Ford Fuel System :: Changed Fuel Filter Now Just Cranks But Won't Fire / Start

2002 E-250 with the 4.6 V-6. Pulled the 30 amp fuse, replaced the fuel filter, replaced the fuse, now the truck wont start. Checked the fuse and the kill switch under the passenger kick cover, all ok. Cranks and cranks but wont fire. No problem prior to changing the filter. Even swithed out the relay with another, no luck.

View 4 Replies

Sierra :: 2003 - No Fuel Pressure At Cold Start

I have an 03 Sierra Half Ton when the engine is warm it runs fine but at cold start, half the time it doesn't have the fuel pressure to start, i have to turn the key a couple times to build it up. Idk if the fuel pump is weak for if it would be more the regulator. I started having this problem after i replaced the fuel pump. The fuel pressure gauge shows 50-55 lbs, but every now and then when its cold it will only jump to around 5 lbs (but this is only when the engine is cold... why?) What should i go after first? Regulator, new pump, Replace the fuel filter again?

View 2 Replies

Ford 7.3L Power Stroke (1999-2003) :: Cranks But Won't Start - Fuel Pump Not Pumping Fuel

01 7.3. Cranks, won't start. Tank was at 1/4 but is full now. The lift pump runs, I can feel and hear that the motor is spinning when I cycle the key. I removed the fuel filter and cycled the key and get no fuel into the bowl. It looks like the lines are stainless from the pump to the tank so I doubt it is sucking air. I pressurized the tank with a shop vac and I get fuel coming into the filter housing. Am I missing something obvious? I have never seen an electric pump that would run and not pump fuel. I removed the suction line at the pump and don't feel any suction there.

View 14 Replies

Golf V R32 :: Cranks Over / Get Fuel And Try To Start Then Putters Out

Car cranks over. Its getting fuel (you can smell it). Sometimes it tries to start but then putters out. Cam Position sensor? I haven't had a chance to pull codes. Ill hook it up to a vag com in the morning when i get back to work (car is parked there for now).

View 24 Replies

Gmc - Sierra :: 2003 - No Cranks Or Clicks / Just Complete Silence

I own a 2003 Sierra 1500 SLT Extended (4-Door) Cab which I bought brand new. It currently has 120k+/- miles on it, but the problem I'm about to describe started about 5 years ago. Here's the issue: Whenever I first attempt to start my truck, I know the odds are 50/50 that it will actually start. When I turn the key, it will either crank right up like it's brand new or it will do nothing at all--no cranks, no clicks, just complete silence. When the weather is colder, the chances it will start are slightly better.

Those chances go downhill as the weather improves--the frequency of "non-starts" increases. I have had a whole lot of mechanics--both physical and virtual--try to diagnose this problem. I even left my truck at a GMC dealership for 4 days so they could replicate the problem and diagnose it. Unfortunately, my truck started on every attempt they made which was 2 or 3 times per day. The only hint of where the problem my lie came from an automotive electronics technician. He said he can't be sure unless he replicates the scenario, but he said the factory installed alarm system is most likely the cause.

View 4 Replies

Accent LC (2000-05) :: Cranks But Will Not Start / Fuel Pump Was Not Spinning

Accent that will crank but won't start. I found out that the fuel pump was not spinning, so I purchased a replacement. Before installing it, I connected all of the wires and the new pump wouldn't spin either. I then hooked the pump directly to the battery and it spins with no problems. After that I realized that the power wire for the pump must be shorting somewhere. So I hooked up the old pump and ran a new power wire from the relay box to the pump. The pump now runs, but the car still won't start. I definitely have fuel to the rail now. I unhooked the fuel line at the fuel rail and it sprays as soon as I turn the key to "On". Now all I need to know is if I'm forgetting something (bleeding the fuel rail?, etc.). Are there any other parts I'm forgetting?

View 24 Replies

Golf V R32 :: How To Check Fuel Pump - Car Taking 8 Cranks To Start

Lately my car takes 2-3 cranks before it starts and I'm thinking it could be my fuel pump. There were a few times recently it took like 8 cranks to start. How to test fuel flow to see if it has issue? Also, could a old battery cause this issue?

View 18 Replies

Ford - Suspension :: 2001 - Won't Start But Cranks / No Fuel Is Getting To Injectors

After driving my truck for a few hours a day it doesn't want to start it cranks ok but it just wont start it feels like no fuel is getting to the injectors. I let it cool down around 30 min then it just starts this happens to me twice a week approx. i replaced the fuel crank sensor. but to no avail.

View 3 Replies

Golf IV R32 :: Cranks Fine But Won't Start, Fuel Pump Doesn't Shut Off

The car cranks absolutely 100%, in no way is this the battery, it just will not start. Then I noticed the fuel pump wasn't shutting off, I only had a quarter tank in the car, I figured as hot as it was today I was getting some vapor lock with the fuel. Went and got some gas, still wouldn't start, then the dash started yelling at me telling me I have no oil pressure, shut off the car.........car you are not running calm down. So then there's that along with the car not starting. I took the fuel hose off to make sure I was getting fuel, I was, so I took the key back out, but the car would not give up, the fuel pump kept going and the dash was blinking violently. When I put the hose back on and got compression it finally stopped, that can't be how the cars work can it? The fuel pump doesn't shut off if there's no compression? Checked all fuses and the fuel pump relay, every was fine, the fuel pump even still ran with the relay out. What could be going on, I can't seem to find one damn thing even related to the fuel pump not shutting off.

View 24 Replies

Golf IV R32 :: Cranks But Won't Start / No Spark And Fuel Pump Not Making Any Noise

Was driving normal and my 2004 r32 died. It felt just like it ran out of gas. Fuel pump was not making any noise. I replaced fuel pump relay and now i can here the fuel pump making noise. Pulled the fuel pump line off and fuel is coming out the line. So now i checked for spark and have none. I have 12 volts at the coils. I ohmed out the crank sensor and have .777 k ohms. I also checked codes with generic snap-on scanner and found no codes.

View 2 Replies

Astro - Chevrolet :: Cranks / Has Park And Getting Fuel But Won't Start After Rebuilding The Motor

I have a 2001 chevy Astro 2 wd. After rebuilding the motor it cranks has a spark and is getting fuel but won't start. Has a new starter new battery new coil crankshaft position sensor new distributor, cap and rotor plugs and wires but does not start...

View 3 Replies

Golf IV / Jetta IV :: 2005 1.8t AWP Cranks But No Start - Cannot Hear Fuel Pump Priming

2005 1.8t gti wont start. The other day I was driving on the highway when a thin plastic type wrapping got caught in my serpentine belt. The car immediately died and I hit the gas and nothing and with no power steering i pulled over to the side.

Timing belt was done with water pump and tensioners
Spark plugs and coils are brand new

What fuel line to disconnect to test if the fuel pump works? Like I said in the title I cant hear the fuel pump priming. The engine was running 100% before this 2 techs saw it and the vw dealer i workrd at looked it over.

View 7 Replies

Ford Ranger / B-Series :: 1998 4.0L Cranks But No Start / High Fuel Pressure

Made a trip to the hardware store yesterday. When I came out, the truck would crank just fine, but wouldn't start (98 4.0L 4x4). Tried adding gas, no luck. I had actually called a wrecker, but it eventually started after sitting for about an hour. All I did differently was hit the gas pedal a couple of times. Thinking it may be a low fuel pressure problem, I took it to autozone this morning (started it about 4 times now with no problems). Checked the fuel pressure, and it sat at a solid 65 lbs at idle. I tried holding the throttle open and it stayed at the same pressure. I forgot to try with the vacuum off.

First off, I've seen some people say 60 lbs is right, but more say it should be at about 45lbs. 45 seems right since the fuel return is on the block, not on the pump. I'm guessing the fuel damper went out, but is there any good way to check it? Also, since the damper is vacuum controlled, would a bad vacuum cause this problem? Third, could high fuel pressure cause it to not start? That's the one I'm most worried about what was wrong there.

View 14 Replies

Ford Super Duty (1999-2016) :: 2002 F350 7.3 - Cranks / No Start And Not Getting Fuel

OK, I have a 2002 F350 with 160k miles that cranks fine, but has a hard time starting when it is cold. By cold I mean that it is not hot from being driven in the last 5 hrs or so. No problem starting after being at rifle practice for 3 hrs or after a trip to the store. Always have trouble starting in the morning, like this morning when the temperature outside was 49 deg. I have to crank for quite a while to get it to turn over, but once it catches, it runs like a champ. Afraid I'm going to wear my starter or batteries out because It seems like I have to crank for about 2 minutes.

I have a fairly new CPS replaced less than 15k miles ago, new glow plugs, and recently replaced the leaky bleeder valve on the bowl. This difficult starting condition came about some time before the bleeder valve seal repair, and is still doing it after the repair. This problem seems to have cropped up on it's own unrelated to any work I have done. I am using Mobile 1 5W-40 diesel oil. When the no start occurs, there is no smoke present out of the tail pipe like what you would get if you had bad glow plugs. There is just no fuel getting into the injectors.

View 2 Replies

Ford Wiring/Electrical :: 2004 Taurus Hard To Start / Cranks But Acts Like It Is Not Getting Fuel

While the owner of 2 Ford Trucks, I also have a 2004 Ford Taurus with 28K on it. For a while now the vehicle is hard starting, cranks but acts like it is not getting fuel, however, I can hear the pump come on. Other times it starts right up, but a clicking sound can be heard coming from the firewall area. At times the gauges will not immediately respond when the Vehicle is started and then all at once they will begin to work. Now, my check engine light is on, but my hand held obd will not read it. All the terminal pins look great, obd tester works on my other two vehicles, cigar lighter working, the fuses i checked are good. Vehicle runs great. Can this all be related to a bad module?

View 1 Replies

Ford 7.3L Power Stroke (1999-2003) :: 1999 - Cranks But Won't Start - Water In Fuel Light On?

My 99 F350 cranks, but won't start, and the "water in fuel" light on the dash stays on while cranking. I have never paid close attention to it in the past. Is it supposed to be on while cranking?

I drained the water from the yellow lever located on top of the engine, and tried to start it. The light went off for the first few cranks, but again the truck still will not start.

I just came from a 10 hours round trip to NC. I filled the truck up two times from gas stations on the way. Is it possible that the fuel is bad? I drove on the same fuel almost 3/4 of this tank and now at the last 1/4 I am having this issue.

A little update:

I took the top of the fuel bowl off to see what the filter looks like, and it is nasty and completely black. I could not tell if the fuel in the bowl contained any water, but it looks greenish and uniform, no the obvious separation that happens when you mix water and oil.

Could the fuel filter be the problem?

A little history about the truck. It's always hard to start if cold and not plugged in overnight. I know it's the glow plugs relay, so I just keep it plugged in all the time until I get a chance to fix it.

IDM was acting up shutting off half of my engine, but I took it off, cleaned it, plugged it back in and it has been working fine for over 2 months.

View 14 Replies

Sierra :: 1992 GMC Truck Fuel Pump Went Out

I have a 1992 GMC step side, short bed, 350 engine, Sierra, auto trans, factory air, factory exhaust, power steering.......

Three years ago the fuel pump went out. I have to work alone so I lowered the tank after draining and went through a lot of agony with floor jacks, supports, etc. but finally got the job done in 3 days.

The replacement was a Bosch fuel pump.

It went out today while I was at Sams stores. I got a pull home and it is in my driveway.

It started up once I got it home, but that is what it did the last time it went out, 3 years ago.

Question...should I check the ground first to make sure it is not getting intermittant ground or just do the job with a new pump?

Also, can I do this job by raising or sliding the bed after I unbolt it? I have heard war stories but no actual person that has done it.

Also, when moving the bed either up or sliding it back, isn't there a concern about wires that go to the tail lights?

I cannot afford the 500 dollar shop fee to have it towed and fixed.

View 6 Replies

Sierra :: 91 GMC 5.7 - No Fuel From Throttle Body When Cranking

When cranking there is no fuel from the throttle body. Dropped the fuel line on both sides of the filter that was replaced last fall and have good flow before and after the filter. If I spray starting fluid down the throttle body it will fire. Switched out the throttle position sensor and idle air control valve to no avail. It used to die after warming up every so often at a stop light but would start right back up, now it just quit and wont start ???

View 1 Replies

Sierra :: Fuel Tank Pressure Sensor - Code P0453

I have the code P0453 set and believe I need to replace the fuel tank pressure sensor. I have the part and want to know if this part can be replaced without removing the fuel tank. There is a video on youtube that shows replacing the part by lowering the tank with a transmission jack after the straps have been removed. Replacing the sensor by touch and feel maybe using mirrors to see what you are doing? It might be possible to cut a hole in the bed and patch it later but that seems pretty time consuming too.

View 1 Replies