Ford Wiring/Electrical :: 2008 - With Climate Control On CC Won't Work - Printer Noise Form Dash?
Just purchased a 2008 F250 V10 Crew Cab with 64,000 miles. The truck has some electrical issues that didnt show up during the test drive/inspection. It seems that the HVAC head unit causes some interesting things to happen. The most obivous problem is that when you turn the climate control on and turn the fan speed up the CC will not work. If you turn the fan off but leave the HVAC control on CC starts working. At this point you can turn the fan speed back up and everything stays working. Not sure if its related but it also has the printer noise going on behind the dash which Ive read is the one of the blend door actuators going bad and the keyless entry pad will not accept a personal code(everything else works on it, factory code, lights up, two button lock). Any checks?
View 1 RepliesFord Wiring/Electrical :: 1991 F250 - Dash Lights Have Gone Out Entirely
I have a 1991 idi diesel f250. My dash lights have entirely gone out and i cannot seem to figure out why, i checked the fueses under the driver dash and under the hood for that matter and nothing is blown.
At the same time, the dome lights, door lights, cab lights, stereo, windows, ever the light in the ash trey etc, work perfectly fine. Could a wire have come loose behind the dash cluster and shorted out everything in the driver area?
I still get the high beam signal, check engine, engine, wait to start, and water in fuel light in the cluster. but no back lighting (when turning the key to the on position)...
Ford Wiring/Electrical :: 1978 F150 - Dash Lights Are Not Working
Dash lights are not working in my 78 F150. The climate control lights come on and are dimable with the headlight switch. I pulled the cluster and the Blue/Red wire has voltage. Which might be the ground? The Seat belt light comes on at start and the left turn signal will blink. What am I missing. Oh the cluster is deteriorating. some of the bulb holes are chipping out.
View 1 RepliesFord Wiring/Electrical :: 2006 F350 - Exterior / Tail And Dash Lights Out
Looking for a schematic on this truck,standard cab diesel. I have a dead short on exterior lamp fuse. I have no tail lights, running lights, door ajar light is also on.
View 4 RepliesFord Wiring/Electrical :: 2005 - No Dash Lights / No Gauges - Rough Idle?
OK, I just got done replacing the alternator on the wife's 05 escape 3.0 V6, after it started on fire. The 3 wire plug was melted onto the alternator, so I had to replace the pigtail. I'm 99.9% sure that I got the wires in the right place. But now, after putting it all back together, it idles sporadically, when I drive it seems almost like it's trying to start out in 2nd gear, and shifts oddly. And there are no dash lights or gauges. Headlights work fine. And everything worked normally before I took it apart.
View 1 RepliesFord Wiring/Electrical :: Brake Lights / Cruise Control / Rear Hazards Not Working
1991 F250 Supercab Diesel 4X4. I made a mistake while wiring up my trailer lights and ended up grounding out my brake controller, frying it. Along with that, I popped a couple fuses as well (1, 5 and 9 I believe). Replaced all fuses and got my signals (F/R) back at least.
Here's what's NOT working/messed up:
*Brake Lights
*Cruise Control
*Rear ABS light comes on a few minutes after driving.
*Front hazards work, not rear. When I apply the brake, the hazards pause in the on position.
I've tested the brake switch on the brake pedal (Green/Red and Green) and it works properly. So, current is obviously not reaching the rear brake lights.
Another note. The truck is wired with a 7 pin plug in the bed for a goose neck trailer. It also was wired to a 6 pin on the bumper. I replaced the 6 pin with a 7. The signal/brake pins on the plugs (both) and also not receiving power. What's the next thing to check?
Electrical-wiring - Acura - Rl - Gauges - Starters :: 1997, Battery And Brake Lights Came On After Alternator Replaced
I got my Alternator replaced last week. Last night, I hit a very small bump, not even large enough to really cause me to slow down, and as soon as I did, my battery and brake lights came on. My RPM gauge also jumped around and eventually went to 0 until I stopped and put the car in park. (The bump might just be a coincidence who knows). So after all this happened, I turned off my car, tried to restart and got nothing. Sometimes I get a click, sometimes 2 clicks up to 4-6 consecutive clicks. Every few times I won't even get a click, just a slight attempt to start, then the car dies, then 2 seconds later all my lights and radio etc. come back on. My problem here is a few things:
1. I've been told it could be the starter. If it's the start, those dashboard lights shouldn't have came on right? just the STARTING portion of the car.
2. I've been told it could be the battery.
Well If i got my alternator tested and Advance said it was working, Why would my battery be dead? And if it WAS dead, wouldn't my lights have went dim or something else happen to the car?
Ford Wiring/Electrical :: 2000 F250 - Dash / Parking And Tail Running Lights Not Working
I have a 2000 Ford F250 lariat 7.3 .... This vehicle has an aftermarket double din stereo pillar gauges for Pyro meter and transmission temp and has also had a snowplow attached but since re moved since I purchased it. It also has H ID headlights, which are run by the passenger side headlight connection.
The problem I'm having is that whenever I turn on the parking lights it is blowing the number eight fuse under the hood. Which is giving me no dash lights running lights parking lights or taillights. Initially the fuse would last for a few minutes and then burn out. I should also add that the trailer wiring harness doesn't work either and the driver side headlight will work sporadically.
Ford Wiring/Electrical :: 1981 - Headlights / Dash Lights And Charging Light Will Flicker At Same Time
I have a 1981 F100, lately when I've been driving at night I notice my headlights, dash lights, and charging light will flicker at the same time, and even sometimes my headlights will flash on and off by themselves.
View 2 RepliesFord Wiring/Electrical :: 1997 F250 - Dash Lights Flicker Off When Place The Transmission In Drive Position
I have a 1997 F250 that I am fixing up. The issue is this... The dash lights now flicker off when I place the transmission in Drive position. I can slightly move the slack in the gear selector and the lights come back on. When the transmission is in Park, the dash lights work correctly. Not sure why there is some type of switch to control the dash lights buried within the steering column?
View 2 RepliesStalling - Electrical-wiring - Honda - Batteries :: Stuck On Hills / Mid Dash Lights Not Coming On
Yet again my honda is doing some new. My mid dash lights don't come on at all anymore (even when i start the car), my power drive and winter drive buttons don't work, I can't stop/start on a hill, I have to get 2rpms going to get anywhere, and my battery volts are over 12 when driving.
View 1 RepliesFord Wiring/Electrical :: Wiring For Cruise Control Switch
Looking for wiring diagram for the older Ford cruise control switches. I'm wanting to add an aftermarket system but use the factory switches. It's for a 99 ranger with the steering wheels like the mark 8s, older mustangs, explorers, and many others, had.
View 1 RepliesFord Wiring/Electrical :: Reverse Lights Wiring - Adding 2 LED Spot Lights
What I am trying to do it put in 2 led spot light for added backing up light. What i want to do is have them turn on when put into reverse but also have a switch i can use to turn them on when not in reverse. Just need to know what relay I need and if it even can be done.
I was also thinking of just taping into the wiring harness and adding a wire that goes to the spot lights and another wire that goes to a switch that I could turn on and supply power to the light when not in reverse (I know it will light the revers light also) but is it ok to do that?
Ford 6.0L Power Stroke Diesel :: 2006 - Wiring Harness For Windshield Wiper Circuit?
Looking for an electrical schematic and or wiring diagram of the windshield wiper circuit for a 06' Super Duty?
View 5 RepliesFord Wiring/Electrical :: 1997 F250 - Rear Tail Lights Wiring
I have a 97 F250 HD. Wiring the rear tail lights. When we bought it the had cut off the wires going to both sides of the rear lighting assemblys and I was wondering what wire went to what i have the left turn signal working just can't seem to get the brake/back up light to work on that side and i can't figure out how to get the right side going either.
View 8 RepliesFord Wiring/Electrical :: 7 Pin Trailer Wiring - Running Lights Not Working
Just bought an 04 Super duty with the factory plug 7pin and 4 pin plug. Checked the fuses and finally tracked down the 2 relays under the hood but can't seem to find anything wrong. Everything on the trailer works except for the running lights. Is there another fuse or something I have missed? Trailer works fine on my buddies Duramax and worked fine on my old 97.
View 14 RepliesDodge - Electrical-wiring - Ram50 :: 1995 - Intermittent Dash Panel Electrical Malfunction?
My beloved 1995 Dodge Ram Van has intermittent dash panel electrical issues. The gas gauge an speedometer are intermittent, coupled with lights and radio on off too. It It all started when I had the transition services years ago. It has less than 100k mileage.
View 1 RepliesFord Wiring/Electrical :: Replaced Alternator - Humming / Buzzing With Key On And Engine Off
2003 f350 6.0l single alternator. Replaced alternator a couple weeks ago with one from napa, noticed a humming with key on and the engine off . Traced it to the alternator, called napa they said it was not normal come get a replacement, put the new one on same thing. Charging in the 13.5 to 14v range the case of the alternator seems to get hot quickly when running.
View 14 RepliesFord Wiring/Electrical :: 1963 - Replaced Generator And Regulator Still Not Charging?
I have a 63 Falcon that the generator went out on. I replaced the generator and the regulator and it still isn't charging. A friend of mine told me if I disconnect the FLD at the generator and connect a jumper between FLD and the battery + terminal it should start charging which it does. I have swapped out two different generators and regulators now and it is still doing it.
View 5 Replies