Golf V R32 :: Car Shifts More Aggressively In S Mode Allowing Higher RPMs Before Shifting
When not using the manual mode of the DSG...What are the differences between driving in D and S? It seems like the car shifts more aggressively in S mode, allowing higher rpms before it shifts. Are their any other pros/cons to the different driving modes when in automatic, And what do most drivers prefer?
View 15 RepliesGolf/GTI VII :: 2016 - Clutch Pedal Vibration And Pulsation At Higher RPM
I have been having troubles with my 2016 GTI clutch. There has always been a gritty/sandy feeling while disengaging/engaging from the first day.
On top of it, this weekend I noticed that there is a vibration/pulsation in the pedal at higher rpm (3000+), as this weekend my car was close to the break-in 1000 miles, so wanted to take it out for some spirited driving.
While shifting 2-3, 3-4 at 3000-4000 rpm, I can feel a rough pulsation in the pedal (no noise) when the pedal is around mid-way pressed.
I further experimented, to see if this happens in neutral, so parked the car with E-brakes, and then pressed gas pedal, and pumped the clutch. Have the same rough pulsation/vibration.
I took it to the dealer (right infront of my workplace), and they said this is normal, "you are just feeling the engine from your clutch"...
Golf/GTI VII :: 1st To 2nd Gear Grinding When Let Out The Clutch Pedal At Any Speed
MK7 with 15k miles... This morning on my commute into work, I started having some clutch issues. When I would try to go into 2nd gear from 1st at any speed, it would grind when I would let out the clutch pedal. It was like it didn't fully engage and if I pushed the pedal back in and tried to get it in 2nd, it would grind. All other gears were fine. I don't drive the car hard so I don't think I torched the clutch.
Synchros? Shift Alignment if these models have that? Pressure Plate?
Golf IV / Jetta IV :: 2003 - While Shifting Making Grinding Noise - Clutch Or Engine?
noticing a few issues with my 2003 jetta 2.0 when driving/shifting....so first main thing I noticed is when shifting from 1st to 2nd gear often times it will make a grinding sound and not shift smoothly from 1st to 2nd....you have to do it real slow/gingerly ...if I short shift from neutral to 2nd its fine or if down shifting to 2nd its fine...I have changed the gear oil...other sounds idk if its my tranny or engine but if going up hill and you throw into 3rd and not going fast enough its makes a rattling sound and is sluggish I know its a old car 177,000 miles so idk just curious if this is a sign of problems?....Last thing after driving and getting home and putting into reverse gear to park it makes a noise like a chugging sound when reversing and can be finicky going into reverse.
View 1 RepliesGTI 337/20th Anniversary :: Barely Able To Move The Shifter / Clutch Pedal Fell To Floor
The transmission is a Six-speed MQ350 transmission in an MKIV 337 GTI.
I was driving last week and ran over a large snow chunk, heard it hit the underside of my car. A mile down the road my foot is resting on the clutch pedal at a stop light, and the clutch slowly went to the floor. It was still drivable, barely. The clutch came about an inch off the floorboard, but still caught. So i pull into the parking lot ahead of me, and was barely able to move the shifter left to right nor would the shifter go into gear. There were no fluids coming from under the car, nor could i see anything that looked wrong. I turned off, back on again. nothing. I then pulled the clutch pedal up from the floor and it went back to normal. Everything seems normal now, but the shifter seemed a little sticky yesterday from left to right.
Passat (B6) :: 2.0T Automatic Shifting At Higher RPMs
Over the past couple of days, my wife and I have been noticing that our B6 (2.0 Auto/Tip) is shifting at around 4000 rpms. I'll probably be taking it in to have the dealer look into it but wanted to see if the community has experienced anything similar to the issue at hand.
It shifts (Appox):
1st into 2nd - 3200 rpms
2nd into 3rd - 3800 - 4200 rpms
3rd into 4th - 3500 rpms
4th into 5th - 3000 rpms
5th into 6th - 2500 rpms
Notes:
* the appox amounts above are at regular driving acceleration.
* while in Drive - "D" mode
* used to shift into all gears between 2500-2900 rpms
* doesn't shift nearly as smooth as in the past
Is it OK to slip into "Sport" from "Drive" while Driving? How about slipping into Tiptronic while using "D" or "S"?
[URL]......
Corolla / Matrix 2009-13 :: Shifting At Higher RPMs During Break In Of Engine
Had a quick question on if there is a right or wrong way to break in a brand new engine?
I have a 2011 Corolla S, Manual Transmission...Since ive got it i shift gears at 3,000 RPM's, I have a buddy who shifts every 3,500 RPM's. Is There any benefits to shifting at higher RPM's during the break in of the engine?
Elantra MD (2010-15) :: Transmission Fluid Leaking And Shifting Up At Higher RPMs
I have a 2012 elantra limited about 9 month's old with about 14,000 miles on it.
About a week ago I began noticing a burning smell. I first chalked it up to being 1,000 over the 3k mark for an oil change. However I then started to pay attention when I parked if there was any sign of fluids leaking. At first I didn't notice any or seemed like one or two drips. Well tonight I noticed a larger puddle that was def not water.
The other symptom is that it's been shifting up at higher RPMs. Tonight when I got on the freeway I was trying to speed up to 65 but the rpm gauge had me at over 4,000 rpms with normal acceleration...I was not gunning it. I also could not get the car to go past 60 at first, all the while the rpm increasing still, until I let off the gas then hit it again and seemed to trip it to shift and was able to get to 65.
Elantra MD (2010-15) :: 2012 - Eco Mode - Rough While Shifting At Higher RPMs
I have a 2012 elantra manual transmission. I noticed the eco mode but never found out if it really does anything. when I shift from 1st to 2nd at higher RPMs its rough. At other gears its ok but I feel like the gas pedal is weak sometimes. With a manual does the eco mode make that more difficult?
View 12 RepliesHonda - Accord :: 1999 - Clutch Pedal Vibrates After Shifting
Had my original clutch replaced by mechanic. Had 200K on it. Car clutch petal vibrates badly when bringing clutch pedal out after shifting. Mechanic states it has to do with motor mounts that were affected when changing clutch or the clutch takes time to seal and stop vibrating in the next 500 miles. I have warranty for 12 months and 12,000 miles. Which I had no problem of vibration before having clutch replaced? What is the problem and how to proceed.
View 3 RepliesFord - Ranger :: 2002 - No Clutch Pedal Or Shifting Hard
When I bought my ranger used, the clutch felt ok. But as a couple weeks had passed, it started to get hard to shift. The clutch doesn't slip at all so a friend of mine said there might be air in the system.
I would pump the clutch pedal a few times and then it would shift ok for a while, then back to shifting hard. I found the bleeder and had my son assist me with bleeding the system. Everything was fine at first but I made a big mistake and now i have no pedal feel at all.
My mistake was i didn't realize what I thought was the reservoir was not the actual reservoir. There was a black rubber thing in the reservoir that I filled with fluid. My mistake was I needed to take out this black rubber thing.
So now i am stuck with no pedal and don't know what to do. When I pulled out the black rubber thing, the reservoir was empty so i filled it and it bubbled for a second and then stopped. Tried pedal at this point and there is no feel at all. It just goes to floor with no effort.
Sonata NF (2006-10) :: Grinding Metallic Noise For A Few Seconds - Clutch Pedal Way Down?
I'm at my place in Florida 1,000 miles from home, and when I started the car in a mall parking lot, there was some grinding metallic noise for a few seconds and I couldn't get it into first or reverse and the clutch pedal was way down. I was able to get going in 2nd and eventually the clutch was back to normal and I could get 1st and R. What happened? Broke some fingers in the pressure plate? Seems to run fine now but have a 1,000 mile ride ahead in the morning.
View 1 RepliesTiguan :: Grinding When Downshift / Clutch Pedal Stuck Straight To The Floor
I've been driving manual 12 years, all my driving life, and been in 10+ manual vehicles during that time, including a 10+ year stint in a 1.8T Passat with a 5-speed.
In all that time, and all those experiences, I've never replaced a clutch, damaged a clutch, or had one problem. In fact, I consider myself a very good operator of the manual transmission.
This is preface to my current situation. 2009 Tiguan (early build) 2.0T 6M, driving at 57mph in 6th gear - downshift to 4th to pass a truck and WHAM. Grinding, confusion, and then the clutch pedal stuck straight to the floor. Glide to a stop on the side of the bayou road.
Totally immobile vehicle. Impossible to shift into gear, or get the pedal off the floor except by pulling. Smell of acrid smoke.
VW dealership says "we're doing a courtesy warranty repair" on the clutch, flywheel and bearings, as if it's my fault. Impossible. This is a mechanical defect if I ever saw one.
Golf/GTI VI :: Engine Would Rev Up Higher Before Up Shifting
I noticed my engine would rev up higher before up shifting which is what I always wanted in "D" after I took back my car from the 20K service. Drivetrain Reprogrammed. Now my car is feels a lot more responsive than before.
View 9 RepliesFord Ranger / B-Series :: 2003 - Grinding Noise While Shifting - Use Pressure Bleeder On Clutch System?
Just picked up a 2003 Ranger XL 2.3L and notice that I get a little grinding every now and then when shifting into 1st gear. The clutch was replaced 3 years ago according to the PO but had no clue as to how long it's been since the clutch was bled.
I've used my Motive pressure bleeder numerous times in the past on brakes with much success but I've never used it on the clutch. I've used vacuum bleeders as well but it's always a 50/50 success rate with that. The pressure bleeder just works much better for me.
Using a pressure bleeder on a clutch and if so any tips like still needing to tip the master cylinder end up to release any potentially trapped air bubbles?
Accent LC (2000-05) :: Light Grinding Noise When Let The Clutch Out / Pedal Super Hard
Yesterday I was driving home and my clutch started acting up. To start I was unable to press the pedal. The pedal was super hard, then let up but didn't feel right.
I removed the slave and the pedal went down fine. Both the master and the slave have no leaking and fluid levels are good. I haven't been able to have a buddy look at the levels when I press the clutch, but....
Here is a little more, the car shifts fine with the car off, it goes into all the gears, but with the car on it will not shift into gear. Also there is a light grinding noise when I let the clutch out..
I ordered a clutch kit already, but don't want to pull the trans if I don't have to, I would love to hear the issue is with the master or slave.....
2005 Hyundai accent with 138,000 miles
Ford - Ranger :: Clutch Pedal Feels Normal But No Resistance When Shifting Gears
I have a 5-speed transmission pickup (’04 Ford Ranger EDGE SuperCab). Clutch pedal feels "normal", No resistance when shifting gears. Will go into gear with ease, except for 2nd gear (grinding noise), must push clutch to the floor and still grinds; but only 2nd gear. In 1st gear, my truck will slowly creep forward as if unable to engage and not having any kind of pulling power. Even when shifting to 2nd, 3rd, 4th and 5th gears, it barely maxes out at 30MPH (top speed unless vehicle is on a slope or slight decline then I can get up to and over 40MPH. Checked brake fluid level, it’s ok. The fluid’s at max. Clutch is relatively new (April 2014), with only about 13,000 miles on it, if that. It must be cylinder issue. Is there any way to tell whether it's the clutch master cylinder or slave cylinder?
View 5 RepliesGolf/GTI VI :: Losing A Little Boost At Higher RPMs
I have been looking around for some boost information. I have come across a few threads that have boost graphs, but the images are no longer available. I have tried to get a hold of some of the posters, but no luck.
I only recently hooked up a boost gauge and have been monitoring my boost more. I had a slight feeling before I hooked it up that I was losing a little boost at higher rpms. Between 4500-5000 my boost drops from 18 to 15 and then from 5000-6000 it drops to about 10. I know it's sometimes normal for boost to drop at top end, but I'm not quite certain it's supposed to be that much.
I installed the Spulen Boost Pipe Kit hoping it may make some type of difference, but it's the same. What it might be? I have checked all my pipes as best as possible, but couldn't find anything.
Nissan - Versa :: 2007 - Clutch Feels Loose And Slight Grinding Sound When Shifting Only From Neutral To First Gear
Still chugging along!!
So, I haven't been the kindest car owner to my poor little hatchback. I do my best to get regular oil changes, but other than replacing the brakes last year, I have not kept up with most of the manufacturer's suggested regularly scheduled maintenance. The car has about 130,000 miles. Manual Transmission. My clutch feels a little loose, and I have been noticing a slight grinding sound when shifting (only from neutral to first gear).