Touareg :: Passenger Side Automatic Mirror Stuck In Down Position
Problems with the passenger side automatic mirror sticking in the down position (position it assumes when Touareg transmission is put into reverse). I have had my Touareg for about 1 week and the mirror does not return to the regular position when I place the transmission in drive.
View 5 RepliesGTI 337/20th Anniversary :: Side View Mirror Removal?
How do I get my driver's side view mirror off? I already have the glass and housing off. I need to get the base off of the door.
View 3 RepliesGTI 337/20th Anniversary :: Low Beam Only Work When Car Is In On Position
So I got this car for 750 and I did choose to take on the problems of the car for the miles on it and how much life I've seen these jettas go for I thought it was a pretty good deal runs and drive great except front left wheel bearing. Onto the lighting so found that the low beams only work when the car is in the on position and when the car is started and running the low beams do not work the bulbs are good because I replaced them and they work when the ignition is in the on position and I have check the fuses all seemed to be fine I also noticed that the only lighting I get on my cluster is the two display screens down on the bottom not even rpm/mph cluster? Could any of this be symptoms of faulty headlight switch? Or too much resistance somewhere?? I also notice my high beam switch also doesn't stay on I would have to hold the switch if I wanted to keep it on....
View 2 RepliesGTI 337/20th Anniversary :: Where Camshaft Position Sensor Located Under The Hood
The CEL just came on in my 20th AE Gti. The code indicates a Camshaft Position Sensor issue. Don't know where this sensor lives under the hood of the GTI? Is an easy enough fix for a beginner to attempt? (have hand tools, former bike mechanic, but no shop just a parking lot in the Texas sun!)
View 6 RepliesGTI 337/20th Anniversary :: Clock And Trip Odometer Resets When Turn Key To Off Position
Every once in awhile my car "resets." When I turn the key to the off position, my clock and trip odometer resets to 12:00 and 0.0mi and my radar detector shows a warning of low voltage.. I looked at all the fuses, and they are all good. And it seems to be intermittent.
View 3 RepliesGTI 337/20th Anniversary :: Engine Shaking Almost If Motor Was Bogging Down A Little
I have a 2004 gli and there r no lights an no codes but when I am driving the car shakes a little almost if the motor was bogging down a little. its nothing to major just a slight back and forth movement. I cant seem to figure out the problem it seems to go away during acceleration. Also one other thing is it seems to do it worse when its warmer!
View 1 RepliesGTI 337/20th Anniversary :: Rpm And Speed Gauges Get Stuck
Happened first yesterday. The rpm and speed gauges get stuck at the 10 o'clock position. Seems all the lights come on. I can accelerate for a bit but the car just putts and then turns off. After that i try to start the car and nothing. If i take the ground of the battery for 10 min (ecu reset?) the car starts right up but any sooner and it wont start. I have APR stage 1 flash, cat back exhaust, drop in filter, forge hybrid valve, and Boost gauge.
View 4 RepliesGTI 337/20th Anniversary :: Horn Stuck On When Start The Car
Weirdest thing happened this morning. I went to start the car and the horn was immediately on. I figured maybe the steering wheel was stuck. Anyways it went for a bit then while I was on the highway it came on and stayed on. People were looking while I'm going 60mph with the horn blasting. Anyways it went off on its own. I checked the fuse today and it is blown. I no longer have a horn. Why this happened? I will take the steering wheel off tomorrow to check the grounds.
View 4 RepliesGTI 337/20th Anniversary :: 2003 Stuck In Gear - Cannot Get The Car To Go Into Reverse
I parked the car yesterday and everything was working fine. I go out this morning to go to work and i cannot get the car to go into reverse. I put it in neutral and attempted to push it out of my parking spot, but when I took my foot off the clutch, it stalled like it was still in gear even though the stick was in the neutral position. While still in the neutral position, i can still move forward as if it were in first. When i put it in reverse and attempt to move, i get no movement. I can get it to move forward, but it refuses to go into reverse. I have no diagnostic lights illuminated and the car has no issues running or starting.
View 14 RepliesGTI 337/20th Anniversary :: Clutch Stuck To The Floor On The Highway
50k Miles on my clutch. Was driving a couple weeks ago on the highway and clutch stuck to the floor. At first I thought it was my Slave cylinder. Got the trans out this weekend to find the mess (below) inside my bell housing. Obviously need a new clutch now and will still replace the slave while I am in there.
Cars setup is around 375ish whp. I know I could spend 1300 bucks and call it a day for a clutch master or south bend but was seeing if there is a cheaper alternative.
Also If I were to buy an OEM clutch or an upgraded one that was not rated for up to 400~whp would it drive and pull the same as a fully upgraded one just not last as long?
6 Speed ...
GTI 337/20th Anniversary :: Clutch Pedal Stuck In Place - Could Not Put It In Gear
So last night I was driving home from work, and at a red light while i was waiting to go i had my clutch down when light turned green i tried to go and noticed i could not put it in gear and that my clutch pedal was stuck in place. i didn't know what to do so I checked my shifter plate everything looked fine so went to look at the pedal and i pulled it forward and it came lose. I started it up everything was fine and back to order. This morning going to work same thing happened again, I don't know what is going on and what could be the cause?
View 5 RepliesGTI 337/20th Anniversary :: Shift Fork Stuck In 3rd / No Neutral Or Reverse
Well, like the title says, The trans is stuck in third gear, with no other gears, or neutral or reverse. The car is slightly modified 02 GTI 337. APR Chip, Forge TIP, Full 3" exhaust, Greddy FMIC. I definitely drive the car, and had been beating up on it on the highway for a little on my way in to work, then on the way home, down shifted to pass someone, dropped it third, passed them, went to shift to fourth, Shifter moved, felt like it engaged "a gear" and then then i let off the clutch and it was still in third.
I also noticed that unless, I press the clutch in the, the car stays in this gear, even when the shifter is in neutral. I looked at the linkage, and it appears to be functioning. I did some reading around the Vortex and it seems like this might be a shift fork problem. Also, if the trans will be apart, what items should be upgraded?
GTI 337/20th Anniversary :: Drain Plug Stuck In Hybrid Oil Pan Hole
Changing the oil in my friends gli tonight and the drain plug ended up becoming stuck in the oil pan hole, just spinning in both directions and not tightening or loosening. He has the hybrid oil pan, and we took the bottom steel part off, do they sell just that part so I could fix the stripped drain hole, or should I try and salvage the one I have now and rethread the hole with a bigger drain plug?
View 1 RepliesGTI 337/20th Anniversary :: Huge Clunk Sound Seems Like Coming From Under Driver Side Motor Mount
I was sitting at the stoplight in neutral when the light turned green. I pushed in the clutch and put the car in first then all of a sudden a huge CLUNK like when you take out the starter bolt without supporting the trans or motor. Then while letting out the clutch about halfway all hell broke loose. It sounded like a bunch of marbles rattling like crazy in the trans. I pushed the clutch back in then it stops until you let it back out again. The car still moves forward and reverse but with all that noise. The sound seems like it's coming from under the driver side motor mount. When I put my hand on the tranny I can feel the vibrations very well. Does this sound like the throw out bearing?
View 3 RepliesJeep - Grandcheeroke :: 2008 - Passenger And Driver Front Windows Get Stuck In Down Position
Both passenger and driver front windows get stuck in down position. What do you think the problem is and can it be repaired by me?
View 2 RepliesGTI 337/20th Anniversary :: Headlight On Passenger Side Is Out
So I just recently purchased an HID kit for my GLI. After installing i went to turn them on and my passenger side is out. But when we tested both sides individually they both worked fine. I checked the bulb and tested it with a new one and the new one didnt turn on either. We tried 3 different ballasts and still nothing. I took it to my local shop where i bought them and they were stumped as well. We tested it for power and yes there is power getting to it. Along with all this, my highbeam light on my dash is on?
View 2 RepliesGTI 337/20th Anniversary :: Fuel Door Stuck / When Hit The Switch For Gas Tank Release It Is Completely Silent
Happened on my mk6 now on the 20th! When I go to hit the switch for the gas tank release it is completely silent. Could that be the module? Half a tank left so not to worried about bringing it somewhere.
View 2 RepliesGTI 337/20th Anniversary :: Passenger Side Glass Scratched Up
My passenger side window is all scratched up. This happened before I bought the car.
View 4 RepliesGTI 337/20th Anniversary :: Popping Noise Come From Passenger Side
I recently developed a tapping/popping noise come from the passenger's side of my GLI. The noise is kind of hard to explain, it's similar to the popping sound the seats make every once in awhile when you move around in them, if that makes any sense. I can't really get a video of the sound because I don't think it's quite loud enough. It's starting to get worse, and getting aggravating. It's not coming from the seat, it's more up near the front of the car, maybe where the door hinges are? I can't really pinpoint it.
View 5 Replies