Ford Super Duty (1999-2016) :: Replacement Of Broken Oil Drain Valve?
I have a 2016 f350 diesel dually (my first diesel).I changed the oil in the truck myself back in April and learned a messy lesson of how much pressure is pushing on 13 quarts of oil. I would like to replace the oil drain plug with a Fumoto F106SX M14-1.5 Sx series drain valve. I have only one question for everyone, have any of you that replaced your drain plug with a drain valve had it snap off while driving? I do not off road, except for driving through a campground when towing a 5th wheel trailer.
View 14 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Light Smoke And Heavy Exhaust Smell
I have a 2008 6.4L F-250 and occasionally when I come to a stop I can see a faint white smoke coming out from under the truck and the hood. The smoke has a heavy diesel exhaust smell. When I step on the pedal nothing comes from the exhaust and it does not happen all the time. What is going on?
View 2 RepliesFord Super Duty (1999-2016) :: What Size Tube To Fit For Brake Bleeder
2010 F250, what size tube do I need to fit on the brake bleeder screw? The tubes I have are all too big and the size marks are no longer legible.
View 4 RepliesFord Super Duty (1999-2016) :: 2003 - Changing Plugs / Boots - Grease And Water In C-O-P?
OK changing plugs and boots on 2003 f 350 5.4 (I have a bad miss and mis-fire code) First time messing with these things. When taking out the coil over plugs it looks like somebody put die-elect grease up underneath the boot at the top where the spring and the metal prong touches together. I thought I just needed only to grease the plug on the sides to keep the boot from sort of melting onto the plug. And some boots had maybe a drop of water in them is this common or any concern? Might be condensation and water does conduct elec, so not that concerned, but these C-O-P's are new to me and thought I'd ask. I've searched here and read posts about changing of the plugs and C-O-P's but don't remember any water boot coming up.
View 6 RepliesFord Super Duty (1999-2016) :: 2004 F250 - Drive Shaft Removal To Grease The Center Spline
I'm wanting to grease the center spline on my drive shaft. I got the 4 bolts off with a 12mm 16 point boxed in wrench but can't get the drive shaft loose from the rea rend. I don't blindly want to go beating it out of the yoke with a hammer to try to knock it loose (but I will if I have to). What am I missing to get this shaft out?
View 3 RepliesFord Super Duty (1999-2016) :: Heavy Duty Rubber Floor Mats With Transfer Case
New floor mats. My truck is going to be 10yr old and has the original King Ranch floor mats. I want some heavy duty rubber ones that will fit around my manual transfer case lever. I ordered the Weathertech digital fit liners and I am not happy with them so they are headed back tomorrow. They have a heavy duty all weather mat but not sure how it will work with my shift lever on the floor. Husky liners/mats look nice and heavy duty but won't accommodate the floor lever.
View 6 RepliesFord Super Duty (1999-2016) :: Difference Between F250 Custom And Heavy Duty Steering Stabilizer?
Is there a steering stabilizer for a 92 Ford F-250 custom 2wd? and what's the difference between a f250 custom and a f250 heavy duty?
View 2 RepliesFord Super Duty (1999-2016) :: Vibration At 70 MPH / Heavy Rumbling
I have an issue with a truck I recently purchased. I have a vibration that starts around 50, feels like a wobbling vibration. Than once I hit 75 it feels like the truck is going to fall apart. Heavy rumbling.
It's a Ford F-350 dually extended cab. With 115,000 miles on it.
I took it to the shop to balance out the wheels and all the wheels needed atleast 2 oz of weighs on each side. Some have as much as 4.75 oz on one side. Is it possible that I need 6 brand new rims?
Ford Super Duty (1999-2016) :: Stuck Steering Wheel / Heavy And Does Not Center On Its Own
06 F250 6.0 CCSB 4x4 163K Truck was in a pass side wreck about three weeks ago. Aside from bumper, head light, etc I had to replace the track bar and then I had the alignment done. Mech said the steering was loose and was either the steering box or column.
PROBLEM: Truck drove and parked fine last night, I went to leave the driveway this morning and I had to turn the wheel full right while backing up. The wheel locked up and wouldn't turn back to the left to straighten out. Hood wouldn't pop either to check anything
I crawled under the truck, the belt was in place and I didn't see any power steering fluid leaking. Thinking it was a PS problem and the hood not opening, I basically floored it and yanked on the wheel and it broke loose. Also, for what ever reason the hood opened after that
Now the steering is heavy and the wheel doesn't center on it's own. It will stay turned when I let go of the wheel. Scared that it would happen I didn't try turning it full lock on the way to work. but it happened again exiting the parking lot, again full right lock and the wheel stuck.
I managed to yank the wheel to the left again and I heard a distinct pop from what I'm sure was the pass side wheel area.
The PS fluid is dark and I'll figure out how to change it. I've read issues from the U-joints, ball joints, Steering box, steering stabilizer, and failing PS pump could all lead to this. Being the truck had a pass side fender bender, and I'm pretty sure the pop sound came from the pass side how do I check all of these items.
Ford Super Duty (1999-2016) :: Excessive Blue Smoke After Heavy Acceleration
I have installed a delete kit and a H&S chip on my 2009 F350 6.4 powerstroke , I installed the mild tune and run in street level. When I accelerate fast from 20 to 70 it puts out a little black smoke but as soon as I let off to maintain speed it starts blue smoke really thick and runs rough , it will eventually stop after 5 or so miles but if I accelerate it will puff blue each time for a bit longer. What could be the issue?
View 11 RepliesFord Super Duty (1999-2016) :: Headlights Gone Out While Driving In Heavy Constant Rain
I did the HID headlight swap about a month and a half ago. Driving tonight about an hour away in heavy constant rain my headlights have gone out... They have flickered. They have gone in and out a couple times but end up off. Any Quick fix????
View 14 RepliesFord Super Duty (1999-2016) :: 2005 F350 - Heavy Vibration While Accelerating
My '05 F350 PSD has developed a pretty bad vibration most noticeable above 40mph but only under acceleration. As soon as i hit speed and let off the gas its gone but if i accelerate again to pick up the speed i lost its back. Haven't looked into it too much yet as i was busy all weekend and drove the Expy but I did get down there and don't have an obviously bad u-joint or carrier bearing. I'm also gonna see if i popped off a driveline weight or something.
View 8 RepliesFord Super Duty (1999-2016) :: Trans Fluid Leak After Pulling Heavy Load
I have a 2000 SD F250, gasser, auto. Last week I pulled a heavy load and developed a tranny fluid leak. The fluid appears to be coming from what looks like a freeze plug on the bottom of the casing forward of the (torque converter?) pan . Is that plug easily replaced by a DYIer. Small leak. 150K on the motor. First time it has leaked. Heaviest load I've pulled.
View 2 RepliesFord Super Duty (1999-2016) :: OEM 7 Way Trailer Connector Broken Off?
Well, it seems the cover on my trailer connector got broken off. The cover locks the trailer plug into the truck side. The connector on the truck is/was supplied by Ford. Now the dealer say NLA, only 2005 and up. Truck is 99 F250 SD. Plug is 4/7 way. Where can I locate a direct plug-in replacement? I do not want to be cutting and splicing.
View 14 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Steering Seems Heavy And Won't Return To Center After A Turn
Just bought this '08 F250 CCSB 4X4 5.4 Problem is the steering seems heavy, it tends to wander at higher speeds and won't return to center after a turn. I've searched on here and found a few possibilities (axle u joints, ball joints, steering gear, etc). I have an appointment with the dealer on Friday to fix it under warranty but he is convinced it's the u joints in the steering shaft seizing. When my F150 steering shaft began to seize, it would be hard to turn then break free then be hard then break free and this is not what is happening on the SD. I haven't had a chance to check the front end myself but not sure how you would check the axle u joints if there was no play in them. How would you check to see if they were seizing up.
View 3 RepliesFord Super Duty (1999-2016) :: Long Term Negative Effects Of Heavy Condensation In Engine?
I only live 6 miles from work and I've been getting a lot of condensation gunk building up inside the filler cap and around the neck. Is there going to be any long term damage from this? Here is a picture of what I'm getting.
I know it's not coolant because I'm not loosing any and the oil on the dipstick is clean.
Since it got cold I've been taking another route to work that gets me up to 9 miles one way. Also, twice a week I take the long way home that has the engine running for a half hour but I'm still getting build up. In the winter I'm on call a lot and rarely go far from home so taking a two hour trip to really heat things up is probably not going to happen.
ETA. I change my oil every 3000 miles if that makes a difference.
Ford Super Duty (1999-2016) :: 2002 F250 - Misfiring Under Heavy Load Or High RPMs
So basically I thought it would be a great idea to degrease my motor from the top down.... After washing I start it up and drive down the road to head abunch of misfiring under heavy load or high rpm's.
My problem is that the misfiring won't throw a code. I then proceeded to buy a new ignition coil (thinking this was the problem) but with no code to go off which cylinder was bad I just switched the good ignition coil into each cylinder and starting it.
Up each time. None of them seemed to make it better. Also the injectors all seemed to be good. So what to do ?
2002 Ford F-250 5.4l
Ford Super Duty (1999-2016) :: Trailer Plug Door Is Broken
The door on my trailer plug is broken. I can't seem to find just the door. Need to get one without having to buy the whole plug assembly?
View 6 RepliesFord Super Duty (1999-2016) :: Front Drive Shaft Broken?
Not sure what caused it to break but my front driveshaft split in half. I had it in 4wd and was doing a K turn to back in my driveway in a snow storm.
I got underneath in the snow (miserable) and wasn't able to come close to getting it off. The bolts holding the shaft onto the t-case will not budge and the tiny 5/16" bolts stripped all my small 1/4" sockets. I'm guessing I need a 3/8" drive 5/16" for front and the rear just spins. Any tricks to getting this off the truck.