Ford - Taurus :: 2002 - Air Conditioner Only Blows Hot Air On Any Setting
I have a 2002 Ford Taurus which I bought in the Winter and didn't check the air conditioner. It only blows hot air on any setting, some settings blow more hot air than others. I will have to pay to remove the dash to find out. Here's the weird part, last summer the coolant was a little low and I was stuck in a drive thru line. I watched the temperature go up until, lo and behold, the air conditioner kicked in and blew frigid air! It came on and worked twice more that day. I filled up the coolant and it hasn't worked since.
View 5 RepliesFord - Taurus :: Serpentine Belt Squeak Due To Contamination / Timing Cover Leak
My serp belt squeaks due to contamination due to timing cover leak. I removed belt and cleaned it with mild degreaser solution and it was quiet for 1 day. If I had 100% water in cooling system, would any more leakage cause a belt squeak? I am putting off fixing timing cover gasket since it is a 5hr job. Coolant is @ 90% water concentration now.
Taurus 3.0 Vulcan motor.
Ford Ranger / B-Series :: 1987 Truck Won't Start / Ignition Firing While Key On Engine Off
I've got an 87 ford ranger 4x4. The truck won't start. The ignition is firing off with the key on engine off. When I got the truck the transfer case was blown. The people I got the truck from drove it to here it sat. I check the wiring but the transfer case to make sure it diet get damaged causing a sort. When I got the pcm was missing. Took one out of a bronco 2 and changed the relays on the fender. Here what I've done so far
Relays
Pcm
Complete tune up.
Distributor and ignition module
Replaced and repair some grounds.
Taurus :: 1999 Ford - Key Won't Come Out - New Ignition Cylinder
I put a new ignition cylinder the key won't come out at all. I was told that the key needs to come out in order for them to code the key. How do I get the key out of the ignition??
View 12 RepliesFord :: 1982 - Cannot Adjust Ignition Timing?
I have a 1982 Ford Granada with a 3.8L V6 engine. It has an old-fashioned distributor with a cap, rotor and vacuum advance mechanism. I can’t seem to find any provision for loosening and rotating the distributor in order to adjust the ignition timing. Nor can I find a timing scale alongside the crankshaft pulley. Can the ignition timing be manually adjusted in this engine? Or, is it computer-controlled like the modern vehicles?
View 8 RepliesLexus RX 2010-15 :: Setting Wipers To Go Down After Ignition Is Off
I notice that wipers stop in position they were caught when I turn engine off (in the middle across windshield). Is it possible to set them to go down after ignition is off as other (not so luxury cars) do?
View 3 RepliesTaurus :: 1996 Ford - Headlights Stay On When Ignition Off And Key Out
I have a 1996 Ford Taurus. With the headlight in the OFF position and the ignition off, key OUT, the headlights stay on. All other lights are off. The highbeam indicator in the cluster stays on also. I've disconnected the headlight switch (completely removed from vehicle), and the headlights still stay ON! I know absolutely nothing about this car.
View 7 RepliesFord - Taurus :: 2001 - As Soon As Ignition Is Turned All Power Is Lost
2001 Ford Taurus 3.0 DOHC. Starting Problem. When the door is opened the interior lights come on, door dings, etc. As soon as the ignition is turned everything goes black all power is lost. Disconnect battery cable and reconnect, the open door again and the interior lights come on, door dings, insert key and turn, everything goes black, the car does not start. This cycle repeats over and over again every time the battery is disconnected and reconnected. I have replaced the battery, ignition switch. The starter was replaced last year. Why does power blackout, and car not start when the key is turned?
View 1 RepliesFord - Taurus :: 1993 - Won't Shift Into Gear After Ignition Turns On
I have a 93 taurus 3.8L V6 automatic GL. After I start my car up with my foot on the brake it won't shift into gear from park. But if I pump the brakes a few times it will then go into gear. What is wrong with my car?
View 7 RepliesTaurus :: 2001 Ford 3.0l V6 - Fuel Pump Not Engaging Sometimes When Turn Ignition On
Having a problem with the fuel pump engaging. Warm or cold same problem. When I turn the ignition on I can hear the fuel pump engage and the car runs fine on start. Other times I turn the ignition on and don't hear the pump engage, thus no start. But repeatedly turning the ignition on an off I get the fuel pump to engage and I have start, will run until I shut it down. been doing this for a couple of weeks now. Is this an ignition thing or fuel pump? No wiring diagram. Replaced all relays, battery good. Never did anything with the fuel system.
View 3 RepliesFord - Taurus :: No Click When Turn The Key In Ignition To Start / Dead Silence
I have a 2003 Taurus wagon (a real babe magnet) that has 63K on it. On random occasions recently, I turn the key to start it and there is dead silence--no groans, no clicks, nada. This happened for the second time last week at a tire shop, and the technician had me hold the key in the start position while he tapped the starter with a metal rod, which worked miraculously. He showed me where the starter was and how to perform this miracle. Unfortunately it is a two-person job, and I was stranded the next evening alone at my house, and missed work the next day. Later that day it started right up like nothing had happened.
It stranded me again two days later, and nice lady in the parking lot held the key in start position while I used my cane to tap the starter as I had been shown. I took it to the dealer and explained the problem and my temporary solution, hoping they would know from this exactly how to fix it. After four days, they said they could not duplicate the problem, that the car started right up every time they tried it. Meanwhile the car I had borrowed from a friend broke down in a busy intersection, stranding me again for a short while. I went back to the dealer and brought the Ford home, figuring there isn't much to do but play the odds....Logic suggests that because tapping the starter seems to get it to go, that the problem must be in the starter. Yet the guys at the dealership wouldn't touch anything until the car refused to start for them. Where does one go (or in this case, possibly not go) from here?
Volvo :: 1987 Sedan Engine Do Not Stop When Ignition Key Removed
I am happy owner of a 740 1987 4 door sedan. How to solve the problem: the engine do not stop when ignition key is removed.
View 3 RepliesGolf/GTI VII :: Green Brake Light On When First Turn On Ignition Prior To Setting In Reverse
I just purchased my first VW about a month ago. (Golf tsi white auto). I love the way the car drives/handles. But I was surprised because at just under a 1000 miles the engine light went on. Took it to VW service to check it out. They had to keep it for a few days to do tests with the main VW center. I got the car back without much explanation other than they put in an O2 sensor.
No engine light now for a couple weeks. They also noticed that my wheels are missing 4 lug nut covers (not a big deal). For some reason I am just starting to notice the green brake light on when I first turn on the ignition prior to setting in reverse which disappears upon reverse or drive. I assume this is normal... Question: should I be concerned about this engine light O2 sensor issue?
Camry :: 1987 Toyota Not Starting When Turn Ignition / Sometimes Hear Grind
Just bought for around town. Problem with starting. Turn ignition and sometimes hear grind. Second try in neutral and she starts right up. I don't know if it's problem with key ignition/coil, or the starter.
Also need to convert a/c, fan ok but no cooling. Is this major cost to convert?
Taurus :: 1998 - Ignition Won't Turn?
as stated I have a '98 taurus and whenever I try to start it, the key gets locked in the ignition. I can turn the key to just before starting with the car in neutral and it will start, but not with it in park. Also the turning signals are intermitten at best. Brake lights and tail lights work fine.
View 1 RepliesCivic :: 1989 Cranks Really Slow / Misfire And Won't Start - Intermittent Ignition Timing
From a cold start, my '89 Civic starts and runs just fine - on a short trip. If I shut it off for 15 minutes and let it sit, then try to restart it, it cranks REALLY slow, misfires and won't start (like the cylinders are fighting each other). The battery's brand new, with plenty of juice. So the next time it happened, I disconnected all 4 plug wires - it cranked nice and fast, no resistance. This leads me to believe that the ignition timing is getting messed up once the engine warms up. I think the coil is fine, because the plugs are firing when the wires are connected. I'm thinking it could be a bad sensor that acts up when it gets warm. My prime suspect is the TDC/Crank Sensor. Does the TDC/Crank Sensor can fail when warm?
View 2 RepliesSanta FE SM (2001-06) :: 2004 - Timing Belt Broke And Turning On Ignition Switch Blows CPU Fuse
Son has a 2004 Hyundai Santa Fe 2.7 motor. The timing belt broke before we could replace it. Long story short, 24 valves, gaskets, timing belt, water pump, new belt tensioner and new pulleys. The motor is back together. The only problem is when you turn the ignition switch on, it blows the CPU fuse. The only electrical part we replaced was the purge valve.
View 3 RepliesFord F-150 (2004-2008) :: All New Timing Components And Now Loud Squeal Behind Timing Cover
My daughters 2004 f150 5.4 3v. 130k miles. Had a broken timing chain guide on passenger side. Changed phasers, solenoids, timing chains, crank gear, tensioners, and oil pump. Pulled pan and cleaned it and the pickup tube of pieces of the old guide. Engine had zero sludge. Very clean inside.
Put it all back together. Left crank sensor unplugged to rotate engine until it had good oil pressure which only took a few seconds. Plugged sensor back in. Truck started right up. Runs perfect. Drove perfect. Idles with no noise. But as soon as I rev it up a little, there is a HORRENDOUS squealing from the lower left of the engine. Pulled serpentine belt and squealing is still there. Used a stethoscope to determine its in the lower left behind the timing cover.
I haven't pulled the cover back off yet but what this could be? Everything went back together fine so I can't imagine what it is.
HOWEVER, I did notice that my new tensioners only had an oil hole in one of them. The two I removed both had an oil hole. So one of the new tensioners does not have an oil hole in the center of the plunger. I see online, that many did not come with an oil hole. But I'm wondering if this could be the source of the squealing? Maybe not oiling the chain enough and the squeal that I hear is the chain on the plastic guide?
Subaru - Forester :: 2010 2.5X Automatic With Timing Belt Or A Timing Chain?
I was thinking about checking out the above vehicle at my local dealer (Chevrolet). They're asking 15.9k and it has 57k miles. I need to know if it has a timing belt or a timing chain and how reliable is the engine/transmission.
View 1 Replies