Golf IV / Jetta IV :: Popping Slightly At Idle Occasionally
So I just noticed now that my car is popping slightly at idle occasionally...It doesn't do it all the time and the idle is kinda lumpy but always holds at 800-900. Sometimes it drops a bit lower.
Also when starting it up in the morning, or when the engine is cold it doesnt rev up to 1500rpms it just starts and immediately drops to 800-900??
When I press on the gas and keep the pedal at one spot, say 2000rpms, it slowly drops down to 1500??
Golf IV R32 :: Slightly Raising Idle Speed?
Is it possible to slightly raise the Idle speed of our R32s?
And if so, how is it done?
Is there a procedure with Vagcom?
Golf IV R32 :: Idle Too High And Shudders Slightly?
So my cars idle has been revving slightly from 9 to 10. siting idle sometimes it will do the same but from 10-11. when it does it shudders the car slightly.
So I stop by a local auto parts and get the check engine scanned.....it comes back as Idle control too high.
So What is that? The guy working there who seems to have some knowledge of turbos said it was either some control piece or a vacuum leak.
Golf/GTI VI :: Rough Idle / Slightly Misfire / Burning Oil
This is my first new car, but I am assuming the idle should be pretty smooth. I feel my idle and it feels sort of rough. Almost like there is a slight misfire but not that intense.
One more question, car burning oil?
@ 7500 miles I was down a little more than a quart and now @ 14,100 I am down almost a quart. That is slightly alarming.
Golf VI R :: Weird Drop To 500 In Idle While Coming To A Stop
I have had my golf R for 7 months now and ever sense I got tuned I have had this little issue. Besides this the car is amazing but ever now and then the car while coming to a stop and put it in natural to come to a stop the idle will go to 500 then come back up to 1200 then rest at 800. I'm getting my PCV replaced tomorrow. I'm um stage 2 tune fully loaded with Bsh intake full 3" exhaust.
View 4 RepliesGolf IV / Jetta IV :: Infrequent Popping Noise At Idle
I can't figure out what this popping noise is that is coming from under the car (towards the back, not from engine). Its infrequent and I only notice it at idle. If I had to guess it would be exhaust related, but that still doesn't sound right. What could it be? See the video below for the sound I am talking about.
View 2 RepliesGolf IV R32 :: Cold Start As It Should - High Idle Then A Gradual Drop
I picked up my latest R back in April - 3 owner, 33K mile car - as far as I know no tune. The previous owner owned the car for the previous 9 years and kept it stock.
The issue: If the car sits for more than one day (I work form home so this happens a lot) upon initial start up it will start and idle at 800 RPM and then drop a little from there once warmed up. Now if the car sits for less than a day, it will cold start as it should - high idle then a gradual drop.
Golf IV / Jetta IV :: 1.8t - Headlights Dim With The Idle Drop / Battery Light Is On
So recently my water pump failed so i did the pump, timing belt, and thermostat. While putting the alternator back in a may have broken a few fins on the alt. case. Anyways I was ripping it a bit today only a day after stuff done and the battery light came on. The car is warmed up and the idle drop a few hundred rpm and then back up. The headlights dim as well. and come back up with rpm. Even when I hod the pedal steady at 2k rpm itll still dip and come back up...thinking its an alt but is that really a symptom of a bad alt? I was also thinking I didn't tighten the alt bolt down alt the way or fuses or something so checking that but I am almost positive it's all tight down.
View 9 RepliesVan - Chevrolet :: 1994 - Gauges Drop Slightly When Turn On Anything Electrical
I travel and often live in a 94 chevy g20 3/4 ton van. Today I started it up and the electrical was flipping out, I got to the end of the road and I smelled electrical smoke and the van died.
I opened up the hood and the piece of wood that I usually wedge between the battery terminals and the metal frame of the van (the battery is very poorly placed and slides around) had slid out of place and the positive terminal had melted a bit and fused to the frame.
After I got it unstuck, I got a jump and it started right back up fine, but now when I turn on anything electrical my gauges drop slightly for a moment and my gear wont shift from low gear (it's an automatic transmission). This definitely won't do...
GTI 337/20th Anniversary :: Boost Drop After Popping Noise When Driving
Was driving when I heard a pop n my boost dropped. Normally run 17 psi but my boost gauge is now only reading it's pushing 4psi. There is no smoke coming out my exhaust or anything, when I had it scanned it read it was a bad pressure sensor in the inter cooler so I replaced the sensor cleared the code took it for a drive n the same thing happened...check engine light came back on n still running like crap.
View 5 RepliesFord Ranger / B-Series :: 2006 - Low Humming Sound And Brake Pedal Momentarily Drop Back Just Slightly When Going Downhill
I recently bought a 2006 Ranger with supposedly 110000 miles... I don't think I made a good deal... because I found the stabilizer end link in terrible shape which seems suspicious for this mileage in my personal opinion!? But this isn't the reason I am posting today... I have a serious breaking issue and I couldn't find explanation yet.
My ABS Light is on. When I slowly brake at low speed and when the brake is almost completely depressed... I hear a low humming sound, and the brake pedal seems to momentarily drop back just slightly. This also happens when I'm going down hill and breaking. For the most part, the car breaks, and it's only every 8th or 10th time braking that I experience this issue.
My guess is this is linked to the ABS... but I can't afford expensive service and need to resolve this on my own.
Passat (B5) :: Car Shudders Slightly And Goes Back To Idle
When I'm driving and i let off the gas and come to a stop, my car dips close to 200rpm below idle and shudders slightly and goes back to idle.
My car just doesn't seem to have the amount of power that it should. My roommate has a 1.8t jetta with just a few more mods than I do and his car seems so much faster. I put an APR chip in my car and i still have a lag in the throttle..my car jerks..and it just doesn't seem that my car has the right amount of power.
Passat (B5) :: 2003 W8 Slightly Bumpy Idle
My '03 W8 with 22,000 miles on it has had a slightly bumpy idle since I got it, the dealer has told me that this is not a big deal. This afternoon, however, I noticed that the idle has suddenly become much rougher, though it has not thrown a CEL. The idle is noticably rough at speeds below 10 mph and while it is fully stopped (in Drive, Neutral, and Park). I just picked my car up from the dealer this afternoon after it had a window control module replaced, and now it looks like I am going to have to go back to the dealer. I know that they are going to give me the run around and try and convince me that nothing is wrong with my car, but the idle is rough enough to shake the whole car and it sounds as if there is a new (or louder) noise coming from under the hood (other than the valvetrain noise). I suspect that this might be the clogged oil screen issue, but I really don't know what to do.
View 11 RepliesCamry :: 2002 - Car Rough-ish Idle And Jerks Slightly In Low RPM
I changed all of the brakes on her car yesterday, test drove it, everything was great. Put close to 100 miles on it w/ no issues. Therefore, I don't think it's anything I did.on her way to work, the CEL came on. The car has a rough-ish idle, and jerks slightly in low RPM. I went to Pep Boys and got it read. it threw 8 codes:
P0171
P1130
P0300
P0301
P0303
P0305
P0442
From what i've read, the p0171 is the system is running too lean and p0442 is a leak somewhere. The 300s are cyl misfires.I don't want to go replacing every conceivable part. What these codes mean in conjunction?
Tiguan :: 2010 - Hesitate A Little Bit And Jump Slightly When Idle
My check engine light came on around 2 weeks ago, had the code checked, it read P0302. Noticed it started to hesitate a little bit and would jump slightly when idle. About a week after that I had a friend, (who used to be a mechanic at Lexus and for the Army) switch the coil on cylinder 2 to 3, then the code moved to the 3 cylinders. The next day the CEL started flashing this time, checked the code again and it was back to P0302, switched all the sparks plugs.
CEL was cleared and hasn't come back but I know something is wrong..but the car still loses powers when driving and jerks/misfires when the car is first started up but after it runs for about 5 mins or so, it doesn't do it anymore while sitting idle. I have a rental car right now and will take it soon, just really swamped with work. I'm just fearing the worst until I get time to get it into a mechanic.. and just hoping to hear something less dreadful than a repair... that's why I did the minor things first, my friend thinks it may be a more serious issue. The report from AutoZone (the second time I got the code scanned) said this. But this is not 100% accurate correct?
Vacuum Leak on Engine, Probable Cause, Ignition system fault, Fuel Injector Fault, Engine Mechanical condition
Elantra GD (2013+) :: Slightly Rough Idle During The First Few Miles
I have a 14 GT base with manual and I've been noticing at idle (sitting at stop lights...foot on or off brake and or clutch...in or out of gear) it has a bit of a rough idle or stumble during the first mile or two...then its fine. It doesn't feel like it will stall and if I tap the gas I do not notice any difference in throttle response. RPM needle stays steady... is the just something that is normal? It doesn't bother me a lot... just noticeable. All that aside, except the occasional lifter noise at cold start (not always...which is odd) all is good.
View 6 RepliesLexus IS 2014+ :: Slightly Rough Idle On Cold Starts
Owner of a 2014 350 fsport here.... 15,000 miles ... I noticed on cold starts a slightly rough idle since its gotten colder here recently. After starting the car it'll start fine and everything but then as its warming up the needle sometimes jumps 75-100 rpm. its like someone tapped their foot on the accelerator and let off. no lights or anything and the car runs fine.
Heres the catch... i have a joe z catback and joe z intake with fsport filter, could this possibly be why? because of the airflow ? i also have been using Lucas fuel injector cleaner and lubricant.
Also when i put the car in park after driving, i notice the needle isn't steady, it does move a little maybe 20-50rpm, not sure if this is normal or not because i never really paid attention until now.
Elantra MD (2010-15) :: Slightly Rough Idle At Stop Lights
My 2011 Elantra has a slightly rough idle at stop lights. It doesn't happen ever time, and some people probably wouldn't even notice it, but at every few/several stops it idles a bit rough. When I recently had it in to Hyundai service for the ECM update, I asked them to take a look at it. Of course, they couldn't replicate it at the time, so they couldn't do anything to address it directly. The service manager asked if it happens when the A/C is on or off. While I didn't know the answer at the time, it seems to happen with it both on or off. He did say that the ECM update may address/fix the issue, but unfortunately it didn't. While it's not a big problem, it's a minor annoyance I'd like to get fixed (as I need to enjoy my ride at all times.
View 220 RepliesLincoln - Towncar :: Slightly Rough Idle When Started Up And Let It Sit In Driveway
I have a 1998 Lincoln Town Car with about 350,000 miles on it. This morning I sensed a slightly rough idle when I started it up and let it sit in the driveway. While idling I plugged in a scan tool and after a few minutes it showed a P0306, a misfire in cylinder 6. I know there could be a few causes of this but my past experience has been a bad ignition coil (this car has the coils on each plug).
Over the years I've had 3 coils go bad, all giving the same rough idle symptom and P030x, where x was the cylinder number. Replacing the coils solved the problem each time.
So this morning I assumed it would probably be the same. On my way to the auto parts store (4 miles), I monitored the computer, it kept throwing a P0306 (cylinder 6) and I kept clearing the code. About 2 blocks from the store, the car seemed to be running a bit rougher. When I pulled into the lot, I got a P0307 code (and no P0306). Hmm. Well, I bought a new coil and replaced coil 6. I then sat in the lot and idled it and after a few minutes it threw the P0307 again. I cleared it a few times and it came back.
I assumed there was about 0 chance that a second coil could go out within minutes of another (assumption from a car tinkerer, not a professional), so rather than buying another coil, I drove it home to do some further testing. On the way home, it kept throwing the P0307 and nothing about P0306.
So at home, I swapped coil 7 and 5, idled it for a few minutes, and, sure enough, it threw a P0305 (the problem had moved to cylinder 5, following the coil). This indicates to me that I had 2 bad coils?!?
So my question is whether it's possible, or even common, to lose two coils at virtually the same time. I should also point out that before today I did not notice rough idling and there were no computer codes set. I also thought maybe it's possibly a problem developing with an ignition module (but I'm not sure if my car even has one).
Anyway, it was late and I have not replaced the second coil. I did do a couple other tests. I measured the resistance on the primary of the new coil, as well as 5, 6, and 7 coils. They were all close to 0 ohms. The resistance of the secondary ranged between 5k and 8k depending on the coil. Out of curiosity, I also did a final swap of the original coil 6 with the "faulty" coil 7 now in 5 (follow me?) and it still throws a P0305, indicating both the old 6 and old 7 coils are, indeed bad. Another note is that both "bad" coils are about the same age (maybe 150k-200k miles on each), so they're not newer ones.
Does this all make sense? Should I go ahead and replace the other coil and see what happens, or should I check something else?