Ford Super Duty (1999-2016) :: 2004 - Front Wheel Hub Stock?
I have a 2004 F250, CCSB, 6.0L, Fx4, Lariat.
I am trying to replace the passenger side front hub. I either have a bad hub, or I am not installing it properly. I have it installed with the locking hub unlocked and trying to turn the hub, the entire passenger side axle spins. It is also very hard to turn it. I strapped axle, and the hub is almost impossible to turn, with or with out the actual hub installed.
This is the second hub that I installed with the same results. I''m not ruling out bad out of the box, but it is the second one I installed today.
Ford Super Duty (1999-2016) :: 2004 - Adding Stock Driving / Fog Lights To XLT?
I have a 2004 F250 and would like to have more light in front of me. I looked under the front to where the stock fog light would get mounted but I don't see any wire harness in that area. What is involved if I pick up a pair of replacement fog lights like the offer at LMC Truck. Would i need buy a harness? And what about a switch?
View 11 RepliesFord Super Duty (1999-2016) :: 2004 - Removal Of Bench Seat?
Just bought my first 04 F250 super duty Xl...4x4 Ext Cab...need to get this bench seat out and buckets and console in!!! I hear this is easy swap but never done before, or believe anything is easy.
View 1 RepliesFord Super Duty (1999-2016) :: 2004 F250 - 4x4 Shift Knob Removal?
I tried searching and googling but came to no results, unless its like similar trucks. How do the 4x4 shift remove? I have an 04 F250 and someone decided to put the shift on sideways so the 4HI and etc read upside down before I purchased the truck. Do I just rip the thing off?
View 1 RepliesFord Super Duty (1999-2016) :: 2004 - Shift Cable Removal At Trans
The kid at body shop called, he has the cab ready to swap onto the 04 gas job except for the shifter cable at the trans. I have never done one either, and do not know how to take it off. I thought it was like the old trans where it was in a plastic grommet, but the cable almost looks like it is grafted to the trans. How to get the cable off the trans shift arm?
View 2 RepliesFord Super Duty (1999-2016) :: 2004 F250 - Drive Shaft Removal To Grease The Center Spline
I'm wanting to grease the center spline on my drive shaft. I got the 4 bolts off with a 12mm 16 point boxed in wrench but can't get the drive shaft loose from the rea rend. I don't blindly want to go beating it out of the yoke with a hammer to try to knock it loose (but I will if I have to). What am I missing to get this shaft out?
View 3 RepliesFord Super Duty (1999-2016) :: 2003 - Restoration Of Stock Rim?
I like the stock rims on my 03 Super, any success story about this type of rim refurbishing? Or cleaning them up? Something like stripping all that chrome plating off them for a flat universal look? Nothing fancy.
View 1 RepliesFord Super Duty (1999-2016) :: 2015 - 35/12.5 Fit On Stock 17 Wheel?
Recently bought a 2015 f250 xlt.....very impressed with it. Only thing is the wheel feel and look to small. What is the largest size i can run stock? Will 35/12.5 fit on stock 17 wheels or should i just spring for aftermarket rims at the same time? Also exhaust options for the 6.2? Remember, i need load range e!
View 4 RepliesFord Super Duty (1999-2016) :: 2004 F250 - Driver Side Rear Sway Bar Link Upper Bolt Removal
I have a 2004 F250 Lariat Crew Cab FX4 6-3/4' bed.
What is the procedure to remove the Driver's side Rear Sway Bar Link upper bolt? - the link attaches to the frame. The nut is on the inside of the frame with about 1/3" to 2/3" clearance between the frame and the fuel tank. Of course, the frame's "C" shape faces towards the inside.
Ford Super Duty (1999-2016) :: 2003 - Hole In Stock Muffler - Replace It?
I have a 2003 F250 5.4L crew cab with the 156"wb. She has just developed a hole in the stock muffler so it will need to be replaced.
I want something that is an easy-fit, has better flow, and maybe better sounding.
Ford Super Duty (1999-2016) :: 1995 F350 - Stock Fog Lamps And Towing MPG
Fog Lamps. How do you turn them on. I have a new (to me) 2005 F-350 Crew Cab Long Box Dually King Ranch 6.0L with all the fixes, S/C Programmer, and a water filter system. 200,000 miles
How do you turn on the Fog lamps and what kind of towing MPG are you getting? My 28' 5th Wheel weighs under 7,000, and my 36 footer triple axel under 12,000.
This sure isn't my old '95 F-350 7.3L single axel XLT Crew Cab 4X4 Long Box.
Ford Super Duty (1999-2016) :: 2003 - Muffler Delete On Stock Exhaust Sound?
How will a muffler delete on stock exhaust sound? I don't want to remove the cat because I don't want it to be too loud. I want it to sound good but not too much whistle (considering my truck is a 2003 the whistle would be very loud) Should I just to a delete pipe on the stock exhaust, or do a cat-back 4 inch straight pipe? what will sound better? Also doing the cat back exhaust will cost a lot more.. but is it worth it? What I should do.
View 4 RepliesFord Super Duty (1999-2016) :: 2011 - Shorty Headers Match Up With The Stock Exhaust?
Looking for aftermarket headers for a 2011 f250 6.2l gas job. I have the famous leak and I want to put something in that isn't going to warp. I was told shorty headers typically match up with the stock exhaust. Eventually going to put in a cat back also so true shorty headers would be sick.
View 14 RepliesFord Super Duty (1999-2016) :: Leak At PTO Cover On Manual Transmission
I see an oil stain on/surrounding the lower half of what I'm guessing is the PTO cover on the side of my manual transmission. (rectangular plate bolted to side of tranny) I couldn't find a gasket at any autoparts stores. Is there a gasket or did Ford just use a sealer? Would red RTV work ok here instead of a gasket? Or should I use something else?
2004 F250 SuperDuty 4x4 CC, V10, 6 speed manual tran
Ford Super Duty (1999-2016) :: 6 Speed Manual Will Not Shift Into Reverse Or Low
I have a 2000 F350, Turbo diesel with 223 000 miles. 6 speed manual transmission will not shift into reverse or low.
View 14 RepliesFord Super Duty (1999-2016) :: 4x4 - Front Hub Missing The Manual Lock
Just bought a nice little project 1999 4X4. 100k miles and overall decent condition.
One of the first things to tackle is the driver's front hub has no manual 4x4 locking mechanism like on the passenger side. Is this a tough job?
Attached is the picture of the hub & missing lock setup. (Can't upload...).
Ford Super Duty (1999-2016) :: Manual Locking Hubs Code
I just ordered '00 F250 SC 4x4 SWB XLT with the factory standard manual hubs. The hubs show up on the vehicle order confirmation as code "21M MAN LOCKING HUB". I can't find this code in the ordering guides anywhere but kbb.com shows this code as "Manual hubs delete. Required with 213 shift-on-the-fly". I want the manual hubs. I think ##### is incorrect. For my piece of mind, could someone who has also ordered the factory standard manual hubs verify that the code is indeed 21M. And for those who ordered shift-on-the-fly, could you verify that 21M does NOT show up on your order confirmation...
View 8 RepliesFord Super Duty (1999-2016) :: F350 - 4x4 Manual Lock Out Hubs
I just purchased an F-350 with manual locking hubs. I am unsure if I can keep these locked in for part time four wheel driving or I need to unlock them each time I go back to two wheel drive?
View 6 RepliesFord Super Duty (1999-2016) :: F250 4X4 - Auto To Manual Transmission?
I am changing my 99 f250 4x4 from auto to manual tranny. I am just looking for pics of where the hydro line runs. I don't want line rubbing something and ruining line. Like does line run under the cab wiring harness? Like between wiring and firewall? Where on firewall does reservior get mounted usually? Are the holes all ready there for it that I am not seeing?
View 1 Replies