SC/SL/SW :: 5 Speed Manual Transmission - 97 SL2 Won't Shift Into First Or Second Gear
My 1997 Saturn SL2 with 5 speed manual transmission won't shift into first or second gear. When I shift into the location where first would be the car is in third gear. It shifts into 4th, 5th and reverse just fine, though the shifter is in the wrong position for those gears. I can wiggle the shifter in neutral and get it to move into the position where 5th and reverse are normally found, but it is stiff and makes a clunking noise when I move the shifter over to the far right side.
I have removed the center console and the bushing appears to be intact. Both cables are in their proper positions inside the vehicle and at the engine. One of the cables (the top one in the engine) has some wear and tear on the boot, but does not appear to be binding. Other than the stiffness and the clunking noise, the shifter seems to be working fine too.
Passat (B6) :: Slight Bump Between 1st And 2nd Gear During Speed Shift
So when I shift "normal", e.g. just driving around, I notice a slight bump between 1st and 2nd and the other gears as I enter the gate. And it is good feedback that you're entering the gate. But when I am trying to clean out the injectors from a stop light , that bump between 1st and 2nd becomes a lot harder to push through when I try to do it fast. My old Jetta was not that way.
View 6 RepliesHonda - Accord :: 1989 LX 5-Speed Won't Shift Into First Gear
'89 Honda Accord LX Sedan 5-Speed, 266k miles...
Bought this car recently and it worked fine when I got it (the most perfect 22-year old car I've ever seen). Between then and now I've driven it a little. It's my first stick shift car, so I've stalled it a few times, ground the gears a little, etc. learning to drive it. Anyway, it now won't shift into first gear. It shifts fine and drives fine in all the other gears, the only problem is with first. It also shifts fine into all gears when the car is off.
On a side note (in case it pertains to this situation), the car takes a little while to warm up. For 5-10 minutes after it is turned on, it idles really fast and makes a horrid scratching noise and then stalls if put into reverse (don't know about first, since it won't go into first). Once the idling slows down, though, this problem goes away.
Golf IV / Jetta IV :: Can't Shift Into Second Gear After Shift Linkage Done
So i was trying to adjust my freinds shift linkage on his o2j and i got a little ahead of myself and forgot to put the shift tower in the home position before making the adjustment. after i realized you can't shift into second ( either that or 2nd and 4th are extremely close together now and feel like the same gear ). I try to get it in home position even with the cables off ( did this for experimentation) and still wouldn't go into home position...meh. still have all the other gears including reverse .
View 4 RepliesCamry :: Lights For Gear Shift Selector / Fan Speed And Temperature Dial Are Out
In my 2004 Camry the lights for the gear shift selector and fan speed and temperature dial are out. Is this a common light source or fuse that controls these lights?
View 1 RepliesAccent MC (2006-11) :: Hard To Shift Into Proper Gear At Different Speed Ranges
My 2008 seems to be having some intermittent trouble shifting into the proper gear at a couple of speed ranges.
Occasionally I'll start it up and pull out of a parking space (or leave a stoplight) and it feels like it's stuck in 1st well after it should have switched to a higher gear (I sometimes feel the upshift at about 10* mph). If I continue accelerating and hit about 40-50 mph, once again it appears to stay in the current gear instead of shifting.
When this issue is happening, the car feels even more underpowered than usual and takes way more throttle than it should to accelerate. This results in a cruising RPM of 3.3-3.5k at 60 mph. At that speed the engine would normally be doing about 2.2k RPM. Similar power and RPM conditions exist in the lower-speed range, too.
This whole thing is usually preceded by a rough shift into gear (D or R) when I first start the car. It's always had a slight lurch in the appropriate direction as I take it out of park, but this is really noticeable.
If I stop the car and come back in an hour, it (usually) appears to have reset itself. I can drive around and the transmission control is as good as always.
This has been going on for about a month, with an episode maybe every week or two. I took it to a shop and they didn't find any problems (I told them about the weird shifting and lack of power).
Does it sound like this is what's happening (it's not getting into the right gear)? Thoughts on what I should do? I can't really remember the speeds.
GTI 337/20th Anniversary :: 1st And 2nd Gear Shift Fork Broken On 6 Speed Trans
My 20th Ann. GTI randomly would not go into first or second (they move into place but are just limp there and not catching into the gear) I was told for replacement of new 6-speed transmission and they did not offer any alternatives beside replacing it completely.
I know there is a thread talking about this but I read about the shift fork, or a piece of the shift fork that breaks and this problem fits my exact description. Not much info on what I can do, or at least not specified. What is any cost effective way to get my gears back without completely replacing the transmission? Is there anything I can do to just replace a broken part or are there any alternatives?
Lexus GX 2004-09 :: Hard To Shift Into Next Gear When Merging Onto High Speed Roadway
2006 GX470 57000 miles loaded. I purchased this new and I was wondering if anyone on here can give me a bit of input on what you may think is going on.
My truck when merging onto a high speed roadway my truck doesn't seem to want to shift into the next gear. Almost like if it was a manual I would have to shift it. It really whines out before it shifts.
Also My husband is hearing a humming/vibration from the rear when we are doing about 65 steady I've already had my tires removed and checked to see if I may have thrown a weight or a broken belt but everything is good. I have Michelins on the truck and they are about 2 yrs old. No damage on the tires I have them rotated every 5000 miles.
I had the truck in for service and told them about this. The Lexus service rep told me his mechanic told him he found nothing. I asked them to check again and he said the mechanic would take it home to drive it at a speed that was needed. Again I was told nothing was found. Got the truck back from the seat repair don't even think the truck was taken home.
Golf IV / Jetta IV :: Very Hard To Get A Smooth Shift From Gear To Gear
Background facts:
Tranny swapped from my 4 speed auto to a 1.8t o2j 5spd
13lb. Light flywheel
Powerflex dogbone mounts
Peloquin LSD
The problem: Very hard to get a smooth shift from gear to gear. Trust me, I know how to drive, but I can always feel the car shifting into a different gear if you know what I'm saying. On my friend's bone stock Jetta, I just let the clutch out without gas in between shifts and you don't feel a thing.
On my car, you feel EVERYTHING. People have told me the light flywheel will make the ride more uncomfortable in many ways, especially since the RPMs drop much quicker in between shifts than stock.
Ford Super Duty (1999-2016) :: 1997 Truck Won't Shift Past 2nd Gear Top Speed 35 Mph
Ok so I went mudding this past week, and I put my 997 7.3 truck in 4x4 had fun then took it out of 4 wheel now it won't shift past 2nd gear top speed 35 mph.... It still has all the power revs up Rpms fine but it won't go faster then that.
View 8 RepliesGolf IV R32 :: When Driving Hard And Speed Shift From 2nd To 3rd Transmission Grind
I have an 04' R32 with about 56k on it. Here's the problem; when I drive it hard and speed shift from 2nd to 3rd it grinds just a little. It doesn't do it when I'm just cruisen grany shifting. For awhile now I've been thinking that the synchronous from 2nd to 3rd gear was going bad, till I talked to a friend with a 20th GTI who said that the 6 speed trannies will start to do that, and there's really nothing you can do about it. Is this true that I just have to deal with it or can it be fixed?
View 12 RepliesGolf VI R :: Won't Shift To Second Gear Under Load
So, in the last month or so I have been having trouble getting the car to go into second gear when mashing the go pedal. I have to try several times and seems to be that the car has to unload and then it will shift.
I am using the DG shifter and have been for 30k+ miles and I have the red HPA dogbone insert. The shift has not been a problem up until the last month or two.
Is it time for motor mounts?
Golf VI R :: Vibration When Shift From First To Second Gear
When I shift from first to second gear, especially when the car is still cold, I get a vibration(?) feeling through the shifter. I'm not shifting hard but not slow either. It's definitely not a grind but it only happens when shifting from first to second.
FYI- The car has ~550 miles on it.
Golf VI R :: Really Hard To Shift Into 1st Gear
I just finished the DG install yesterday. I am having a real problem with the first gear: it is really hard to shift into it (I mean hard!) - and several times I went into 3rd believing it was in 1st, while driving. I know that the DG is notchy and a little stiffer (which I like) but this does not feel right. I have to really push hard (moving slightly toward reverse) to shift into 1st. My wife would never be able to find it or shift into it (not that I let her drive my R that much...).
Note that all the other gears (2,3,4,5,6 and reverse) shift beautifully without any effort with that nice click. But not 1st.
What is it? Adjustment? I did it twice. I made sure that both cables were "all the way in" before tightening the first two bolts (and I made sure that the cables were not moving - a common problem with this install) with the engine lock on and pin in.
Golf/GTI VI :: Hard To Shift In 2nd Gear When Cold
2011 TDi 6 Speed (Sportwagon) with problems shifting into 2nd? Mine is currently in the shop under investigation for a balky shift when cold. The tech says it's not right, but then they find another vehicle in inventory with the same issue...currently waiting on a VW engineer.
View 16 RepliesGolf IV R32 :: When Shift Into Second Gear RPMs Go Down Fast
So after my 500 mile break in I decide to see what my new set up is made of. Had the kinetics stage 3 and the south bend stage 3 clutch installed. Did my first launch...everything went great. Got just a little bit of spin and the car took off like a scud missile. Right as Im going to shift into second my Rpms go down fast. No weird noises no metallic sounds nothing. No fluid under the car. Only a slight clutch smell nothing crazy. Car wouldn't go into gear. Shut the car off and it goes into gear.
View 20 RepliesGolf/GTI VI :: 2010 - Bad Grinding When Shift From 1st To 2nd Gear
when i shift from 1st gear to 2nd gear, above 2500 rpms i get a really bad grinding, i am just under 50,000 miles so it is going to the dealership to get fix. It also kicks me out of second gear some time.
View 24 RepliesGolf VI R :: Clanking Noise When Shift From First To Second And Second To Third Gear
Sometimes when I shift from first to second and second to third I hear a clanking noise coming from under the car. It happens when I move the stick and clutch pedal is fully depressed. Doesn't happen all the time and doesn't happen in gears 4-6. Something I should be worried about? Car is stock and has about 1k miles. It's been doing this since I bought it.
Also get a deeper boom noise coming from back sometimes when depressing clutch petal when under boost. Think this is normal tho? My BMW used to do the same thing.
Golf VI R :: Really Grabby With Grind When Shift Into 6th Gear
I just bought a 2012 R last friday. 14k on the odometer.
Car is perfect, cept when i shift into 6th its really grabby with a grind. does it every time.
should I take the car in to have it checked out, is this normal?