Camry :: 2010 - Temperature Gauge Reach Half Temp Scale All Time
Is it normal that the temperature gauge reach half the temp scale all the time ? Even though I live in a tropical island were outside temp is mostly above the 85 mark I find it a bit weird for the temp to reach that point.
View 4 RepliesFord Super Duty (1999-2016) :: 5R110 Transmission Would Suddenly Hard Shift
I have a 2005 Ford 6.0L Diesel with the 5R110 transmission.
About a month ago, i started seeing some strange shifting issues with the transmission. While driving normally, it would suddenly hard shift (slam itself into gear), the entire truck would shake it shifted so hard. It would also cause the Tow/Haul indicator to start blinking. (my understanding is that the Tow/Haul light indicates an error code).
I drained/flushed the transmission, installed the larger pan/with the improved filter. I put Mercon LV back into the transmission (what type of fluid was in there before).
The problem still persists, and got a bit worse. The truck is almost un driveable at this point. Still getting Tow/Haul flashing messages. Can the error code be read by an standard ODB2 reader ?
Ford Transmission :: Temp Gauge Reads High Even When Truck Is Cold
I have a 2002 F-350 6.8L, 4x4, crew cab, 8' bed, SRW, trailer tow pkg. I purchased it new in the fall of 2001. The truck currently has 54,000 miles on it (only gets used when I need to tow/haul something). It's kept in the garage and is in near showroom condition.
Everything on the vehicle is 100% functional except the transmission temperature gauge. Even when the truck sits for weeks, the needle will move to mid scale as soon as the key is switched on - haven't even started the engine yet! Put the scanner on it - no codes stored.
I'm attempting to trouble-shoot the TFT (transmission fluid temperature) sensor. Found some documentation online on the 4R100 transmission. It shows an electrical connector on the solenoid body with pins for the thermistor (so I can measure its resistance). However, I can't find a connector anywhere on my transmission that even remotely resembles the diagram I found online.
Question 1: When you first get in your vehicle and turn the key, does your tranny temp gauge read "cold" just like the engine temp gauge?
Question2: Does my truck have the 4R100 transmission? How can I verify that?
Question3: Looking for documentation on what connector and which pins are for the thermistor?
Passat (B6) :: Transmission Died - When Pushed Pedal Harder RPM Gauge Rev High
My transmission died last night on the way home from school. I was driving down the road just after leaving school and as I started to accelerate the car, I noticed that it wasn't moving so I pushed the pedal a little harder when I saw the rpm gauge rev. Up pretty high. The car was showing it was in 4 th gear and as I was slowing down so was the number on the display. I came to a stop and tried to move forward but noting. I had the car towed to the dealership so now the fun begins to see what is wrong with it.
I had the car in a few months ago for a whining sound coming from the car especially when I would put the car in reverse to back up. The dealer said we don't see anything wrong, go figure.
I'm suspecting that the transmission is shot. When the car was towed to the dealer I had to engage the parking break because the car wouldn't stay parked, it would roll even though it was in park.
Ford Super Duty (1999-2016) :: Speedometer Goes Back And Forth Full Scale?
Buddy has '96 Dump Truck. I think it is an F650 but there a no markings. It is small as dump trucks go, but has air brakes and an automatic transmission.
The speedometer goes back and forth full scale as if a speedometer cable were bad. Problem with that is, my buddy says it has an electronic speedometer.
About the only thing I can think of that would cause that problem is the Vehicle Speed Sensor.
Ford Excursion :: 5R110 Running Hot - No Warning And Not Towing
2005 Excursion 6.0 104,000 miles
I have a scanguage2. Normal driving yesterday morning. Not towing. Temp got up to 200 deg.....then later to 240!! Never an issue with the tranny !!
Yesterday I checked:
-the fluid level and it's fine.
-There was some crud on the dipstick though.
-temps for EOT and EWT are fine.
-a distinctive hot rubber smell too when it got to that temp.
Today I checked:
- the coolant for traces of transmission fluid...there was none.
-looked under the truck for fluid that may have blown out the vent....none
-no leaks anywhere
The truck is parked and will be towed to the shop so i don't incurr any more damage. So what could the prob be??
Ford Super Duty (1999-2016) :: 5R110 Started Flaring Between 3rd And 4th Gears
Started flaring between 3rd and 4th I changed the pressure solenoid and the direct clutch and no change. Flushed the tranny and changed filters and no change the oil is not burnt. When it flares it goes into a safe mode on the dash and will shift perfect through 4th gear no issues. I guess I've always know if it's bad it's bad but I don't understand why it works in a safe mode but slips in regular. Also if it is a bad tranny will a 3c2p-7000 work as a swap in my truck. 2008 6.4 4x4 ....
View 5 RepliesFord Super Duty (1999-2016) :: 5r110 Trans - Occasional No Shift From Park
Iv got a 2003 6.0 stroke with 212k miles on it. Runs like a top. Done a slew of work from injectors to hpop, 2 alternators, intake, exhaust. NO tuner! Stock. Anyway recently I started the old girl up, warmed up a bit and shifted into reverse and truck did nothing. Went to drive and same thing. Held brake and revved it up and it dropped in gear. Shifts fine after that. No issues other than the occasional NO shift from park problem. Iv dropped pan and replaced all filters recently.
View 2 RepliesFord Transmission :: C6 Transmission Keeps Burning Up Reverse High Clutch Plates?
I have rebuilt my transmission but it keeps burning up reverse high clutch plates. It has burned up two sets so far. I am thinking that it might be something stuck in the valve body.
View 4 RepliesFord Super Duty (1999-2016) :: 5r110 With Code P0766 / Shifting Erratic And Trans Control System Fault
The truck belongs to a very good customer of mine and is a 05 f350sd 6.0 td with 5r110 torqshift tranny. The vehicle presents with these symptoms and codes....
-there is a delay from p to r and its intermittent, sometimes it will be in a weak reverse where it wont creep unless you give it some gas, sometimes it will hit reverse hard after this. sometimes it bangs reverse
-there is a delay into drive intermittently with the same symptoms as reverse where sometimes it bangs and sometimes it will take a little throttle to get it moving
-once the trans is hot (operating temperature) it has trouble downshifting. my solus tells me sometimes it tries to start off in 3 or 5 then sometimes it will bang back down into first and almost chirp tire with little throttle input
-tow haul light will flash after several miles and then it only has 1-2-3-4 no 5-6. then the starting off symptoms get worse
-throws codes for
p0766 shift sol d performance/stuck
p2701 friction element b apply time range/performance
p2703 friction element d apply time range/performance
p0700 trans control system fault.
So far the ideas i have are as follows
replace solenoid D
direct clutch replacement and seals for corresponding drum
torque converter replacement and pump replacement
harness rub through between pcm and transmission
The truck has had similar issues a year ago. Upon testing line pressure i found it was out of spec and replaced the epc. (electronic pressure control solenoid) and this cleared most of it up . I have had the pan down many times and the fluid has not been burnt and there is little debris in the pan. nothing i would consider beyond normal wear. Tomorrow I will be dropping the pan again to inspect the magnet and fluid as well as the condition of the harness. i will post my findings at that time. I am hoping between now and then some of you will be able to point out a few possibilities to get me on the right track.
Ford Excursion :: A/C Gauge Reading - Leak In Low And High Pressure Valve?
These are my gauge readings at 70 degrees Fahrenheit. According to an AC conversion for gauges calibrated in Pascals, 35-40F converts to 241-276 KPa, 140-160F converts to 1000-1103Kpa. The gauges are in Mpa which by conversion is 3 decimal points to the left so .241-.276 and 1-1.103 Mpa. Here are my gauge readings at 68 degrees ambient temp. Rear air is same as an ambient temp on max ac and the front is pictured. There seem to be virtually no pressure differences which I would interpret as a novice that there is ) freon flow.
There is freon in the system with the high pressure being approx correct but the low side is too high if I understand correctly. Basically when at highway speeds at 75 degrees yesterday the front AC was cold and the rear was outside vent temp only. There are slight leaks in the low and high-pressure valves. I have a Mastercool replacement tool but they did not send a fitting for the high-pressure valve. What these readings mean as far as what may be wrong?
Ford Ranger / B-Series :: 1996 - Battery Gauge Jumps To High Around 4000 RPM
I was driving around town and I kept noticing my aftermarket radio would shut down and turn back on when I put my foot to the floor, then I noticed that my voltage gauge would shoot to the H when I hit around 3000 rpm and all the dash light's and head lights get brighter but once I let off the throttle it goes right back down. I've been taking it easy lately and now around 4000 rpm it will shoot up now. But I just replaced the voltage regulator I checked the battery and cables they don't seem to be damaged and I already replaced the belt. What could cause this?
View 3 RepliesFord F-150 - 1997-2003 :: 1998 V6 - High Beams And Coolant Gauge Not Working
I just bought a 98 F150 V6 Manual transmission 2wd truck. Its a clean truck and I'm liking it so far but its got a couple minor issues. Whats the point of buying a truck if you don't get to work on it??
The High Beams don't work at all. Low beams are fine. I've put new bulbs in, and fuse 16 in the passenger compartment has continuity. I'm suspecting the multiple function switch, because when I pull out to engage the high beams, nothing happens. The indicator on the dash doesn't come on, and the low beams don't turn off either.
The second issue is the coolant gauge doesn't read. When I turn the key to the on position, the needle on the gauge moves up just a bit, but it never moves after that. Anything to check?
There are a couple other minor things like the e-brake light on the dash doesn't always turn on, but I can deal with that.
Toyota - Tundra :: Transmission Went Out When Try To Shift From 4 WD High Into Low Then Back Into High
My 2008 Tundra's tranmission went out last week when attempting to shift from 4 WD high, into 4wd lo, then back into high.
I was stuck in the snow in 4wd high, then tried low, to no avail, tried the transmission in lo (which didn't engage--just 'lo' light blinking and alarm buzzer, then tried 4wd HI and there was NO transmission response, a grinding in "P' and no low, high, or anything--from Park to D, Reverse, all the gears were gone, and I was getting ready to call for a tow truck, and after grinding the P gear for a while and back into N, it went into 4wd high.
Toyota replicated the problem, after some doing, and they're trying to fix it as the 4wd acuator is a problem--it's backordered to Japan which means the truck is out of action for a month.
There are similar reports of damage and problems listed on the NHTSA website.
Ford F-150 - 1997-2003 :: Gauge On Dash Is Running High And Battery Light Flickering
Over the past weekend i noticed all the electronics having a slight "flicker", so I figured my alternator was on its way out. After replacing the alt with a reman, I still had the issue. Then, replaced it with a new new one and the issue still persists. I will be getting a meter to test later when my buddy gets off work. The gauge on the dash is running high and battery light is flickering. Is there something I am missing? I ran another ground to frame also.
2001 SCAB 5.4 144,000mi 4x4 ....
Ford Transmission :: 4R100 - Temperature Gauge Installation
How to install a temperature gauge for the 4R100 transmission in my 1998E350 w/ V10 engine Van? what's the normal temperature for this transmission?
View 8 RepliesFord - Explorer :: 1998 - Temp Gauge Shooting To High In Just Seconds Then Drops Back To Normal
For reasons I can't figure, the Temp gauge on the wife's Explorer is shooting from normal to high in just seconds. Then, it drops back to normal. When I looked at it this afternoon, I noted 2 things.
1) There was no sign of a coolant leak or overheating.
2) There wasn't ANY coolant in the tank!!!!!!!
The truck has evidently been running fine while this is going on.
Ford Excursion :: Installing Auto Meter Transmission Temp Gauge
I am going to install an aftermarket gauge on my Excursion. Just would like to know the best place to install the probe. Hopefully it isn't that hard.
View 14 RepliesPassat (B5) :: Gas Gauge Fluctuates From Low To High
This is weird. SOmetimes my gas gauge fluctuates from low to high. I don't know how to explain it but it just bothers me thinking there might be a problem I'm not aware of. This also shows LCD display saying 190km left then after I start driving for a while it'll show 210km. [IMG] [URL] ....
View 8 Replies