CAI had a hole in it. The pylon that has the screw that mounts to the engine tore out. No large part flew into the turbo

View 24 Replies

Golf IV R32 :: Fault Code P0606 - Powertrain / Engine Control Module?

The code the R threw was p0606 which is the Powertrain/ Engine control module? Where these components are in my R? Or how I can go about trouble shooting this problem?

View 9 Replies

Golf/GTI VI :: P1628 - Steering Angle Sensor Code / 18036 - Powertrain Data Bus Comes On

2012 GTI. DSG My airbag was blows, so I replaced it. Now im getting the following code.

18036 - Powertrain Data Bus

P1628 - 000 - Missing Message from Steering Angle Sensor

Can the sensor go bad after the airbag was blown? All the steering wheel controls still work.

View 4 Replies

Avalon 2005-12 :: CEL Error Code P0440 Error Code / Charcoal Canister Replacement

So of course it has to happen 3 weeks after my warranty expires. My CEL comes on and I have it read and the result is P0440. I find out that my wife has a habit of topping off the gas tank and so I am thinking that she has probably ruined the charcoal canister. It is something easy to replace?

I have an 06 limited edition... Yes, she will not be topping off any gas tank anymore.

View 2 Replies

Golf/GTI VI :: CEL Along With The Error Code P2187

I am getting a CEL and the error code is p2187 engine too lean at idle. I have been reading around to try and find the issue, some seem to say PCV could be the issue. I have also read a test would be try and remove the oil cap while car is idling. I did this test and the oil cap was difficult to remove and the idle got really rough once removed.

View 2 Replies

Golf IV R32 :: P0601 Error Code - Need New ECU?

My r is throwing a p0601 sum error. I clear, it comes right back. I know the previous owner has it chipped at a garage that wasn't linked to any brand. I was planning on putting an apr/giac tune over it but now I can't (no money). I know this might mean I need a new ecu. Right now I plan on going to vw on monday and having them reflash the ecu bringing it back to stock...if it returns then i guess i need a new ecu... This sound right?

View 5 Replies

Golf/GTI VI :: System Error Code When Hit About 115 Mph?

I've got a golf tdi with a tune and straight pipe exhaust, and after I hit about 115mph I get a system error code. When I shut of my car, it dissapears and when I try to find it with a code reader, its no where to be found. What's the cause?

View 6 Replies

Golf V R32 :: Getting Error Code P0480?

Yesterday i took 300 miles trip to VA and my engine light when on. turn out it was p0480 code. I had check online and find out it was a cooling fan malfunction. I want to know any1 else have the same problem? also is this DIY problem? or should i bring it to the stealership?

View 2 Replies

Golf V R32 :: P0160 - O2 Error Code Detected

My r32 mk5 is throwing that code.

I replaced new o2 sensor with oem new one.post cat on driver side.

I have erased dtc and drove 15 miles dtc came back again.

Now i have replaced catalysator on driver side and same thing again.

View 2 Replies

Golf IV R32 :: Error Code, P0353 Pulled Over

I threw a code and I have it but I am unsure what to do.

The code is P0353

"Ignition Coil C Primary/Secondary Circuit"

I saw that this might be the coil, the wiring or the ground? I had my coils go on my 1.8t Jetta and that was pretty distinct as the car ran like crap.

The car seems to run fine, I have had the code for 2 days. It went off this morning and it came on again this afternoon.

View 3 Replies

Golf/GTI VI :: 2011 - Got CEL And Error Code P2015?

Soild CEL, autozone pulled a P2015 code, but couldnt find it for VW in their system, just hyundai, toyota, dodge, and kia codes came up.

Looked around and everywhere says it's the notorious MKVI IM replacement issue.. Im under PT warranty until Nov. '15 so im good there.

Heres the catch.. sometimes it goes off without any changes to the vehicle. First thing (before the obd2 reader from autozone) i checked was my gas cap, that will cause a CEL sometimes, next time I started the car the CEL was off. the next day, without touching the gas cap since, the CEL was on again, today its off

car idles fine, drives fine, MPG are fine, pulls fine, stops fine, steers fine, everything works in the car. year: 2011

View 2 Replies

Golf IV / Jetta IV :: Got Error Code P0107?

So finally got past the smog cert issue and a bad map sensor in the intercooler. However, during the smog test, I was informed I am getting low air pressure in the intake! What causes this? A bad MAF? a leak? I have replaced the EGR, and all rubber that connects hard pipes. The only piece not changed out during the rebuild is the plastic flex line from the airfilter box to the turbo intake.

View 2 Replies

Golf IV R32 :: Airbag Light Went On - Error Code 00592

My airbag light went on so i scanned for codes and I got:

00592-seatbelt switch:right (e25) 32-00-resistance too high.

What I need to do to fix this and make the light go away?

View 4 Replies

Golf IV / Jetta IV :: Code P0021 - Cam Timing Error

When checking my check engine light , I got P0021 a cam timing error, but my mk4 Gti runs perfectly ??

View 4 Replies

Golf V R32 :: Engine Error Code 000372 And P0174

1 Fault Found:

000372 - Fuel Trim; Bank 2

P0174 - 001 - System Too Lean - Intermittent

Freeze Frame:

Fault Status: 00100001

Fault Priority: 0

Fault Frequency: 3

Mileage: 136626 km

View 5 Replies

Golf/GTI VII :: Start System Faulty Error Code

Last month, I started my gti up and a "Start System Faulty" code appeared. The car started normal and drove perfectly fine.

I immediately took it in to the dealership and they could not diagnose the problem or turn off the damn warning! They released my car and said to come back in a few weeks.

So, two days later, the warning disappeared and I thought it was just an electrical glitch.

Fast-forward to last week, the warning light came back on and took it in again. I suggested that they take a look at the ignition switch and sure enough, they fixed it for me over the weekend by installing a new ignition switch and the problem is gone.

View 2 Replies

Golf IV / Jetta IV :: Error Code - Car Stuck In 3rd Gear

Damn car is stuck in 3rd gear! Hooked up scanner and the screen just says error! I have to keep the scanner in the vehicle, hooked up, just to drive the car. That's just so it'll shift as its supposed to! Now it's not letting me pull the code out, in order for me to erase it! It just keeps saying "error".

View 1 Replies

Golf IV / Jetta IV :: Getting Error Code P0420 Intermittently?

I keep getting the error code P0420. Cat below threshold.

I have replace both the front and rear O2 sensors and we reset the check engine light. While driving through the cycles to reset the sensors for them to be ready for DEQ, the check engine light came on again.

I am about ready to buy the Cat Converter, but it is really expensive and if there are any other things that I can try before replacing the Cat I would like to try that first. Any other issues associated with that code, or should I just replace the Cat Converter as my next step.

View 23 Replies