Ford Super Duty (1999-2016) :: F250 V10 - ABS Light Come On Then Go Off - Code P0500
My 99 F250 with a V10 had an abs light come on and then it would go off. Now the ABS light stays on and it drove fine for a little while but the other night the Service Engine light came on along with the ABS light. Tranny was shifting harsh, winding out and I scanned the codes and got P0500. Is it the sensor on top of the rear differential or is it the ABS light causing the problem?
View 2 RepliesFord Super Duty (1999-2016) :: F250 - Check Engine Light Comes On And Code P0500
So yesterday I decided to wash my truck and after taking care of that I took it for a short drive and the tranny started acting funny. Check engine light comes on and the code is P0500 . It calls for a VSS but I cant locate it. Also the fact that it did after washing the truck is making me think its a wiring issue... F250 SD 5.4 4x4 ....
View 5 RepliesFord Super Duty (1999-2016) :: ABS Light On Dash Came Up - Code P0500
1999 F250 Super Duty 6.8 V10 4x4 157k miles
On Friday afternoon the ABS light on my dash came up, ran the codes on my SCT Livewire and came up with a "P0500 Vehicle Speed Sensor A"
What should I be going after? Rear speed sensor? Front ABS sensors? Transmission speed sensor?
Speedometer is functioning 90% of the time, twice in the last 48 hours it wouldn't then shift hard and I would pull off to reset.
I have looked over the search results and wondered if there is a way to test the sensor with my multi-meter? Seems quite a bit of people had flashing over-drive light's at the same time, which I do not.
Ford Super Duty (1999-2016) :: 2001 - F250 V10 Transmission Malfunction - Only Goes Into Park / Reverse?
I have a 2001 F250 V10,
So the truck drove fine yesterday had zero issues... I used my auto start as I do every morning in this cold weather, get into the truck and shift from park to drive and its like it does nothing. I can free rev in N,D,1,2. Reverse works great.
I tried switching from 4wd to 2wd, no change. Reverse works just fine. No noises, codes or anything, just doesn't want to engage...
I am assuming I have a 4R100. Could something electrical cause this? I am thinking its mechanical, but hoping someone has ran into this before.
Literally no way I would have known the trans was going bad... It's always worked fine. Tranny fluid is full, I tried unplugging the battery waiting and plugging back in, no dice.
Ford Super Duty (1999-2016) :: 2006 F250 Speedometer Malfunction - Stuck On The Deceleration
On my 2006 F-250 truck, the speedometer is acting funky. It's like it stuck on the deceleration and now at a complete stop or idle it shows a speed of anywhere from 40-60 mph. It does change and go up and down, as I drive but it's now just off by 30-60 mph. Is this an electronic setting/calibration that one can do?
View 10 RepliesFord Super Duty (1999-2016) :: 2002 F250 - Turn Signal Malfunction Caused By Brake Light Circuit
I'm having a turn signal issue with my '02 F-250 that started this morning out of the blue. Seems that when the signal switch is set for a right hand turn and the brakes are applied, the signal will then become solid, not flash, and then blow the fuse. Evidently something with the brake light circuit is overloading the turn signal circuit and not canceling when the turn signal is activated.
Here are a couple of things I have tried to narrow down the culprit.
1) Left turn signal works fine regardless if the brake lights are operating.
2) Brake light circuit operates fine by itself.
3) Right turn signal works fine but there seems to be a back-feed of power causing the center third brake light as well as the left side rear brake light to flash in unison. If brake lights are then activated, the flash stops and becomes constant thus blowing the fuse.
4) Emergency Hazard lights work perfect but the center third brake light again flashes as well which reverts back to some type of back-feed of power. Also, if brake lights come on, flashing turns to constant light and then blows the fuse again.
I guess my question is,. does this seem like the multi-function switch needs replacing or could this be a relay issue of some sort? I don' think its a ground issue simply because the left turn signal circuit as well as the center brake light circuit are both being breached when the right turn signal is activated. Your thoughts?
2002 F-250 Super Duty 5.4 V8
Ford Super Duty (1999-2016) :: 2004 F250 - Rear Tail Lights And Front Running Lights Not Working
The rear tail lights on my truck have been out for a while now. I wasn't doing much driving at night so it wasn't much of a bother but the new job is getting me home a little later and having to drive with my hazards on is getting old fast.
My radio wasn't working either and I disconnected it a while back hoping maybe it had something to do with my lights shorting out but no luck. It remains disconnected. Just in the past few days my front running lights have went out as well.
I've tested all fuses multiple times (and replaced a couple of them) and checked and replaced bulbs. My brake lights, headlights, dash lights and hazards all work fine. I have the trailer light hook up on the rear bumper and disconnected it at the wiring harness as well hoping it was the problem but it wasn't.
Ford Super Duty (1999-2016) :: 2005 F250 - CEL Code 2285?
Ok says injector pressure sensor low first guess was the upgrade to the blue spring. Did that code clear for a day then comes back on looking at the hfcm but kinda unsure? Came on after we got the real cold snap and i had to buy a block heater I don't see one on here i also added diesel 911 to the tank this is a 05 f250 w 6.0l....
View 2 RepliesFord Super Duty (1999-2016) :: 2001 F250 - PCM Code Location?
Where to find the PCM 4 digit code on 2001 F250 superduty/v10- Lariat?
View 3 RepliesFord Super Duty (1999-2016) :: Adding Fog Lights To 2012 F250 XLT?
I read in a thread about how fog lights need the auto light sensor or something in the kit to be installed and flashed.
My truck is a 2012 f250 XLT that I bought left over from a podunk town IN illinois. It does not have fog lights but it Does have automatic head lamps. So Im very confused on what kit to order to add fog lights to my truck.
Ford Super Duty (1999-2016) :: 2004 F250 - No Brake Lights?
I have an 04 F250 with no brake lights. However the third brake light works. I've also noticed that my trailer brake lights don't work either. I do have all my turn signals and running lights. Another issue that could be connected is I have one out of four hazard lights. When I push in the hazards my front passenger blinker works but none of the others. Could this all be due to a relay switch?
View 14 RepliesFord Super Duty (1999-2016) :: 2004 F250 - No Brake Lights
Bought an 04' F250, looked good but definitely not well maintained. Have replaced tranny temp sensor, thermostat, fuel filters, air filter.... Etc. heads have been redone and new studs installed , Egr delete, new oil cooler, flushed cooling system. Now tonight coming home noticed the brake lights aren't working, all 3 are out... fuses are good. I've heard multifunction switch or brake switch.....
View 12 RepliesFord Super Duty (1999-2016) :: 08-14 Tail Lights In 2007 F250?
I have a 07 f250 and wanted to change them to the 08-14 tail lights. Did Ford change the size or a simple switch...
View 2 RepliesFord Super Duty (1999-2016) :: 2010 F250 - No Tail Lights
I have a 2010 F250 super duty and I cannot figure out what is wrong with my 7 way for trailer lights. I have brake and turn signals but no tail lights. I have checked all fuses and relays and they are fine.
View 4 RepliesFord Super Duty (1999-2016) :: 2006 F250 - CEL And Error Code For TPS Occasionally Comes On
Engine light and error code for tps occasionally comes on , then stays off a while. parts store said it was ok (shows full range) , but ford has an update for computer to fix. engine is v10 and parts store erased code and it hasnt come back. the only indication that something was wrong is the light coming on and once on the interstate at high speed , then the off ramp slow down, the engine seemed to want to stall as if engine not matching actual speed for a few seconds, then it was ok again. I was out of town and the mechanic that looked at it told me to go to Ford for an update. He tested the tps and said it was ok.
View 2 RepliesFord Super Duty (1999-2016) :: F250 - Rough Idle And Code P0113
I have a 99 f250 5.4l 2v with 165000. just two weeks ago i went to start up the truck on a job site to take lunch and it was running really rough. I talked with a mechanic at my shop and he said that it sounded like the aic or that i needed plugs. I went and bought aic and plugs and installed them all in one day. I unhooked the battery before i did any work and have changed the coil packs about 3-4 months ago when it was jerking at highway speeds. I am at a loss.
Read so much on the site about could be this or that and cant afford to through money at it like the govt does. I replaced the ait(air intake temp sensor) and the ect(engine coolant sensor) after i got a code from oreillys that said p0113 which is high input on it. I have read it can be so many things and it seems to be running rich because i am getting about half of mileage i was getting before problem started. i need a fix soon as i must drive the truck to work everyday which is a 52 mile trip total.
Ford Super Duty (1999-2016) :: 2005 F250 - Code For Cylinder 3 Misfire
My 5.4 F250 with 200,000 miles having many problems... It all started a few months ago, when the cam needed to be replaced, and a cam phaser was also replaced at the same time. It ran fine after, then threw a code for cylinder 3 misfire. The guy I took it to said it was due to the huge crack in the exhaust manifold and that was messing with the o2 sensor coming up as a cylinder 3 misfire. So, got the new manifold and it was good for a few weeks.
Now, starting the other night, Friday the 13th, it threw a CEL when I was coming into the driveway. It had been throwing a code every once in a while, and I brought it to school to scan it Friday the 13th but there was no code. So, I assume that it is an intermittent problem, no big deal. When I go to get in my truck to go to work a few hours later, the 5.4 cranks... and cranks... and cranks.
I get it to fire up, and it dies again. Run codes, and it says that the cam positioning sensor is broken. Replace both of them, still acts up ie. doesn't start when it does start it runs very rough and stalls. Get it up to my uncles shop, and replace fuel filter.. Still runs like trash. Run codes now, and it says rich/lean in bank 1.. My uncle tells me to move my truck out of the shop, so I start it up, and it runs great. No hiccups, it idles perfect as I move his truck out of the shop first.
I park my truck outside and let it idle for about 10 mins, and when I come back out it is still idling, perfectly fine. I get in, put it in reverse, and get about 20 feet when it dies and will no longer start back up. What could be going wrong?! Sick of throwing money into this thing! At one time while started up in my uncles shop, it was blowing black smoke, as if it was a diesel!
Ford Super Duty (1999-2016) :: 2004 F250 6.8L - Engine Just Shuts Off No Code
I've got a 2004 f250 4x4 crew cab that is driving me nuts. It runs great, but sporadically it will just quit running. Tach drops to zero. Engine is still turning, because it usually restarts by itself as long as I am moving over about 45. If not I can pull over, put it in park and restart it. Sometimes it sets codes, never the same ones and usually not something even related to the problem (transfer case solenoid for example). Most times it doesn't set any codes. I have changed the plugs and coil packs on all cylinders. Right now it is showing the P1000 code so I am suspicious of the pcm or the wiring to it. I think the tach is the only thing dropping out on the instruments and all the instruments are powered through the pcm.
View 3 RepliesFord Super Duty (1999-2016) :: 2010 F250 - Setting Keypad Code?
I recently purchased a 2010 F250 Super Duty and would like to set a keypad code. I have looked every where I can think of except behind the radio.
View 5 Replies