Ford Super Duty (1999-2016) :: F250 - Brake Shutter - Steering Has Dead Space?
I just bought a 99 f250 2wd with 290k on it and my only issues are brake shutter and steering play.
The steering has about an inch to two dead space at center while driving. The truck tracks straight and doesn't wander at all. I was wanting input on what i should look at first to fix the dead space in the wheel. Its a little iffy having to steer through dead area to get steering output.
I just need something good so I can do it once and not have warped rotors again.
Ford Super Duty (1999-2016) :: 2001 F350 - Parking Brake Pedal Is Extremely Hard To Push
I have a 2001 F-350 Diesel 4x4 crew cab 8ft bed dually 7.3 diesel 6 speed. The issue is that the parking brake pedal is extremely hard to push. One day it pushed down and ratcheted into a locked position as normal and the next day I couldn't push it more than an inch down. I have rear disc brakes with internal drums in the rotors for the parking brake assembly. I replaced the shoes and hardware (which were fine) and I still have the same issue. I removed the front single cable from where it splits into the two rear ones and the foot pedal depresses smoothly and with the touch of a finger with no load on it. What else is it? The only other thing is one of the rear cables unless I am missing something?
View 5 RepliesFord Super Duty (1999-2016) :: No Forward And A Little Bit Of Slipping Reverse Now Totally Dead
I have a problem. 2002 F-350 4R100 tranny. Put a reman transmission in about 30000kms ago. pulled excellent with no problems. shut it off for night. In the morning it had absolutly no forward and a little bit of slipping reverse for a few minutes now it is totally dead. No movement either way. The OD on off flashed a few times but not anymore. Put a Genisys scanner on and no codes at all. What could be the issue?
View 14 RepliesFord Super Duty (1999-2016) :: 2009 F250 4x4 - Rattling When Push The Clutch Pedal To The Floor?
My stock 2009 ford f250xl 4x4 with a 5.4 and 6 speed has been giving me a weird sound lately started about a month ago and only happens on a cold start situation meaning if it sits over night it will do the sound. the sound goes away after 3-5 min of warm up in my driveway, the sound happens when i push the clutch pedal to the floor. it has no pronounced abnormal sounds through out the rest of the day when its hot which perplexes me, check out the vid on my u tube site for a sound of it.
MAH00111 - YouTube
MAH00115 - YouTube
Ford Super Duty (1999-2016) :: 2002 F250 Gauges And Pedal Dead
I have a 2002 f250 7.3 with a dead pedal and gauges. This has happened to me once before checked fuse 45 and it was blown. I didn't know that the po used a 30 amp fuse when it should have had a 15 amp. I replaced it with a 30 not knowing. Well coming home the other night it happened again gauges dead and pedal. Checked fuses all were good. Found this site and read about the cause in the shifter. Took that apart and fixed the wire that was broken in half. My question is what else is fried now from having a 30 amp fuse in while it was shorting out since I have no gauges and gas pedal.
2002 f250 banks six gun
banks 4 inch exhaust
Ford Super Duty (1999-2016) :: 2002 - Spongy Brake Pedal?
I replaced all the brake pads on all 4 wheels. Pretty standard procedure. I now have a very spongy brake pedal. It stops but the pedal will be almost to the floor. I did not break any of the lines open during the procedure just used c-clamp to spread the calipers. No ABS light. Have a Snap-On power bleeder and bled the system several times with no change. Checked the power steering fluid level and inspected entire system for leaks.
2002 F-550 V10
Ford Super Duty (1999-2016) :: Strong Pulsing From The Brake Pedal
Just got a 99 super duty and I have a very weird problem. When stopping i feel a very strong pulsing from the brake pedal. I assumed warped rotor. but the strange part is when I hit the brake the cab dome light comes on. How to locate this pulsating?
View 8 RepliesFord Super Duty (1999-2016) :: 2008 V10 - No Pulsating In Brake Pedal?
Test drove an 08 V10 today. Brakes seemed to work fine and didn't lock up but I felt no pulsating in the pedal and heard no chirping of the tires like most ABS systems do. Is this normal? Anything special to look for in used late model V10s?
View 1 RepliesFord Super Duty (1999-2016) :: Parking Brake Pedal Won't Stay Down
When I parked my truck at work this morning, I pushed the parking brake pedal down like always, but it popped back up. I didn't pop all the way back up, it stayed down about 1/4 of the way. Several tries yielded the same results.
Since I'm at work, I didn't have any time to crawl under there are investigate. I'll do so tonight when I get home, or maybe tomorrow. Kinda sounds like the locking "teeth" mechanism may be misaligned?? Since it doesn't come all the way back up, I'm hoping the mechanism isn't totally broken.
Ford Super Duty (1999-2016) :: Brake Lights Would Come On When Slightly Touch Pedal
So, before I noticed a problem, all I had to do was a slight touch to the brake pedal, and the brake lights would come on. Now, they MAY just quickly flash and won't come on unless I really push hard on the pedal, such as at a complete stop.
I've noticed some issues with trying to lock-in 4W-LOW now too, and I know the brake pedal has to be pushed to engage 4W-LOW. Never had problems before now. 1999 F250 Superduty ...
Ford Super Duty (1999-2016) :: Loud Bang And Brake Pedal Went All The Way To The Floor
I was driving, Iput the brakes on then suddenly I heard a loud bang and brake pedal went all the way to the floor. I knew there was something wrong with the brakes, parked went and checked the passenger side rear brake caliper was ripped off which made a hole through my rim and also ripped off the brake lines. I need to get the part but I don't know what its called. See the pictures....
View 12 RepliesFord Super Duty (1999-2016) :: 2002 F250 Brake Pedal Goes All The Way To The Floor
The other day I got in my truck and started down the driveway when I realized I had no brakes, I slowly backed up and parked it. I haven't driven the truck for approx. 2 weeks and it seemed fine then. The master cylinder is full, there are no signs of leakage from wheel cylinders or lines. Today I unscrewed the left front zert and no fluid came out. My pedal goes all the way to the floor.... Whats going on, and if its a easy fix?
View 14 RepliesFord Super Duty (1999-2016) :: 2004 F250 - No Brake Pedal Sinking
I don't know whats up with my new truck, its a 04 f250 scsb, 4x4, 5.4l with 61k orig miles on it. Truck will stop on a dime, has NO pedal sinking, but it takes about 3/4 of the pedals travel to apply pressure to the pads and have the truck stop, sometimes if I push the pedal down then let up and push it again the pedal wont travel as far, I just flushed the system today, no air in the lines, is there a bleeder on the abs? truck has 4 wheel abs...
View 14 RepliesFord Super Duty (1999-2016) :: Brake Line Failure / Pedal Went To The Floor
First, I am fortunate that I was only going 25 mph when some turned in front of me causing me to slam on the brakes. The pedal went to the floor, but did slow the truck enough to miss the jerk. Had I been on the highway, it would have been very bad.
Anyway, what I found is still hard for me to believe for two reasons. It find it hard to believe it failed, but more important that I am getting the last national inventory of 2 of the 3 lines in this picture (according to my Ford dealer).
The three lines are almost directly under the front end of the master cylinder between the block and frame. These are as I found them. The larger one goes to the rear feeding both rear brakes while the two smaller run to the front brakes. The spring looking part below is just a plastic protector. The line which failed goes to the front left.
I think anyone with a 2005 SuperDuty which uses the same or similar parts should take a very close look at the flex sections. The parts I have ordered are: 6C3Z-2B523-BA, 6C3Z-2263-BA, and 6C3Z-2264-BA (rear, right, and left).
How long a manufacture is required to maintain inventory? I thought 7 years, but someone suggested 17. I'm at 8 years, but I would have expected more than 1 each of the fronts to be available. Do they changed parts on the '06 or '07?
My 350 spent 2 winters in the Chicago area and has been resting in Florida since 2006. No work was done in this area, but the closest work was the main fuel pump (frame mounted) replaced 2 years ago, but that is almost 2 feet to the rear.
Ford Super Duty (1999-2016) :: Brake Pedal Sets Door Locks Off
We are putting a truck back together after converting a single cab to crew cab and struck a problem. Every time you hit the brake pedal the door locks continually try to lock themselves. Any clues as to the problem or what to test to find out for sure?
View 3 RepliesFord Super Duty (1999-2016) :: 2000 F350 - Loose Brake Pedal?
my dads front drivers brake caliper was dragging so last Thursday he had the local Ford dealer install a new one WHY i don't know since i always work on everything of ours plus my friends Fords. Today he said he pushed the brake and it went to the floor then he let up and pushed it again and they worked?? I haven't looked into it yet but the dealer cant look until Friday morning so my dad asked me to do it today after work..... what should i check for? leaking brake line, maybe air in the system still?
View 4 RepliesFord Super Duty (1999-2016) :: 2001 F250 - Brake Pedal Seems More Spongy Than Usual
I noticed last week that my brake pedal seemed more spongy than usual. The next day the pedal would go down about half way to the floor before I had pressure. And then the next day the pedal would go straight to the floor. Pedal comes back up once released. I still have brakes pressure about an inch before the pedal bottoms out. Its been like this a couple days now. The vaccum pump works fine. I'm gunna try bleeding the brakes on it tomorrow.
View 5 RepliesFord Super Duty (1999-2016) :: Clicking Noise In Park Or Brake Pedal Press Down - Brake Switch Noise?
The truck in my sig. makes a clicking noise when it's in the park and I press the brake pedal down. The click is coming from somewhere up high in the steering column. It doesn't make the clicking noise in any other gear only in park. Might be normal but I don't remember hearing it before?
View 9 RepliesFord 7.3L Power Stroke (1999-2003) :: Truck Would Just Die From A Dead Stop / Push The Pedal And No Go
I am pretty sure my pedal is going.. Today and last month it would just die from a dead stop push the pedal and no go, but truck idling fine. I cleaned it off a few weeks ago but now its back. push pedal in and out a few times and all is fine for a few weeks. Truck runs fine other than that. Does not throw a code, just trans light comes on because no movement I think, then it goes off as soon as i start to move along. I have a adjustable pedal assembly 2c3z-9f836-de 508.45 at white bear lake ford.
View 1 Replies