Ford Super Duty (1999-2016) :: Terrible Noise When Hit A Bump / Front Axle Shaft Removal
I have a E99 F350 7.3L 4x4 I know some or most of you have already probably replaced this part and or pulled a front axle shaft out. So here is my question...In the pictures provided you can see what I think everyone is calling a "Dust Seal" and as you can see it is bad and making a very terrible noise when i hit a bump...I was wondering what parts I would need to replace this seal? I tried looking it up and just get lost in all of the other things....I have found write-ups for the axle being removed while changing ball joints but none by it self to just replace this seal.
[URL] ....
Ford Super Duty (1999-2016) :: F450 - Terrible Vibration Between 70 - 80 MPH
Purchased new 2016 450 platinum. Has less than 800 miles on it and has a terrible vibration between 70-80 mph... Already have taken to dealer who stated there was a wheel out of balance and that they fixed the issue. But still present.
View 14 RepliesFord Super Duty (1999-2016) :: Noise That Sounds Like The Bed Is Loose
I have with my truck is when i pull into a parking lot or even my driveway on a angle the truck sounds the like the bed is loose and the body is creaking.
View 14 RepliesFord Super Duty (1999-2016) :: 2008 F350 - Rotational Noise Almost Sounds Like Creaking
In forward drive or reverse, I hear a rotational noise that almost sounds like the bed creaking when you're getting it on. As I go faster the noise goes faster until drowned out by road and engine noise. The noise is unaffected by applying the brakes. I jacked the truck up and spun tires as fast as I could by hand and got no noise but when I lowered it back to ground and had the truck roll the noise was back. Noise is not affected by turning wheel.
View 13 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Thumping Noise While Turning Sounds Like U-joints?
I have a 2003 f250 superduty v-10 -- 4x4 -- when turning with 4wheel drive disengaged I have consistent thumping sound coming from front end -- more so when turning to left but still prevalent on right turns -- I put new hubs in due to the grinding noise when driving slow to mid speeds -- like axles not totally disengaging and grinding on teeth. but this is a secondary noise -- replaced left front axle with dorman unit -- tried to replace u joints on oe axle but rusted so badly couldn't get c clips to separate from ujoints --
this one is kicking my butt and making me look like a novice -- don't think it is ball joints or anything suspension related but I could be wrong -- sounds like thump thump thump as turning in slightly tight circle or going around corner in the parking lot.
Ford Super Duty (1999-2016) :: Clicking Noise At Startup?
I have a 99 F-250 SD 4X4 7.3 with about 160,000 miles and still running strong. I haven't been able to troubleshoot a strange clicking noise during the Glow plug / pre start warm-up process. It seems like the noise is coming from a vacuum "relay/ actuator" ( I think that's what the part is) under the hood on the passenger's side. But again I am not a Ford mechanic, nor have I owned this complex of a truck before.
There seem to be two different vacuum terminals that both have two outlets that attach to vacuum hosing. The unit does not have a line ( or 2 ) connected to the innermost vacuum outlet. Does this need to be connected? If I put my fingers on the units outlets to restrict the noise becomes more high-pitched, then will cease to make the clicking sound sooner than if I didn't cover the outlets.
I'm unsure on the process on how to insert a photo. it's asking for a URL, does this mean I need a flickr photo account to transfer the photo? Can I just upload a JPG?
Ford Super Duty (1999-2016) :: Clicking Noise Behind Dashboard
Whats the clicking noise going on behind my dashboard? It's constant even with everything shut off in my'02 F350. The truck has been laid up for three years and I'm getting it ready to move...
View 7 RepliesFord Super Duty (1999-2016) :: 2002 V10 - Grinding Noise On Driver Side Sounds Like Driving On Rumble Strip
Have a 02 v10 125xxx miles have had grinding noise on drivers side sounds like driving on rumble strip took out the unit hub everything looks good changed out the needle bearing because it was frozen still have sound after needle bearing replacement sound goes away if hubs are locked so question is it the unit bearing or stub shaft...
View 2 RepliesFord Super Duty (1999-2016) :: Clicking Noise From Front Axle
I have a slight problem and don't know how serious it is. I own a 2003 F350 with a lift kit. After my drive shaft shattered last September. due to a U-Joint a clicking noise started up in the front axle area after we locked the hubs so we could crawl it down the road out of traffic.
What would be the likely causes and how much would a typical repair/replace cost?
Ford Super Duty (1999-2016) :: Ticking / Clicking Noise Under Dash?
Diesel truck starts fine. Idles up in cold. Runs fine. Sitting in cab I hear a random clicking. This sound comes and goes. Driving down the highway at 70 it will do it. After an hour or so it won't do it any more. If I shut the truck off and start it again the random clicking will resume it comes and goes? Where to start looking. It sounds like the click from dead batteries but the batteries will turn over engine and start with no problems.
View 7 RepliesFord Super Duty (1999-2016) :: Truck Won't Start / Just Rapid Clicking Noise
So I was trying to put led turn signals in my truck then I decided not to because it was getting too dark. Earlier today started without complaints. Then after I was done with the headlights I tried to start my truck, nothing besides rapid clicking. First thought was battery was dead from me leaving the dome light on the entire time while working on it and also having the headlights on a good portion, so I decide I'll jump it. Get it all hooked up and and start the donor truck then wait 2 mins and try to start my truck still nothing but rapid clicks. I got the voltage meter out to check the battery and had 11.97 volts (that's not great but either way it wouldn't start when I tried to jump it). Put it on a charger? Bad starter? Solenoid?
View 11 RepliesFord Super Duty (1999-2016) :: 2000 F250 - Clicking Noise And Dinging When The Key Is Off Or Out
So, yesterday when I got home I stopped at the barn to unload a few bails of hay and when I got back in to crank it, nothing happened. I turned the key and nothing, so I figured I would just worry about it today. However, when I turned the key back to off and started to take it out all sorts of stuff started to happen. There was a clicking noise and a dinging, not like when the door is open. It was quicker. Also, when I turned my key back on none of my dash lights or radio came on. Nothing happens now, except the strange clicking when the key is off or out. The first thing I thought of was the GEM or fuse box.
View 3 RepliesFord Super Duty (1999-2016) :: Reverse Sensor Making A Clicking Noise
I remember seeing a post a while back stating that the reverse sensor would make a clicking noise (when you're ear is up against the sensor) when working properly, I only had one working but I figured I'd replace them all since the 4th one was sure to go out . Fast forward to using two different sets of sensors, and not a single has worked or made that clicking noise like I would assume it should be. Can an aftermarket head unit cause these sensors to not work properly or have I just gotten two bum sets?
View 3 RepliesFord Super Duty (1999-2016) :: F250 - Dead Battery - Low Clicking Noise In Cab
My 1999 f-250 7.3 has been sitting for months, and I went to start it and both batteries are dead. Replaced both batteries and at first the alarm went off like normal. Turned the alarm off, hit the unlock button and it beeped like normal. Got in and stuck the key in the ignition and tried to turn it over. Completely dead. Now I cant even get the alarm to go off, showing no signs that its even getting any power. And all I'm hearing is a low clicking noise in the cab.
View 5 RepliesFord Super Duty (1999-2016) :: Loud Clicking Noise From Turn Signal Switch?
Example, if I'm turning the wheel to the left with the left turn signal on there will be a LOUD click, click, click ect. sound from the column. The sound is louder than the turn signal relay and can be heard with the radio on.
Today is the third time I've brought it in to have fixed and now they tell me it is "normal". They came to the conclusion that it is "normal" because two other trucks on their lot make a noticeable clicking sound and one is just as loud as mine. However, My truck JUST STARTED making the noise a few months ago and was quiet when I originally bought it.
I know this is not a big problem ,but it is annoying and I want it fixed. Anyways, my Ford dealer had bailed out on me so how do I fix it myself?
Can you hear the column switch clicking ALOUD in your truck?
Ford Super Duty (1999-2016) :: 2003 - Clicking Noise Form Front While Driving?
2003 F350 4.4 5.4L auto. The front hub assemblies, seals, axle ujoints and upper/lower ball joint were all replaced. I bought all the parts gave them to the mechanic and told him if there's problems call me. I took a week off went to MS and he never called. I go to get truck he tells me, the bearings in the hubs are not spinning freely causing the axles to spin. I checked the hubs they are in the unlock position (Warn manual hubs). Originally auto hubs. Now i have the whole front diff spinning and the front drive shaft is spinning too. Clacking and clicking from the front wgen driving. Oh he said the front drive shaft ujoint was bad also. I paid $600 to have it all replaced and i get it back wrong. Is there something i need to check on the hubs that he maybe did wrong? Or is it possible i was sold the wrong hub assemblies?
View 14 RepliesFord Super Duty (1999-2016) :: Rapid Clicking Type Of Noise Out Of Vents When AC Is Turned On
So my truck is making a rapid clicking type of noise out of the vents when the ac is turned on.
The noise sounds like a thin piece of paper getting hit by a fan (that's what I hear) It started during this past winter when I would cold start the truck. but as the heater warmed up it went away completely. well now since its warm out I am running the ac now, and it blows cold but doesn't have a lot of volume to it it seems. but being the problem was when the truck was cold running the cold ac makes the noise permanent.
The blend door acutator is working as should (i can only assume the blend door is ok) the vacuum lines are good and vacuum signal is good.
Ford Super Duty (1999-2016) :: 2008 F350 4WD - Clicking Noise Only When Turning Hard Left
'08 F350 6.4l 4wd, I had the truck come in with a exploded transfer case. (See pics). Ive read all about this happening to many others. The truck still drove, hubs not locked, plenty of fluid in the TC, pretty sure it was the double Cardan that did it. Anyways I replaced thwith TC, replaced the front driveshaft, filled the TC with recommended fluid. Test drove and drives great, shifts fine. Only until I turned left.
At slow speeds turning hard or 15-20 taking a turn, it sounds like a ratchet clicking from somewhere on the left side, right around the drivers door, from what I can hear from the cab. Does it in 2wd, 4wd hi/low, hubs locked or not. I changed the vacuum pump, no leaks, changed the IWE solenoid, pulled out both locking mechanisms, tightened crossmember, checked everything from the hours of research I did on the internet. I cannot find the problem. I don't know what else to check. Front axles free spin and lock when they are supposed to. I'm at the end...
Ford Super Duty (1999-2016) :: F450 V10 - Loud Clicking / Clunking Noise Coming From The Front
I thought there was a v10 specific superduty section like how the psd does, but my thread went in the "performance, engine, troubleshooting" section.
I wanted more exposure than that particular small viewed area.
I don't have a video of the noise, but my 99 f450 v10 5spd has some iffy noise coming from the front. I've read so many threads on this and they either end with "my motor had 1-2-3 bad pistons" or "my flexplate was cracked" and all that dealt with chain tensioners were never finished.
I know what piston slap sounds like (worked on many cobras and lightnings with forged pistons that had it) and have experience with bad wrist pins and broken piston skirts, and this noise doesn't sound like any of it.
Noise is a loud clicking/clunking/Detroit diesel idle noise. When you rev the engine up it doesn't lighten or get better, only worse as rpm goes up. Oil is terrible looking, I'll be getting that changed this week.
Story on truck. I've had this thing for 4 years with blown motor. I got a buddy that acquired a parts truck and he said it ran good. I dropped my truck off and he swapped the engine. I got my truck back running, but with this engine noise. He said it needs to get run some more and change oil.
I think it's timing tensioners, my buddy says it will come out of it, a mechanic friend says it's going to blow up "because they all do" and I don't really want to replace the engine again.
If it's tensioners, how big of a job is it. I have the cam clamps and crank stop and the ford tools to make sure crank and cams don't rotate while apart.
I'm just 650 miles from my truck and may need someone else to do the work. Which sucks.