Ford Super Duty (1999-2016) :: Way To Disable Reverse Sensor?
Any way to disable the reverse sensors by maybe adding a switch to turn off power so it does not constantly go off while plowing and the sensors are snow covered? i thought maybe by just unplugging the switch would do it, but that did not work. truck is an 02 diesel with auto trans.
View 6 RepliesFord Super Duty (1999-2016) :: Reverse Sensor Making A Clicking Noise
I remember seeing a post a while back stating that the reverse sensor would make a clicking noise (when you're ear is up against the sensor) when working properly, I only had one working but I figured I'd replace them all since the 4th one was sure to go out . Fast forward to using two different sets of sensors, and not a single has worked or made that clicking noise like I would assume it should be. Can an aftermarket head unit cause these sensors to not work properly or have I just gotten two bum sets?
View 3 RepliesFord Super Duty (1999-2016) :: 2011 - Temp Sensor Location?
I need a replacement driver side door, towing mirror for a 2011 Ford F250 SuperDuty with turn signal, heated, electrically adjustable manual-extend and manual fold options. The truck VIN number is 1FT7X2B67BEC96261. The truck also has an Outside-Air-Temperature indication which is what I'm not sure about. It is my understanding that the Outside-Air-Temperature sensor may be in the side mirror. Looking for any info on the temperature sensor located on this truck? I found an aftermarket mirror while I can not afford Ford. However, the aftermarket mirror ad says it does not have Outside-Air-Temperature and I would like to keep that working.
View 1 RepliesFord Super Duty (1999-2016) :: 2011 - Hesitates While Shifting Into Reverse?
I have a 2011 super duty with the 6.2 flex. When shifting into reverse, it hesitates, then slams into reverse. Same on the lower gears when driving. This doesn't occur all the time, but the majority. Been talking to a couple other super duty owners (diesel owners) who have been having the same prob, but not as severe. We all have noticed the prob after having charcoal filter replaced. Is this a tranny issue or computer issue?
View 3 RepliesFord Super Duty (1999-2016) :: Transmission Malfunction - While Coming To Stop Bucking In Cold - Sensor?
I have a 2000 ford f350 7.3l with a auto transmission(4r100) and I have had problems with it . It started a while back when the transmission is cold like in the morning when I put it in drive it acts like when you don't push the cluch in on a standard when coming to a stop kind like it's bucking and this only happens when it's cold when it's nice and warmed it's fine so I changed the whole transmission and put a billet torque converter and I'm still having the same problem can it be a sensor or something electrical ?
View 14 RepliesFord Super Duty (1999-2016) :: 2011 F250 Truck Shaking Badly When Put It In Reverse
Well I just bought a 2011F250 6.7 on Friday. The truck has 42000 miles when I picked it up and now has almost 42800 4 days later. I love the truck so far. But anyways its an early build so is there anything I need to look out for? I noticed today I pulled into a parking spot and went to back up and as soon as I put it in reverse the truck shook pretty bad. It did it a few times as I sat there and went from drive to reverse. Is this something that is normal?
View 9 RepliesFord Super Duty (1999-2016) :: 2008 F250 - No Cruise Control - Radio / Reverse Sensor And Towing System Error
I recently bought a 2008 F250 with the 6.4 diesel indirectly from a dealership. The truck itself has 220,000ish kilometers, but the engine (as well as the turbos) are Ford reman that had about 12,000km when I bought it and I have only put about 6500km on it. It is already leaking oil but that is for another thread.
The reverse sensors, steering wheel controls and part of the stock 6cd radio have never worked. The towing system has errors as well. The fuel level sensor often has problems reading the new level after I put in fuel, but that is always fixed by disconnecting the batteries and forcing a hard reset.
I figured the steering wheel/cruise control problem was due to either a broken clock spring and/or the brake pressure switch. I replaced both those as well as the airbag because the horn relay failed closed when I put it back in the wheel. It did not fix the problem. The steering wheel buttons still intermittently illuminate, but the radio controls and cruise control buttons do not function regardless. The truck isn't giving any codes either.
The towing system will activate lights and brakes on a trailer as well as set the gain, but it will not detect that it is actually hooked to a trailer. I cleaned the pins, but I haven't looked any further into it. No codes for this as well.
The reverse sensors/system does not work. It will lock itself in "off". I am guessing this is because one or more of the sensors have failed, but I am skeptical that it would be just that given the trucks other problems.
The radio does work, but the auxiliary input/mode will not work. I ran the diagnostics on the radio and on 'Test 1' I got "SELF FAIL B1342 ECU" and "B2477 CONFIG". I tried to clear the codes, but I can't. I think this means the radio is kill.
Ford Super Duty (1999-2016) :: Code P2195 (Bank 1 Sensor 1 O2 Sensor Stuck Lean)
So I just replace my Cat. Converter with all new sensors in them. I just replaced my spark plugs. (I'm knocking out these check engine light problems) and I think I'm getting close to the root as to why these other parts went bad. Why my o2 sensor would be stuck on "lean" ....
View 5 RepliesFord Super Duty (1999-2016) :: 2008 F250 V10 - Bank 2 Sensor 2 Oxygen Sensor Is Faulty
My Bank 2 Sensor 2 oxygen sensor is faulty and I need to replace it. The guys at the parts store were pretty certain it is downstream driver's side, but I just want to make sure before I PB Blasted and removed it. 2008 F250 SD v10 ....
View 1 RepliesFord Super Duty (1999-2016) :: 2005 - Died At Stop - Crank But Won't Stop?
I have a 2005 ford f250 6.0 I was driving back home from a interview and my truck died at a stop light it would crank but no start I tried replacing the stc fitting didn't work so the I replaced the ipr still didn't work bought a new hpop still didn't work I'm lost at this point I have low pressure oil pump is working new icp, what is going on?
View 8 RepliesFord Super Duty (1999-2016) :: 2004 - RPMs Will Stop Then Pick Up And Stop - No Codes?
i have an 04 f250 5.4 4x4 250k miles+ ...the truck has been acting weird lately. I has 0 power...i went to pass an 18 wheeler today at about 15 mph and gave it about half throttle...well it held first gear till about 5 grand then slammed into 2nd...It just has 0 umph ... it wont even consistanly pick up speed at half throttle or over..the rpms will stop ...then pick up...then stop...it always accelerated smoothly....it is bogging really bad...it was downshifting into 3rd today on little overpass hills that it NEVER does that on...something is telling me torque converter BTW no codes and no flashing overdrive light
View 14 RepliesFord Super Duty (1999-2016) :: 2012 - CEL Came On - EGT Sensor 4 Bad
Purchased my 2012 6.7 about 3 weeks ago. Driving yesterday the CEL light came on. I took and had the code read and it was determined that EGT sensor # 4 was bad. Also how far can it be driven before it leaves you stranded since the closest dealer is 35 miles away.
View 2 RepliesFord Super Duty (1999-2016) :: Reverse And Low Are Non-existent
Picked up a project truck for the spring..... single cab 99 4x4 7.3 with the 6 speed. 1st through 5th work perfect...... however reverse and low are non existent.
What I am sure of:
1. I'm positive its not a clutch problem.
2. The shifter goes into the position of reverse and low just fine but there's no engagement at all.
3. I can put the shifter in low or reverse position whether the clutch is engaged or not... makes no difference at all.
Once i was messing with it and somehow by moving the stick sort of to the side it hit reverse and the gear worked fine but then it remained in reverse no matter what position the shifter was in until i was able to move it around enough to get it out.
I'm thinking bent shift fork? Looking at a few writeups on rebuilds it looks like i might be able to replace the fork without dropping the tranny.... just divorce the t-case and remove back half of trans?
Ford Super Duty (1999-2016) :: ABS Light Won't Go Off With New Speed Sensor
So I had an ABS light going on and off on my 05 250, finally got it read, and the computer said right front speed sensor. I changed it and the light stayed on all the time then. I had someone plug it in and drive it and the left front sensor was reading nice and flat on the graph, while the right front was spiking all over the place. I then assumed I got a bad sensor. I changed it one more time and now the light still won't go off. Now what?!
View 11 RepliesFord Super Duty (1999-2016) :: Code P2285 - New ICP Sensor
I have been trying to find a new sensor after my truck popped a P2285 code. I can't find ICP sensor at any auto parts store. I found this but it was labeled as a fuel pressure sensor on RockAuto: More Information for Standard Motor Products ICP103... Is this the same thing?
View 2 RepliesFord Super Duty (1999-2016) :: 2005 - Location Of O2 Sensor?
My engine light came on a friend of mine did a scan and came up with o2s12 showing low voltage.we need to know which side and location of sensor..the truck is a 2005 ford f250 super duty 5.4l.
View 2 RepliesFord Super Duty (1999-2016) :: Reverse Lights Dim Or Don't Work At All
I have an 02 f350 XL. The other day it rained and all of my rear lights went haywire. All problems are out back.
- Step on brakes, high mount, and lic plate lights light up with brakes.
- Turn on marker lights and the high mount lights up and the tails and lic plate lights dim.
- Marker lights on, apply brakes, and the tails and lic plates lights go out on bed, high mount activates.
- Use turn signals with markers off and all of the rear lights including high mount flash..
- Reverse lights dim or dont work at all.
I have tried a new MF switch, checked all fuses. cleaned rear frame ground. took apart brake switch and cleaned it. non tilt column but checked wires. replaced flasher. unplugged brake light switch and headlight switch, problem is still there. removed trailer relays, no luck. checked all chassis plugs. disconnected TRS.
I should mention i have 12v cummins swap and a pcs with standalone harness. no problems over the last few months since swap until it rained last monday.
Ford Super Duty (1999-2016) :: F350 Stutter When Go Into Reverse
I just picked up a 2003 F350 4X4 5.4L it has 130k on it. It drives ok, it doesn't seem to be able to accelerate very quickly and one thing I noticed is when i go into reverse it seems to stutter or feels like it scoots a little bit.
View 14 RepliesFord Super Duty (1999-2016) :: Reverse Camera Won't Work
I have recently put a platinum tailgate on my 2012 off a 2014 and for some reason the camera no longer works just wonder why this is and how I fix it....
Click the image to open in full size....