Ford - Taurus :: Chirping Noise Under Hood
Noise sounds like chirping ,was told it was idler tension pulley,changed it,and the idler pulley and still have noise.
View 2 RepliesCamry :: Blower Motor Chirping Noise
I'm getting this weird chirping noise from what sounds like the A/C and Heat fan. When I turn it down it is noticeable and sounds like something needs oiled. Kind of like pieces of plastic hitting each other over and over again. When I turn the air up there's no noise but probably because the air rushing out is so loud. I'm thinking I may need to take something out and oil it up. Too cold here to do my own thorough investigation.
View 4 RepliesFord - Taurus :: 2002 - Motor Makes Ticking Noise When Warmed Up
Three days ago, my 2002 Taurus ses, 144k, auto, 3.0 v6 motor, started "ticking" after I drove it to the local grocery. It is coming from the top of the motor, but does not make noise when it is first started, cold, only after it is warmed up. Oil & filter has 2500 miles on them, all other fluids are good.
View 1 RepliesFord - Taurus - Sensors :: 2003 - Occasional Chirping Sound With The Engine Running
2003 Ford Taurus, Vulcan V6 (OHV), 40k miles. I picked it up in January, occasionally I would hear a "chirp" sound with the engine running. I assumed it was the serpentine belt and replaced it. It seemed to work.
Today the chirping started once the car was warmed up. I did some research and discovered the chirp sound is a symptom of a worn synchronizer. I checked with a mechanics stethoscope and verified the chirp is coming from the area of the synchronizer.
I'm debating doing the repair myself, regardless I won't do the repair until the weather warms up. It not my primary car, but I would still like to drive it a couple times a week. The chirping is intermittent for the moment. Am I risking anything driving it as is?
Prius (2004-09) :: Chirping Noise Related To Brakes?
Mostly while negotiating in very crude camp ground roadways, we started to hear a new noise. This started before the incident I will be reporting in my third thread, so I do not attribute this noise to that incident. The noise seems to come from applying the brake when the car is already stopped or nearly stopped. Its a bit of a chirp, but it is a low-throated chirp. It think they come in twos, "chirp, chirp."
View 6 RepliesLexus RX 2004-09 :: Fan On Lower Speed Making Chirping Noise
I'm having an issue where when the fan is set to the lower fan speeds it will make a high pitched, harmonic chirping noise. I've isolated it to the operation of the fan, so I know it's something to do with the HVAC stuff.
View 2 RepliesDodge - Ram :: 2004 - Making Rubbing / Chirping Noise At Low Speed
I have an 04 dodge ram. I have recently encountered a chirping noise at low speed (it may be there at higher speed, but I can't hear it over the engine). It sounds like rubber, rubbing against itself or birds underneath the truck. The noise speeds up and gets a bit louder as I accelerate. The sound generally goes away or I can't hear it after 25-30 mph. This only happens when in motion, so I don't think it's the belts. I've read a number of things from CV Joints to Bushings and not sure if it's either.
View 3 RepliesFord - Taurus :: 1995 - Motor Swap And Now Fuel Electrical Malfunctions?
I have a 1995 Ford Taurus, and I just swapped in a new engine from a donor from 2000. The engine is a Flex Fuel 3.0L Vulcan OHV.I've got a wealth of background knowledge as a mechanic [5 years+] and an electrician [4 years+]I have swapped over everything required to make this work, in theory. I swapped exhaust, fuel system, and computer/harness and all the relays to go with it. I also made a custom gauge cluster from a 2000 Taurus as well.
Well everything works just peachy, all the wiring for the most part is correct minus a few buzzing relays that I just need to work out. The main issue this [now monster in my eyes] has is the PCM is not telling the FPDM to tell the Fuel Pump to start. Turn key, and no 3 second startup. I've checked the fuel pump, and it's fine. I replaced the PCM and that didn't solve it. I have the security system from the 2000 in there as well, thinking that was an issue. I also have the emission sensors and canisters installed, just like you would see in the 2000.
I'm at my wits end trying to figure out why the PCM isn't sending voltage out to the FPDM. I had to of missed something along the way but I double checked and still can't find anything. How to get this working properly.
Ford - Taurus :: 1996 - AC Suddenly Quit / Blower Motor Stopped Working
Well, let me rephrase that, the AC works but blower motor doesn't. When you put your hand up to the vents, they're cold.
Long story short, I ran my AC on MAX on way home from work, driving time of approx. 35 minutes. I got home, showered, and got back into car to go downtown to store. It was then I discovered that the AC wasn't coming on, and it was still on max. I shut it off and turned it back on, but to no avail. I checked all related fuses, or at least what I think is related and checked my "Taurus Bible" the chilton manual. I swapped out a blower motor relay and it didn't work, but i'm not sure that relay was or was not good, it was out of a '96 E-250 at work.
So now I get out my test light. I pulled the connection from blower motor, connect it and turn on AC and light comes on. Vents are getting cooler. So I get my tool and pull the radio and climate control assembly. I pull the plug to the actual fan connection, the part that connects to the fan switch that controld fan speed. I'm getting nothing there.
Is there a relay I don't know of? I know the AC still works because vents are still getting cold, but I can't get air to move. A LONG time ago it did this but "corrected" itself. What is my next step? I'm not sure what to check next and my repair manual is leaving me in a boat with no oars.
More details of car:
1996 Ford Taurus 3.0 V6 Vulcan motor, 8th VIN is UAUTO188,000 miles
White 4 door gray interior 3 car seats
GoodYear Tires inflated to : 33lbs LF34lbs RF36lbs RR35lbs LR
Lexus RX 2004-09 :: Chirping Noise Coming From Belt Tensioner Or Idler Pulley
So from reading around a lot, it seems like the chirping is from the belt tensioner or idler pulley. That said, I've not been able to find anything definitive. I tried to do the water bottle squirt test (from Gates' youtube video) and either I did it wrong or the chirp did not go away implying the issue is not the belt. While I was looking in, I could see the tensioner shaking some.
If my tensioner should not be moving, do I just need the pulley or the pulley and the mount?
- Pulley [URL] ....
- Pulley and mount [URL] ....
Also, if the above items will fix the chirp, which brand would be best?
2007 RX 350, 113K.
Chirping gets worse as it heats up. Seems to happen independent of ambient temperature. Purchased a year ago so unsure of the history of part changes.
Passat (B5) :: 2004 1.8T - High Pitched Chirping Noise Comes From Front Passenger Side Wheel
2004 Passat 1.8T Tip GLS FWD ... Stock wheels w/ Dunlop Sport SP5000 tires ...
A high pitched chirping noise comes from the front passenger side wheel ONLY when turning left and ONLY when it's below 40F. Goes away once it warms up.
Wheel bearing?
Taurus :: Blower Motor Completely Quit Working
My a/c has not been working so we added R134a yesterday and it fixed the problem just like it did last summer. Once I was finished I left the a/c on high when I shut my car off. This morning when I left for work it was too cold so I turned it to the "off" position. On my drive I decided to turn the a/c on and make sure it was still getting cold at which point nothing happened, absolutely no air (hot or cold) was blowing out. I kept turning it on and off and at one point the a/c did start working again at which point I turned the fan speed to low. A few minutes later the blower completely quit working again. Nothing works at any speed, any position regardless of heat or a/c. Absolutely nothing is blowing out of my vents. I can hear something that sounds like opening and closing when I change the position/type of a/c/heat but the other than that the only sound is a "shhhhhhh" when I turn it to the off position. Where to start on diagnosing and fixing this issue?
View 14 RepliesFord F-150 (2004-2008) :: Engine Knocking Noise Out Of The Top Of Motor
I have an 04 F150 Lariat with the 5.4. I get alot of noise out of the top of the motor. I hear lots of stories of sludge issues, is that the problem or do I need to have the motor gone through? the knock is not horrible but when the motor is warm the noise is pretty apparent!
View 3 RepliesFord F-150 (2004-2008) :: 2007 5.4L - Ticking Noise Coming From Somewhere Around The Motor
I have a question about my 2007 F150 4x4 with the 5.4L. It has a ticking noise sound coming from somewhere around the motor, but it's not there till the motor has warmed up. It almost sounds like a exhaust leak, but I'm not sure. What it might be, or what to look for?
View 11 RepliesFord F-150 (2004-2008) :: Engine Seafoamed - Motor Noise Upon Initial Startup After Oil Change
Today I decided to do some maintenance on the truck as it needed an oil change and some other unrelated misc stuff.
1. I seafoamed the engine thoroughly. I bought two cans of this stuff, half of a can went into the fuel, another half can in through the brake booster vacuum hose, and I dumped a full can of into the oil. Took it for a 30 minute drive, let the ol' gal smoke as it usually does on a seafoam, and then changed the oil. No noises, I noticed immediately improvement in acceleration.
2. Upon intial startup after the oil change, I thought the motor was coming apart. It was only for about two seconds, (i was counting to make sure) if it didn't have oil pressure and no noise by 3, I was shutting it off. It hasn't done it since.
Is it possible I just knocked some crap loose in the heads causing the oil drain a lot faster into the pan than I expected? I'll try it again in a few hours after everything has cooled off and oil has drained back into the pan, but I wanna make sure I didn't damage anything. Still drives good, no problems, no noises since.
The last oil change I did, I didn't do a Seafoam, but I figured with winter coming it's a good idea to get her running in top form. I used Pennzoil Platinum 5w20, with a Motorcraft oil filter for those wondering.
Truck has 133K on the clock, and it's had the slight cam phaser tick since I've purchased it, no other problems. I bought it almost a year ago.
Ford - Explorer :: Chirping Noise Coming From Bell Housing?
Getting a chirping noise coming from (i think) the bell housing. a few small chirps at start up, then constant after about 1300rpm, eventually gets high enough and drowns out behind the exhaust that i cant hear it.
Possible flywheel issue? I've uploaded a video to try and illustrate the issue. 1996 ford explorer XLT 4.0.
Just replaced starter a few weeks ago, but this problem was happening before. I dont know if it was as prominent and got worse, or if im just now noticing it and focusing on it.
1996 Ford Explorer bell housing chirp. Flywheel? - YouTube
Ford F-150 - 1997-2003 :: Chirping Noise From Driveshaft Area
I have a 99 F150 4x4 4.6L automatic trans. The truck has 260,000 miles on it. Saturday, while going down the interstate, this chirping noise started up from the rear. When I got home I jacked the rear up and spun the wheels while listening. There is a chirping noise that, as best as I can tell is coming from around the front of the driveshaft around the u-joint area. I've never known of a u-joint to make this type of noise before. There is no vibration or anything, just the noise. The frequency of the noise increases and decreases as I speed up and slow down. I don't think it's coming from the transmission, but it's hard to tell, as everything echoes. I couldn't imaging the driveshaft itself making this noise, but I guess it's possible.
View 12 RepliesFord F-150 (2004-2008) :: Paint Chirping / Rust Below Gas Cap
I've got an 07 f-150 and the paint is starting to chip below the gas cap, there isn't really any rust yet. Whats the best way to fix this? I was thinking about taping it off and sanding a bit and then spraying on bedliner spray.
View 1 RepliesFord F-150 - 1997-2003 :: 1999 - Chirping Noise Coming From Engine
I own a 1999 F-150 V6 4.2 and would like solving what sounds to be a chirping noise coming from the engine. Noise is pretty consistent at which occurs at first startup while in park, drive or reverse and definitely every time I hit the gas from a standstill. The noise is pretty faint but bothers me just enough to where I want to ask the experts. Anyway noise began roughly days after I washed down the motor. I sprayed some degreaser on it and was very careful - making sure to cover the fuse box, alternator and high flow k&n intake air filter.
I stayed away from cables and just used a garden hose. Recently I had the lower idle pulley bearings replaced, serpentine belt and alternator. When I took to Ford for a new belt (it was old) and to inspect the chirping noise, they said # 6 spark plug was loose and that was the reason for the chirp (they called it a ticking noise). First of all how does a spark plug just come loose? They hand tightened it back and I drove the truck for less than a week then the noise was back. Any possibility this sounds like something specific that is wrong? My research says that it could be anything from the belt tensioner to the cam sychronizer to the heat shield around the cat converter.