Ford Super Duty (1999-2016) :: Shudder Like Driving Over A Rumble Strip / Clunk Underneath
My vehicle had a shudder which felt like driving over a rumble strip. It would usually occur after hitting a small bump at around 35 mph and hearing a clunk underneath. The shudder lasted just a few seconds. Checked the whole steering, suspension, chassis, drivetrain, u-joints, rear e-brake shoes etc. Finally found that the RF axle shaft could be moved up and down excessively in the steering knuckle. Removed axle shaft, R&R u-joint, vacuum hub seal and the torrington bearing in the hub. (used to call it a spindle bearing) ...
There was a little bit of wear into the stub shaft where the spindle bearing rides. That removed the play from the axle when it was all re-assembled. I was very happy until about a month later when it started doing it again, but not as bad as it was originally. I think maybe the stub end of the axle shaft needs to be replaced due to the wear in it. I don't want to just throw a somewhat expensive part at it without some info about "superduty shudder".
Ford Super Duty (1999-2016) :: 2004 F250 4X4 - Front End Rumble - Squeaking / Grinding Noise Then Clunking
So to start at the beginning.... Traveled across Canada East to West towing 11000lb travel trailer, no problem. Have used 4x4 in a few campsites to pull out of a pitch without spinning the wheels and causing damage to the site when it has been really wet. All good.
Got to Banff in December and the town was an Ice rink, engaged 4x4 and all good. Crossed the Rockies and the 4x4 starts making grinding noises. Up and down some mountains and squeaking, grinding noise then clunking.
I have manual hubs, disengage and the noise all goes away. Engage 1 hub and no noise. Engage both hubs, noise back.
I bought some needle bearings and went to swap them. Got hubs apart and they look good. No scoring on the drive shafts. They are not dry, but as I have them open, repack them with grease anyway.
Do more research... Remove ABS sensor and repack main bearings with grease. (broke one sensor pulling it out, too cold plastic brittle oops). Still clunking noises.
The universal joints look good, doesn't appear to be any play in them. However, the axle seal (knuckle seal) (F81Z-3254-CB) does move around a lot in it's metal casing. It is tight on the shaft, but with the hub off, I can move it in and out, and move it side to side. If I had ESOF hubs I guess they would not be locking as I'm sure there would be no vacuum in there!
Question is then, would this seal be allowing the universal joint to wobble under load in 4x4 mode? Would this wobble be the cause of the rumble? As it is labelled as a seal and not a bearing, I wouldn't of thought this would have been a loaded point, and the weight would have been taken by the associated bearings and it could be run without this seal? But if it is not this, then I'm still looking for a clue as to what is making the rumble....
Ford Super Duty (1999-2016) :: Whistle Sounds On Right Side When Driving Over 60 Mph
I have a whistle from my 2000 f250 super duty when driving over 60 mph. windshield is new, seal around windshield is good (looks good to me).
whistle sounds like its on right side when driving, and left side when sitting in pass side. wife narrowed it down to the over head console sunglass pocket is where whistle is loudest.
Could the clearance lights be whistling? How does one tighten them up or add sealant to the bottom of them to seal them to the roof. Do I have to drop the front of the headliner to access them?
Ford Super Duty (1999-2016) :: Shaking And Grinding From Front Driver Side Of Truck
My truck has an intermittent shake with a grinding/binding kind of noise. It seems to happen at lower speeds, generally when slowing down and turning. When I apply the brakes or speed up it seems to stop the noise.
The rubber/plastic seal on the back of the wheel hub is loose on both drivers and passenger side but I don't think that is the problem. I'm wondering if it is the u-joints or something.
The brakes look shiny and i don't see any scratches on them so I don't think there is a rock or something in there. I have the wheel hubs in the auto setting, and it is a 4x4. The truck is a early 99 7.3L with a leveling kit and 230k miles.
Ford Super Duty (1999-2016) :: 2001 F350 - Vibration / Grinding On Front Driver Side After Partial Rebuild
2001 f350 4x4 dually 7.3 powerstroke, I recently replaced the hub assembly, stub shaft and seal, u joint, ball joints on the front drivers side and now periodically the truck makes a grinding growling vibration coming from front drivers side and stops after hitting a bump...
View 3 RepliesFord Super Duty (1999-2016) :: F350 - Grinding Noise On Left Side Front
I replaced both front bearings, calipers, brake pads, now I have a grinding noise on the left side front stops sometimes when you step on the brakes? 1999 F350 ...
View 6 RepliesFord Super Duty (1999-2016) :: 2002 4x4 - Vibration Coming From Front Driver Side
I've got a 02 SD v10 4x4 with Warn hubs and 97k. Bought it a couple months ago and I've noticed a vibration coming from the front driver side. Symptoms are that of a bad wheel bearing; vibration that increases with speed and not RPM, seems to lessen on left handed turns (weight transfers from driver side to passenger side) and gets worse on right turns. Also the truck seems very twitchy and hard to keep straight on the highway.
Snowed the other day so I locked in my warns (just in case) and I instantly noticed the noise and vibration almost went away entirely except for on the freeway around 70+ mph. Also noticed it seems less "Twitchy" on the freeway. Mind you the hubs are locked in but still in 2wd. After doing a little bit of reading some were saying this is a sign of bad needle bearings and not the entire hub.
I haven't jacked up the tire and checked typical movement in a bad wheel bearing. I know my way around vehicles and 4x4's pretty well...
Ford Super Duty (1999-2016) :: 2002 - Leak Beneath Driver Side Manifold?
This is right beneath the drivers side exhaust manifold. Not sure what it is but it appears to be leaking oil. Tried to tighten it and it seems snug. Can it be the gasket has gone bad for whatever it is?
Truck is 02 SD, 7.3, 4x4, with 512k miles.
Not really leaking bad but if easy enough to fix why not. It also appears to be leaking on the same side cylinder bank back near the rear of the valve cover. Need to see if I can snug that up as well.
It's right in the center of the pic. It's a bolt going into some sort of fitting housing that ties into the back portion of the block. Ignore the coolant streaks on the coolant hose. This is the oil leak in the darker center of the pic.
Ford Super Duty (1999-2016) :: 2002 - Driver Side Front Leaf Spring Snapped?
I just realized my driver's side front leaf spring on my 2002 F250 has snapped. I checked the weight sticker on my truck and it weighs 5200lbs in the front. My question is the heaviest springs I found only support 2630lbs a piece, so being a 7.3 is 5200lbs a correct weight for the front of this truck? also why would Ford make springs that support only 60lbs more than the front weight? Hell I weight more than 60lbs.... Did I snap the damn thing just by climbing into the cab?!?!
View 6 RepliesFord Super Duty (1999-2016) :: 2002 F250 - Driver Side Front Power Window Will Only Go Down And Not Up
here's the problem. The driver side front power window will only go down and not up. I checked the motor and the master switch with a multimeter and both work just fine. the motor is receiving power and the master switch is sending power. However when i plug the motor back in and re-install it, the window will not go up. Is there some sort of relay that might have gone bad that is not letting the motor raise the window up???
View 5 RepliesFord Super Duty (1999-2016) :: 2002 F250 - Radio Is Staying On When Turn The Key Off And Open Driver Side Door
I have a 2002 f250 7.3, an my radio is staying on when I turn the key off and open the drivers door. Windows are also still working. But if I open the passenger door it shuts off. What do I need to fix this I am tired of leaning way over and tryind to open that door every time I turn the truck off. I have been told to spray wd-40 into the door catch are i used a whole can an it still isn't working...
View 2 RepliesFord Super Duty (1999-2016) :: 2003 - Blower Motor Loud Rumble Noise?
I have a 2003 super duty V10 4WD super cab long bed.
loud deep rumble noise when turn on the blower. both heat and a/c. removed the blower and seemed to turn ok. blew out all vents. removed heater radiator cover, checked most flaps to see if working. doesn't seem to be obstruction invent. the flap behind blower clear and functioning ok.
When on second speed, almost sounds like blower motor is out of balance. if run on high for 1 minute, smell electrical burning! Think to replace motor will work? will post another issue with radio and power windows
Ford Super Duty (1999-2016) :: Rumble Noise At Low Speeds Like 30 Mph Or Lower And More Prominent When Come To A Stop
Experienced rumble type noise, like if you drive over those highway rumble things on the edge of the road. It happens at low speeds like 30 mph or lower and more prominent when you come to a stop. It came on all of a sudden . Replaced new tie rods, dampener and stabilizer bar links and still have it. Tires wear great and thought the hub's were still turned in as it sounded the front differential drive line was going around. This is on a 2002 F250 crew cab.
The complete tie rod kit that connects to the the pitman arm isn't cheap, it did need replaced as there was a lot of play in it but damn, when on a set income and it still have same problem , very upsetting. On social security disability and I told them that I can't keep spending money on parts that they told me were bad and it didn't work. Everything is tight on the wheel according to the tire shop , it takes me a while to get underneath and I can't find anything .
Ford Super Duty (1999-2016) :: 2001 F250 4x4 - Getting Noise In The Front Driver Side Wheel
Here's the deal. I have a 2001 F250 4x4 and I am getting a noise in the front drivers side wheel. The noise is not a grind or clunk, but its like a u-joint is rubbing inside an empty cylinder kind of. Anyways, it seems like it does it only with small bumps. I took off my oem hubs and re-installed them and the noise went away for about a week. Now I replaced them with manual locking hubs and the noise is back. One other thing I notice is if i put the switch to 4x4 the noise goes away. I checked all major components for the steering and suspension and nothing was loose. The front end is tight. Is there anything inside the axle that would cause this? I dont know what to check for anymore. Where else to check?
View 4 RepliesFord Super Duty (1999-2016) :: 2012 - Whirring Noise Occasionally Under Driver Side Floor
So I'm going to be putting a deposit on a 2012 6.7 dually tomorrow after work. It has about 40k miles 2800 hrs 1400 idling. It looks perfect. Drives good, sounds good except for a bit of a whirring noise occasionally under the drivers side floor (fuel pump maybe?)
For warranty I still have the remaining 2 yrs, and the miles left. I am going to try to get them to give me 5 more years on the powertrain. Before I pass the check is there anything I should specifically look for? It is a beautiful truck ....
Ford Super Duty (1999-2016) :: 2003 6.0 4WD - Low Rumble Noise / Whining When At Light Throttle Load And Above 50 - 60 MPH
I have a 2003 F250 SD with 130K miles. I primarily use it to pull a race car, about 5000 lbs is all. It has all the upgrades, from studs to EGR delete. Ford replaced the automatic transmission in 2005. I'm looking at a truck newer than 2011, but thinking either a flex fuel 250 or diesel. I want it loaded and 4WD, but they seem expensive.
Anyway, I have bad front wheel bearings. I know this because of the low rumble noise and how it acts when I rock the steering. How tough are they?? I build my entire race cars, so I have a well-equipped garage and some ability to cuss, but I don't have a lot of time. A buddy wants to do it for $300 total for both sides plus parts cost.
Also, this is the bad part I really need input on. It has a whining when at light throttle load and above 50-60 MPH. This seems to come from the floorboard area behind me. Gear changes do NOT affect the pitch, but a change in throttle crowding makes it louder and weaker. It has no coast down noise at all, and the noise pitch seems to track the drive shaft speed. It is a whine much like the low gear set in an automatic trans, but it does it in any gear with or without 4WD on. The only thing that affects the level is slightly pushing the accelerator, speed, or weight I am towing.
Ford Super Duty (1999-2016) :: Front Driver Side Wheel Making Clunking Noise When Hit Bump?
My front driver side wheel is making a clunk noise when I hit a bump. I replaced the wheel bearing hub assembly and discovered both axle seals were bad.
View 10 RepliesFord Super Duty (1999-2016) :: Noise That Sounds Like The Bed Is Loose
I have with my truck is when i pull into a parking lot or even my driveway on a angle the truck sounds the like the bed is loose and the body is creaking.
View 14 RepliesFord Super Duty (1999-2016) :: Hub Sounds Like Terrible Clicking Noise?
I have a 2001 F250 Super Duty 4x4 with the 5.4L I bought it cheap and runs well. While going through doing the stuff that needs attention I noticed the 4x4 isn't workijg. It has whatbappears to be some cheap maybe plastic locking hubs and the manual pull stick onj the floor for engaging the 4x4.I can pull it into 4H and 4L, the dash lights confirming come on but the front wheels will not lock in.
One of the cheapo hubs looks like someone clamped vice grips on it to try and turn the and doesnt seem to totally lock in. The drivers side hub sounds like it is lock in but makes a terrible lound clicking noise.
They may be the stock hubs, have no markings to designate the direction to lock and unlock and do appear to be somt sort of plastic hub.... Are the hubs my problem since I can manually pull it into 4x4 and I can see the 4x4 shaft spin but the tires are not engaging?