Ford Super Duty (1999-2016) :: 2007 F250 Auto 4x4 Not Engaging - Rear Wheels Spinning / Front Did Not Turn
Yesterday I was parked on an incline with my front wheels on gravel and the rear wheels on wet grass/mud. When I tried to go, the rear wheels started spinning. I then switched on the low 4x4, and tried to go. The rear wheels continued to spin, but the front did not turn. I had new wheels installed, that has a cap that covers the manual locking hub, so I couldn't turn it to lock the hub. What should I look for to fix the problem?
2007 F250 4X4 Larriat SRW
Ford Super Duty (1999-2016) :: 2008 F250 - Squeak And Clunk / Bearings Are Loose
My rear wheel bearing are a little loose. This afternoon while diagnosing a squeak in the back I found this. While pushing the truck side to side there is a clunk and when you lay your hand on the tire you can feel it, bearings are loose. Nothing during the operation of the truck to give this away, truck runs and drives as it should but I need to check it our before something does go wrong. What I'm looking for is a torque / preload that the rear wheel bearings need to be set at.
View 2 RepliesFord Super Duty (1999-2016) :: 2008 F250 Will Turn Over But Not Crank
I have 08 f250 6.4 was driving down the road truck just died. Will turn over but not crank. I've checked oil level, water level, fuses, fuel cut off switch. Still no start.
View 3 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Back Tires Spinning While Front Ones Sit Idle In 4x4?
We have a lot of snow and a lot of ice up here at the moment and my 2003 ford F-250 SC Fx4 isn't performing so well. The truck is stock other than a pair of 285/16R BFG A/T's
I have been noticing that my rear tires will spin while trying to go up hill on some ice or snow covered areas and my front tires just sit still while in 4x4 or 4x4 low. In the case I just described I remain stuck in place until the rear tires can get a grip then I continue up hill. I don't understand why my front tires are not spinning as well, to me this seems just like 2 wheel drive not 4x4. I have been using ESOF most of the time. I have mentioned in other threads that I do plan on upgrading to warn premium hubs, but I am wondering if its that my truck isnt actually shifting into 4x4 or if there is a reason why even in 4x4 my rear tires would spin while my front tires do not?
I am confused because when I shift on the fly while driving I can feel the 4x4 kick in because it just feels different than driving with 2 wheel drive, but then something like I described will happen and I start second guessing myself. What might be happening? It's not that I am opposed to switching to the warn premium hubs, but is that actually going to fix this issue or is my truck acting normally??
Ford Super Duty (1999-2016) :: 2008 F250 - How Hard Should It Be To Turn Hubs
On my 2008 f250 I can not turn the hubs without a set of pliers...does that mean I need new hubs....
What auto tranny do I have with the 5.4.. is it a six speed...
Ford Super Duty (1999-2016) :: 2007 F250 - Front Wheel Clunk When Turn Sharply In Either Direction
2007 F250 4WD 5.4l ... when I turn sharply in either direction I am getting a light clunk sound similar to when you are in 4WD on blacktop and try turning. The engine also seems to wanna stall when I cut the wheel too sharp.
View 4 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Little Bit Of Movement In Front Wheel Bearing And Hub Assemblies
I have a 2008 F250 5.4 4x4 supercab long box (68,000 miles) that has a little bit of movement in the front wheel bearing and hub assemblies. Made it through inspection OK but it will need to be changed soon. Just asking for everyone's thoughts on brands they prefer. I have had great luck with Moog brand products in the past. I put SKF hubs on my wife's 2010 Explorer and they I would say are top quality also. Not interested in a conversion kit or cheap junk. I want a good quality unit. What brand has everyone had good results with? Are Moog or SKF the way to go?
View 8 RepliesFord Super Duty (1999-2016) :: 2008 F250 - Front Wheel Brake Fluid Leak
I have a 2008 f-250 6.4 Diesel. Yesterday the Brake Fluid light came on. I thought maybe a sensor, but once I parked and checked I realized my brake fluid was down to the Min line. I started looking for a leak and it was apparent that it was the front drivers wheel area.
I am attaching a picture of the brake. The leak is either coming from the area where the fluid line runs into the gold thing (caliper?) or the bolt at the bottom of the gold thing.
Ford Super Duty (1999-2016) :: 2008 F250 - Steering Seems Heavy And Won't Return To Center After A Turn
Just bought this '08 F250 CCSB 4X4 5.4 Problem is the steering seems heavy, it tends to wander at higher speeds and won't return to center after a turn. I've searched on here and found a few possibilities (axle u joints, ball joints, steering gear, etc). I have an appointment with the dealer on Friday to fix it under warranty but he is convinced it's the u joints in the steering shaft seizing. When my F150 steering shaft began to seize, it would be hard to turn then break free then be hard then break free and this is not what is happening on the SD. I haven't had a chance to check the front end myself but not sure how you would check the axle u joints if there was no play in them. How would you check to see if they were seizing up.
View 3 RepliesFord Super Duty (1999-2016) :: 2014 F350 - Rotational Squeak From Under The Cab Or Possibly Left Front Tire
Its a rotational squeak, that sounds like its under the cab or possibly left front tire. The truck only has around 25k miles on it. I recently had a 2" leveling kit installed, 35" tires, and rear airbags installed (within 5k miles). I checked the universals and they seem to ok and there is no noticeable clunk. I am hoping its something small.
View 7 RepliesFord Super Duty (1999-2016) :: 2002 F250 V10 - Squeak From Under The Truck
I have a 2002 f250 super duty v10 with the manual transmission... It has aloud squeak from under the truck when Im slowing down or maintaining a certain speed. The squeak goes away when I accelerate or if I push the clutch in. It does have a vibration to it when im speeding up. And shakes bad sometimes when I let off the clutch from a stop..
View 1 RepliesFord Super Duty (1999-2016) :: Front Drive Shaft Spinning While In 2 Wheel Drive
I have a 1999 Ford F250 super duty 4wheel drive, lifted (really a leveling kit but had to lift rear to compensate), 5.4l. Im having a problem with my front shaft turning while in 2 wheel drive. Hubs aren't locked and its in 2 wheel not 4. I've taken hubs off and the bearing spins free soo I know its in auto. Why is the drive shaft still turning???????
View 5 RepliesFord Super Duty (1999-2016) :: Squeak / Slight Creaking Sound In Steering Wheel
I've noticed lately when I turn the steering wheel slowly I get a slight creaking sound from somewhere behind the wheel. What is causing it and if it's worth tearing it apart to fix it. I only notice the noise when the radio is off and turning the wheel while sitting still.
View 9 RepliesFord Super Duty (1999-2016) :: 2014 F250 - Squeak Coming From Drive Shaft Area
I have a 2014 4WD Super Duty. It has a squeak that is coming from the drive shaft area. I had someone listen to it as I drove slowly next to them. It is a repetitive: squeak squeak squeak squeak squeak. Not loud. The frequency increases as speed increases. I could believe it may be a U joint based on the frequency, but seems hard to believe with a new truck. I heard this sound when I first got it, but the sound was so slight that I thought it was just some sound associated with a newer engine. But now it is becoming a bit louder.
View 4 RepliesFord Super Duty (1999-2016) :: 2003 F250 Squeak While Driving Through Town Sounded Like U-Joint
I have a 2003 F250 Ext Cab 158" wheel base, 5.4, auto. 2wd
Last week I noticed a squeak squeak squeak while driving through town, sounded like the u-joint. I got home, jacked it up and pulled the rear shaft. Unfortunately I, bone-headedly, did not mark it when I pulled it. I took it into town and had a shop put in two new U-joints from autozone.
I got home and, forgetting to mark it, put the driveshaft in 180 degrees out. This caused the whole assembly to get out of balance and tear up the carrier bearing.
I replaced everything, pulled the complete shaft and disassembled it to put the new carrier on it...again, for some reason I didn't mark it. I knew I was supposed to.
It destroyed the carrier bearing again. So I limped it to my mechanic the next morning. He went through and replaced the front u-joint and carrier and called it good. I picked it up that afternoon and it was vibrating again.
I took it back and they kept it overnight and fixed it again. The problem they had was the driveshaft was coming back on the 'flex' and rubbing into the carrier instead of sliding back and forth, it was sticking.
They got that all fixed up and the wife picked up the truck while I was at work Friday. I called her at lunch and she said it was still squeaking like before I took it to the shop. I get home that evening and drive it and, sure enough, it's squeaking like it has a bad u-joint.
But the squeak didn't start right away, I had to drive it about 5 miles for it to start, and then I didn't hear it until I slowed down enough to get rid of the wind noise.
I took it back to the mechanic this morning. He called me around 4 and said they drove it about 25 miles around town and on the highway and couldn't duplicate the noise.
He said they went ahead and hit the grease zirks on all 3 u joints(even the ones they didn't install on the rear shaft) and they couldn't hear any squeaks. So I pick it up, drive through town a bit and start heading home. No squeaks.
I get about 20 miles out of town and slow down going over a bridge with the windows down, and there is the squeak again. Still sounds like a bad u-joint. But I didn't hear it until I drove it about 25 or 30 miles. What this noise is or what I need to be looking for?
Ford Super Duty (1999-2016) :: Proper Tire Pressure For F250 Truck?
What is the proper tire pressure for these trucks (F250)?
Sidewall says max is 80 PSI.
Door jam says 71 PSI.
This is coming from a guy who has traditionally driven passenger cars and trucks. I've never even gotten CLOSE to advertised max PSI ratings. 71 seems awful close to max PSI.
Ford Super Duty (1999-2016) :: 2000 F250 - No Key To Lower Spare Tire
OK, I never heard of any "key" to lower the spare tire. However, the nice people at Discount tire weren't able to swap my tire because I'm missing some "key". How do I get a key for this and ELIMINATE the need for the key? 2000 F250 Crew Cab 4x4.
View 3 RepliesFord Super Duty (1999-2016) :: 1997 F250 - While Steering Edge Of Tire Roll?
I have recently bought a 1997 F250 XL and i have a steering problem. It has a lift with 35" tires on it. Its not extreme but fairly mild. But everytime i turn slowly in either forward or reverse the edges of my tire seem to roll under itself or something. It seems like the outside of my tire or inside will catch the road when i make tight turns in and out of parking spots. I can see the outside edge of my tires becoming worn and starting to take small chunks out of it. And when i turn the truck will bog down and i will have to give it some gas just to get it to move. I cannot figure out the problem. I have engage and disengaged the 4 wheel drive numerous times and it still does this.
View 4 RepliesFord Super Duty (1999-2016) :: 2014 F250 - How To Disable Low Tire Warning Light
How to do this, or have had it done? I do have 35x12.50x18's on it. I did go to the tire center here in my town to have them reprogram it but only worked for a few to a week cant remember.
View 13 Replies