Ford Super Duty (1999-2016) :: F250 - Thump While Backing Up - Loss Of Reverse And Park
I was driving my 1999 F250 5.4 Triton last week, after noticing a thump while backing my small boat down the ramp (sounded like u joint) I went and parked. When I got back in the truck it starts fine but when I shift into reverse, it's staying in drive, anywhere I put my shift lever..... It's in drive! I even noticed that even all the way up into park it feels like it's in drive, but with something holding it back. If I give it gas while in park it will go forward! I have tightened the two torx screws under dash, pulled cable off and tried shifting by hand (clicks like switching gears, but still in drive) pulled pan, everything looked good there, fluid is nice and red, smells good, no metal in pan? It's the 4r100od tranny.
View 7 RepliesFord Super Duty (1999-2016) :: 2004 - Front End Noise When Hit Bumps Or Backing Out Or Entering A Driveway
I have 2004 Super Duty with a noise in the front end when I hit bumps or backing out or entering a driveway with a lip. I don't feel anything in the steering wheel but I feel it on the floor board with my feet? Where to begin?
View 3 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Front Right Wheel Wiggles
2003 F250 4x4 7.3L
While doing my brakes in the front, I tried to wiggle the front left, nothing. Solid. Then when I did the right, I was surprised to see it wiggle when I grabbed the tire. So I looked to see what was moving.
Not the U joint, not the ball joints, But it looks like what is a drive shaft.. (I am new to this stuff). On the right side a shaft comes out of the axle just before the U joint and the rest of the wheel assy. What is wrong?
Ford Super Duty (1999-2016) :: 2003 F250 - Vibration Coming From Front?
I have a bad wobble/vibration coming from front end i think i replaced hub locking hubs u joints truck dont feel safe at all took it to ford they say its normal no way its not just starting doing it few month feels like the 4x4 is in use when hitting bumps when driving if you go slight left or right it seems too make act up more.
View 2 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Front End Clunking When Turning
Have an 03 f250 6.0L and the tie rod from pitman arm moves easily and there isn't a steering stabilizer, noise got worse after I put new tires on front but it's a loud clunk that I can feel. I've replaced the sway bar bushings and end links. Would the worn tired rod make that noise or would it be ball joints?
View 1 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Front Seat Repair?
2003 F250 super cab, 335,000 miles. the seats are all in good condition except the drivers seat bottom, no rips or tears but the outer bolster area is worn. Looked at new replacement and no go. Is there a decent cover or a aftermarket replacement that looks good? The truck is not worth high end stuff, just would like it too look better
View 10 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Tire Rubbing Front Brake Line
I noticed yesterday that my tire on the driver's side has rubbed a flat spot on the rubber brake hose. I bent the metal tubing so that it doesn't rub any more, but should this be of great concern? Obviously I'd hate for it to rupture, but it looks as though it's not too bad.
View 1 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Moaning Noise From Front End At Highway Speeds
I noticed a moaning from the front end a few weeks back and it seems to be slowly getting a little worse. It is only noticeable when I'm accelerating or maintain speed, but as soon as I let off the accelerator and start to decelerate, it goes away. Sometimes, when the truck hasn't been driven for at least a couple hours, I pull away and there is a really noticeable sort of "clunk clunk clunk" but then it goes away and it just moans. I can also hear some noise from the front end at highway speeds, but of course it is hard to hear much else other than engine and road noise from the cab. It's a 2003 F250 with a 7.3 and four wheel drive.
View 8 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Back Tires Spinning While Front Ones Sit Idle In 4x4?
We have a lot of snow and a lot of ice up here at the moment and my 2003 ford F-250 SC Fx4 isn't performing so well. The truck is stock other than a pair of 285/16R BFG A/T's
I have been noticing that my rear tires will spin while trying to go up hill on some ice or snow covered areas and my front tires just sit still while in 4x4 or 4x4 low. In the case I just described I remain stuck in place until the rear tires can get a grip then I continue up hill. I don't understand why my front tires are not spinning as well, to me this seems just like 2 wheel drive not 4x4. I have been using ESOF most of the time. I have mentioned in other threads that I do plan on upgrading to warn premium hubs, but I am wondering if its that my truck isnt actually shifting into 4x4 or if there is a reason why even in 4x4 my rear tires would spin while my front tires do not?
I am confused because when I shift on the fly while driving I can feel the 4x4 kick in because it just feels different than driving with 2 wheel drive, but then something like I described will happen and I start second guessing myself. What might be happening? It's not that I am opposed to switching to the warn premium hubs, but is that actually going to fix this issue or is my truck acting normally??
Ford Super Duty (1999-2016) :: 2003 F250 - Replace The Front Hub Wheel Bearing Assemblies?
I am needing to replace the front hub wheel bearing assemblies on my 03 F250 4x4. I know Ford changed the studs from coarse thread to fine thread in between the 02 and 03 model years. Mine has a build date of 08/02 and I haven't been able to find the exact date they switched over. I'm ordering the parts online and want to get it right the first time.
View 3 RepliesFord Super Duty (1999-2016) :: 2003 F250 2WD - Rattling Thumping Noise Under Front End On Passenger Side
I have a 2003 F-250 6.0L 2WD and I recently noticed a rattling thumping noise under the front end on the passenger side. I noticed the rattle shortly after I got new tires, which are a hair bigger than the tires I had on it before. I thought it might be my new tires rubbing since they were bigger but then I noticed the rattle when I had my wheel straight and also when not moving at all. I've been driving it for a couple of weeks now with this rattle and I've been able to determine that it rattles most when I am going downhill and turning to the left putting more of the weight of the truck on the front right suspension components.
After reading several threads my first attempt to find the problem lead me to the discovery of a worn sway bar bushing. I thought this was for sure the problem and replaced both bushings and end links. But the rattle didn't go away. Then I thought maybe it was a bad wheel bearing so I replaced the wheel bearings in both front wheels. Still no change. Lastly, I happened to find a loose ABS line in the front right wheel well that was no longer secured and was banging against plastic. I secured that and still no change. All the bushings seem to be in good shape so I am considering taking it to a mechanic since I don't want to just replace everything hoping that it solves the problem piece by piece.
Ford Super Duty (1999-2016) :: 2003 F250 - T-Stat Stuck / Puking Coolant In Front Of Engine
I have an 03 F-250 6.0 Lariat with almost 200,000. The other day my t-stat started sticking and popping at 220 and then would go back to normal. Now it won't pop and it's puking coolant in the front of the engine. Would just a bad t-stat cause this or do I need to do my water pump as well.
View 1 RepliesFord Super Duty (1999-2016) :: 2001 F250 - Antifreeze Leak Parked The Truck In Slightly Forward Downhill Position
I have a 2001 F250 HD gas engine. I have had this truck since 2010. I drive it only occasionally and had not driven it in a few weeks so decided to drive it the other day. I drove about 30 minutes with about half of that on the interstate. It was a fairly hot day mid 80s and I had the AC running. I parked it at a very slight forward downhill position. When I came out after 45 minutes, I saw a puddle of antifreeze in front of the vehicle. When I looked underneath the truck it was primarily dripping from the oil filter canister but also from a couple of other places. I was down about 4 inches in the reservoir. My small truck camper is on the vehicle and I had my coolant container in there.
I topped it off and traveled about 10 minutes on surface streets to my next stop.After about two hours there I came out to the truck to leave and there was not a drop. I then drove 25 minutes home with a little on the interstate running the AC and when I got home not a drop. I got up underneath it and looked all around and couldn't really see an obvious source. My neighbor is a mechanic of sorts and I asked him about it. He had a couple of theories but one involved the heater. He said to crank it up, let it warm up, and turn the heat on and see if I smelled anti-freeze. I did that and there was not a smell at all. He also said something about a cold leak.
Ford Super Duty (1999-2016) :: 2003 - Clattering Noise Coming From Suspension Or Drive Train - Backing Plate Gone?
So on my 2003 F250 SCLB 4x4, I I was driving 70 or 80 miles to Huron in Ohio, to pick up a boat for a buddy with my truck. On the way up I heard a new clattering noise coming from the suspension or drive train, and we couldn't figure out what it was. After picking up the boat and coming back home without a problem, I looked under the truck and couldn't see any U-joints loose, But I saw that my right rear backing plate was disintegrated and gone. I took the truck to the shop and they said that the noise I'm hearing is the guts of the emergency brake pads and pins bouncing around in there when I drive and that my rear wheel could lock up at any time.
View 14 RepliesFord Super Duty (1999-2016) :: 2003 F250 - Front Tires Leaf Springs Rubbing Even On Slight Tight Turn
I got an 03 f250 with a 10 inch lift on 40x14.50 tires on 20x10 fuel hostage wheels. They rub my springs pretty bad when trying to make even the slightest kind of tight turn and the sound they make when they rub is even worse than them actually rubbing. My question is should i stay with this tire and wheel setup and try to get some 6061 billet aluminum 2 inch spacers? (I'm not sure about going that route though because of what i heard about spacers) or go down to some 38s with a 20x14 wheel that hopefully would push the tire away from the hub like spacers would do. I'm leaning more towards going to 38s because of the rubbing and also because I feel they might look better on the 10 inch lift rather than the 40s but dont know whats the best thing to do.
View 12 RepliesFord Super Duty (1999-2016) :: 2003 6.0L - Transmission Swap / Gear Ratios Are Slightly Different
Will an 05-07 5r110w transmission work in a 2003 truck? Some sites show same part number for each and some show different part numbers. I know the gear ratios are slightly different and that there is some other internal changes made to the 5r110w.
View 2 RepliesFord Super Duty (1999-2016) :: 1997 F250 - Cold Engine - Heater Would Blow Either Cold Or Slightly Warm
I can't seem to get the engine temp to middle range on the marker, but yet my heater blows "to me" hot air. Even while sitting in idle for extended amounts of time I cannot get it to "operating" temperature. I would think if my thermostat was stuck open my heater would blow either cold or slightly warm air. I have the 5.4L engine with knn air filter and no cats.
View 14 RepliesFord Super Duty (1999-2016) :: F250 4x4 - Front Radius Arm Length
I trying to find the distance/length of a 2005 4x4 onward front radius arm. I'm fitting a 2004 Cummins nv5600 and transfer case into a 1997 fzj80 Landcruiser. I'm also fitting front and rear diff/axles from a 2008 f350 however don't have the radius arms and late model f250 are extremely rare birds here as Ford don't sell them here. I want the distance from the rear bush in the radius arm(at the chassis) to the front bush (top and bottom) at the diff/axle....
View 1 RepliesFord Super Duty (1999-2016) :: F250 - Front Bumper Bent?
I bent my front bumper. Every time I look on amazon or ebay , when I put in my year, model, engine, it says their bumper won't fit. Mine has the 3 rectangular openings, 2 have the holes for mounting and tow hooks. It is chrome with the gray plastic or rubber bottom.Xlt. Also what part is the valance?
View 7 Replies