GTI 337/20th Anniversary :: 2002 Not Shifting Out Of 1st Gear Until Warmed Up For 20 Minutes
2002 GTi 337 not shifting out of 1st until is warmed up for 20 min. Then shifts fine. I've already attempted to add the "liquid gold" G-052-990-A2 ATF fluid from VW at $35qt. I put in about 200ML to no change, then another 200ML to no change. So from reading other posts in VWvortex I've seen many folks with the Jetta have had very similar symptoms. They are installing a new (Solenoid valve N92 (green) to fix this issue. Many of them are even using over the counter synthetic ATF. Before I dig in, just wanted to know what folks with the GTi 337 think about this? Am I dealing with basically the same transmission?
View 2 RepliesGTI 337/20th Anniversary :: Hardly Gaining Any Speed When Driving On Highway In 6th Gear
So I was driving on the HWY in 6th gear cruising at about 60, and I go to speed up and when my RPMS hit about 3k or over it feels like I am pressing in the clutch, like my RPMS are going up but I am hardly gaining any speed.
View 24 RepliesGTI 337/20th Anniversary :: 1st And 2nd Gear Shift Fork Broken On 6 Speed Trans
My 20th Ann. GTI randomly would not go into first or second (they move into place but are just limp there and not catching into the gear) I was told for replacement of new 6-speed transmission and they did not offer any alternatives beside replacing it completely.
I know there is a thread talking about this but I read about the shift fork, or a piece of the shift fork that breaks and this problem fits my exact description. Not much info on what I can do, or at least not specified. What is any cost effective way to get my gears back without completely replacing the transmission? Is there anything I can do to just replace a broken part or are there any alternatives?
GTI 337/20th Anniversary :: O2M Shifting Fork Broke Again
Trying to find if any updates to this problem. Just broke a second fork yesterday- only issue I've seen is to simply replace with the same brass fork.
View 10 RepliesGTI 337/20th Anniversary :: Front End Rocks And Bucks When Shifting?
I just had new R32 rear lower control arm bushing installed but I still notice that the car rocks and bucks somewhat when I shift. I can control it I shift and accelerate slowly and deliberately but where's the fun in that?
I didn't replace the front lower control arm bushings but I'm starting to think I should have. Or maybe something else needs replacing??
Experiencing this bucking when shift? Maybe I just suck at shifting?
GTI 337/20th Anniversary :: 2004 - During Shifting From Gears No Movement?
was diriving my toy1and was shifting from 3rd to 4th when the rpm reved up and the car would not take any gears to drive foword or revers my gears when you shift are engagging but no mvement also i dont have to push the clutch in to shift it will go with out clutching.
View 9 RepliesGTI 337/20th Anniversary :: Gears Sounds Like Car Is Shifting But It Doesn't Move
First off i couldn't get the car into reverse to back out of a convenience store and then i let off the clutch to try and pump it again and the car just dies. drove just fine up until i parked. Now when i try to move through gears it sounds like it's shifting but the car doesn't move. The car does have a stronger clutch and unitronic chip if that would have to do with anything.
View 13 RepliesGTI 337/20th Anniversary :: Knocking Sound When Accelerating And Shifting From Stops
Quick q recently just got a gli and I've noticed a knocking sound when accelerating and shifting from stops could this be my motor mounts ? I was thinking my tranny or clutch but everything runs smooth and goes into gear fine
View 5 RepliesGTI 337/20th Anniversary :: Loud Popping Noise When Shifting Gears
sometimes when i switch from 1st to 2nd or 2nd to 3rd i get a loud popping noise like my exhaust is hitting the under side of the center column. I have had the car on a lift and shook the hell out of the exhaust...it's not moving enough to cause that loud popping...so i figured it could possibly be the dogbone mount gone and the downpipe is hitting when i shift because the mount is bad?
Or could it be one of the other mounts...I'm going through a divorce right now and really really broke so i need to make sure i get the right one and fix it right the first time. What mount it is if not positive its the dogbone?
GTI 337/20th Anniversary :: Rpm And Speed Gauges Get Stuck
Happened first yesterday. The rpm and speed gauges get stuck at the 10 o'clock position. Seems all the lights come on. I can accelerate for a bit but the car just putts and then turns off. After that i try to start the car and nothing. If i take the ground of the battery for 10 min (ecu reset?) the car starts right up but any sooner and it wont start. I have APR stage 1 flash, cat back exhaust, drop in filter, forge hybrid valve, and Boost gauge.
View 4 RepliesGTI 337/20th Anniversary :: ABS And ESP Light On After Reached A Speed Of 18 Mph
Title pretty much states it. A while back both my ABS and my ESP light would come on after I reached a speed of 18mph. After some research here I figured it was just a dirty sensor. So I cleaned the front ones and still haven't got around to the rear, but I told my mechanic to scan it. He says I need a new ABS pump which I am hoping, he is wrong. Printout says...
01276-ABS Hydraulic Pump(V64)
008-Implausible Signal - Intermittent
008-Implausible Signal - Intermittent
So I am hoping it is just dirty or unplugged and not the ABS pump.
GTI 337/20th Anniversary :: 2007 - Beeping Noise When Hit Certain Speed?
When I hit 32 mph my car beeps once and it displays "32 mph exceeded" and if i go 30 then pick up to 35 it will warn me again and beep, basically every time i pass 32 mph it beeps so its starting to get annoying and i played with the setting but cant seem to figure out how to turn this off?
View 3 RepliesGTI 337/20th Anniversary :: Steering Wobble At Higher Speed?
To say the least, I had a long winter. First I bent two of my RC's with potholes and blasted my power steering rack with some more potholes. So now I have brand new set of rims, a new steering rack and also when i did the steering rack, i threw some new ball joints on. I am still experiencing a "shimmy" in the steering wheel at higher speeds. What would be the next logical step to check out what could be causing this? Maybe control arm bushings?
View 20 RepliesGTI 337/20th Anniversary :: GLI Will Not Go Into 1st Gear
Driving home from work, I was about 5 minutes from home, got to a light only to not be able to go into 1st. I popped it into 2nd and drove home like that pretty much. Car will let me get into reverse and all other gears.
I can put the shifter towards first but it doesn't fully go in and when I gave it gas it would let me start to creep and then grind a little and pop out.
Heres a pic for your click .....
GTI 337/20th Anniversary :: Code PO322 - Engine Speed Sensor
I drive an 05 Gli n my car has been shutting off on me took it for a diagnostic n the code po322 came up engine speed sensor. So my question is. Is their a DIY on replacing the sensor I'm picking it up tomorrow. To be honest I don't even know where the sensor is located...
View 8 RepliesGTI 337/20th Anniversary :: First And Second Gear Won't Work
I have a problem with my 20th anniversary gti. My 1st and 2nd gear won't work. Every other gear works fine, the gears never grind before or any unusually noise. I was pulling off my driveway and they just stop working. Even when the car it's on I can move my shifter to 1st and 2nd without the clutch and nothing happens.
View 3 RepliesGTI 337/20th Anniversary :: No Reverse In First And Third Gear
So I get in the car to move my car this morning and I can't get the car into 1st gear. It turns out I can't get the car into reverse, 1st gear, or even 3rd gear. It feels like something is blocking me from even approaching those gears, however the others (2,4,5,&6) seem to be fine.
View 14 RepliesGTI 337/20th Anniversary :: Grinds A Little Bit When Going Into Third Gear From Second
I bought a rebuilt trans from a fellow vortex member a little over a month ago. I had it installed and ever since then when I am getting on it going from second to third it grinds a little bit going into third gear. It only does this when i get on it, but when im just cruising its fine. Could the shift linkage just need aligned? Or what else could it be?
View 5 RepliesGTI 337/20th Anniversary :: Refused To Go In 1st Gear?
As of two days ago my car ust refused to go into 1st gear. I know that it is a common occurrence with the 02j and shift fork, but 2nd works perfectly, so how could it be that shift fork?
View 16 Replies