Golf IV / Jetta IV :: 2003 GLI - Air Compressor Clutch Will Not Getting Engaged
I have a 2003 2.8 GLI and my compressor clutch will not engaged i provided the clutch with a direct power and ground from the battery and it engaged. i also went to the junk yard and got a couple of Fan Control Module ($4 each) and it still does not engaged.
View 3 RepliesGolf IV / Jetta IV :: AC Clutch / Compressor Relay Location
Golf 2.0 ... Finding the location of the AC Clutch/Compressor relay location. On the TDI its behind the the dash and I looked on mine and it doesn't seem to be the same. I've seen a thread where some said it was under the battery? Where it is and what number will be stamped on it. Another thread said it should be behind the dash and number 385 or 358, I looked and I don't have those numbers back there.
View 2 RepliesGolf IV / Jetta IV :: AC Compressor Clutch Turn On But Does Not Kick Off
I have an issue with my 2003 golf 2.0 ac I've done everything that I cloud thing of to check but I still have this issue so here it is. The air coming out of the vents is warm, compressor Clush turn on but doesn't kick off. I hook up ac gauges and it reads 70 on low side and 155 on high side with an ambient temperature of 80. The system has freon, I check fans and they are on when compressor kicks in all relays and fuses are fine.
View 8 RepliesGolf IV / Jetta IV :: Clutch Not Stay Engaged After New AC Compressor Installed
99 Jetta, installed a new AC compressor a month ago, has been working great, not clutch will engage for a few moments, then turn off for a minute, then engage again. Seems, like there is Freon in there by the gauge on the low side.
View 4 RepliesGolf IV / Jetta IV :: 2003 - AC Compressor Clutch Won't Engage - Low Voltage?
I got a 2003 GTI 1.8t and the AC air is blowing warm. With the car on, AC on and fans full blast both rad fans turn on but compressor clutch does not engage. Took it to a shop and the mechanic said the system was full of refrigerant but that the compressor was not getting the proper signal and there was an electrical problem.
I check the power at the compressor and it is reading about 7 volts, which is low correct? That should be getting 12-13 volts correct? I also check the pressure switch over by the passenger side and it was getting 13v. What to check next to start ruling out causes? Any quick way to determine whether this is electrical or a compressor issue? I am limited in my abilities as far as electrical work goes.
Golf IV / Jetta IV :: A/C Don't Blow Cold Air - Compressor Clutch Stays On Passenger Side Only
The A/C does not blow cold. The Compressor clutch does kick on and stay on The passenger side fan kicks on only (I think the driver side is toast but i need to test it to confirm) The system has 45psi on the low side
I did not check the high side as I don't have a gauge for it but will get one if I need to test that. So my thoughts are that my expansion valve is toast which is what expands the hot liquid and turns it to cool liquid so the A/C gets cold. I think this because it seems all of the other components work.
Golf IV / Jetta IV :: 2003 - Slight Growl Bearing Sound At Idle?
Not sure where to even start this but ill try to keep in concise. 03 gli 24v 6 speed. 125500 miles. At about 123500, i start noticing this slightly growly bearing sound at idle, without the clutch pedal pressed. When you press the clutch pedal, it goes away. Waited a bit, and at 125k, i replaced the clutch, flywheel, and throwout bearing, thinking it was a bad throwout bearing. It wasnt that.
Next, after more research, it seemed the 02m 6 speeds have had some issue with input shaft bearings wearing out making similar noises. So, pull the trans back out, and send it to APTuning in PA. Have new input shaft bearings, upper and lower pinion shaft bearings, and diff bearings put in. Even though they said they saw no major wear to be worried about in any of them. And here we are, left with the same noise.
One of the guys at APTuning said they had a case with one car where the thrust bearings wore so bad it made for a similar condition. Where the car would make unpleasant noise without the pedal pressed, and would go away when a load was put on it with the pedal. SO, i guess what im asking is, is there validity to that? What are the chances my otherwise seemingly fine 24v has this issue and end play is so bad that is causing this noise?
The noise gets NOTICEABLY louder when the car is hot. Its almost silent on cold starts. But after 15 miles or so it can be heard almost voice level with the windows down when you're stopped and idling; it really hurts to drive it being a caring owner hearing it. The motor is still in the car with all accessories so i can't check the end play scientifically. But to be fair, if this is plausible, and is the issue, i dont think it'd take precision to tell.
I'm so deep into this, and thought I've ruled out everything yet the noise persists. Really at a loss..
Listen around :30 where I start to cycle the clutch pedal. When I press it, you hear the main shaft "spin down" and the noise go away. When I release the pedal again, you here the clunk and the noise again. Its also been sitting for 3 hours. Good bit louder when hot [URL] .....
Golf IV / Jetta IV :: 2003 - While Shifting Making Grinding Noise - Clutch Or Engine?
noticing a few issues with my 2003 jetta 2.0 when driving/shifting....so first main thing I noticed is when shifting from 1st to 2nd gear often times it will make a grinding sound and not shift smoothly from 1st to 2nd....you have to do it real slow/gingerly ...if I short shift from neutral to 2nd its fine or if down shifting to 2nd its fine...I have changed the gear oil...other sounds idk if its my tranny or engine but if going up hill and you throw into 3rd and not going fast enough its makes a rattling sound and is sluggish I know its a old car 177,000 miles so idk just curious if this is a sign of problems?....Last thing after driving and getting home and putting into reverse gear to park it makes a noise like a chugging sound when reversing and can be finicky going into reverse.
View 1 RepliesFord F-150 - 1997-2003 :: AC / Clutch Bearing Making Noise - New Starter And Still Won't Start
I have a 2000 F150 XLT 5.4L truck. I noticed the AC went out about a month ago and since then I could hear the AC/Clutch bearing making noise. Well I went to start it the other day after eating dinner out and it wouldn't start. It sounds like it wants to start but it just doesn't have enough umph. I replaced the starter and charged the battery up to 100 percent. It still won't start.
If I take the belt off it will start and I checked the AC/Clutch and I can move it with my bear hands. I tried disconnecting the AC/Clutch fuse and relay but that didn't work. Is it possible that the Clutch is freezing up when I try to start it?
Santa FE SM (2001-06) :: Clutch On AC Compressor Went Out And Making A Loud Racket
I have a '03 V6 3.5 Santa Fe. The clutch on the AC compressor went out and was making a loud racket. When I was pulling the compressor off I noticed the wire harness connection to the compressor was damaged. Either by me or previous change.
So the end of the harness on the car side is damaged. Can a new one be purchased and spliced? I cannot see where it goes to see if it can be replaced.
Caprice :: A/C Compressor Clutch Making Lots Of Noise When Working
Pretty sure the a/c clutch on my LT1 is going - making lots of noise when working and also when not.
I've heard on some forums that this could be a bearing? Is it advisable for me to replace the entire clutch or just this bearing?
Either way, I assume I'll have to pull the clutch for which I think I'll need two special tools:
(1) clutch holder tool to break nut loose.
(2) pulley puller.
Ford A/C :: Compressor Clutch Making Noise / Would Engage Or Disengage
The A/C in my truck stopped working last year, and this year I intend to fix it. I believe the problem is with the compressor clutch because it was making noise as it would engage or disengage. It was making this noise for a good year or so, and then one day the noise stopped and I have no A/C. So I am only assuming its the clutch.
View 4 RepliesGolf IV / Jetta IV :: Bearing Noise After Bearing And Transmission Replaced?
I replaced all the bearings and put in a rebuilt transmission and still have bearing like noise , seems like the front, directly increasing with speed . Same in neutral, no change with turning or breaking. Getting worse over the past few months.
View 1 RepliesGolf IV / Jetta IV :: Car Making A Sound When Turn The Steering Wheel
its possible to repair? or only a new one it's the solution? cause my gti 1.8t it's making a sound like tssshhh when i turn the steering wheel. I change the power steering rack.
View 2 RepliesGolf IV / Jetta IV :: Rattle Snake Sound After Clutch Swap
2000 GTI all stock 220K miles
AEG motor
02J transmission
I just swapped clutch on the manual transmission of 2.0L 4 cylinder GTI.
Now every time I start the motor, I hear high pitched rattlesnake sound. It starts about 2-3 seconds after the motor starts.
The sound is coming from center of oil pan or downpipe area but can't tell how high on the motor's long block the source of sound is located at.
Check out the following youtube video. You can hear the sound at 9 seconds and it get really audible around 12 - 14 seconds and disappears around 21 seconds. I can hear this sound for the whole duration of motor running. The sound is not coming from the downpipe cover.
Santa Fe (CM - 2007-12) :: A/C Compressor Making Oscillating Sound And Not Getting Cold
My air con is not working, it started making an oscillating sound and not getting cold, which I think is the compressor. Garage couldn't find any leaks using a dye. So I asked my mechanic to change it. The generic part was a little over 300 but when he went to fit it it had the wrong number of mounting holes. Think he said it had three instead of the four from the original part? So he was not sure it was a suitable part, so didn't fit it. Because in the UK the CM model started selling in 2006 not 2007 it's possible he got confused and got a part for the older model? The car is definitely a CM!
View 4 RepliesGolf IV R32 :: Front Right Wheel Bearing Is Making Noise
So my front right Wheel bearing is making noise and its a used Knuckle so its w/e. Guess ill use tonight to do all my bushings and fluids n stuff.
View 6 RepliesGolf V R32 :: When AC Turned On Compressor Clutch Not Clicking
I have recently bought a R32 2008, and when trying to turn the AC I don't hear the AC compressor clutch clicking, the fans are running normally (radiator fans ). What should I check ? Someone told me that maybe it's a compressor problem, and another one said that if the refrigerant gas is low the clutch won't be engaged.
View 3 RepliesGolf VI R :: Clutch Noise Making Vibrations?
Searched through old threads but didn't come across these in particular, a lot to look through so may have missed in Car has 270 miles on it.
1) When clutch is in all the way and the car is revved, I can feel it in my left foot. This can be felt when car is stationary or in motion - Is this common for MK6/R? I don't recall being able to feel this in my MKV GTI
2) When the car is in motion, I hear a knock noise right after the clutch is pressed in. I can only hear the noise if windows are open and stereo is off, and this only occurs while the car is in motion. - Is this a standard clutch noise for healthy clutch/pp/flywheel/throw-out bearing on this platform, or should there be no noises? It sounds like something I'd expect to hear with a messed up throw-out bearing.