GTI 337/20th Anniversary :: Power Will Cut Out When Driving With A Consistent Throttle Input
Mark IV GTI. Neuspeed intake, chip, exhaust. The situation is...
When driving enthusiastically, harder, and sportingly, the car runs beautifully!
When driving normally, such as highway cruise or lower speeds with a consistent throttle input, the power will cut-out. Then the max boost pressure will be approximately 3 psi until the key is cycled. Then normal chipped operation resumes. Since it is difficult to drive hard all the time, this circumstance comes up often.
There is a new N75 recently installed. The situation does NOT set off the check engine light.
I have noticed according to the boost gauge readings, it tends to happen between 10 inHg to 0 psi. Above or below that, don't recall it happening.
GTI 337/20th Anniversary :: Battery Light Comes On And All Power Lost
Every time I stop fairly quickly my battery light comes on and I loose all power. Lights, power steering, everything goes... Is this a connection problem? Its not the battery since I have to turn my car off and start it again for it to be alright.. What's going on?
View 14 RepliesFord Excursion :: Code P0102 - Mass Or Airflow Circuit Low Input
CODE P0102 "Mass or Airflow circuit low input" That was the code and upon checking my records prior to storing it for the year. I installed a new IAC,MAF, Fuel Pump and lots of new hoses, PCV, Fuel injection regulator. The Vehicle has only 110K miles. Now here is the clincher, after doing just the fuel pump it ran perfect for at least 25 miles, perfect I say. When I shut if off I got the check engine light, and thus the code which led me to install the other stuff. Now after pondering the matter, seems that it acted in a similar way PRIOR to my doing anything but there was no code previously. Like maybe some strange electrical connection, or something.
View 1 RepliesGTI 337/20th Anniversary :: Fault Codes / Power Drop - AC Heater Controls Dials Lights Are Out
So I picked up a 337 a little while ago, which I absolutely love, but there are some fault codes I have to deal with. Pretty sure I took care of the ABS hydraulic pump code. The ABS and ASR light came on after driving in some snow, but I found a thread about that, cleaned the fuses and the light is no longer on.
The following are the problems I am experiencing while driving the car:
I am seeming to have a power drop in 1st gear at low rpms. I have never driven a turbo'd car but I don't believe this is just turbo lag. It isn't a quick increase in power, rather a brief decrease, sort of like it's bogging down. I thought it was just me at first, but I have noticed it too many times and my gf even noticed it. I am not sure if this is related, but I thought I would mention it.
On occasion the dash lights will flash off then back on and reset my trip odo and clock. This has been happening more frequently as of late. It normally happens when I turn the lights on, or switch the brights on. The engine has completely turned off once at a stop light. I am currently searching all the codes online and am hoping to find a solution, but I am definitely concerned.
Also the AC/heater controls dials lights are out (just the three dials), and the 12v power outlet is not working. I tried switching the fuse but it isn't that. Thought this might connected. Final bit of info, the instrument cluster had a problem and was replaced by a dealer on November 29th. I don't know much more about it, I bought it right after that was done. Here are the actual fault codes.
Address 01: Engine
Labels: 06A-906-032-AWP.lbl
Part No: 06A 906 032 ML
Component: 1.8L R4/5VT G 0001
Coding: 07510
[Code] ....
GTI 337/20th Anniversary :: Lost 5th And 6th Gear?
I was driving and went to shift from 5th to 6th and when in 6th the engine just revved freely as if it was in neutral. When I tried to get back into 5th it did the same thing. It's also very hard to get into 1st.
I want to try the alignment but I can't find one specifically for the stock 6 speed and I don't have my Bentley DVD on me.
GTI 337/20th Anniversary :: Lost All Throttle And EPC / ASR Light Appeared
Getting onto the freeway, not putting the gas to the floor or anything, my throttle completely cut out on me and the EPC and ASR light came on. Turned off the engine, let it sit, and it fired right back up with no lights on.
Replaced the valve cover gasket recently and had a somewhat rough idle since, not sure if the coil over isn't all the way down but will investigate soon.
GTI 337/20th Anniversary :: Lost 1st And 2nd Gear - Swapping Transmission?
Alright so basically i lost 1 and 2nd gear and i want to replace the transmission since this one already has 150k on it. The hard part is finding a used one because of the six speed! What models can i swap transmissions from? Like i heard i could use a 2003 Audi TT six speed transmission! What I can use to swap out my transmission or do i have to just look for a used one specifically for a 20th?
View 20 RepliesGTI 337/20th Anniversary :: Boost Lost - Limp Mode?
Was driving the other day and one of the couplers came loos and I lost boost and went into limp mode. I pulled over, got it reattached, and after that it would only hit 10 lbs. i have a KO4-001 with the GIAC file and it usually hits 20+ and holds 20 lbs. I have a regular code reader and I had a code for the EBC, cleared it, rechecked the hoses, and verified with the flash loader that I was on the correct file, but it is still only hitting 10 lbs. What else I should check.
View 1 RepliesGTI 337/20th Anniversary :: Lost 1st And 2nd Gear / Feels Like In Neutral
I was driving fine, pulled into 7-11 to get some drinks and came out went in reverse to get outta the parking spot and put it in first and didn't go anywhere....
When i put it in first or second it feels like its in neutral and the car doesn't stall. 3 through 6 gears are fine.....
GTI 337/20th Anniversary :: Randomly Lost Acceleration - Misfire When Hit Over Boost
Ive been having two issues with my GLI lately, last week while driving on the parkway my car just randomly lost acceleration, no lights came on but the gas peddle was unresponsive. I was able to restart it while coasting and thought nothing of it. Then it kept doing it. It was raining that night but ive never had an issue before. Other times it dies it is sunny out. The second issue is sometimes when I hit over 10lbs of boost the car will start to misfire and run like crap. No CEL's come on the dash but if we scan it with VAGCOM it says theres misfires happening, obviously. Already did a smoke test and there are no vacuum leaks.
View 19 RepliesGTI 337/20th Anniversary :: Small Grind When Downshifted Into Third And Then All Gears Lost
I have 20th gti and I downshifted into third the other day and heard a small grind and all of the sudden I lost all my gears, I couldn't shift into anything and was stuck in third. I was able to move the shifter up and down from 3rd neut to fourth without engaging the clutch but it was all the same gear:S I managed to get home in third considering I was close by and when I stopped i was able to throw it into reverse but it would act like i was in a high gear(either 4th 5th or 6th I am not sure).
View 4 RepliesGTI 337/20th Anniversary :: Getting Too Many Error Codes?
Ok, It doesn't start, it tries to but doesn't get there, its not the battery the alternator, the starter or the battery terminals which goes to my second question...for error codes do I just pop them in google to see what they mean or is there a better site??....reason why I'm removing the lip its because its being towed to the mechanic, its at my job's parking lot right now, first time ever my VW leaves me stranded but I guess it happens:
Error codes I got:
p0261
p0267
p0270
p0264
p0445
p0037
p2257
p0010
p0414
p0141B
Passat (B5) :: CEL Codes P0102 And P1137?
So my check engine light came on (2000 Passat 1.8T) and I have one of the generic code readers and got this:
1. P0102
Powertrain: Mass Air Flow (MAF) Sensor Circuit Low Frequency
2. P1137
Powertrain: HO2S Bank 1 Sensor 2 Lean System or Low Voltage
Now last time I had the car in they said I needed to have my throttle cleaned, but I just didn't have the time then. Could this be the reason or am I looking at bad sensors? It's weird, because the car isn't really driving any differently. I have had one side effect though, my turn signals won't come on and the hazard lights will come on, but not always. All the interior lights, headlights, brake lights are working fine.
GTI 337/20th Anniversary :: Backfire - 11 Codes Appeared / ECU Is Going Out?
For about two months I've been having a backfire problem but only when I get on it. We checked for leaks and nothing . The car had 11 codes and were all short to ground. Mechanic is saying my ecu is going out and I need a new one. Is it possible?
View 8 RepliesGTI 337/20th Anniversary :: Receiving Awp Engine Codes During Ecu Swap
I am trying to swap my ecu for a chipped one out of an 04 gti 1.8. Both awp engine codes. I programmed the immobilized and the car doesn't start. I am thinking it has the ignition kill feature but the guy who sold it to me doesn't think it does. i was just wondering if the ecu's are compatible even though the part number is different.
View 8 RepliesGTI 337/20th Anniversary :: Cylinder Misfire Codes For OBDII?
I changed my sparkplugs and coil packs last month. Was getting CEL light but it would go away after a while. I figured out that I had gapped my spark plugs way to small (almost touching) so I took them out two nights ago and regapped/ reseated them.
My car was running fine yesterday, but today when I started my car up, the engine was shaking a lot for about 10 seconds and the CEL was blinking. After 10 seconds the shaking and CEL went away...
It drove fine. I'm just wondering what could be throwing these CEL's and causing the shaking? Plugs are gapped to 0.32
Also, I had my timing belt and water pump replaced almost two weeks ago now. Any chance that could be lending to the problem?
My guess is that one or more cylinders are screwy. I'd rather not bring it into the vw mechanic since I'm tight on cash.
GTI 337/20th Anniversary :: Over Boost Codes / Limp Mode
There ended up being 6 or 7 codes. Originally the first O2 sensor and wire seemed to go bad, I replaced them and it ran well for a couple days and then started running like ass again...Now there are a few codes, none for the 02 sensor, but for over boost issues...Does this mean my n75J valve is causing the problems? Is it possible that my software is just going bad? ...I bought the car somewhat molested and don't quite know the extent of the parts on it, nor the brands( specifically, the software...).
The current codes being thrown:
P0238 mani pres g31 sig to high
P0234 overboost
P0106mani barometric sensor g31
We replaced the manifold pressure sensor, and am not having the issues but they could and probably will come back after 50 or so miles...Previous code also was P1114 02 sensors and we replaced the front sensor. It may be that the software that is on the car is starting to go..
GTI 337/20th Anniversary :: After Installation Of Intake Getting Codes 16485 / P0101
I am having an issue after my intake install, it was working fine all day and last night i get a light on the dash bored (looks like the one when you take off the esp) and I get this:
code 16485 Mass Air Flow Sensor (G70) Implausible Signal : P0101
Static - No
What could be the cause of this because i ran this intake before no issues I only took it off and put the stock intake back in due to the rain but now since the rain is gone i decided to switch
GTI 337/20th Anniversary :: Codes P1007 / P0011 With Check Engine Light Came On
I have a 2003 20th ann. GTI, it shut off on me on my way to work. It would turn on but only for a sec and turn back off. I turned it on and tried to move it over out the way of traffic and wouldnt move and turn back off. Got the check engine light checked and the codes P1007 which is coolant temp sensor and P0011 which is camshaft sensor. I replaced both and problem not solved car will start but wont go and turns back off, black smoke and a strong smell of gas comes out the exhaust.
View 3 Replies