Golf V R32 :: Removing Broken Rear Belly Pan Bolt?
just got back into a .:R 6/18/13 and took it to a nearby jiffy lube to get an oil change not 100% sure if they're responsible or not but i noticed the belly pan was hanging rather low and broke not too long after. ordered a replacement from ecs w/ the 3 M6x20 pan->subframe bolts since they were missing. got under the car today to replace/install new pan and noticed that 2 of the missing bolts were broken in the frame. tried searching but found nothing?
View 4 RepliesGolf IV / Jetta IV :: MK4 GTI Exhaust Leak Or Possible Bolt Missing
Brief back story, a year ago my timing belt went and had to replace the cylinder head and all associated parts. No problems since then, until now. Recently the check engine has come on, and got the code for an exhaust leak. Can't remember the exact code number, but the leak wasn't causing a lean condition or causing the engine to act weird so I left it until I had to time to find the leak. On the way home today I noticed an exhaust leak that got increasingly worse to the point where at a stop light I'd go to accelerate and it would pull away very sluggishly. Got home, opened the hood and tracked down the exhaust leak to somewhere around the manifold/downpipe/turbo area. I took off my cover and noticed what could be a bolt missing, and upon further inspection a bolt that may be coming loose.
Here's what I'm referring to:
- Missing bolt?
- Loose bolt missing bolt?
- Loose bolt?
Golf IV / Jetta IV :: Steering / Suspension Assembly Bolt Missing
While changing the oil on my car I noticed that a bolt was missing from the steering or suspension assembly (not really sure what its for. I was wondering what it is for and how important it is. I went to the store to get a replacement and found that the threads in the hole have all rusted out so I can't get a new bolt in. Is this something I should definitely fix before driving again or is it not too serious.
Here is link for the pictures: [URL] ....
Passat (B5) :: 1999 - Removing Top Piece From Shifter
I have a 1999 Passat with wood trim. I found some instruction on removing the center console but they do not explain how to remove the head piece from the shifter?
View 5 RepliesDodge - Caravan :: Removing Stuck Piece Of Paper Towel In Transmission Dipstick?
A small piece (triangle shape, about 1/2 inch in the base and maybe 3 inches long) of gasoline station paper towel got stuck in transmission dip stick and went inside the transmission when the dip stick was put back. It happened very quick. When I pulled out the dip stick, the paper towel piece was gone. I'm assuming it went in or stayed in the tube where the dip stick is housed. Drove the van about 230 miles to go home in a combination of highway and city driving. So far, no change in transmission performance.
1. Is it harmful to the transmission and if so how could I remove the paper towel debris?
2. Will changing the transmission fluid and filter (not flush) work?
(Btw, I read that it is not a good idea to do a transmission flush for cars with 100K miles or above) I'm hoping the paper towel piece will disintegrate in the fluid and therefore I don't need to do anything. Or perhaps if it doesn't integrate, it will remain harmless.
Ford 7.3L Power Stroke (1999-2003) :: HPOP To Leak From Round Piece Behind Pump Next To Drain Bolt?
How common is it for the hpop to leak from the round piece behind the pump next to the drain bolt? Its on a 2000 f350 7.3.
View 12 RepliesLexus LS 2007+ :: Windshield Missing Molding Piece Causing Wind Noise?
I just noticed yesterday that on my windshield, next to the wipers, I'm missing a molding piece. I think that's why there are some wind noise in that area. Attached are two pictures. The one of the passenger side you can see the black molding. The one of the driver side is missing it. What is the part number?
View 2 RepliesFord Super Duty (1999-2016) :: 2004 - Small Piece Missing From F250 Frame?
I was washing my 2004 F-250 today and I looked down by the front passenger wheel well and I noticed a small chuck missing from the bottom of the frame. The other side in the same spot doesn't have it and at the spot in question, I noticed some sort of crack had been welded before. I never had any of that done to the truck. What about getting it fixed? get it fixed right away or keep an eye out for cracks. so far its just that hole and what looks like a welded crack above. everything else seems fine. I know a repair would be inexpensive and easy just to weld a steel or titanium plate on the spot.
View 11 RepliesGolf IV R32 :: Original Wheel Bolt Length?
What is the original wheel bolt length? Is it 28mm?
View 7 RepliesFord Super Duty (1999-2016) :: Plugs Covering Holes In Plastic Piece Missing - Truck Wrecked Previously?
Bought a dealer demo last may. Truck has been wonderful. Had less the 1500 miles on it. Noticed when I was installing the lock on my tailgate that some of the plugs that cover up the holes in the plastic piece inside the tailgate were missing. Maybe some of the screws, not sure. Dunno if it's supposed to be that way or what. Just started to get a horrible feeling about it, Taft maybe something major happened. Any way to find out or round they have told me? Mebbe I'm over thinking this.
View 6 RepliesFord Excursion :: Missing A Bolt That Hold Fuel Line?
I was looking around under the hood and I'm pretty sure I'm missing a bolt and maybe a nut too. The bolt hold the fuel line I think. Is there supposed to be a nut holding the fan shroud on here?
I know I could go to the hardware store and eventually find something that works, but that is a headache and they don't like me test fitting until I find the right size. What is part number?
Lexus GX 2004-09 :: Rattle On Rough Road - Skid Plate Bolt Missing
I have an 09. I heard a rattle on a rough road and crawled underneath the engine. The right front skid plate bolt is missing. What size bolt belongs there.
View 2 RepliesFord Ranger / B-Series :: Missing The Nut On Top Side Of Front Stabilizer Bar Link Bolt Assembly
Today while driving I noticed a knocking when turning right or going over bumps in the road. I finally got to look under the truck and noticed that I'm missing the nut on the top side of the front stabilizer bar link bolt assembly on the passenger side.
It's a '99 Ranger XLT 4x4. Is this unsafe to drive? Is there a bushing on the top?
Ford 6.0L Power Stroke Diesel :: Lower Valve Cover Bolt Missing - Oil Leak
Just got off the boat (offshore boat captain) and my wife has been using my truck while I was gone so it doesn't sit for forever. I made a quick trip to the hardware store for some materials and back to the house. Total drive time was about 20min. Noticed that I had a terrible shake like a weight got thrown off a wheel. When I got home and started looking at my tires I was on the passenger side front tire and noticed oil on the driveway. That's when I saw the drop.
Now I climbed under the truck and looked around and found oil all over the passenger header and starter and basically all down the passenger side of the motor. I popped the hood and and the valley was clean. Then I felt around the passenger valve cover and found a lower valve cover bolt missing. Second from rear on the bottom. My question after that long description is, can one missing bolt cause a leak bad enough to completely clean the oiled areas and start the truck and in about 1 min have clean oil dripping down? If so, when I get a bolt should I go ahead and replace the gasket?
Nissan - Altima :: 1997 - Piece Of Wheel Cover Popping Off With Metal
It's Nissan Altima 97. My friend need to take her road test so I let her borrow my car this weekend to do some road practice (I was in the car with her). Besides all the heavy braking, and sudden acceleration. She did alright. Because she is from VT, so she was practicing this VT Turn Around (I have never heard of it before today). She turn the wheel all the way to the right and back up.
I heard a small popping noise, and didn't pay too much attention to it at that moment. However, After she finish that VT Turn Around, we started to driving down the hill, and heard this metal-on-metal noise. It lasted for 10 ft, then went away. The noise is coming from my driver side front wheel. When I got off the car, I found the center of the wheel cover pop off.
(see this link for the pictures) [URL] .......
Now here are my questions. What just happened? and do I need to get it look at immediately, or can I wait until the next oil change?
Golf IV / Jetta IV :: 2005 TDI BEW - Auto Transmission Bolts Size / Tool
I need to take the tranny (automatic) off the old engine (BEW).
What are type/size are the bolts connecting the tranny to the block?
The 2 bottom ones I got out using (assuming) 10mm (?) triple square.
What size (socket/tool) and type (triple square, torx, allen) are the others?
Golf/GTI VI :: Square Piece On Passenger Side Of Front Bumper?
What the square piece on the passenger side of the front bumper, in line with the GTI emblem is? The other day I noticed that it appeared to have popped out slightly. I push it back into place, (it snaps into place) but i again noticed today after my commute home it had slightly popped out again. What does this cover and has any experience of it popping out?
View 14 RepliesGTI 337/20th Anniversary :: Standard OEM Wheel Locking Lug Bolt?
What is the mk4 standard locking lug bolt? IIRC it was like a 16 point.
View 1 RepliesFord - Focus :: Control Arm Bolt Broken During Wheel Alignment?
I've had two control arm bolts broken in the last year (resulting in the arms being replaced) during my '3 year alignment' program.
The bolts have been broken and then I get a call and a bill for the new control arm and labor.
Is it that common to break the control arm bolts when aligning the wheels? I do live in Michigan where salt is used on the roads.
There are some other things that seem have not inspired my trust (billing mistakes and not torquing the rear wheel after replacing the arm and letting me drive home) ...But, I want to be fair and if this/these are regular occurrences I'll go back and work with the shop.