Ford Transmission :: Won't Go Into Park - Which E4OD - Replacing Trans?
having never been into an E4OD, I have a quandary. I have an F-350 with a 460 engine with the E4OD trans. the trans works fine, but wouldn't go into park. I pulled the pan and tail housing and found that the thrust washer behind the park wheel had broken and dropped down to obstruct the pawl from engaging. I have no problem in tearing into a C-6 on back, but the E4OD, I'm not so sure. I had considered just pulling the trans and replacing it with a used one. I can find all kinds of trannies, but NOT the '89 to '91 that I'm told is what is needed because of the electronics. I have been told that the '87 to '97 will work but I have to swap out the electronics? is this so, and how much of a mess is that to do? OR, someone told me that it is possible to use the 4X4 trans by putting on my tail housing? doesn't sound right to me, but what do I know? any pointers????
View 5 RepliesFord Transmission :: E4od Trans Will Just Go Into Neutral Driving Down The Road For About A Second
I have a 94 E350 with the 5.8 and E4od trans. The main issue I am having is the thing will just go into neutral driving down the road. It only happens for about a second. The engine revs up and I back out of the throttle and it will hook back up. It sometimes does it as it is shifting up through the gears. It also sometimes does a real hard 1-2 shift and sometimes downshifts when there is really no need. I took it to get the codes read today and there was nothing.. It is so frustrating and I baby the thing all the time because I don't want to be hard on the throttle when it loses drive.
View 11 RepliesFord Transmission :: 1994 F53 E4OD 460 CID Will Not Move In Drive Or Reverse
I been working on this unit and I running into this
no foward
no reverse
no foward in and gear at all
I have to check pump pressure
I'm changing fluid and filter
1994 F53 460 CID will not move in drive or reverse - iRV2 Forums
Ford Transmission :: E4OD Coast Clutch Resistance Check
Last weekend my 95 F350 developed an issue where it feels like something in the transmission is dragging in reverse and it moves forward in neutral. This happened suddenly. One minute it was working fine and the next it was acting up. I found some info that leads me to believe that it might be the coast clutch solenoid causing the problem. Today I tested the resistance of the coast clutch solenoid through the PCM connector. I used pin 55 and pin 37 to test it. The resistance is supposed to be between 20 and 30. I got 0. My meter read the same as putting the leads together.
Am I correct in thinking that I need a new solenoid pack or at least a coast clutch solenoid?
Ford Transmission :: 1993 E4OD - Trans Is Skipping Out Of Lockup For 1 - 2 Seconds And Then Goes Back To Normal Operation
Vehicle: 1994 TripleE RV based on Ford E350 7,3 Diesel, 70000 miles.
My trans is skipping out of lockup for 1-2 Seconds and then goes back to normal operation with lockup engaged. I am shure that it is the lockup disengaging because the increase in rpm is not as much as between gears.
This happens appr once or twice every hour when driving at normal constant highway speed. It happens both in 3rd and in OD. There is no flashing OD lamp, and the OD button is working (I use this actively when going up hill to keep up momentum and rpm)
I am not able to find out what causes this. I have replaced the speed sensor on the rear axle, the rpm sensor on the engine and the brake light switch on the brake pedal. Replaced one item at the time to be able to determine if any of these items was causing the problem. But none of them made any difference, the problem is still there. I have also inspected the harness connector on the trans and it seems fine to me.
Ford Transmission :: 1994 - Auto Trans Will Not Shift Out Of First Unless Let Off Throttle
A friends son just bought a 94 powerstroke. auto trans. it will not shift out of first unless you let off throttle. but once in second it shifts fine, until you stop and go back to first. I am thinking bad or sticking second gear solenoid, but do not want to give bad info.
View 1 RepliesFord Transmission :: 1994 E350 - OD Light Flashing And Trans Shifting Hard
I have a 94 E350 with a 7.3 diesel. I took it to the Ford dealership to have a new fuel filter and oil change when I got it back the OD light was flashing and transmission shifting hard. They tell me they cannot find a problem could they have possibly knock a wire off of something to make this happen...
View 3 RepliesFord Transmission :: Manual 5 Speed Trans - Spinning Noise After Push The Clutch In
My cluch is almost 2 years old and gets treated with kid gloves , I shift low in the RPM's And accelerate slow for smooth shifting and fuel savings (17mpg avg.). But as of yesterday I can here the gears wind up after I push the clutch in. No problems with power or gear handling , Just the sound of the gear(s) (low dry rev/wind sound) No visible leaks , Clutch has oil at the step mark. Also - I can Make The Trans create the same sound if I keep the clutch petal in and rev the engine.
View 3 RepliesFord - Explorer :: 5R55W Rebuild Trans Taking A Long Time Shifting From 2nd To 3rd
Finally finished rebuilding my 5R55W transmission and have it back in the 2002 Explorer. Reverse works good, Drive works great, but I am having problems with it wanting to take a long time shifting from 2nd to 3rd. Have to let up on the accelerator in order for it to go into 3rd.
Goes into 3rd hard! 4th gear and 5th gear are finally back. I rebuilt it because I didn't have overdrive. When I didn't have overdrive, it would also take a long time to shift into 3rd and was hard.
Checked codes and am getting a "pending" P0745. Pressure Control Solenoid "A". What I need to start with?
Ford Transmission :: E4od Transmission Slipping - MLPS?
My tranny slips in drive and od when it is warmed up.It's fine for a few miles when it is cold.Did a quick search and it seems like it might be a bad mlps.
My question is, Will a bad mlps act up all the time or just when it's warmed up? Will a mlps and connector from a 91 tranny work on a 95 tranny? Don't really want to throw money at it if it will need a rebuild.
Civic - Honda :: 2000 - Wheel Don't Spin After Trans Rebuild
Just rebuild my civic 2000 b4ra trans. after I install the trans back and the car does not move under all gears. the manual says the fluid should be 6.2 Qt for overhaul and I added an external filter and an external cooler should take another 1 qt (?). I totally added 6 qt and the fluid level is ok. I put torque converter upside to drain and some fluids come out. but did not count how much.
Another weird thing is that I can not push the car down the drive way with slope with engine off and brake down and neutral gear. I jack up the front and give some gas under D4 and the wheel does not spin.
Ford Transmission :: E4OD Shudder On Take Off
My 95 psd recently started shuddering on takeoff... Pretty sure its the torque converter. It has a full ATS tranny with 5 star t/c and all the goodies installed by the previous owner (warranty not transferable). Its only got about 25k on the trans but they have been far from easy miles.
Symptoms: If I hold the brake and keep the truck stopped while holding the throttle its totally smooth, not until the truck starts moving that the shudder begins. It shudders worse the more power i put to it. Does it in first gear and second gear takeoffs. Goes away at about 10 mph or once the speed catches up with the rpm.
Ford Transmission :: E4OD Is Slipping For A Few Seconds
I have an E350 1992 7.3l Diesel, with E40D. The transmission slips in the 3rd and OD position. Every time, if I want to accelerate it slips for a few seconds and then the drivetrain is correct connected. The shifting into another gear works properly, the transmissions slips by changing from free-wheeling into accelerating ( for example: at speed 90km/h and no changing the gear).
I have recognized that the oil temperature is getting higher now. That may an indication for additional losses in the transmission. What do I have to check?
Ford Transmission :: 1995 E4OD Shifting / Lag Going Into 3rd
I have seen a few threads about E4OD's and there valve issues just want to narrow down to a valve issue or if it needs a rebuild. I can shift threw all gears i just have lag going into 3rd. also when putting it in reverse it takes about 5 seconds to finally drop into reverse. This is also accompanied with P0782 2-3 shift malfunction.
View 6 RepliesFord Transmission :: Replaced E4OD But Won't Working?
A while back I picked up a 1994 Bronco with a bad tranny for a flip. I recently picked up a 1993 E4OD that seemed to work well with low miles to throw in it.
I got it in the Bronco but it does not work right. If you put it in drive if feels like it's taking off in 3rd or 4th gear pull the shifter down one notch and it feels like 2nd gear pull it down again into 1st and no change. It bangs into reverse really hard. When up shifting manully it bangs pretty hard. No kick down at all under any circumstance and no converter lockup. I can't tell if it's in OD or third gear when at highway speed. OD button on the shifter has no effect but the light does go on and off.
I'm not an automatic tranny guy at all but it seems like an electrical issue. I was not able to drive the truck with the original tranny other than reverse (no bang) but the PO told me it was fine till it started slipping. I did test drive the donor truck and the new tranny worked correctly in it.
Being new to the process I need more detail and some of the basics. I'm comfortable with electronics and have the test equipment I just don't know the procedure. I'm guessing a bad connection/wire or something not compatible between the 1993 tranny and the 1994 truck.
Ford Transmission :: E4OD Will Not Accelerate Past 15 MPH
1994 E350 Club Wagon 351w, E4OD Transmission. New MLPS, New VSS, New TPS, New Fluid, New Filter, 5 year old Torque Converter.
The Transmission dribbled a little bit from the front pump seal a couple weeks ago, I checked the level, it was a bit low. Topped it off with Lucas, the dribble stopped. I drove it successfully for another week. I took it on a 10 mile trip, and 5 miles in, it started slipping above, 35mph, I let off the accelerator, and the transmission "Caught up" and I drove 35mph the rest of the trip. I let it sit over night.
The next morning it acted as if nothing were wrong. I drove it some more, and the same thing happened. I parked it, and revved the engine up a bit, and it tried to MOVE in park, I put it in neutral and revved the engine, and it lurched as if it were still in 1rst gear.
This time I let it sit for 24 hours, and after work I successfully put 20 miles on it without missing a beat. It was shifting right, good solid connection between the gas pedal and the road, and I thought the problem was fixed, as the temperature the day before was -20, and it warmed up outside to 30 degrees above.
I parked it for a couple hours and went to go do the errands, and it wouldn't make it above 15mph. It even struggled to do that much. I put it in reverse, and it held great, no slipping at all.
Let it sit until the next morning, and it was better. I pulled the Codes, and it gives me a 63(7) TOT High, and a 62(9) Torque Converter Clutch. It may or may not be relative, but Cruise hasn't worked in about 6 months either. What am I missing here? What could possibly causing this trouble? Fluid is up and new.
Ford Transmission :: 1995 - E4OD Won't Go Into Drive?
My rig is a 1995 F-250 Powerstroke 4x4 with 150k on the clock and an E4OD. It has been well maintained and no major work performed aside from glow plugs recently... That was fun! But that's another story...
The issue: Irregularly and randomly over the last year or so the truck has had a problem going into drive. I'll hop in, put it in Drive and nothing. It's like its in Neutral. It is also the same in 1 and 2. If I put it in Reverse, I can feel it engage and the starts to go in reverse. When it has this drive issue, the only thing that I can do to make it go is to give it some fuel and idle it up. Then it slowly engages and its fine.
Last night it did this... But this time when I could only get it to go by putting it in first and then giving it fuel... It slowly engaged.
Overall its done this maybe five or six times over the last year and doesn't seem to be getting worse. Sometimes it will go for a month with no issue.
This has happened when its warm or cold so I'm not sure heat is an issue. About 10,000 miles ago the transmission was flushed / full service. Oh, and the ATF level is exactly where it should be. My biggest fear is that the transmission needs a rebuild. One local shop quoted me $4200 to rebuild it. What I'm looking for is to know if there is a simpler and cheaper fix. I'm not really interested in a rebuild, unless that is the only option.
Ford Transmission :: Metal In Pan After Rebuild
I was wondering should I find metal in my pan after a rebuild on my AOD? It's been about 4 months since the rebuild and i took it in to have the fluid changed at another shop. Now the unit is doing fine but I did let the shop that did the rebuild know what was found.
View 14 RepliesFord Transmission :: E4OD Shifts Hard When Warm
I just rebuilt my E4OD transmission in my 1996 F250 7.3L it has all new clutch packs torque converter and a shift kit. When I first put itback together it would not shift out of second cleaned mlps and shifts threw all the gears now. I took it out on the road to test it and this thing ran great shifted smooth and quick could not askfor any better but when Trans temp gets around 140-150deg it shifts hard and od light flashes. I have ordered a scanner to read the codes but won’t be in till later this week. What I could check in the meantime.
View 13 Replies