Ford Super Duty (1999-2016) :: 2005 F350 V10 - Wipers And Washer Wouldn't Shut Off
Last fall had one day for about three miles where wipers and washer wouldn't shut off. Now they won't stop at all. Thought the multi switch might be bad, removed whole switch and unhooked. Washer pump and wipers were still on and wouldn't shut off. Had to pull the fuse.
View 4 RepliesFord Super Duty (1999-2016) :: F350 - None Of The Instrument Gauges Work
I have a 1999(03/98 Production Date) F350 DRW Dump 5.4L Reg Cab. I just replaced the ECM (Drivers side Kick plate) with a used ECM
1. Crank but no start, gauges worked.
2. Replaced the ECM (Drivers side Kick plate) with a used ECM
3. Truck now starts.
4. None of the Instrument gauges work. No gas gauge, no speedo, no tach, no bat no odometer or trip odometer. Not one single gauge works.
Does the ECM need to flashed for the cluster to work or might it be a separate issue?
Ford Super Duty (1999-2016) :: F350 - Radio / Interior Light And Gauges On / Off At Will
My prob started with key in ignition warning alarm working with no key, then radio on off at will and interior light not working or delay not turning them off when door closed. Now all gauges and warning lights/alarms go out also. If I open door and key alarm is on all systems work at that moment and without touching truck alarm can stop at will, at that point ignition alarm, interior light, radio and gauges do not work. When I giggle key with truck running the door ajar alarm activates when system working!
View 4 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Battery Light On - Gauges Shut Down - Radio Turn Off?
03 f 250 super duty, my battery light came on and when I accelerate my dash gauges shut down and radio turns off, if I idle or stay under twenty MPH, everything works fine. Battery and alternator test good, lights never dim, any thoughts
View 4 RepliesFord Super Duty (1999-2016) :: 2000 F350 XLT V10 - Gauges Dead In Instrument Cluster
I have a 2000 f350 XLT SD v10 gas. The radio works, the heater works and the power windows work too. It's just the cluster. Lights work in the cluster it's the gauges are dead truck starts fine.
View 2 RepliesFord Super Duty (1999-2016) :: 2008 F250 5.4L - Gauges Will Randomly Start Jumping Around Then Truck Will Just Shut Off While Driving
So I'll be driving down the road and the gauges will randomly start jumping around then the truck will just shut off, this just started a couple days ago, it seems to be gaining in frequency, when i try and restart the engine all my warning lights flash on and nothing happens, try again and it starts back up, now the last time it happened all of the above happened but it was followed by a fast clicking noise from under the steering column, it has to be a electrical issue as i have full tanks and motor is in tip top shape. Also no codes pop up with my code reader.
View 1 RepliesFord Super Duty (1999-2016) :: 2006 F350 - Check Gauges / TBC Fault / Warning Lights
Just got a new-to-me 2006 F350 Super Duty XL with the 5.4L V8 and 5-speed auto. I haven't had a full-size truck in a few years and forgot what I was missing!
When I bought the truck, all gauges were inoperative except for the fuel and oil pressure gauges. The previous owner told me they would work intermittently and at some point just stopped. The usual warning lights - ABS, CEL, and "the wrench" - were all lit, and from Googling and searching this forum, it looked like an easy fix - probably a pinched or frayed shifter wire, or possibly a cluster repair.
I took it home and did a self test on the gauges. The "sweep gauges" made everything swing fine, so I was thinking it might not be a problem in the cluster. I pulled the steering column apart, removed the Tow/Haul overdrive wire from the plastic retainer, re-ran it with some slack, taped the end where it comes out of the shifter (even though I saw no breaks/frays) cleaned the connections, gave it a dollop of dielectric grease in the connector, and put it all back together. VOILA - GAUGES and no warning lights! You can imagine the touchdown dance in the driveway.
Fast forward a few weeks and....back to no gauges and warning lights lit. Figuring the overdrive wire had finally given up, I ordered and installed a replacement shifter figuring it was an easy and cheap fix. No joy - same problem. Tried cleaning and reseating the connection. Nothing. I've searched FTE like mad and it seems like 95% of the problems are with the wire exiting the shifter fraying and/or blowing a fuse, but this is a new shifter. I've also checked fuses #2, #24, #33, #36, #41, and #45 (some referenced #19 but I don't have a fuse there). All were unbroken - just put them back in and reseated firmly. I did a code pull via OBD2 and have a "rear catalytic efficiency degraded" code...not sure if that's related, but figured I just had an exhaust issue.
I may take the dash cover off and try to clean and reset the connections on the gauge cluster, as well as do the same for the PCM. Is it possible that the tow/haul overdrive wire to the PCM (where the shifter connects to) is bad? How to test and/or replace if it comes up bad?
Ford Super Duty (1999-2016) :: 2000 F350 - Gauges / Speedometer And Tach Stopped Working
I have a 2000 F350 4x4 with 7.3L diesel and a manual transmission. While driving home yesterday my gauges (fuel, temp, volts, oil pres) stopped working. Within a couple min the speedometer and the tach also stopped working, but the truck was still running fine. Within a couple miles the engine stopped running, just like I had turned the engine off.
After having it towed home I checked all the fuses, none are blown, but there is no power to fuse #16 (15A, instrument cluster, high beam head lamp). Also in the fuse box under the hood, again, no fuses are blown, but fuse #9 (left head lamp low beam) and #11 (right head lamp low beam) have no power to them.
Ford Super Duty (1999-2016) :: 2002 F350 - Power Window Gauges And Ignition Buzzer Quit Working
The interior lights, radio, and power window gauges and the ignition buzzer on my 2002 F350 quit working. What could cause this? Everything else still works.
View 7 RepliesFord Super Duty (1999-2016) :: 2004 F350 - All Gauges / Lights And Windows Quit Working - Truck Ran Rough
Ihave a 2004 F350 4x4 Dually diesel. While in my hay field I hit a small rut and the truck bounced. About two seconds later all gauges and lights/windows quit working and the truck ran rough. I have a Banks system and it registered a code 33. Maybe 32 error. Book says it is an airbag deployment. They did not deploy. So I drove out of the field and turned it off to see if that would reset the gauges. No, not only that but the gauges all swept the faces from off to full to off and the truck would not start, just chatter.
I disconnected both batteries and waited. Reconnected and it started, but the gauges quit after 10 seconds..... Everything flatlined even the banks IQ. But the truck kept on running. Got back to the ranch and the batteries went flat overnight... Charged them up, starts fine gauges work but alternator puts out 11.5.
Ford Super Duty (1999-2016) :: 2008 F350 - Started But Immediately Shut Down
Tried changing fuel filters on my 2008 F350 diesel. Tried primary - open drain - no tool to remove cap, closed drain. Removed top cap, replaced filter.
Started but immediately shut down. Did this twice. Put old filter back in - still no start. Wrench code light on.
Ford Super Duty (1999-2016) :: F350 Dripping Water After Engine Shut Off
I have a 1999 F350 7.3 truck and when I shut off the engine I get a small drip of water (not antifreeze or oil) for about 20 seconds and then it stops. It's coming down from the passenger side somewhere under under the wheel well back around the firewall. Everything in the truck appears to be running normal and all fluids are at normal levels.
View 12 RepliesFord Super Duty (1999-2016) :: 2005 6.0 Shut Off Then Fired Right Back Up
After a long day at work, I had the pleasure of driving home in traffic. While sitting there enjoying the last of the warm weather, I tapped the brakes to slow down and then the truck shut off. I looked down and naturally the battery light came on. I pulled over, turned everything off, then tried to start the truck. The truck fired right up and all indications were normal. The scan gauge showed no codes and batt voltage was normal at 13.3 volts. Where to start looking? Drive home without any faults for the next 20 minutes.
View 2 RepliesFord Super Duty (1999-2016) :: 2004 F350 - Dome Light To Shut Off Without Delay When Door Closed?
Ok so long story short, my Viper 2 way alarm, instead of the brain being wired to each of the 4 doors individually, the installer ran 1 wire to the dome light. seems to work fine as far as arming/disarming/locking/unlocking, but since the dome light stays on for 10 seconds or whatever after the door is shut.
When I arm it, the 2 way remote says "door open" because the light is still on so it thinks a door is open. this eventually times out and all the sensors arm, but theres a long delay. it arms fine and no alerts pop up if i lock the doors first from the outside keypad on the door, making the lights go off, then hit arm on the viper, and everything is good to go.
can i change it so no matter what, as SOON as i shut the door, the light goes off? i want there to be NO delay, if possible. if not, i may need to just have the installer run a wire to each door and take the single run to the dome light off, as it is sorta annoying to me.
Ford Super Duty (1999-2016) :: 2005 F350 - 4X4 Not Disengaging
I have and 05 F350 4X4. I put it into 4 wheel drive high yesterday to make sure every thing was working correctly and it was so I went to 4 wheel low and that worked fine. Problem is it won't come out of 4 wheel low. I didn't try to go back to 2 wheel when I was in 4 high. What to look for? The truck has the electric switch to engage 4 wheel.
View 12 RepliesFord Super Duty (1999-2016) :: 2005 F350 - ABS Light Came On And Has Not Gone Off
Recently drove a 3500 mile road trip with no issues after installing a SCT X4 programmer from 5 star. Upon returning home the following week the ABS light came on and has not gone off. Additionally, last week the truck stalled while driving down the road at around 45 mph. Had something similar happen last summer, got the truck stuck and was trying to rock it in the mud and every time I shifted from reverse or forward the rpm's dropped to 500 and the truck could not respond to the gas pedal and the ABS light came on. Once I got out and washed all the mud from under it light went off and it ran fine without any warning lights.
Truck is an 05, V-10, 4x4, off road and tow package, lariat. No other mods besides the programmer.
Ford Super Duty (1999-2016) :: 2005 F350 - Bad Misfire With Blinking CEL
My dad gave his 2005 Ford F-350 truck with the gas 5.4L (?) I drove it home. If i floor it it misfires badly, or if the RPM's get over 3000 it misfires then about 3800 it stops and keeps going. but i can't give it to much gas....
The spark plugs where replaced 2 years ago along with the cat converters. I can hear some very fait manifold gasket leak ...
A few days ago it was raining and it had a bad misfire with blinking CEL. but it never threw a solid CLE. can i still put the codes on it to see what cylinder it is? Are these issue related? Where should i start?
Ford Super Duty (1999-2016) :: 2005 F350 - Radio Shutting Off By Its Self
2005 F-350 diesel... When I first got it the radio was shutting off by its self, my 02 did the same thing so I wasn't to worried about it.
But things have advanced , radio shuts off , windows wont work? Goes on and off at will , does not seem to be road bump related as they go off and on when Im not moving.
Will stay off until I restart truck sometimes and other times it only stays off for a few minutes.
Ford Super Duty (1999-2016) :: 2005 F350 - 4WD Was Not Working / PS Hub Not Locking In
On my 05 350, I noticed the other day that my 4wd wasn't working, when I needed it of course. I quick test this morning and I discovered my PS hub is not locking in. I've read a lot of posts about it being the opposite, the auto portion causing a problem. In my case, it won't lock in in auto or manually turning. I can lock it in, spin the wheel and the axle shaft isn't turning. The pressure is the same as the other side, not too loose or too stiff. Can I pull the hub assembly off and rebuild it? I watched a video about that, but not sure on how my issue would allow me to work on it.
View 4 Replies