Electrical-wiring - Ranger :: 1999 XLT Electrical Power Lost When Turn Key To Start Position
My 1999 Ford Ranger XLT, 6 cylinder, auto trans, with 134K miles has an electric problem. When I turn the key to the 'on' position, all dash lights show normal, headlights work, radio plays, etc. But when I turn the key to the 'start' position, all electric power is lost. The power remains lost until I disconnect and reconnect the battery ground wire. After reconnecting, I again have power until the key is turned to the 'start' position. I was able to jump start the truck, so I assumed I needed a new battery. I bought one a week ago, and was back to normal until today. The truck started, I drove 4 miles to the grocery store, and then I found myself back to square 1 (i.e., the no-start situation).
View 3 RepliesFord Wiring/Electrical :: 2002 F250 - All Power Lost
2002 f250 v10 4x4. Truck will loose all power...
View 10 RepliesFord Wiring/Electrical :: 1976 - Truck Just Lost All Power And Came To A Stop
I bought a great 76' SuperCab with a 390 4 barrel Wednesday (the 30th) and while driving around the neighborhood this evening the truck just lost all power and came to a stop. No lights, no engine, nothing and I cruised to an easy stop (fortunately at the end of my own block). I thought I smelled a bit of electrical burn for a moment after I came to a stop but could not track it down before the smell disappeared.
Some early symptoms - on drive home from purchase, the turn signal light function was in and out. The starter was also turning slowly and sounded tired/weak. The ignition switch was a bit loose and previous owner said you had to make sure the key was not all the way to the right or accessories would not work.
Some early checks/fixes- replaced battery and battery cables and checked grounds. Starter began turning stronger and turn signal lights were back. Thought I had it going well.
Ford Wiring/Electrical :: 2003 E250 - Lost Power To Circuit 124?
'03 E250 connector C3136 located by the left lower B Pillar---have lost power to the Brown wire which seems to be designated as Circuit 124.
Which fuse controls that circuit? I have a factory EVTM but I can't find what fuse to check. And here I though I knew something?!
Ford Wiring/Electrical :: No Power To Fuse 32 And Stereo Does Not Work?
I recenty was having some problems with my 2003 6.0 liter. My FICM connection was not seated all of the way which casued my truck to just die without warning....... AFter I had fixed that, my stereo died. Just dead??? Nothing...EVERYTHING ELSE WORKS???
So, after I had messed with everything I could think of, I thought, OK new DVD/Stereo time.
I checked fuse #32 which was the fuse to my stereo. The fuse is fine...BUT...There's no friggen power to the fuse via my test light. Test light works on other fuse spots so I know i"m not getting power to the fuse #32.
Since I don't have any power to this fuse....WHAT NOW???? How to trouble shoot this problem?
Ford Wiring/Electrical :: 2006 F350 - No Power To Fuse Box
I have a 2006 F350 Diesel. Had one of my employees go out to start the truck yesterday and when I went out I had no electrical power to most of the accessories (gauges, warning lights, power windows, radio, interior lights, turbo charger). It also seems to have no power - could barely make it go up the slight incline into my garage. I have checked all the fuses - they seem fine. Although put a tester on the interior fuse box and I don't have any power to the fuses that run these accessories.
View 10 RepliesCamry :: 2011 XLE Lost Acceleration On Hitting A Bump
Driving home the other day I crossed some railroad tracks. They weren't too bad, but bumpy. I wasn't going too fast over them, had slowed a bit with traffic. As I cleared the tracks and hit the gas, nothing happened. The car hadn't stalled and I didn't hear any noises, but for about a second as I pressed the gas, it didn't go in gear.
I think the engine revved, like it was in neutral. I looked down and the traction control light was blinking, but no clicking noises were heard. After a second it started acting normal again, and I have gone over those tracks again the next day to try to replicate and it didn't happen again. Is this a known issue, traction control kicks in when a bump is hit...but no clicking noise like i usually get on ice/snow? Or should I have it looked at?
Ford Wiring/Electrical :: 1986 F250 - No Spark From The Coil
I have an 86 f250 i just bought back with no spark. this truck is not original. used to be a diesel. has a 400 out of 81 f250. had this truck running just fine 4 years ago. sold it to a guy running and bought it back 4 yrs later not running.
Checked all the connection to make sure they r clean. Had the ignition modular tested and tested good. I have 12+ volts from the white and red wire. I have a little over 6 volts at the bat side of the coil. I have no spark from the coil. I notice every time I connect and disconnected the bat cable I will get a spark from the coil. i ran a test light from the tack test sight on the coil and tried to start and the light stayed real dim and never flickered.
Subaru - Electrical-wiring - Legacy - Batteries :: Lost Power While Driving
This evening I drove our Subaru Legacy Wagon (1999) about 3 miles or so to the gym. When I pulled into the lot, I noticed my radio (tuned to NPR, no less) had gone off. Curious! A few seconds later, dashboard lights come on (ABS, maybe others). After that, engine goes quiet, car is dead -- turning the key does nothing at all, and the car is completely without power. Only the dome light works, and barely. I get a jump, and eventually the car starts back up --- but it took a while, and several tries, before I could get the engine going.
On the way home, I kept a careful eye on the RPMs -- when I was close, I noticed the ABS light pop back on, and the RPM needle go down to zero. I tried my best to keep the RPMs up by staying in first, and managed to park. Of course, the car was unresponsive when I immediately tried to restart it. Some quick internet searches suggest alternator, bad connections to the battery, and some other ideas. We've never had this problem before. The twist is that we're literally on the brink of selling this car -- we've got one more than we need. Thus, we'd be pretty bummed if we had to put much, if any, cash into the car just so we can get rid of it days later.
Ford Wiring/Electrical :: Moving Engine And Ignition System - Wiring Harness For Further Use?
I plan on moving the engine/drivetrain from my 1986 F350 460 to my 1996 F250. I also want to move over the 1986's ignition system with a Duraspark 2 setup.
Although I could just cut in the easiest places to remove the wiring for later reuse I am looking for where to make the cuts, what to take and what to scrap. Alternatively I am also asking if there are aftermarket or OEM replacement sets out there are aren't a ton of money. The current harness in the 1986 has been sprayed with engine oil and cooked for 27 years so I am looking at alternative options if there are any.
Ford Wiring/Electrical :: 1986 F-150 Misses And Backfires When Headlights Turned On?
The truck has a 300 straight 6 and runs pretty good until you turn the headlights on or anything that uses current for that matter ie. Radio , Fan ect. But is worst with lights. Just got the truck last week and can't seem to figure this one out.
View 1 RepliesFord Wiring/Electrical :: 1986 - Starter Continues To Turn Over Even After The Engine Fires
1986 ford f150 standard cab, manual trans with 3 plus overdrive.
1989 302 rebuild v8. When trying to start occasionally the ignition continues to turn over..
Even after the engine fires, the starter continues to turn over until I have to disconnect the battery to stop it. Then it fires up fine afterwards what could the problem be.
I'm thinking the starter, or the ignition switch but I also heard it could be the starter solenoid.
Ignition - Dodge - Caravan - Electrical-wiring :: 2000 - No Blower / Power Seats / Blinkers / Power Locks?
Blower, seats, locks, blinkers stopped simultaneously, abs and airbag light came on. The internet suggested it was the ignition switch, I changed it to no avail. The horn, wipers, 4-way flashers, headlights, taillights, and brake lights all work. Is my wife correct in suggesting we replace this 140,000 mile pile of rust?
View 5 RepliesFord Wiring/Electrical :: 1986 F150 - No Gauges / Left Turn Indicator Light On Dash Does Not Come On
Okay, my 1986 f150 with a 351w (non-feedback carbed) Has no lights on the cluster, and none of the gauges work (haven't tested the speedo yet, truck is not registered yet).
I also have a minor issue with the turn signals... Fronts work, no rears. The left turn indicator light on the dash does not come on but the right turn one does. All my "primary lights" (markers, tail, headlights) work fine. I have not yet tested the brake lights.
Fuses all look good, truck did have some roof leaks. I've done some research, does this sound like the dreaded voltage regulator issue for the gauges?
My assumption for the left turn indicator light is that there is a replaceable bulb in the dash (probably blown), is that right? Rear signals might be wiring (PO installed his own trailer wiring) or bulbs? haven't gotten that far into it yet...
Ford Wiring/Electrical :: No Fuse From Lights In Cab?
I need to hook up a lamp for my mechanical oil pressure gauge and tested all the fuses, they are either on or on with key in run position, but I found none that went on with the lights, which of course is what I need. So now I guess I start randomly sticking needles in wires under the dash and testing for a possible light switch dependent circuit? Or run a wire through the firewall and tap a wire near a running light? There's got to be an easier way, but my Haynes manual seems useless--one wiring diagram for 1995-2008. I will be forced to run it off a key on circuit which means the lamp will be on anytime I drive, day or night, unless I install a toggle switch--not the best way to do it though.
View 3 RepliesFord Wiring/Electrical :: Overdrive Fuse Keeps Blowing
Overdrive fuse keeps blowing. Drive one and 2 shifts fine. 3 and overdrive don't work. Had transmission checked it is fine. Repair shop says it is electrical.
View 1 RepliesFord Wiring/Electrical :: How To Add A Constant Hot Fuse Block
I want to add a CB and some flood lights to my pick-up, but am getting tired of hunting for wires that are constant hot or switched hot under the dash. Not to mention the rats nest of wiring that results, and the potential for overloading the factory wiring.
Above is a diagram that I came up with while trying to figure out how to add a constant hot fuse block, and a switched hot (or ACC) fuse block to the truck to clean up the wiring.
Am I using the relays in the right way? (Never used one before)...
Ford Wiring/Electrical :: Fuse For Fuel Tank Gauge?
I have a main tank and an Aux tank with a gauge selector switch. I believe I may have a bad fuse as the indicator has stopped working. Where it is on the fuse block??
1978 Ford F-250
Ford Wiring/Electrical :: Fuel Pump Keeps Blowing A Fuse
I have a 1994 Ford Ranger king cab 4x4 with a three inch lift kit on it . My problem is the fuse is blowing that goes to the fuel pump . It started out blowing the fuse now and then when it was raining . Well I thought it mite be the fuel pump going bad but after I put the new pump in the truck it lasted about a week and started blowing fuses again . I put another fuse in and it go a few days and blow it . Last week on a 100 mile tripe I got almost there and it burned a fuse on the highway . I tried to put another fuse in and it would blow it as soon as I tried to start the truck . Burned five fuses right then . So I had it towed to mothers house and put another fuse in and it cranked up . I looked at the wiring that was not wrapped in that plastic cover stuff and have not found anything yet ...
View 14 Replies