Damage :: Timing Chain Was Grinding - Metal Shavings In The Oil
OK, I just recently discovered my timing chain was grinding. Now, there are metal shavings in my oil and filter. What would you recommend to flush the shavings out of the engine, so it doesn't cause further damage? Other than this, my truck is running perfectly fine. It has 106,000 miles on the motor. Are there any other concerns that I should consider?
View 10 RepliesGTI 337/20th Anniversary :: Timing Belt Same For 2004 Or 2005 GLI?
is the timing belt the same for the 2004.5 and the 2005 gli?
View 1 RepliesGTI 337/20th Anniversary :: Engine Overheating After Replacing Timing Belt
I replace my timing belt and water pump and my engine is now over heating. I notice it's only over heats when the ac is running and the engine is idling. When I start to drive the engine temp goes down.
View 1 RepliesTiming-belts - Belts - Volkswagen - Touareg :: 2004 - Timing Chain Malfunction At 90,000 Miles Common?
I brought my 2004 VW Touareg V6(83k miles) to the dealer for a recall on the ignition call and much to my surprise, was presented with a diagnosis of a $6,000 problem! The dealer told me that the computer read some codes which say that the timing chain is stretched and needs to be replaced. They said it will take 4-5 days and should be done asap so it doesn't "go out", because if it does, it's an even more expensive problem. I took the car to another VW repair shop and they asked me if I heard any noised when I start it cold (like pebbles in a bucket). I have not had any problems like that at all, so they said I shouldn't worry until I start getting symptoms. They also said there is no recommended point (like 90,000 miles) when VW recommends the change, so it really shouldn't be a common problem. I want to do the right thing, but I don't want to rush into an expensive repair if it isn't necessary.
View 1 RepliesPassat (B5) :: Timing Chain Won't Working - Blown Engine?
I posted my passat to sell/part out last week. So I talked to the mechanic today and he hasn't looked in the engine. He just says that when the timing chain goes it wrecks the valves and pistons (needs rebuild). HE WAS TRYING TO SAVE ME MONEY THOUGH...FAMILY FRIEND. My sister got lucky on her passat and only messed up the valves. But she was sitting still....I was doing 80mph on 95 going to work. Should I have the engine looked at or sell it.....what are the odds I got lucky??? I found a lot of posts/blogs about how everyones engine blew, but no one said they got lucky.
View 9 RepliesToyota - Avalon :: 2004 - When To Replace Timing Chain
I'm told by my dealer that I must replace the timing chain by 100,000 miles. I've also been told by others who've driven multiple vehicles over 250K miles that they've never replaced a timing chain on any of their vehicles. Who's right in this case?
View 9 RepliesFord F-150 (2004-2008) :: Timing Chain Replacement?
I have a new style 2004 F150 XLT supercrew with a 4.6. Well, I just hit 300,00 miles earlier this week. The truck has performed pretty much flawlessly over the years (and still does). I've replaced front hubs, IWE's, brakes, fluids, etc, but have NEVER opened up the engine. Is it time to replace the timing chain?
First thought is ,yes, like 50,000 miles ago, but... It has some dents and dings and the rust is getting to it. There is 300,000 on the transmission also... Virtually no residual value- If it strands me on the road, it's time for a new truck.
On the other hand, it only burns a little over a quart at 3000 mile change intervals, the transmission seems strong. I just shampooed the cloth interior and detailed it. The thing looks great from the vantage point of the steering wheel.
No engine issues at all- no rattling, etc.
Subaru - Forester :: 2010 2.5X Automatic With Timing Belt Or A Timing Chain?
I was thinking about checking out the above vehicle at my local dealer (Chevrolet). They're asking 15.9k and it has 57k miles. I need to know if it has a timing belt or a timing chain and how reliable is the engine/transmission.
View 1 RepliesMaintenance / Repairs :: Loose Timing Chain Cause Engine Miss?
is it possible for a loose timing chain to cause a engine miss.
View 1 RepliesFord - Explorer :: 2004 SOHC - Timing Chain Failure
Replacing the timing chains and tensioners on an SOHC Explorer, only to have the tensioners fail again after only a few thousand miles? I'm a pretty experienced back yard mechanic and have rebuilt several engines over the years with great results, but this one has me stumped. The only part of the instructions I did not do was to remove the valve springs, but everything was lined up as it should have been using the special tools required to set the timing. I really like the truck, but don't know if it's worth fixing if this is just going to happen again.
View 3 RepliesExplorer :: 2005 Ford - Timing Chain Rattle When Engine Is Running
I have a 2005 Ford Explorer with a 4.0 SOHC while the engine is running the left side timing chain rattles. I replaced the timing chain and guides and tensioner, the engine has good oil pressure but the noise is still there.
View 2 RepliesCamry 2012+ :: Timing Chain Rattle Noise Coming From The Engine?
I've noticed a noise coming from the engine which sounds to me like the timing chain. Seems like the tensioner is keeping the chain a little loose while the RPM's are low. The rattle doesn't happen all the time; only when I let off the throttle or accelerate keeping the RPM's low.
This is just my guess that it's the timing chain. I had heard a similar rattle in my old I35 and I had to change the timing chain tensioner.
I'm going to check the engine oil level tomorrow morning. This 10,000 mile oil change is really starting to seem like a not so good idea! Right now I'm at 9950..
Santa FE SM (2001-06) :: Rattling Sound In The Engine - Timing Chain Or Belt?
My 2003 Sante Fe has developed a rattling sound in the engine. The oil level has been good. I took it to a dealer for diagnoses and they told me that the engine was gunked up and the timing "chain" tensioner couldn't move to keep it tight and it was rattling. They put some engine cleaner in and changed the oil and wanted me back in 500 to clean it again. I did that again, but the rattle is still there. It gets a little quieter after I have driven it for a while.
My question is doesn't the Sante Fe have a timing belt? If that is the case what do you think the rattle is?
Ford F-150 (2004-2008) :: Passenger Side Timing Chain Guide Badly Damaged - Replacement?
So working on a 2005 F150 with a 5.4. Started off as a phaser replacement. Turn out the passenger side timing chain guide was badly damaged. Front timing chain cover came off and replaced the guide and phaser. Got everything back together and it ran rough. Pulled the front timing cover off and the passenger side was off a tooth.
Retimed that passenger side and also replaced the tensioner because the seal on the old tensioner wasn't the best. Now rotating the engine, i noticed the tensioner pushes then retracts. Seems like a vacuum is created pulling the plunger in, but not entirely sure. Only the passenger side does this, not the drivers side.
Worried about putting the front cover and valve covers on, buttoning everything together and having it skip another tooth because of slack in the chain. Any fix for it or reason why it does it?
GTI 337/20th Anniversary :: Engine Code For 2004.5 GLI 1.8t?
whats the engine code for the 04.5 gli 1.8t???
View 5 RepliesFord F-150 (2004-2008) :: 2005 - Replaced Timing Chain Kit / Phasers / Solenoid But Truck Stalls At Idle?
Just got 2005 screw fx4. Seemed to run ok 115000 mi.Had exhaust leak,I put on 3" cat back on. Then I noticed tapping at front of the engine.Turns out tim. chain guides are broken. looks like very common prob after reading many forum/threads. Anyway got timing chain kit, phasers, selinoids. Truck runs and sounds great.But so far had truck back 2weeks stalled 2x at idle.What next??
View 14 RepliesGTI 337/20th Anniversary :: Grinding Noise While Engine Braking On 2004 Jetta GLI V6
2004 Jetta GLI V6 24v 6 speed ... This started a few years ago, but it was happening in 3rd gear only -- therefore I avoided engine braking in 3rd gear all along. The noise was a pretty loud, noticeable grinding/spinning noise. 3rd gear while accelerating or maintaining gas worked and still works perfectly, smooth as can be.
Somewhat recently (6mo-1yr ago) all the other 5 gears started making this grinding noise, some more than others. 1st gear I don't really know because I don't engine brake in 1st. However, 2nd, 3rd, 4th, 5th and 6th (barely noticeable but still there) all make the noise. I now of course avoid all engine braking, however even the transitional steps between gears can be heard sometimes ... unless I perfectly match the RPM etc, but I'm just trying to get to work and back here ...
The car is still quite drivable, but with a major obstacle (pain in the ass) and a new clutch is probably around the corner -- I have 107K on it now. However ... a few years ago when it had 26K on it .. it didn't need a new clutch yet 3rd was still making that noise.
GTI 337/20th Anniversary :: 2004 GLI Started Jolting Like Going To Stall And Check Engine Light On
So yesterday i was driving fine and all of the sudden the car started jolting like it was going to stall and the check engine light came on. I pulled over popped the hood to see if there was anything i could see and got back in and took off no problem and the light went off. I starting pushing it and accelerating it to see if it would come back on and it didnt. Today it started doing the same thing but this time the light stays on and every time i change gears it does that jolting like its going to stall.
Its a 2004 gli 6 speed gli 1.8t ....
Passat (B5) :: Piston Damage After Broken Timing Belt
I recently broke a timing belt on my 1999 AEB 1.8t Passat. I'm in the process of doing all of the repairs myself while working around my college and work schedule. I have yet to pull the head off, and I'm scared of what I'll find when I do. Should I expect any piston damage? I have one completely broken valve and a bunch of bent valves.
View 12 Replies