Golf IV / Jetta IV :: Slam Driver Side Door / Fuel Pump Primes / Starts Then Stalls

I have been without my dub for over a month mk4 gti/golf awp motor 1.8t manual transmission and have ran multiple scans and replaced multiple parts. I am suffering from a no start condition, start and stall immediately, and have troubleshot many problems.

Most recent vcds scan results are: intermittent door module fault (not faulty, not implausible, "intermittent") (j386) Speed sensor implausible (g28) (already replaced with no change) open circuit or short b+ fuel level sensor fault.

I have had the driver side door taken apart on multiple occasions and found: no cracked joints on the pcm of the LOCK module (solder covered by brownish/gold sealant?) Two breaks, 1 in the ground and 1 in the hot wire between the chassis and the door and since applied electrical tape to the chafed part of the door wire harness. I have ran multiple scans since applying the tape with various results.

After applying a maintainer and verifying full charge on BRAND NEW BATTERY I ran scan with above codes.

I have in the last month replaced coolant temp sensor, fuel filter, fuel pump relay, above mentioned battery, and installed toggle switch to lock module micro-switch, speed sensor. About 5-10k miles ago I replaced the fuel pump with vemo brand from ecs tuning and fuel pump relay.

I have re "seated" and cleaned all terminals, below and on the battery as well as on the transmission, have "checked" the ground just in front of the ecu and removed enough parts to place my hands on it to check for a loose condition. Also checked ground on top of block next to coil packs. I've checked pillar a for chafing and the ground next to pillar A and the ground just below the CCM.

I have also taken a mallet and attempted to re create this door slamming condition by tapping everywhere around the door jam on the chassis and door with no change. Also with the door LOCK module removed, I have tapped on it to see if pump would prime, no change...........

After sitting in my recaro imitation cloth seat totally defeated I realized that the intermittent fault code was pointing the "integrated window motor/DOOR module" that was the only thing I hadn't attempted to "test" (originally thought window motor was only a window motor)

Verified continuity to the door module, and verified continuity to relay panel, fuel pump and lock module........... Also tapped on the DOOR module itself with no change.

Piece the whole door back together, slam the door and bam fuel pump primes........... (also massaged the repaired-chafed wires before and after re-installing back into door, with no change/prime.) After sitting a while sometimes it will prime by itself......(with any of the 3 fuel pump relays I have for this car)..

Replacing 1 fuel part after the other over the 4 years I've owned the car has temporarily resolve my issue, until now. (Also have tapped around gas tank/retainer ring on the pump to see if fuel level sensor fault was a culprit). I don't believe this to be the issue because I've netted this fault in the past and has never cause a no start condition or come back after clearing when replacing fuel related part.

After slamming the door I have noticed the pump primes in waves, like a hum hum hum instead of 1 solid hmmmmm and when the car DOES start (when the pump primes) the pump continues the hum hum hum condition before dying. (I have gone as far as a test drive and I rev the engine and put in gear but acts as if i have a bad clutch, all rpms, no horse power like it's slipping condition from a bad clutch

immo light goes off when key in on position, epc and check engine light are off after car STARTS when slamming the door. With key in on position hear a loud click under hood (relay station I'm certain) but the throttle body buzz's until the chime sounds with door open (have not tested this when it DOES prime.....)