Golf IV R32 :: Front Lower Control Arm Bushings Completely Separated
Front lower control arm bushings are completely separated. Looking to upgrade in some way to poly bushings or some other sort of performance setup.
View 4 RepliesGolf IV / Jetta IV :: Car Makes Sound As Result Of Swapped Control Arm Bushings
Picked up another gti vr6 5 speed for my girlfriend. It needed the control arm bushings replaced. Finished up and went to drive the car. Now when in gear and let of the clutch. Makes a terrible sound and won't move. But speedo goes up .
View 3 RepliesFord F-150 - 1997-2003 :: 1999 - Squeaking Badly - Replace Chassis Bushings?
I am buying my Dad's '99 F-150 4x4 Lariat from him and this truck squeaks something terrible. I am assuming that the chassis bushings need to be replaced. I have 2 questions.
1. Am I on the right track to solve the problem?
2. How hard is the job?
Tiguan :: 2010 WE - Control Arm Lower Bushings
Brought the Tig in for an oil change & while it was on the lift the tech noticed that the subject bushings are cracked/separating...Tig has about 43,400 mi...is this a common issue?
View 6 RepliesFord Aerostar :: 1995 - Control Arm Bushings?
can you replace the upper control arm bushings (pass side) with the arm still in the truck?
View 8 RepliesGTI 337/20th Anniversary :: Rear Control Arm Bushings Are Cracking
My rear control arm bushings are cracking. I was wondering if this is a serious problem and what negative effects it will have if I leave them alone.
View 10 RepliesLexus RX 2004-09 :: 2007 - Control Arm Bushings Worn?
I bought a used 2007 Lexus RX350, FWD, in December 2012 and had it looked over before I signed the papers by a non-biased mechanic. He said the control arm bushings would need to be replaced in the future.
When I took the car in last month to my mechanic (a private mechanic, not a Lexus dealership), he said the control arm bushings on the right side are worn a lot more than the left side. He said on this Lexus, it would require removing the engine to replace the parts (?) and that because it was such a labor intensive job, and the left will eventually wear, that he advises I get both the left and right replaced at the same time.
Mazda - Mazda6 :: 2003 - Control Arm Bushings Cracked
MILEAGE: 65,000
Last time I was in, the shop replaced my sway bar links, which had already been diagnosed and the repair scheduled. Then, after replacing the sway bar links, the mechanic told me that the control arm bushings were cracked. They already put new struts on the front, as well. So I asked him what else was going to go wrong with my suspension. He said nothing else should need work. He also said that the car was safe to drive for a couple months but I definitely needed to get it fixed.
QUESTIONS:
Is it normal for a car with 65,000 miles to have cracked bushings? I realize that the car is 11 years old; I just wondered how much a car's mileage plays into cracking the bushings and, if so, after how many miles should one expect before cracking occurs.
Does it sound like they're trying to soak me? Why tell me one thing at a time? Perhaps more revenue from the labor side of things?
Assuming the bushings truly need to be replaced, does the community here think there is anything else that should be checked and taken care of at the same time? It is both costly and annoying to have to take the car back numerous times.
Ford Aerostar :: Bushings And Upper Control Arm Replacement
We've got a '96 aerostar (4x4). The bushing and upper control arm seem to need replacement but the parts seem to be obsolete. Any source for these (other than salvage yards)?
View 14 RepliesLexus RX 2004-09 :: Lower Control Arm Suspension Bushings Replacement?
Car has a little over 100K. How to replace the bushings on the suspension arms. Took my car in for the brake switch recall and was told my bushings were cracked. Not sure which ones, but I assume all of them. Looked online for a DIY, but not for the RX330. From some of the DIY's I've seen so far, it looks like a bit$! to replace those rubber bushings.
View 14 RepliesFord Aerostar :: 1992 - Rear Control Arm / Bushings Have Worn Out
I have a '92 Aerostar XLT with a rear control arm problem. The bushings have worn out and the rear end floats side to side as much as 1 1/2 inches. Ford says one bushing comes in the arm ( no longer avail ), one is a press in (no longer available), and the other is like a strut bushing and is available but without the other 2 there is no point in replacing the one. How to fix this enormous problem???
View 10 RepliesHonda - Pilot :: 2008 - Control Arm Bushings / Normal To Fail After 5 Years
I have a 2008 Honda Pilot less than 80,000 miles on it. was just told by the dealer the control arm bushings need to be replaced. They put it on the lift for me and I saw what looks to be dry rot on the bushings. I am the original owner and it has not been abused .. all required service completed.
View 4 RepliesGolf/GTI VI :: Bushings On The Front End Links Are Worn
I'm scheduled for my first HPDE next week and I just discovered that the bushings on the front end links are worn. I don't notice any issue when taking curves and I'm asking due to the timeline of when the dealer will get the parts...it'll be cutting it close before the event.
View 3 RepliesGolf IV R32 :: Rear Sway Bar Bushings Squeak?
I'm pretty certain that my 22mm neuspeed sway bar bushings are shot. they squeak like crazy and when I looked at them to grease them up it looked like they had space, oh and they knock like crazy. Any better source or place to check locally? Would Napa carry something like this? and is Poly my only option? would a rubber bushing wear quicker?
View 3 RepliesGolf V R32 :: Clicking Noise While Turning Steering Wheel - Sway Bar Bushings?
Front sway bar bushings causing "clicking" noise while turning the steering wheel? Usually happens when I'm moving into or out of a parking spot and while I'm turning my steering wheel. I got the driver side, I believe, lower control arm replaced and after that i started getting a faint clicking noise when I'm turning the steering wheel.
The dealer, after multiple visits, discovered it's the front sway bar bushing causing the noise. They said it's really not worth the cost, since it's isn't a safety issue and the whole sway bar needs to be replace since you can't buy bushings alone. I want to get rid of the noise regardless of safety or not.
Golf VI R :: Loud Squeaking From VWR Sways
I have been getting some loud squeaking from my VWR sways and decided to have them serviced at a local shop. The rear sway bushing could be removed and greased without problem. However, the front bushing could not be removed and the best the tech could do was grease the bar and slide the bushing back and forth to try and lube it up. The squeaking became higher pitched but did not go away and it is driving me nuts when I go over small bumps. Did VWR upgrade the parts at any point to make the front bushings serviceable?
View 17 RepliesGolf IV R32 :: Mounts Squeaking When Moved?
I replaced my 3 mounts a few months ago with 034 track density mounts. Torqued properly.
I noticed the other day, while in the rain, if I let off the gas when going slow, when the car does its little jolt forward, I heard a squeak. Gotta be one of the mounts...
Could it have been the rubber got wet and one of the mounts was simply squeaking when it moved? I noticed it when dry but not nearly as much. Guess I should re-check the bolts, but other than the squeak nothing feels different.
Golf/GTI VI :: Rear Brakes Are Squeaking
I have a '13 GTI Autobahn Edition...
40K miles on it, and the rear brakes are squeaking.
I have some new rotors and pads picked out, but i dont know if i have the Bosch or the Girling rear calipers...
Golf VI R :: Brakes Have Been Squeaking At Low Speeds
So I'm at the dealership because my brakes have been squeaking at low speeds for the last two months. They measured the rotor thickness and checked the pads and calipers. Their response is that this is a common problem in Texas humidity with the type of brake pads that are used. Apparently almost everyone is dealing with this.
New pads or to shave my rotors are not covered under warranty.